Closure to “ Incipient Motion of Sand Particles on Side Slopes ” by Syunsuke Ikeda (January, 1982)

1983 ◽  
Vol 109 (5) ◽  
pp. 784-786
Author(s):  
Syunsuke Ikeda
Water ◽  
2021 ◽  
Vol 13 (7) ◽  
pp. 994
Author(s):  
Reza Shahmohammadi ◽  
Hossein Afzalimehr ◽  
Jueyi Sui

In this study, the incipient motion of four groups of sand, ranging from medium to very coarse particles, was experimentally examined using an acoustic Doppler velocimeter (ADV) in different water depths under the hydraulically transitional flow condition. The transport criterion of the Kramer visual observation method was used to determine threshold conditions. Some equations for calculating threshold average and near-bed velocities were derived. Results showed that the threshold velocity was directly proportional to both sediment particle size and water depth. The vertical distributions of the Reynolds shear stress showed an increase from the bed to about 0.1 of the water’s depth, after performing a damping area, then a decrease toward the water surface. By extending the linear portion of the Reynolds shear stress in the upper zone of the damping area to the bed, the critical shear stress, particle shear Reynolds number, and critical Shields parameter were calculated. Results showed that the critical Shields parameter was located under the Shields curve, showing no sediment motion. This indicates that the incipient motion of sediment particles occurred with smaller bed shear stress than that estimated using the Shields diagram in the hydraulically transitional flow region. The reason could be related to differences between the features of the present experiment and those of the experiments used in the development of the Shields diagram, including the approaches to determine and define threshold conditions, the accuracy of experimental tools to estimate critical shear stress, and sediment particle characteristics. Therefore, the change in the specifications of experiments from those on which the Shields diagram has been based led to the deviation between the estimation using the Shields diagram and that of real threshold conditions, at least in the hydraulically transitional flow region with sand particles.


2019 ◽  
Vol 579 ◽  
pp. 124178
Author(s):  
Arif Jewel ◽  
Kazunori Fujisawa ◽  
Akira Murakami

Author(s):  
D.S. DeMiglio

Much progress has been made in recent years towards the development of closed-loop foundry sand reclamation systems. However, virtually all work to date has determined the effectiveness of these systems to remove surface clay and metal oxide scales by a qualitative inspection of a representative sampling of sand particles. In this investigation, particles from a series of foundry sands were sized and chemically classified by a Lemont image analysis system (which was interfaced with an SEM and an X-ray energy dispersive spectrometer) in order to statistically document the effectiveness of a reclamation system developed by The Pangborn Company - a subsidiary of SOHIO.The following samples were submitted: unreclaimed sand; calcined sand; calcined & mechanically scrubbed sand and unused sand. Prior to analysis, each sample was sprinkled onto a carbon mount and coated with an evaporated film of carbon. A backscattered electron photomicrograph of a field of scale-covered particles is shown in Figure 1. Due to a large atomic number difference between sand particles and the carbon mount, the backscattered electron signal was used for image analysis since it had a uniform contrast over the shape of each particle.


2009 ◽  
Vol 36 (1) ◽  
pp. 80-95
Author(s):  
Achanta Ramakrishna Rao ◽  
Bimlesh Kumar
Keyword(s):  

Coatings ◽  
2021 ◽  
Vol 11 (2) ◽  
pp. 151
Author(s):  
Yuyang Liu ◽  
Chang-Hwan Choi

Sand, a cheap and naturally abundant particulate material, was modified with photocatalytic and hydrophobic coatings to reduce evaporation loss and facilitate the purification of water. The first-level photocatalytic coatings (TiO2 or ZnO nanocrystals) rendered nanoscale roughness on the surface of the sand. The additional second-level hydrophobic coating of a self-assembled monolayer of octyltrimethoxysilane (OTS) made the sand particles superhydrophobic because of the nanoscale roughness imposed by the nanocrystals. The superhydrophobic sand particles, floating on the free surface of water due to their superhydrophobicity, significantly reduced the evaporation loss of water by 60%–90% in comparison to an uncovered water surface. When the outer hydrophobic coatings are weathered or disengaged, the inner photocatalytic coatings become exposed to water. Then, the sand particles act as photocatalysts to degrade the contaminants in water under solar radiation.


Chemosphere ◽  
2021 ◽  
Vol 268 ◽  
pp. 129365
Author(s):  
Sadra Sadeghian ◽  
Hossein Pourfakhar ◽  
Majid Baghdadi ◽  
Behnoush Aminzadeh

2021 ◽  
Vol 300 ◽  
pp. 124332
Author(s):  
Gongxun Deng ◽  
Wen Ma ◽  
Yong Peng ◽  
Shiming Wang ◽  
Song Yao ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document