Design and experimental study of pilot scale throat-less downdraft gasifier fed by rice husk and wood sawdust

2017 ◽  
Vol 37 (9) ◽  
pp. 873-885 ◽  
Author(s):  
A. A. P. Susastriawan ◽  
Harwin Saptoadi ◽  
Purnomo
Keyword(s):  
Experimental Study ◽  
Rice Husk ◽  
Pilot Scale ◽  
Downdraft Gasifier ◽  
Wood Sawdust

EXPERIMENTAL STUDY OF A BINARY MIXTURE OF RICE HUSK AND SAND IN A FLUIDIZED BED

2019 ◽  
Author(s):  
Fernando Manente Perrella Balestieri ◽  
Carlos Manuel Romero Luna ◽  
Ivonete Ávila
Keyword(s):  
Experimental Study ◽  
Binary Mixture ◽  
Fluidized Bed ◽  
Rice Husk

scholarly journals Gasification and Power Generation Characteristics of Rice Husk, Sawdust, and Coconut Shell Using a Fixed-Bed Downdraft Gasifier

2021 ◽  
Vol 13 (4) ◽  
pp. 2027
Author(s):  
Md. Emdadul Hoque ◽  
Fazlur Rashid ◽  
Muhammad Aziz
Keyword(s):  
Rice Husk ◽  
Fixed Bed ◽  
Cost Effective ◽  
Coconut Shell ◽  
Energy Sources ◽  
Airflow Rate ◽  
Gas Generation ◽  
Biomass Feedstocks ◽  
Downdraft Gasifier ◽  
Synthetic Gas

Synthetic gas generated from the gasification of biomass feedstocks is one of the clean and sustainable energy sources. In this work, a fixed-bed downdraft gasifier was used to perform the gasification on a lab-scale of rice husk, sawdust, and coconut shell. The aim of this work is to find and compare the synthetic gas generation characteristics and prospects of sawdust and coconut shell with rice husk. A temperature range of 650–900 °C was used to conduct gasification of these three biomass feedstocks. The feed rate of rice husk, sawdust, and coconut shell was 3–5 kg/h, while the airflow rate was 2–3 m3/h. Experimental results show that the highest generated quantity of methane (vol.%) in synthetic gas was achieved by using coconut shell than sawdust and rice husk. It also shows that hydrogen production was higher in the gasification of coconut shell than sawdust and rice husk. In addition, emission generations in coconut shell gasification are lower than rice husk although emissions of rice husk gasification are even lower than fossil fuel. Rice husk, sawdust, and coconut shell are cost-effective biomass sources in Bangladesh. Therefore, the outcomes of this paper can be used to provide clean and economic energy sources for the near future.

scholarly journals Simulation of a Downdraft Gasifier for Production of Syngas from Different Biomass Feedstocks

2021 ◽  
Vol 5 (2) ◽  
pp. 20
Author(s):  
Mateus Paiva ◽  
Admilson Vieira ◽  
Helder T. Gomes ◽  
Paulo Brito
Keyword(s):  
Modeling And Simulation ◽  
Pilot Scale ◽  
Operating Conditions ◽  
Fuel Gas ◽  
Heating Value ◽  
Downdraft Gasifier ◽  
Process Operation ◽  
Independent Parameters ◽  
Gasification Temperature ◽  
Main Operating

In the evaluation of gasification processes, estimating the composition of the fuel gas for different conditions is fundamental to identify the best operating conditions. In this way, modeling and simulation of gasification provide an analysis of the process performance, allowing for resource and time savings in pilot-scale process operation, as it predicts the behavior and analyzes the effects of different variables on the process. Thus, the focus of this work was the modeling and simulation of biomass gasification processes using the UniSim Design chemical process software, in order to satisfactorily reproduce the operation behavior of a downdraft gasifier. The study was performed for two residual biomasses (forest and agricultural) in order to predict the produced syngas composition. The reactors simulated gasification by minimizing the free energy of Gibbs. The main operating parameters considered were the equivalence ratio (ER), steam to biomass ratio (SBR), and gasification temperature (independent variables). In the simulations, a sensitivity analysis was carried out, where the effects of these parameters on the composition of syngas, flow of syngas, and heating value (dependent variables) were studied, in order to maximize these three variables in the process with the choice of the best parameters of operation. The model is able to predict the performance of the gasifier and it is qualified to analyze the behavior of the independent parameters in the gasification results. With a temperature between 850 and 950 °C, SBR up to 0.2, and ER between 0.3 and 0.5, the best operating conditions are obtained for maximizing the composition of the syngas in CO and H2.

Experimental Study on Utilization FGD Byproducts in Building Bricks

2010 ◽  
Vol 150-151 ◽  
pp. 753-757 ◽  
Author(s):  
Xiong Hao Li ◽  
Yong Jie Xue ◽  
Min Zhou
Keyword(s):  
Experimental Study ◽  
Compressive Strength ◽  
Optimum Design ◽  
Power Plants ◽  
Pilot Scale ◽  
Mixture Composition ◽  
Technical Requirement ◽  
Do No Harm ◽  
Maximum Compressive Strength ◽  
Scale Experiment

This paper discussed the feasibility of unburned and non-autoclaved, steam cured bricks prepared by FGD byproducts from coal-fired power plants. The results show that FGD byproduct, aggregates, cementious materials and water could be used to prepare bricks during the process of stir and compaction under natural cure and steam cured condition. S4 and Z2 are the optimum design mixture composition. The maximum compressive strength and saturation coefficient are 28.7 MPa and 96.7%. FGD byproducts do no harm to environment and a pilot-scale experiment demonstrates that bricks made with FGDA can meet the MU10 level bricks technical requirement.

Co-gasification of Different Biomass Feedstock in a Pilot-Scale (24 kWe) Downdraft Gasifier: An Experimental Approach

Energy ◽  
2021 ◽  
pp. 121821
Author(s):  
Muhammad Awais ◽  
Muhammad Mubashar Omar ◽  
Anjum Munir ◽  
Wei li ◽  
Muhammad Ajmal ◽  
...  
Keyword(s):  
Experimental Approach ◽  
Pilot Scale ◽  
Biomass Feedstock ◽  
Downdraft Gasifier

scholarly journals Energy Efficient Dryer with Rice Husk Fuel for Agriculture Drying

2015 ◽  
Vol 4 (1) ◽  
pp. 20-24 ◽  
Author(s):  
M. Djaeni ◽  
N. Asiah ◽  
S Suherman ◽  
A. Sutanto ◽  
A. Nurhasanah
Keyword(s):  
Rice Husk ◽  
Energy Efficient ◽  
Pilot Scale ◽  
Drying Process ◽  
Energy Usage ◽  
Drying Time ◽  
Heat Efficiency ◽  
Operational Temperature ◽  
Time And Energy ◽  
Fossil Fuel Energy

Energy usage is crucial aspect on agriculture drying process. This step spends about 70% of total energy in post harvest treatment. The design of efficient dryer with renewable energy source is urgently required due to the limitation of fossil fuel energy. This work discusses the performance of air dehumidification using rice husk fuel as heat source for onion, and paddy drying. Unlike conventional dryer, the humidity of air during the drying was dehumidified by adsorbent. Hence, the driving force of drying can be  kept high.  As consequences, the drying time and energy usage can be reduced. Here, the research was conducted in two step: laboratory and pilot scale tests. Results showed that the lowering air humidity with rice husk fuel has improved the energy efficiency. At operational temperature 60oC, the heat efficiency of 75%  was achieved. 

Sign in / Sign up

Export Citation Format

Share Document