scholarly journals The potential bio-conversion of Palm Oil Mill Effluent (POME) as Bioethanol by steady-state anaerobic processes

2020 ◽  
Vol 148 ◽  
pp. 02001
Author(s):  
Muh. Ilham Anggamulia ◽  
Mindriany Syafila ◽  
Marisa Handajani ◽  
Andri Gumilar
Keyword(s):  
Palm Oil ◽  
Alternative Energy ◽  
Fossil Fuels ◽  
Batch Reactor ◽  
Formation Rate ◽  
Degradation Process ◽  
Raw Material ◽  
Palm Oil Mill Effluent ◽  
High Concentration ◽  
Palm Oil Mill

Biomass is a central issue as new material that can be used as a substrate to produce biofuels, it has become global research to replace liquid fossil fuels with alternative renewable and sustainable fossils. Palm oil mill effluent (POME) is the potential of Agri-industrial waste to be used as alternative energy with anaerobic digestion of high concentration organic wastewater can be used for bioethanol production to replace food as raw material. Bioethanol can be produced in acidogenic steps in the organic degradation process. In this research, bacterial mixed cultures sourced from bovine rumen as biomass and the substrate used was palm oil mill effluent (POME) with a characteristic COD concentration of 25,600 mg/L, The operation of the reactor is set at pH 5; 6; 7 for 72 hours with the type of anaerobic circulating batch reactor (CBR), measurement of bioethanol products and acidogenesis of samples is carried out every 6 hours. The results showed that the reactor with variations in pH conditions 5 gave the highest efficiency of bioethanol formation in the 12 hour running process, result is 102,94 mg/L with a maximum formation rate of 9,98 mg/L/hour.

scholarly journals Phytoremediation Potential of Vetiver System Technology for Improving the Quality of Palm Oil Mill Effluent

2014 ◽  
Vol 2014 ◽  
pp. 1-10 ◽  
Author(s):  
Negisa Darajeh ◽  
Azni Idris ◽  
Paul Truong ◽  
Astimar Abdul Aziz ◽  
Rosenani Abu Bakar ◽  
...  
Keyword(s):  
Palm Oil ◽  
Oxygen Demand ◽  
Raw Material ◽  
Biofuel Production ◽  
Palm Oil Mill Effluent ◽  
System Technology ◽  
High Concentration ◽  
Low Concentration ◽  
Control Sets ◽  
Palm Oil Mill

Palm oil mill effluent (POME), a pollutant produced by the palm oil industry, was treated by the Vetiver system technology (VST). This technology was applied for the first time to treat POME in order to decrease biochemical oxygen demand (BOD) and chemical oxygen demand (COD). In this study, two different concentrations of POME (low and high) were treated with Vetiver plants for 2 weeks. The results showed that Vetiver was able to reduce the BOD up to 90% in low concentration POME and 60% in high concentration POME, while control sets (without plant) only was able to reduce 15% of BOD. The COD reduction was 94% in low concentration POME and 39% in high concentration POME, while control just shows reduction of 12%. Morphologically, maximum root and shoot lengths were 70 cm, the number of tillers and leaves was 344 and 86, and biomass production was 4.1 kg m−2. These results showed that VST was effective in reducing BOD and COD in POME. The treatment in low concentration was superior to the high concentration. Furthermore, biomass of plant can be considered as a promising raw material for biofuel production while high amount of biomass was generated in low concentration of POME.

Treatment of Palm Oil Mill Effluent by Electrocoagulation Process

2012 ◽  
Vol 610-613 ◽  
pp. 363-367
Author(s):  
Tipakorn Suwannarat ◽  
Nipon Pisutpaisal ◽  
Siriorn Boonyawanich
Keyword(s):  
Palm Oil ◽  
Contact Time ◽  
Batch Reactor ◽  
Oxygen Demand ◽  
Total Suspended Solid ◽  
Suspended Solid ◽  
Steel Plates ◽  
Palm Oil Mill Effluent ◽  
Electrocoagulation Process ◽  
Palm Oil Mill

