A Statistical Study on the Required Sample Number of SiC SBD to Secure Estimated Junction Temperature with K Factor

2018 ◽  
Author(s):  
Shuhei Fukunaga ◽  
Tsuyoshi Funaki
Keyword(s):  
Statistical Study ◽  
Junction Temperature ◽  
Sample Number ◽  
K Factor

A little current K-factor method for measuring junction temperature of aviation lighting power LED

2012 ◽  
Vol 38 (3) ◽  
pp. 371-375
Author(s):  
于孟诚 YU Mengcheng ◽  
李湘宁 LI Xiangning
Keyword(s):  
Junction Temperature ◽  
Factor Method ◽  
K Factor ◽  
Measuring Junction

Statistical Study of the Rotation Effect of Am Stars

1976 ◽  
Vol 32 ◽  
pp. 675-683
Author(s):  
Keiichi Kodaira
Keyword(s):  
Statistical Study ◽  
Rotation Velocity ◽  
General View ◽  
Slow Rotation ◽  
Rotation Effect

SummaryExcess of [m1] index of Am stars, relative to normal stars, is statistically found to be correlated with rotation velocity; the coefficient is estimated at ∆׀m1׀ /∆V(km/sec) ˜ - 0.0007 among Am stars. This result supports the general view that slow rotation is essential for Am phenomena.

Identification of Venous Variants in the Pineal Region with 3D Preoperative Navigation. A Statistical Study on the Venous Anatomy in the Living

Skull Base ◽  
2009 ◽  
Vol 19 (01) ◽  
Author(s):  
Mario Giordano ◽  
Wolf Luedemann ◽  
Lennart Stieglitz ◽  
Karsten Wrede ◽  
Laura Columbano ◽  
...  
Keyword(s):  
Statistical Study ◽  
Pineal Region ◽  
Venous Anatomy

Analysis of Coliform and Colifecal Total Pollution Test on Various Types of Drinking Water Using the MPN (Most Probable Number) Method

2020 ◽  
Vol 2 (2) ◽  
Author(s):  
Wanda Aulya ◽  
Fadhliani Fadhliani ◽  
Vivi Mardina
Keyword(s):  
Drinking Water ◽  
Fecal Coliform ◽  
Pathogenic Bacteria ◽  
Microbiological Quality ◽  
Coliform Bacteria ◽  
Most Probable Number ◽  
Inspection Method ◽  
Sample Number ◽  
Probable Number ◽  
Fecal Coliform Bacteria

Water is the main source for life and also the most severe substance caused by pollution. The mandatory parameters for determining microbiological quality of drinking water are total non-fecal Coliform bacteria and Coliform fecal (Escherichia coli). Coliform bacteria are a group of microorganisms commonly used as indicators, where these bacteria can be a signal to determine whether a water source has been contaminated by bacteria or not, while fecal Coliform bacteria are indicator bacteria polluting pathogenic bacteria originating from human feces and warm-blooded animals (mammals) . The water inspection method in this study uses the MPN (Most Probable Number) method which consists of 3 tests, namely, the presumption test, the affirmation test, and the reinforcement test. The results showed that of 15 drinking water samples 8 samples were tested positive for Coliform bacteria with the highest total bacterial value of sample number 1, 15 (210/100 ml), while 7 other samples were negative. From 8 positive Coliform samples only 1 sample was stated to be negative fecal Coliform bacteria and 7 other samples were positive for Coliform fecal bacteria with the highest total bacterial value of sample number 1 (210/100 ml).

A Statistical Study of Process Variables to Optimize a High Speed Curtain Coater: Part I

TAPPI Journal ◽  
2009 ◽  
Vol 8 (1) ◽  
pp. 20-26 ◽  
Author(s):  
PEEYUSH TRIPATHI ◽  
MARGARET JOYCE ◽  
PAUL D. FLEMING ◽  
MASAHIRO SUGIHARA
Keyword(s):  
Boundary Layer ◽  
Experimental Design ◽  
High Speed ◽  
Statistical Study ◽  
Process Variables ◽  
High Speeds ◽  
The Stability ◽  
Air Removal ◽  
Removal System

Using an experimental design approach, researchers altered process parameters and material prop-erties to stabilize the curtain of a pilot curtain coater at high speeds. Part I of this paper identifies the four significant variables that influence curtain stability. The boundary layer air removal system was critical to the stability of the curtain and base sheet roughness was found to be very important. A shear thinning coating rheology and higher curtain heights improved the curtain stability at high speeds. The sizing of the base sheet affected coverage and cur-tain stability because of its effect on base sheet wettability. The role of surfactant was inconclusive. Part II of this paper will report on further optimization of curtain stability with these four variables using a D-optimal partial-facto-rial design.

Design of Solar-Powered LED Road Lighting System

2019 ◽  
pp. 75-85
Author(s):  
Canan Perdahci ◽  
Hamdi Ozkan
Keyword(s):  
High Pressure ◽  
Renewable Energy Sources ◽  
Junction Temperature ◽  
Mercury Vapour ◽  
Light Sources ◽  
Street Lighting ◽  
Led Light ◽  
Road Lighting ◽  
Lighting Systems ◽  
High Pressure Sodium Lamp

Turkey is rich in terms of renewable energy sources and, therefore, is now encouraging the use of sustainable clean lighting systems in road applications. High pressure sodium lamp is the most widely used type in main roads, but other types of lamps such as mercury vapour lamps or metal halide lamps can be utilized for street lighting. Since it enables energy and money saving, LED light technology has replaced high pressure sodium lamps nowadays. Once solar power system (PV) is integrated with LED lamp for street lighting, the amount of saving and local impact might be enriched. LEDs used as light sources in road lighting luminaires with rising lumen values, decreasing junction temperature, higher colour rendering efficiency, longer lifetime have become more efficient than many light sources with the latest developments. Since the structure of the luminaires in which the LED light sources are used differs from that of the conventional light sources, the optical, thermal and electrical design of the LED luminaires must be considered differently. Thus, this study concentrates upon design considerations and the operating principle of solarpowered LED road lighting luminaire in details. Also, a simple solar panel system was designed and the economical values obtained at the end of 20 years were compared when using the ongrid system and the off-grid system.

Statistical Study of Impetigo Contagiosa in the Last Three Years

1980 ◽  
Vol 42 (4) ◽  
pp. 665-669 ◽  
Author(s):  
Satoshi DEKIO ◽  
Yoshiko MAEHAMA ◽  
Reiko YAMASAKI ◽  
Kazuko HAMANAKA ◽  
Sanae IKEDA
Keyword(s):  
Statistical Study ◽  
Impetigo Contagiosa

A Case Report of Kerion Celsi Caused by Microsporum Canis and Statistical Study of Tinea Capitis at Akita University Hospital.

1993 ◽  
Vol 55 (1) ◽  
pp. 92-97 ◽  
Author(s):  
Noriko SATO ◽  
Okitaka MAIE ◽  
Shinya TAKAHASHI
Keyword(s):  
Case Report ◽  
Tinea Capitis ◽  
Statistical Study ◽  
University Hospital ◽  
Microsporum Canis ◽  
Kerion Celsi
Sign in / Sign up

Export Citation Format

Share Document