Ultralong-Life Cathode for Aqueous Zinc-Organic Batteries via Pouring 9,10-Phenanthraquinone into Active Carbon

2021 ◽  
Author(s):  
Beibei Yang ◽  
Yuanyuan Ma ◽  
Duan Bin ◽  
Hongbin Lu ◽  
Yongyao Xia
Keyword(s):  
Active Carbon ◽  
Organic Batteries

PEMANFAATAN KARBON AKTIF UNTUK MENGURANGI CEMARAN FORMALIN PADA IKAN ASIN JAMBAL ROTI

2020 ◽  
Vol 5 (1) ◽  
Author(s):  
Erma Ayu Nurcahyani ◽  
Merkuria Karyantina ◽  
Nanik Suhartatik
Keyword(s):  
Active Carbon ◽  
Food Preservation ◽  
Hazardous Substances ◽  
Salted Fish ◽  
Hazardous Chemical ◽  
The People ◽  
Randomized Design ◽  
Completely Randomized Design ◽  
Safe Food ◽  
Chemical Material

Ikan asin adalah metode untuk pengawetan makanan menggunakan kombinasi penggaraman dan pengeringan matahari. Di kalangan masyarakat, pembuatan ikan asin banyak menggunakan bahan kimia berbahaya seperti formalin. Penambahan bahan berbahaya mempengaruhi kualitas terutama keamanan. Makanan yang aman didefinisikan sebagai makanan yang terbebas dari cemaran biologi, kimia, mikrobiologi, yang dapat mempengaruhi kesehatan. Karbon aktif diduga bersifat polar yang mampu mengadsorpsi formalin. Tujuan penelitian ini adalah untuk mengetahui pengaruh pemberian karbon aktif dalam mengurangi cemaran formalin pada “jambal roti”. Rancangan percobaan yang digunakan untuk percobaan yaitu Rancangan Acak Lengkap (RAL) 2 faktorial, dengan faktor pertama yaitu konsentrasi karbon aktif 0, 3, dan 6% serta perlakuan kedua yaitu lama perebusan selama 5, 10, dan 15 menit. Penelitian ini dimulai dari pembuatan “jambal roti” dengan penambahan formalin dan perebusan dengan karbon aktif kemudian dianalisis uji kadar formalin, NaCl, protein, dan air. Hasil penelitian menunjukkan bahwa konsentrasi karbon aktif dan lama perebusan memberikan pengaruh yang signifikan pada kualitas jambal roti. Semakin tinggi konsentrasi karbon aktif dan lama perebusan maka semakin berkurangnya kadar formalin pada jambal roti. Hasil terbaik penelitian ini adalah karbon aktif 6% dan lama perebusan 15 menit. Menghasilkan formalin 3.21 ppm, NaCl 9.40%, protein 42.00%, dan air 30.02%. Kata kunci: Karbon Aktif, Formalin, Jambal Roti, Lama Perebusan. ABSTRACT                 Salted fish was a method for food preservation using combination of salting and sun drying. Among the people, the manufacture of salted fish use hazardous chemical material such as formaldehyde. The addition of hazardous substances affects the quality especially the safety. Safe food define as food that free from biological, chemical, microbiological contaminants that can affect health. Active carbon suspected to be polar which able to adsorb formaldehyde. The purpose of this research was to determine the influence of active carbon in reducing formaldehyde in salted fish “jambal roti”. The research used completely randomized design (CRD) with 2 factors, the first factor was the concentration of active carbon 0, 3, and 6% and the second was the boiling time (for 5, 10, and 15 min). This research was started from making “jambal roti” with the addition of formaldehyde and boiling with active carbon then analyzed for formaldehyde content, NaCl, protein, and moisture. The result showed that the concentration of active carbon and boiling time had a significant effect in quality salted fish “jambal roti”. The higher the concentration of active carbon and boiling time the more formaldehyde in “jambal roti” were removed. The best results of the research was 6% active carbon and 15 min of boiling time. Resulting 3.21 ppm of formaldehyde, 9.40% of NaCl, 42.00% of protein, and 30.02% of moisture. Keywords: Active Carbon, Formaldehyde, Jambal Roti, Boiling Time

