The Removal of the Boundary Layer of a Supersonic Flow by Means of a Slot

1963 ◽  
Vol 30 (2) ◽  
pp. 275-278
Author(s):  
M. Cloutier

The influence of slot opening and of suction pressure upon the mass flow through the slot and the subsequent development of the boundary layer has been studied for the case of a single transverse slot opening into a boundary layer with a displacement thickness of 0.168 in. at a free-stream Mach number of 2.92. The results show that as much as 85 percent of the mass flow in the boundary layer between the wall and the position of the slot lip enters the slot, and that this result is independent of the slot reservoir pressure, providing the latter is less than approximately twice the tunnel static pressure.

1981 ◽  
Vol 103 (3) ◽  
pp. 385-390 ◽  
Author(s):  
J. A. Hoffmann

An experimental evaluation of the effects of free-stream turbulence on the performance of a subsonic two-dimensional diffuser has been made. Increases of the diffuser’s static pressure recovery coefficient of 11.3 and 23.9 percent at total included divergence angles of 12 and 20 degrees respectively were obtained when the value of the inlet integral free-stream scale of turbulence in the flow direction was at least 7.2 times larger than the inlet boundary layer displacement thickness, when the inlet total free-stream turbulence intensity was at least 3.5 percent, and when the axes of upstream rods used to generate turbulence were perpendicular to the flow and parallel to the diverging walls of the diffuser. It is hypothesized that a larger scale of turbulence with the specified eddy axis orientation transmits the free-stream energy to the walls more effectively and, when coupled with large turbulence intensities, are mechanisms which act to decrease the distortion and delay separation within the diffuser.


1971 ◽  
Vol 22 (2) ◽  
pp. 169-182 ◽  
Author(s):  
L. C. Squire

SummaryShear stress, eddy viscosity and mixing length distributions have been obtained from measured boundary-layer developments over porous surfaces with air and carbon dioxide injection at Mach numbers up to M=3·6. It is found that, if the eddy viscosity is non-dimensionalised by dividing by the product of the free-stream velocity and the kinematic displacement thickness then this non-dimensional ratio is almost independent of injection ratio, but decreases slightly with Mach number.


2010 ◽  
Vol 24 (13) ◽  
pp. 1409-1412 ◽  
Author(s):  
HAO DONG ◽  
CHENG-PENG WANG ◽  
KE-MING CHENG

In order to obtain the flow field characteristics and the influence of boundary layer, numerical simulations and wind tunnel tests are conducted for two streamline traced Jaws inlets at Mach number 7. The inlets are designed based on a flow field with 8-7 planar shock wave (the ramp in pitch plane is inclined at 8° to the free stream and in yaw plane is inclined at 7° to the free stream, yielding planar shocks). In the study, the static pressure distributions were measured and analyzed along the plane-symmetric centerline of the inlet with and without the boundary layer correction, respectively. Results show that boundary layer correction can obviously weaken the viscous influence to the inlet, increasing the mass flow coefficient and improving total pressure recovery.


1990 ◽  
Vol 112 (2) ◽  
pp. 243-245 ◽  
Author(s):  
D. E. Paxson ◽  
R. E. Mayle

Velocity measurements in the laminar boundary layer around the forward portion of a circular cylinder are presented. These results are compared to Blasius’ theory for laminar flow around a cylinder using a free-stream velocity distribution obtained from static pressure measurements on the cylinder. Even though the flow is periodically unsteady as a result of vortex shedding from the cylinder, it is found that the agreement is excellent.


Author(s):  
Weidong Shao ◽  
Jun Li

The aeroacoustical oscillation and acoustic field generated by subsonic flow grazing over open cavities has been investigated analytically and numerically. The tone generation mechanism is elucidated with an analytical model based on the coupling between shear layer instabilities and acoustic feedback loop. The near field turbulent flow is obtained using two-dimensional Large Eddy Simulation (LES). A special mesh is used to absorb propagating disturbances and prevent spurious numerical reflections. Comparisons with available experimental data demonstrate good agreement in both the frequency and amplitude of the aeroacoustical oscillation. The physical phenomenon of the noise generated by the feedback loop is discussed. The correlation analysis of primitive variables is also made to clarify the characteristics of wave propagation in space and time. The effects of free-stream Mach number and boundary layer thickness on pressure fluctuations within the cavity and the nature of the noise radiated to the far field are examined in detail. As free-stream Mach number increases velocity fluctuations and mass flux into the cavity increase, but the resonant Strouhal numbers slightly decrease. Both the resonant Strouhal numbers and sound pressure levels decrease with the increase of boundary layer thickness. Results indicate that the instability of the shear layer dominates both the frequency and amplitude of the aeroacoustical oscillation.


1964 ◽  
Vol 20 (4) ◽  
pp. 593-623 ◽  
Author(s):  
R. T. Davis ◽  
I. Flügge-Lotz

First- and second-order boundary-layer theory are examined in detail for some specific flow cases of practical interest. These cases are for flows over blunt axisymmetric bodies in hypersonic high-altitude (or low density) flow where second-order boundary-layer quantities may become important. These cases consist of flow over a hyperboloid and a paraboloid both with free-stream Mach number infinity and flow over a sphere at free-stream Mach number 10. The method employed in finding the solutions is an implicit finite-difference scheme. It is found to exhibit both stability and accuracy in the examples computed. The method consists of starting near the stagnation-point of a blunt body and marching downstream along the body surface. Several interesting properties of the boundary layer are pointed out, such as the nature of some second-order boundary-layer quantities far downstream in the flow past a sphere and the effect of strong vorticity interaction on the second-order boundary layer in the flow past a hyperboloid. In several of the flow cases, results are compared with other theories and experiments.


