CALCULATION OF ELECTRICAL CONDUCTIVITY FROM SOLUTION COMPOSITION DATA AS AN AID TO IN-SITU ESTIMATION OF SOIL SALINITY

Soil Science ◽  
1970 ◽  
Vol 110 (6) ◽  
pp. 405-414 ◽  
Author(s):  
B L McNEAL ◽  
J D OSTER ◽  
J T HATCHER
Soil Science ◽  
1977 ◽  
Vol 123 (2) ◽  
pp. 126-129 ◽  
Author(s):  
J. T. GILMOUR ◽  
J. A. FERGUSON ◽  
C. L. GRIFFIS ◽  
K. S. SHIRK

2021 ◽  
Vol 285 ◽  
pp. 110171
Author(s):  
Sebastián Bañón ◽  
Sara Álvarez ◽  
Daniel Bañón ◽  
María Fernanda Ortuño ◽  
María Jesús Sánchez-Blanco

2021 ◽  
Vol 13 (10) ◽  
pp. 1875
Author(s):  
Wenping Xie ◽  
Jingsong Yang ◽  
Rongjiang Yao ◽  
Xiangping Wang

Soil salt-water dynamics in the Yangtze River Estuary (YRE) is complex and soil salinity is an obstacle to regional agricultural production and the ecological environment in the YRE. Runoff into the sea is reduced during the impoundment period as the result of the water-storing process of the Three Gorges Reservoir (TGR) in the upper reaches of the Yangtze River, which causes serious seawater intrusion. Soil salinity is a problem due to shallow and saline groundwater under serious seawater intrusion in the YRE. In this research, we focused on the temporal variation and spatial distribution characteristics of soil salinity in the YRE using geostatistics combined with proximally sensed information obtained by an electromagnetic induction (EM) survey method in typical years under the impoundment of the TGR. The EM survey with proximal sensing method was applied to perform soil salinity survey in field in the Yangtze River Estuary, allowing quick determination and quantitative assessment of spatial and temporal variation of soil salinity from 2006 to 2017. We developed regional soil salinity survey and mapping by coupling limited laboratory data with proximal sensed data obtained from EM. We interpreted the soil electrical conductivity by constructing a linear model between the apparent electrical conductivity data measured by an EM 38 device and the soil electrical conductivity (EC) of soil samples measured in laboratory. Then, soil electrical conductivity was converted to soil salt content (soil salinity g kg−1) through established linear regression model based on the laboratory data of soil salinity and soil EC. Semivariograms of regional soil salinity in the survey years were fitted and ordinary kriging interpolation was applied in interpolation and mapping of regional soil salinity. The cross-validation results showed that the prediction results were acceptable. The soil salinity distribution under different survey years was presented and the area of salt affected soil was calculated using geostatistics method. The results of spatial distribution of soil salinity showed that soil salinity near the riverbanks and coastlines was higher than that of inland. The spatial distribution of groundwater depth and salinity revealed that shallow groundwater and high groundwater salinity influenced the spatial distribution characteristics of soil salinity. Under long-term impoundment of the Three Gorges Reservoir, the variation of soil salinity in different hydrological years was analyzed. Results showed that the area affected by soil salinity gradually increased in different hydrological year types under the impoundment of the TGR.


2021 ◽  
pp. 004051752199547
Author(s):  
Min Hou ◽  
Xinghua Hong ◽  
Yanjun Tang ◽  
Zimin Jin ◽  
Chengyan Zhu ◽  
...  

Functionalized knitted fabric, as a kind of flexible, wearable, and waterproof material capable of conductivity, sensitivity and outstanding hydrophobicity, is valuable for multi-field applications. Herein, the reduced graphene oxide (RGO)-coated knitted fabric (polyester/spandex blended) is prepared, which involves the use of graphite oxide (GO) by modified Hummers method and in-situ chemical reduction with hydrazine hydrate. The treated fabric exhibits a high electrical conductivity (202.09 S/cm) and an outstanding hydrophobicity (140°). The outstanding hydrophobicity is associated with the morphology of the fabric and fiber with reference to pseudo-infiltration. These properties can withstand repeated bending and washing without serious deterioration, maintaining good electrical conductivity (35.70 S/cm) and contact angle (119.39°) after eight standard washing cycles. The material, which has RGO architecture and continuous loop mesh structure, can find wide use in smart garment applications.


RSC Advances ◽  
2016 ◽  
Vol 6 (87) ◽  
pp. 84200-84208 ◽  
Author(s):  
Adil Sultan ◽  
Sharique Ahmad ◽  
Faiz Mohammad

We report the synthesis of polypyrrole (PPy) and polypyrrole/silicon carbide nanocomposites (PPy/SiC) and PPy/SiC/dodecylbenzenesulfonic acid (DBSA) by in situ chemical polymerization and their application as sensors for the detection of highly toxic chlorine gas.


Energies ◽  
2018 ◽  
Vol 11 (10) ◽  
pp. 2849 ◽  
Author(s):  
Yong Du ◽  
Haixia Li ◽  
Xuechen Jia ◽  
Yunchen Dou ◽  
Jiayue Xu ◽  
...  

Graphite/poly(3,4-ethyenedioxythiophene) (PEDOT) nanocomposites were prepared by an in-situ oxidative polymerization process. The electrical conductivity and Seebeck coefficient of the graphite/PEDOT nanocomposites with different content of graphite were measured in the temperature range from 300 K to 380 K. The results show that as the content of graphite increased from 0 to 37.2 wt %, the electrical conductivity of the nanocomposites increased sharply from 3.6 S/cm to 80.1 S/cm, while the Seebeck coefficient kept almost the same value (in the range between 12.0 μV/K to 15.1 μV/K) at 300 K, which lead to an increased power factor. The Seebeck coefficient of the nanocomposites increased from 300 K to 380 K, while the electrical conductivity did not substantially depend on the measurement temperature. As a result, a power factor of 3.2 μWm−1 K−2 at 380 K was obtained for the nanocomposites with 37.2 wt % graphite.


2006 ◽  
Vol 11-12 ◽  
pp. 493-496 ◽  
Author(s):  
Ruben L. Menchavez ◽  
Koichiro Adachi ◽  
Masayoshi Fuji ◽  
Minoru Takahashi

This work demonstrated an in-situ pyrolysis of gelcast alumina under reduction sintering to make alumina and carbon composite in providing semi-electrical conductivity. To increase the carbon content, the monomer was varied in the premix solution with reduction sintering in nitrogen gas. Two-probe method was used to measure electrical resistance of the sintered samples. The results revealed that the increase of monomer addition and sintering treatment were effective in reducing electrical resistance. The lowest value was 3.6×106-cm, which is a potential candidate for electrostatic shielding application. The reduction-sintered sample was re-sintered in an air in order to gain insight on the conductive path due to carbon network. Further tests such as XRD, TGA/DTA, and scanning electron microscopywere used to explain the semi-conductive property of the material.


Sign in / Sign up

Export Citation Format

Share Document