Nano-silver active carbon fiber dressings improving bedsore wound healing in rats

2015 ◽  
Vol 36 (10) ◽  
pp. 1051 ◽  
Author(s):  
Ying WANG ◽  
Jian-xing SONG ◽  
Jiang-ping CHEN ◽  
Xiao-li LOU
Keyword(s):  
Wound Healing ◽  
Carbon Fiber ◽  
Active Carbon ◽  
Nano Silver

PWAS EMIS-ECIS Active Carbon Filter Residual Life Estimation Methodology

2013 ◽  
Author(s):  
Victor Giurgiutiu ◽  
Jingjing Bao
Keyword(s):  
Active Carbon ◽  
Residual Life ◽  
Life Estimation ◽  
Carbon Filter

Adsorption equilibria of ethanol vapours on active carbon

1973 ◽  
Vol 38 (2) ◽  
pp. 321-327 ◽  
Author(s):  
A. Zukal ◽  
O. Kadlec
Keyword(s):  
Active Carbon ◽  
Adsorption Equilibria ◽  
Ethanol Vapours

Analysis of the pore structure of adsorbents and its characterization by a numerical method

1984 ◽  
Vol 49 (12) ◽  
pp. 2721-2738 ◽  
Author(s):  
Ondřej Kadlec ◽  
Jerzy Choma ◽  
Helena Jankowska ◽  
Andrzej Swiatkowski
Keyword(s):  
Distribution Function ◽  
Pore Structure ◽  
Numerical Method ◽  
Active Carbon ◽  
Numerical Evaluation ◽  
Suggested Algorithm

This paper describes the algorithm of numerical evaluation of the parameters of the pore structure of adsorbents ( the micro, mezo and macropores). The structure of individual types of pores is described with the equation proposed by one of the present authors and giving the total distribution function of the pores with respect to their radii. The reliability of the suggested algorithm was verified in a number of calculations using a specially developed program. The results of the analysis and characterization of three different specimens of active carbon are shown as an example.

Improved removal and decolorization of C.I. anionic reactive yellow 145 A dye from water in a wide pH range via active carbon adsorbent-loaded-cationic surfactant

2014 ◽  
Vol 55 (1) ◽  
pp. 227-240 ◽  
Author(s):  
Mohamed E. Mahmoud ◽  
Gehan M. Nabil ◽  
Nabila M. El-Mallah ◽  
Shimaa B. Karar
Keyword(s):  
Cationic Surfactant ◽  
Active Carbon ◽  
Carbon Adsorbent ◽  
Wide Ph Range ◽  
Ph Range

Investigation on a New Hydraulic Cementitious Binder Made from Phosphogypsum

2013 ◽  
Vol 864-867 ◽  
pp. 1923-1928
Author(s):  
Yue Xu ◽  
Jian Xi Li ◽  
Li Li Kan
Keyword(s):  
Compressive Strength ◽  
Fly Ash ◽  
Active Carbon ◽  
High Strength ◽  
Tricalcium Silicate ◽  
Dicalcium Silicate ◽  
Cementitious Material ◽  
Saturation Ratio ◽  
Tricalcium Aluminate ◽  
Cementitious Binder

A new kind of high strength cementitious material is made from phosphogypsum (PG), active carbon and fly-ash. Through the orthogonal research, it was showed that the calcination temperature, retention time, dosage of active carbon and fly ash on the compressive strength of cementitious binder are the most important. The result also showed that, in the conditions of temperature 1200°C, time retention 30 min, dosage of active carbon 10%, dosage of fly ash 5%, the compressive strength of the cementitious material for 3d and 28d could reach to 46.35MPa and 92.70MPa, the content of sulfur trioxide was 11.60% accordingly. A lot of active mineral materials, such as dicalcium silicate, tricalcium silicate, tricalcium aluminate were formed in the calcination. The C-S-H gel, calcium hydroxide and ettringite were found in 3d and 28d hydrates. It is found that the lime saturation ratio and silica modulus need to be control between 0.40~0.65 and 4~8 in order to produce high strength cementitious material.

