Meticulous system calibration as a key for extracting correct photon emission spectra

Author(s):  
Norbert Herfurth ◽  
Christian Boit
2003 ◽  
Vol 5 (4) ◽  
pp. 239-242 ◽  
Author(s):  
Marian Elbanowski ◽  
Krzysztof Staninski ◽  
Malgorzata Kaczmarek ◽  
Stefan Lis

Chemiluminescence (CL) of selected inorganic reaction systems, generating ultraweak photon emission, has been studied. The kinetics of the systems and their emission spectra have been characterised by measurements with the use of the stationary and the flow methods of CL recording. The systems studied contained cations at different oxidation degree such asFe2+\3+,Cu+\2+,Co2+\3+,Eu2+\3+,CLO−anions and hydrogen peroxide without organic sensitisers. On the basis of the analysis of the spectra, in particular systems emitters have been identified and mechanisms of the reactions have been proposed. The effect of carbonate and azide ions and propylene carbonate on the yield of CL and spectral characterisation of the systems studied has been evidenced and discussed. A possibility of the application of the systemsEu3+\N3−\H2O2andCo2+\propylene carbonate\H2O2for analytical purposes has been considered.


Sensors ◽  
2021 ◽  
Vol 21 (17) ◽  
pp. 5947
Author(s):  
Joseph Biagio McLaughlin ◽  
Giacomo Gallina ◽  
Fabrice Retière ◽  
Austin De St. De St. Croix ◽  
Pietro Giampa ◽  
...  

In this paper, we report on the photon emission of Silicon Photomultipliers (SiPMs) from avalanche pulses generated in dark conditions, with the main objective of better understanding the associated systematics for next-generation, large area, SiPM-based physics experiments. A new apparatus for spectral and imaging analysis was developed at TRIUMF and used to measure the light emitted by the two SiPMs considered as photo-sensor candidates for the nEXO neutrinoless double-beta decay experiment: one Fondazione Bruno Kessler (FBK) VUV-HD Low Field (LF) Low After Pulse (Low AP) (VUV-HD3) SiPM and one Hamamatsu Photonics K.K. (HPK) VUV4 Multi-Pixel Photon Counter (MPPC). Spectral measurements of their light emissions were taken with varying over-voltage in the wavelength range of 450–1020 nm. For the FBK VUV-HD3, at an over-voltage of 12.1±1.0 V, we measured a secondary photon yield (number of photons (γ) emitted per charge carrier (e−)) of (4.04±0.02)×10−6γ/e−. The emission spectrum of the FBK VUV-HD3 contains an interference pattern consistent with thin-film interference. Additionally, emission microscopy images (EMMIs) of the FBK VUV-HD3 show a small number of highly localized regions with increased light intensity (hotspots) randomly distributed over the SiPM surface area. For the HPK VUV4 MPPC, at an over-voltage of 10.7±1.0 V, we measured a secondary photon yield of (8.71±0.04)×10−6γ/e−. In contrast to the FBK VUV-HD3, the emission spectra of the HPK VUV4 did not show an interference pattern—likely due to a thinner surface coating. The EMMIs of the HPK VUV4 also revealed a larger number of hotspots compared to the FBK VUV-HD3, especially in one of the corners of the device. The photon yield reported in this paper may be limited if compared with the one reported in previous studies due to the measurement wavelength range, which is only up to 1020 nm.


1994 ◽  
Vol 49 (5) ◽  
pp. 3943-3953 ◽  
Author(s):  
T. Zuo ◽  
S. Chelkowski ◽  
A. D. Bandrauk

2016 ◽  
Vol 5 (3) ◽  
pp. 20 ◽  
Author(s):  
N. Moultif ◽  
E. Joubert ◽  
O. Latry

In this paper, we present one of the most important failure analysis tools that permits the localizing and the identification of the failure mechanisms. It is a new spectral photon emission system, enabling to localize the failure, and quickly get the photon emission spectra that characterize the failure with high resolution. A diffraction grating is used as a spectrometer in the system. Application results on mechatronic power devices such as HEMT AlGaN/GAN and SiC MOSFETs are reported.


2013 ◽  
Vol 796 ◽  
pp. 424-427
Author(s):  
Chuan Xiang Qin ◽  
Lin Qin ◽  
Guo Qiang Chen ◽  
Tong Lin

Trans-4- [p- (N, N-Die (2-hydroxyethyl)) styry-N-ethyl pyridinium bromide (DHEASPBr-C2), a hemicyanine fluorescent dye, was encapsulated into silica nanoparticles by co-hydrolysis and co-condensation of organosilanes in the presence of the dye. The dye containing silica nanoparticles were applied onto cotton fabrics. Scanning electron microscopy (SEM), UVvis spectra, single-photon emission fluorescence spectra and reflectance spectra of the samples were characterized. The SEM results showed that the particle size (ranging from 100-200 nm) and dye encapsulating (1.5-8.1 mg dye per g silica matrix) could be adjusted by the concentration of fluorescent dye and organosilanes. The reflectance of the treated cotton fabrics showed that there were obvious adsorption spectra in 410 - 540 nm and emission spectra in 560 - 700 nm.


2019 ◽  
Vol 3 (3) ◽  
pp. 124
Author(s):  
Ailton Jose Moreira ◽  
Thales Martins Silva ◽  
Gian Paulo Giovanni Freschi

This study broadens the understanding of photochemical processes by calculating the quantum efficiency of the Hg-MDEL lamp and discusses the environmental application of this lamp model in advanced oxidative processes. This set of information is relevant to broaden the application of Hg-MDEL in various environmental studies. Thus, a photochemical reactor composed of a microwave-fired mercury-free mercury (Hg-MDEL) lamp (MW) was evaluated from KI/KIO3 actinometric studies. The emission spectra were characterized along the UV-A, UV-B, UV-C and visible regions by means of a spectroradiometer, displaying linear correlation with the microwave power variation applied. The photochemical conversion of KI / KIO3 to I3- was up to 0.073 mmol L-1 when the KI initial concentration was 0.1 mol L-1 and 0.65 mmol L-1 when the KI concentration was 0.7 mol L-1, applying a microwave power of 600 and 400 W respectively. These results indicate that the photon emission near the reactor is more significant for higher powers, actively contributing to the formation of I3-.


Sign in / Sign up

Export Citation Format

Share Document