Second-Generation Integrated Coal Gasification/Combined-Cycle Power Systems

1978 ◽  
Author(s):  
N. G. Carlson ◽  
F. L. Robson ◽  
J. S. Westmoreland ◽  
W. M. Talbert
Keyword(s):  
Power Plant ◽  
Power Systems ◽  
Molten Salt ◽  
Coal Gasification ◽  
Second Generation ◽  
Combined Cycle ◽  
Integrated System ◽  
Operating Conditions ◽  
Plant Design ◽  
Major Equipment

This paper discusses the second-generation integrated coal gasification /combined-cycle power systems using, as a basis, the molten-salt gasifier. A brief description of The major equipment which forms the basis of the power plant, the analysis identifying the operating conditions for the integrated system, and a discussion of the overall power plant design are given.

scholarly journals Numerical investigation of advanced gas turbine combined cycle coupled with high-temperature nuclear reactor and cogeneration unit

2019 ◽  
Vol 128 ◽  
pp. 03005 ◽  
Author(s):  
Marek Jaszczur ◽  
Michal Dudek ◽  
Zygmunt Kolenda
Keyword(s):  
High Temperature ◽  
Power Plant ◽  
Power Systems ◽  
Gas Turbine ◽  
Nuclear Power ◽  
Coal Gasification ◽  
Nuclear Reactor ◽  
Combined Cycle ◽  
The European Union ◽  
Intergovernmental Panel

In the European Union by 2050, more than 80% of electricity should be generated using nongreenhousegases energy technology. Nuclear power systems share at present about 15% of the power market and thistechnology can be the backbone of a carbon-free European power system. Energy market transitions are similar to global pathways were analysed in the Intergovernmental Panel on Climate Change report. From a practical point of view currently, the most advanced and most effective technology for electricity generation is based on a gas turbine combined cycle. This technology in a normal way uses natural gas, synthesis gas from the coal gasification or crude oil processing products as the energy carriers but at the same time, such system emits sulphur oxides, nitrogen oxides, and CO2 to the environment. In thepresent paper, a thermodynamic analysis of environmentally friendly power plant with a high–temperature gas nuclear reactor and advanced configuration of gas turbine combined cycle technology is investigated. The presented analysis shows that it is possible to obtain for proposed thermalcycles an efficiency higher than 50% which is not only more than could be offered by traditional coal power plant but much more than can be proposed by any other nuclear technology.

Coal-Derived Gas Utilization in Combined Gas-Steam Cycle Power Plants

1990 ◽  
Author(s):  
R. Tuccillo ◽  
G. Fontana ◽  
E. Jannelli
Keyword(s):  
Power Plant ◽  
Gas Turbine ◽  
Mass Flow ◽  
Power Plants ◽  
Coal Gasification ◽  
Saturation Pressure ◽  
Combined Cycle ◽  
Operating Conditions ◽  
Specific Work ◽  
Steam Cycle

In this paper, a general analysis of combined gas-steam cycles for power plants firing with both hydrocarbons and coal derived gas is reported. The purpose of this paper is to study the influence on power plants performance of different kind of fuels and to evaluate the most significant parameters of both gas and combined cycle. Results are presented for plant overall efficiency and net specific work, steam to gas mass flow ratio, dimensionless gas turbine specific speed and diameter, CO2 emissions etc., as functions of gas cycle pressure ratio and of the combustion temperature. Furthermore, for an existing power plant with a 120 MW gas turbine, the authors try to establish in which measure the combined cycle characteristic parameters, the gas turbine operating conditions, and the heat recovery steam generator efficiency, are modified by using synthetic fuels of different composition and calorific value. The influence is also analyzed either of bottoming steam cycle saturation pressure or — in a dual pressure steam cycle — of dimensionless fraction of steam mass flow in high pressure stream. The acquired results seem to constitute useful information on the criteria for the optimal design of a new integrated coal gasification combined cycle (IGCC) power plant.