scholarly journals Defect-induced B4C electrodes for high energy density supercapacitor devices

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Özge Balcı ◽  
Merve Buldu ◽  
Ameen Uddin Ammar ◽  
Kamil Kiraz ◽  
Mehmet Somer ◽  
...  
Keyword(s):  
Active Carbon ◽  
High Performance ◽  
Carbon Sources ◽  
High Energy ◽  
High Energy Density ◽  
Synthesis Conditions ◽  
High Energy Ball Mill ◽  
Energy Ball ◽  
G Ratio ◽  
Energy And Power Density

AbstractBoron carbide powders were synthesized by mechanically activated annealing process using anhydrous boron oxide (B2O3) and varying carbon (C) sources such as graphite and activated carbon: The precursors were mechanically activated for different times in a high energy ball mill and reacted in an induction furnace. According to the Raman analyses of the carbon sources, the I(D)/I(G) ratio increased from ~ 0.25 to ~ 0.99, as the carbon material changed from graphite to active carbon, indicating the highly defected and disordered structure of active carbon. Complementary advanced EPR analysis of defect centers in B4C revealed that the intrinsic defects play a major role in the electrochemical performance of the supercapacitor device once they have an electrode component made of bare B4C. Depending on the starting material and synthesis conditions the conductivity, energy, and power density, as well as capacity, can be controlled hence high-performance supercapacitor devices can be produced.

scholarly journals High-capacity and small-polarization aluminum organic batteries based on sustainable quinone-based cathodes with Al3+ insertion

2021 ◽  
Vol 2 (3) ◽  
pp. 100354
Author(s):  
Limin Zhou ◽  
Zihe Zhang ◽  
Lianmeng Cui ◽  
Fangyu Xiong ◽  
Qinyou An ◽  
...  
Keyword(s):  
High Capacity ◽  
Organic Batteries

scholarly journals The influence of active carbon contaminants on the ozonation mechanism interpretation

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Lilla Fijołek ◽  
Joanna Świetlik ◽  
Marcin Frankowski
Keyword(s):  
Activated Carbon ◽  
Active Carbon ◽  
Alkali Metals ◽  
Activated Carbons ◽  
Carbon Surface ◽  
Bulk Solution ◽  
Ozone Decomposition ◽  
Reaction Products ◽  
Treatment Technology ◽  
Carbon Impurities

AbstractIn water treatment technology, activated carbons are used primarily as sorbents to remove organic impurities, mainly natural organic matter, but also as catalysts in the ozonation process. Commercially available activated carbons are usually contaminated with mineral substances, classified into two main groups: alkali metals (Ca, Na, K, Li, Mg) and multivalent metals (Al, Fe, Ti, Si). The presence of impurities on the carbon surface significantly affects the pHpzc values determined for raw and ozonated carbon as well as their acidity and alkalinity. The scale of the observed changes strongly depends on the pH of the ozonated system, which is related to the diffusion of impurities from the carbon to the solution. In an acidic environment (pH 2.5 in this work), the ozone molecule is relatively stable, yet active carbon causes its decomposition. This is the first report that indirectly indicates that contaminants on the surface of activated carbon (multivalent elements) contribute to the breakdown of ozone towards radicals, while the process of ozone decomposition by purified carbons does not follow the radical path in bulk solution. Carbon impurities also change the distribution of the reaction products formed by organic pollutants ozonation, which additionally confirms the radical process. The study showed that the use of unpurified activated carbon in the ozonation of succinic acid (SA) leads to the formation of a relatively large amount of oxalic acid (OA), which is a product of radical SA degradation. On the other hand, in solutions with purified carbon, the amount of OA generated is negligible.

Sign in / Sign up

Export Citation Format

Share Document