The purpose of current study was to examine the ability of electrocoagulation in decreasing chemical oxygen demand (COD) and total suspended solid (TSS) constituted in palm oil mill effluent. Bench-scale batch reactor containing two aluminum or steel plates (10 cm width × 30 cm height with 0.1 cm thickness) serving as electrodes with the interval distance of 3 cm was set up. The wastewater with COD concentration of 68,425 mg L-1 was treated in the reactor under the varied direct currents (0.3-1.3 A) and contact time (30-120 min). Sodium chloride was added to the wastewater to obtain the final concentration of 2 g L-1 (conductivity of 10 ms) prior to being fed into the reactor. The results showed that higher treatment efficiency when the aluminum was used as electrodes compared to the steel. COD removal efficiency was directly proportional to the contact time. The maximum COD and TSS removal observed at 1.3 A current input and 60 min contact time are 74.1 and 77.0%, respectively.

scholarly journals Dark Fermentative Biohydrogen Production from Palm oil Mill Effluent: Operation Factors and Future Progress of Biohydrogen Energy

2020 ◽  
Vol 28 (S2) ◽  
Author(s):  
Fatin Sakinah Rosman ◽  
Mohd Zulkhairi Mohd Yusoff ◽  
Mohd Rafein Zakaria ◽  
Toshinari Maeda ◽  
Mohd Ali Hassan
Keyword(s):  
Palm Oil ◽  
Fossil Fuels ◽  
Microbial Consortium ◽  
Global Market ◽  
Review Article ◽  
Biohydrogen Production ◽  
Palm Oil Mill Effluent ◽  
Operational Parameters ◽  
Microbial Strains ◽  
Palm Oil Mill

Malaysia is one of the largest producers and exporters of palm oil, thus, a large amount of palm oil mill effluent (POME) is generated through this process. POME contributes to environmental pollution if it is not properly treated. This complex effluent consists of colloidal matters and mainly organic components with more than 90% water. Thus, it is useful to be used as a substrate for fermentative processes, including biohydrogen production. Biohydrogen from POME is a renewable source that can potentially serve as an alternative to substitute fossil fuels. The abundance of POME and the rising price of fossil fuels in the global market create a demand for this source of energy. However, the complexity of the substituents in POME makes the optimisation of this effluent as a substrate in dark fermentation a challenge. This review article explores the important parameters that need to be considered for optimal biohydrogen production, such as the bioreactor operational parameters and the microbial consortium. Besides, the potential of metabolic engineering as a tool to overcome the limitations of the microbial strains to metabolise POME for increased biohydrogen production was also reviewed. However, further research and development are needed to increase the biohydrogen yield on par with commercial demand.

scholarly journals Enhanced oil recovery from palm oil mill effluent using ultrasonication technique

2021 ◽  
Vol 945 (1) ◽  
pp. 012042
Author(s):  
Y M Tang ◽  
W Y Wong ◽  
K T Tan ◽  
L P Wong
Keyword(s):  
Palm Oil ◽  
Oil Recovery ◽  
Oil Content ◽  
Research Work ◽  
Solid Particles ◽  
Biodiesel Production ◽  
Palm Oil Mill Effluent ◽  
Sound Waves ◽  
High Concentration ◽  
Palm Oil Mill

Abstract Palm oil is the planet’s most exploited vegetable oil. However, its extensive commercialization has resulted in massive waste, particularly palm oil mill effluent (POME), contributing to severe environmental pollution. POME has a high concentration of oil and grease (O&G) with the mean value of 4,340 mg/L, exceeding the standard discharge limit of 50 mg/L. Hence, the recovery of oil content in POME is crucial as it could be a key material in biodiesel production. The oil droplets in POME exist in two phases: floating in the supernatant and suspended in the solids. During the solvent extraction process, the oil adsorbed by the solid particles is not entirely recovered. Thus, ultrasonication-based process intensification is introduced. Ultrasonication can break apart the solid particles and release the oil content using the principle of sound waves, thereby it will eventually increase the yield of oil recovery from POME. Although some studies were done on oil extraction from POME, the use of ultrasonication technique to enhance the extraction of oil from POME has never been done. The current research work is to investigate the feasibility of using ultrasonication technique to enhance the oil recovery from POME and compare it to a non-ultrasonicated POME. Overall, this research discovered that using ultrasonication as a pre-treatment would improve oil recovery yield from POME by 39.17% as compared to non-ultrasonicated sample under the optimum ultrasonication conditions of 30% amplitude and 30 seconds duration.