A GCC Power Plant With Methanol Storage for Intermediate-Load Duty

1991 ◽  
Vol 113 (1) ◽  
pp. 151-157 ◽  
Author(s):  
J. A. Paffenbarger
Keyword(s):  
Power Plant ◽  
Coal Gasification ◽  
Combined Cycle ◽  
Production Costs ◽  
Plant Performance ◽  
Electricity Production ◽  
Fuel Prices ◽  
Electrical Demand ◽  
Integrated Facility ◽  
Plant Configuration

This paper describes the design and performance of a coal gasification combined-cycle power plant with an integrated facility for producing and storing methanol (GCC/methanol power plant). The methanol is produced at a steady rate and is burned in the combined cycle to generate additional power during periods of peak electrical demand. The GCC/methanol plant provides electricity generation and energy storage in one coal-based facility. It is of potential interest to electric utilities seeking to meet intermediate-load electrical demand on their systems. The plant configuration is determined by means of an innovative economic screening methodology considering capital and fuel costs over a range of cycling duties (capacity factors). Estimated levelized electricity production costs indicate that a GCC/methanol plant could be of economic interest as premium fuel prices increase relative to coal. The plant could potentially be of interest for meeting daily peak demands for periods of eight hours or less. The conceptual plant configuration employs a Texaco gasifier and a Lurgi methanol synthesis plant. Plant performance is estimated at peak and baseload output levels. No unusual design or operational problems were identified.

scholarly journals Thermodynamic analysis of high temperature nuclear reactor coupled with advanced gas turbine combined cycle

2019 ◽  
Vol 23 (Suppl. 4) ◽  
pp. 1187-1197 ◽  
Author(s):  
Marek Jaszczur ◽  
Michal Dudek ◽  
Zygmunt Kolenda
Keyword(s):  
High Temperature ◽  
Power Plant ◽  
Gas Turbine ◽  
Thermodynamic Analysis ◽  
Thermal Efficiency ◽  
Nuclear Power ◽  
Coal Gasification ◽  
Nuclear Reactor ◽  
Combined Cycle ◽  
Oil Processing

One of the most advanced and most effective technology for electricity generation nowadays based on a gas turbine combined cycle. This technology uses natural gas, synthesis gas from the coal gasification or crude oil processing products as the energy carriers but at the same time, gas turbine combined cycle emits SO2, NOx, and CO2 to the environment. In this paper, a thermodynamic analysis of environmentally friendly, high temperature gas nuclear reactor system coupled with gas turbine combined cycle technology has been investigated. The analysed system is one of the most advanced concepts and allows us to produce electricity with the higher thermal efficiency than could be offered by any currently existing nuclear power plant technology. The results show that it is possible to achieve thermal efficiency higher than 50% what is not only more than could be produced by any modern nuclear plant but it is also more than could be offered by traditional (coal or lignite) power plant.

Modeling and Performance Analysis of Combined-Cycle Based Ship Power Plant

2010 ◽  
Vol 44-47 ◽  
pp. 1240-1245 ◽  
Author(s):  
Hong Zeng ◽  
Xiao Ling Zhao ◽  
Jun Dong Zhang
Keyword(s):  
Diesel Engine ◽  
Power Plant ◽  
Performance Analysis ◽  
Combined Cycle ◽  
Operating Conditions ◽  
Fuel Oil ◽  
Plant Performance ◽  
Oil Consumption ◽  
Combined Cycle Power Plant ◽  
Simulation Performance

For combined-cycle power plant performance analysis, a ship power plant mathematical model is developed, including diesel engine, controllable pitch propeller, exhaust gas boiler, turbine generator and shaft generator models. The simulation performance characteristic curves of diesel engine under various loads are given. Comparison of simulation results and experimental data shows the model can well predict the performance of diesel engine in various operating conditions. The specific fuel oil consumption contours of combined-cycle power plant and the relations between engine operating conditions and steam cycle parameters are given. The influence of diesel engine operating conditions to the overall performance of combined-cycle power plant is discussed.

Thermo-Economic Assessment Under Electrical Market Uncertainties of a Combined Cycle Gas Turbine Integrated With a Flue Gas-Condensing Heat Pump

2020 ◽  
Author(s):  
Alberto Vannoni ◽  
Andrea Giugno ◽  
Alessandro Sorce
Keyword(s):  
Power Plant ◽  
Power Systems ◽  
Gas Turbine ◽  
Heat Pump ◽  
Flue Gas ◽  
Power Plants ◽  
Greenhouse Gas Emission ◽  
Capital Expenditure ◽  
Combined Cycle ◽  
Gas Turbine Power Plant