1968 ◽  
Vol 34 (3) ◽  
pp. 575-593 ◽  
Author(s):  
Graham Wilks

The work that follows considers the velocity profiles within the boundary layer at the wall of an arbitrarily converging funnel. The occurrence of super-velocities, i.e. components of velocity within the boundary layer exceeding their corresponding free stream component, is investigated and the relevance of such a phenomenon to the efficiency of discharge discussed.


Author(s):  
Mohammad R Soltani ◽  
Mohammad Farahani

The performance characteristics of an axisymmetric inlet at its design and off-design operational conditions are experimentally investigated. The model is tested for wide ranges of free stream Mach numbers, M∞ = 1.5–2.5, and mass flow rates. For each test, the pressure recovery, the mass flow passing through the inlet and the pressure distribution over the spike and the cowl are measured. In addition, the shock wave formed in front of the inlet is visualized. The characteristic curve of the inlet is then obtained for each free stream Mach number. As the Mach number is increased, the pressure recovery is reduced, but the maximum value of the mass flow rate grows up. Variations of the mass flow affect the surface pressure over both the front portion of the cowl and the entire surface of the spike. Further, it has changed both pressure and Mach number at the end of the diffuser, which would consequently affect the performance of the propulsion system. In addition, contrary to the internal boundary layer, the external one far from the cowl lip has been found to be almost independent of the inlet mass flow rate for a constant free stream Mach number.


2017 ◽  
Vol 817 ◽  
pp. 80-121 ◽  
Author(s):  
Elena Marensi ◽  
Pierre Ricco ◽  
Xuesong Wu

The nonlinear response of a compressible boundary layer to unsteady free-stream vortical fluctuations of the convected-gust type is investigated theoretically and numerically. The free-stream Mach number is assumed to be of $O(1)$ and the effects of compressibility, including aerodynamic heating and heat transfer at the wall, are taken into account. Attention is focused on low-frequency perturbations, which induce strong streamwise-elongated components of the boundary-layer disturbances, known as streaks or Klebanoff modes. The amplitude of the disturbances is intense enough for nonlinear interactions to occur within the boundary layer. The generation and nonlinear evolution of the streaks, which acquire an $O(1)$ magnitude, are described on a self-consistent and first-principle basis using the mathematical framework of the nonlinear unsteady compressible boundary-region equations, which are derived herein for the first time. The free-stream flow is studied by including the boundary-layer displacement effect and the solution is matched asymptotically with the boundary-layer flow. The nonlinear interactions inside the boundary layer drive an unsteady two-dimensional flow of acoustic nature in the outer inviscid region through the displacement effect. A close analogy with the flow over a thin oscillating airfoil is exploited to find analytical solutions. This analogy has been widely employed to investigate steady flows over boundary layers, but is considered herein for the first time for unsteady boundary layers. In the subsonic regime the perturbation is felt from the plate in all directions, while at supersonic speeds the disturbance only propagates within the dihedron defined by the Mach line. Numerical computations are performed for carefully chosen parameters that characterize three practical applications: turbomachinery systems, supersonic flight conditions and wind tunnel experiments. The results show that nonlinearity plays a marked stabilizing role on the velocity and temperature streaks, and this is found to be the case for low-disturbance environments such as flight conditions. Increasing the free-stream Mach number inhibits the kinematic fluctuations but enhances the thermal streaks, relative to the free-stream velocity and temperature respectively, and the overall effect of nonlinearity becomes weaker. An abrupt deviation of the nonlinear solution from the linear one is observed in the case pertaining to a supersonic wind tunnel. Large-amplitude thermal streaks and the strong abrupt stabilizing effect of nonlinearity are two new features of supersonic flows. The present study provides an accurate signature of nonlinear streaks in compressible boundary layers, which is indispensable for the secondary instability analysis of unsteady streaky boundary-layer flows.


Author(s):  
Todd Reedy

A turbulent compressible boundary layer in a nominally Mach 4.2 flow was investigated experimentally. Pitot, wall-static pressure, total pressure and temperature measurements were utilized to determine Mach number, temperature, and velocity profiles within the boundary layer. An adverse pressure gradient was observed, resulting in non-uniform flow in the streamwise direction of the test section during development. Alterations were made to the tunnel top and bottom walls to account for the growing boundary layer displacement thickness, resulting in a much improved, uniform Mach number in the freestream and boundary layer. The existence of a slight adverse pressure gradient remained. Flow visualization was conducted via the Schlieren imaging technique. Experimental results were compared against turbulent compressible flow theory and were found to be in excellent agreement, based on an extension of the law-of-the-wall and law-of-the-wake. Velocity profiles and boundary layer thicknesses of the theoretical and experimental results aligned satisfactorily.


Sign in / Sign up

Export Citation Format

Share Document