scholarly journals Simulation Study of Bio-Methane Conversion into Hydrogen for Generating 500 kW of Power

2018 ◽  
Vol 164 ◽  
pp. 01027 ◽  
Author(s):  
Maizirwan Mel ◽  
Fouad Riyad Hussein Abdeen ◽  
Hamzah Mohd Salleh ◽  
Sany Izan Ihsan ◽  
Fazia Adyani Ahmad Fuad ◽  
...  
Keyword(s):  
Research And Development ◽  
Electric Power ◽  
Palm Oil ◽  
Simulation Study ◽  
Methane Conversion ◽  
Fossil Fuels ◽  
Biogas Production ◽  
Simulation Software ◽  
Palm Oil Mill Effluent ◽  
Palm Oil Mill

Research and development sectors have made great efforts for finding cleaner and greener supplements for fossil fuels. The uses of POME (Palm oil Mill Effluent) as feedstock of biogas production has attracted many industries to produce energy because this source (waste) is abundance and not fully utilised. Methane from biogas production has shown to have a significant potential to replace the depleting sources as it can be produced from renewable feed stocks. The main objective of this study is to produce hydrogen from methane obtained by digesting of POME and to transform bio-methane into hydrogen for generating 500 kW of electric power using a simulation software of SuperPro Design.

scholarly journals The performance of a pilot-scale anaerobic hybrid bioreactor on palm oil mill effluent treatment

REAKTOR ◽  
2019 ◽  
Vol 19 (3) ◽  
pp. 111-116
Author(s):  
Adrianto Ahmad ◽  
Bahruddin Bahruddin ◽  
David Andrio ◽  
Amir Hamzah
Keyword(s):  
Palm Oil ◽  
Alternative Energy ◽  
Scale Up ◽  
Organic Content ◽  
Effluent Treatment ◽  
Palm Oil Mill Effluent ◽  
Alternative Source ◽  
Methane Gas ◽  
Working Volume ◽  
Palm Oil Mill

Contemporarily, Indonesia and Malaysia are the largest contributors of crude palm oil (CPO) in the world by up to 40%, and 37.3%, respectively. Furthermore, its production value this year reached 19.7 million tons, where each generates 2.5 m3 of wastewater. Meanwhile, of all the provinces in Indonesia specifically, Riau is the largest supplier for exports by up to 38%, generated from 225 palm oil mills, where a total of 6.3 million tons resulting in the generation of about 15.75 million m3 of wastewater, with organic content between the range of 30,000-60,000 mg COD/l. In addition, one of the uses of this wastewater includes anaerobic processes, with the double benefit of reducing COD concentrations, subsequently applying it as fertilizer, and also in the production of methane gas, as an alternative source of energy. The purpose of this study, therefore, is to observe the effect of bioreactor volume, scale-up on the performance of anaerobic hybrid bioreactors, in the treatment of mill effluents. The technology examined in this study was the anaerobic hybrid bioreactor with the dimensions of length 22 m, width 10 m, and depth 1.5 m, and a total volume of 330 m3, which is impermeable to oxygen, and a 250 m3 effective working volume. This was built and operated at a hydraulic retention time of 1 day, in the Palm Oil Mill of Riau, and the results showed the environmental conditions to range from a pH of 7.2 to 8.0, with temperatures from 320C to 350C, acetic acid of 774 mg/l to 1,180 mg/l, and alkalinity of 2,149 mg/l up to 2,400 mg/l. Furthermore, the performance of these reactors are shown by the highest COD removal efficiency of 77.8%, and a biogas test for the propensity of being applied as an alternative energy source obtained a methane gas concentration of 54%. Keywords: anaerobic, bioreactor, biogas, wastewater, performance, palm oil mill effluent

Sign in / Sign up

Export Citation Format

Share Document