Abstract Renewable energy penetration is growing, due to the target of greenhouse-gas-emission reduction, even though fossil fuel-based technologies are still necessary in the current energy market scenario to provide reliable back-up power to stabilize the grid. Nevertheless, currently, an investment in such a kind of power plant might not be profitable enough, since some energy policies have led to a general decrease of both the average price of electricity and its variability; moreover, in several countries negative prices are reached on some sunny or windy days. Within this context, Combined Heat and Power systems appear not just as a fuel-efficient way to fulfill local thermal demand, but also as a sustainable way to maintain installed capacity able to support electricity grid reliability. Innovative solutions to increase both the efficiency and flexibility of those power plants, as well as careful evaluations of the economic context, are essential to ensure the sustainability of the economic investment in a fast-paced changing energy field. This study aims to evaluate the economic viability and environmental impact of an integrated solution of a cogenerative combined cycle gas turbine power plant with a flue gas condensing heat pump. Considering capital expenditure, heat demand, electricity price and its fluctuations during the whole system life, the sustainability of the investment is evaluated taking into account the uncertainties of economic scenarios and benchmarked against the integration of a cogenerative combined cycle gas turbine power plant with a Heat-Only Boiler.

Medway: A High-Efficiency Combined Cycle Power Plant Design

1995 ◽  
Vol 117 (4) ◽  
pp. 713-723 ◽  
Author(s):  
D. M. Leis ◽  
M. J. Boss ◽  
M. P. Melsert
Keyword(s):  
Power Plant ◽  
Steam Turbine ◽  
High Reliability ◽  
System Optimization ◽  
Combined Cycle ◽  
Advanced Technology ◽  
Plant Design ◽  
Turbine Generator ◽  
Combined Cycle Power Plant ◽  
Plant System

The Medway Project is a 660 MW combined cycle power plant, which employs two of the world’s largest advanced technology MS9001FA combustion turbine generators and an advanced design reheat steam turbine generator in a power plant system designed for high reliability and efficiency. This paper discusses the power plant system optimization and design, including thermodynamic cycle selection, equipment arrangement, and system operation. The design of the MS9001FA combustion turbine generator and the steam turbine generator, including tailoring for the specific application conditions, is discussed.

300 MW Combined-Cycle Plant With Integrated Coal Gasification

1984 ◽  
Author(s):  
Rolf H. Kehlhofer
Keyword(s):  
Power Generation ◽  
Power Plant ◽  
Gas Turbines ◽  
Power Plants ◽  
Coal Gasification ◽  
District Heating ◽  
Combined Cycle ◽  
Liquid Fuels ◽  
Combined Cycle Plant ◽  
The Individual

In the past 15 years the combined-cycle (gas/steam turbine) power plant has come into its own in the power generation market. Today, approximately 30 000 MW of power are already installed or being built as combined-cycle units. Combined-cycle plants are therefore a proven technology, showing not only impressive thermal efficiency ratings of up to 50 percent in theory, but also proving them in practice and everyday operation (1) (2). Combined-cycle installations can be used for many purposes. They range from power plants for power generation only, to cogeneration plants for district heating or combined cycles with maximum additional firing (3). The main obstacle to further expansion of the combined cycle principle is its lack of fuel flexibility. To this day, gas turbines are still limited to gaseous or liquid fuels. This paper shows a viable way to add a cheap solid fuel, coal, to the list. The plant system in question is a 2 × 150 MW combined-cycle plant of BBC Brown Boveri with integrated coal gasification plant of British Gas/Lurgi. The main point of interest is that all the individual components of the power plant described in this paper have proven their worth commercially. It is therefore not a pilot plant but a viable commercial proposition.

Analysis of Integrated Coal Gasification System/Compressed-Air Energy Storage Power Plant Concepts

1991 ◽  
Author(s):  
M. Nakhamkin ◽  
M. Patel ◽  
L. Andersson ◽  
P. Abitante ◽  
A. Cohn
Keyword(s):  
Energy Storage ◽  
Power Plant ◽  
Coal Gasification ◽  
Cost Effective ◽  
Combined Cycle ◽  
Compressed Air ◽  
Cost Comparison ◽  
Compressed Air Energy Storage ◽  
Integrated Gasification Combined Cycle ◽  
Integrated Gasification

This paper presents the results of a project targeted at developing cost effective power plant concept with integrated Coal Gasification System (CGS) and with Compressed Air Energy Storage (CAES) plant. The developed concepts, denoted as CGS/CAES, provide for continuous operation of CGS and the reheat turboexpander train which are high temperature components, thus improving their operation and extending life resource. A parametric thermodynamic analysis is performed for several CGS/CAES concepts differentiated by their turbomachinery parameters, CGS arrangements, operating cycles, and hours of daily generation. A qualitative cost estimate is made using a variety of sources including published EPRI reports and extensive in-house cost data. A technical and cost comparison is made to the Integrated Gasification Combined Cycle (IGCC) plant.

Sign in / Sign up

Export Citation Format

Share Document