The interference of elemental sulfur in the determination of trace organics in drinking water by the carbon adsorption method

1976 ◽  
Vol 11 (6) ◽  
pp. 409-415 ◽  
Author(s):  
Carey B. Bottom ◽  
Gary C. Magruder ◽  
Donald J. Siehr ◽  
Sotirios G. Grigoropoulos ◽  
William P. Clarke
Keyword(s):  
Drinking Water ◽  
Elemental Sulfur ◽  
Adsorption Method ◽  
Carbon Adsorption ◽  
Trace Organics

APPLICATION OF ADSORPTION METHOD FOR DETERMINATION OF LOCAL CONVECTIVE HEAT TRANSFER RATES

1974 ◽  
Author(s):  
S. Koncar-Djurdjevic ◽  
M. Mitrovic ◽  
S. Cvijovic ◽  
G. Popovic ◽  
Dimitrije Voronjec
Keyword(s):  
Heat Transfer ◽  
Convective Heat Transfer ◽  
Convective Heat ◽  
Adsorption Method ◽  
Transfer Rates

Colorimetric Determination of Fluoride in Drinking Groundwater using a Polymeric Zirconium Complex of 5-(2-Carboxyphenylazo)-8-Hydroxyquinoline

2013 ◽  
Vol 12 (7) ◽  
pp. 460-465
Author(s):  
Sameer Amereih ◽  
Zaher Barghouthi ◽  
Lamees Majjiad
Keyword(s):  
Drinking Water ◽  
Detection Limit ◽  
Complex Formation ◽  
Molar Absorptivity ◽  
Colorimetric Determination ◽  
Zirconium Complex ◽  
Reliable Determination ◽  
Percentage Recovery ◽  
Quantitation Limit

A sensitive colorimetric determination of fluoride in drinking water has been developed using a polymeric zirconium complex of 5-(2-Carboxyphenylazo)-8-Hydroxyquinoline as fluoride reagents. The method allowed a reliable determination of fluoride in range of (0.0-1.5) mg L-1. The molar absorptivity of the complex formation is 7695 ± 27 L mol-1 cm-1 at 460 nm. The sensitivity, detection limit, quantitation limit, and percentage recovery for 1.0 mg L-1 fluoride for the proposed method were found to be 0.353 ± 0.013 μg mL-1, 0.1 mg L-1, 0.3 mg L-1, and 101.7 ± 4.1, respectively.

PTSA (pressure and thermal swing adsorption) method to remove trihalomethanes from drinking water

1997 ◽  
Vol 35 (7) ◽  
pp. 243-250 ◽  
Author(s):  
Shigekazu Nakano ◽  
Tomoko Fukuhara ◽  
Masami Hiasa
Keyword(s):  
Drinking Water ◽  
Residual Chlorine ◽  
Remarkable Difference ◽  
Adsorption Method ◽  
Heating And Cooling ◽  
Point Of Use ◽  
Thermal Swing Adsorption ◽  
Long Time ◽  
Musty Odor ◽  
Vacuum Heating

It has been widely recognized that trihalomethanes (THMs) in drinking water pose a risk to human health. THMs can be removed to a certain extent by the conventional point-of-use (POU) unit which is composed of activated carbon (AC) and microfilter. But it's life on THMs is relatively shorter than on residual chlorine or musty odor. To extent the life of AC adsorber, pressure and thermal swing adsorption (PTSA) was applied by preferential regeneration of chloroform. PTSA was effective to remove THMs, especially chloroform. Adsorption isotherms of chloroform at 25 and 70°C showed a remarkable difference so that thermal swing was considered effective. Chloroform was also desorbed by reducing pressure. By vacuum heating at 70°C, chloroform was almost desorbed from AC and reversible adsorption was considered possible. A prototype of POU unit with PTSA was proposed. Regeneration mode would consist of dewatering, vacuum heating and cooling (backwashing). The unit was maintained in bacteriostatic condition and could be used for a long time without changing an AC cartridge.

Determination of Hg(II) in drinking water by atomic absorption spectrometry - Cold vapour method after concentration by column extraction chromatography

1984 ◽  
Vol 49 (5) ◽  
pp. 1134-1139 ◽  
Author(s):  
Zdeněk Šmejkal ◽  
Jitka Tauferová ◽  
Mária Madová ◽  
Zlatica Teplá
Keyword(s):  
Drinking Water ◽  
Atomic Absorption Spectrometry ◽  
Atomic Absorption ◽  
Extraction Chromatography ◽  
Absorption Spectrometry ◽  
Average Yield ◽  
Water Mains ◽  
Cold Vapour ◽  
Column Extraction

The method describes concentration of mercury in samples of drinking water from water mains with Hg concentration above 1.0 . 10-7 g l-1 (5.0 . 10-10mol l-1) by means of extraction chromatography on a column packed with a carrier Synachrom E-5 wetted with saturated solution of bis(diethyldithiocarbamate)copper(II) complex in 1 : 1 mixture 1,2-dichlorobenzene + cyclohexane. After elution with 3.0 mol l-1 HCl the mercury concentration in the eluate is determined by atomic absorption spectrometry - cold vapour method. Average yield of the mercury separation from the model solutions was 95.8%.

Multi-Array Wax Paper-Based Platform for the Pre-Concentration and Determination of Silver Ions in Drinking Water

Talanta ◽  
2021 ◽  
pp. 122474
Author(s):  
Neda Bagheri ◽  
Stefano Cinti ◽  
Eleonora Nobile ◽  
Danila Moscone ◽  
Fabiana Arduini
Keyword(s):  
Drinking Water ◽  
Silver Ions
Sign in / Sign up

Export Citation Format

Share Document