Nonlinear Simulation Analysis and Experiment of Fluid Plain Journal Bearing With Incompressible Fluid

2003 ◽  
Author(s):  
Katsuhisa Fujita ◽  
Atsuhiko Shintani ◽  
Koji Yoshioka ◽  
Kouhei Okuno ◽  
Hiroaki Tanaka ◽  
...  
Keyword(s):  
Stability Analysis ◽  
Incompressible Fluid ◽  
Journal Bearing ◽  
Simulation Analysis ◽  
Journal Bearings ◽  
Stable Region ◽  
Flexible Rotor ◽  
Nonlinear Simulation ◽  
Fluid Forces ◽  
The Stability

Recently, in many areas such as computers and information equipments etc., the fluid journal bearings are required to rotate at higher speed. To satisfy this requirement, the strictly stability analysis of the journal is indispensable. In this paper, we investigate the stability analysis of the dynamic behavior of the fluid plain journal bearing with an incompressible fluid considering the nonlinear terms of fluid forces. The stability analysis is examined by the numerical simulations on each model of a rigid rotor and a flexible rotor. The stable regions by nonlinear analysis are compared with the regions by classical linear analysis. Performing the nonlinear simulation analysis, it becomes clear that there is rather a stable region which amplitude does not grow up abruptly, and this phenomenon can not only be pointed out, but also is judged to be unstable by linear stable analysis. Finally, the experiment using actual bearings is performed and compared with the numerical results.

Non-linear stability analysis of micropolar fluid lubricated journal bearings with turbulent effect

2019 ◽  
Vol 71 (1) ◽  
pp. 31-39
Author(s):  
Subrata Das ◽  
Sisir Kumar Guha
Keyword(s):  
Stability Analysis ◽  
Linear Stability ◽  
Micropolar Fluid ◽  
Journal Bearing ◽  
Journal Bearings ◽  
Turbulent Regime ◽  
Content Type ◽  
Non Linear ◽  
The Stability ◽  
Bearing System

Purpose The purpose of this paper is to investigate the effect of turbulence on the stability characteristics of finite hydrodynamic journal bearing lubricated with micropolar fluid. Design/methodology/approach The non-dimensional transient Reynolds equation has been solved to obtain the non-dimensional pressure field which in turn used to obtain the load carrying capacity of the bearing. The second-order equations of motion applicable for journal bearing system have been solved using fourth-order Runge–Kutta method to obtain the stability characteristics. Findings It has been observed that turbulence has adverse effect on stability and the whirl ratio at laminar flow condition has the lowest value. Practical implications The paper provides the stability characteristics of the finite journal bearing lubricated with micropolar fluid operating in turbulent regime which is very common in practical applications. Originality/value Non-linear stability analysis of micropolar fluid lubricated journal bearing operating in turbulent regime has not been reported in literatures so far. This paper is an effort to address the problem of non-linear stability of journal bearings under micropolar lubrication with turbulent effect. The results obtained provide useful information for designing the journal bearing system for high speed applications.

scholarly journals Stability analysis of long hydrodynamic journal bearings based on the journal center trajectory

Friction ◽  
2020 ◽  
Author(s):  
Yu Huang ◽  
Haiyin Cao ◽  
Zhuxin Tian
Keyword(s):  
Stability Analysis ◽  
Equilibrium Point ◽  
Journal Bearing ◽  
Stability Boundary ◽  
Initial Point ◽  
Journal Bearings ◽  
Bearing Surface ◽  
Rotating Speed ◽  
Stability Threshold ◽  
The Stability

AbstractIn this study, we observe that there are two threshold speeds (stability threshold speed and second threshold speed) for the long journal bearing, which is different for the short bearing. When the rotating speed is below the stability threshold speed, the stability boundary nearly coincides with the clearance circle, and the journal center gradually returns to the equilibrium point after being released at an initial point. If the rotating speed is between the stability threshold speed and the second threshold speed, after being released at an initial point, the journal center converges to a contour containing the equilibrium point. In this situation, for a higher rotating speed, the corresponding contour is also larger. When the rotating speed exceeds the second threshold speed, the journal gradually moves towards the bearing surface after being released at an initial point.

The effects of drivers’ aggressive characteristics on traffic stability from a new car-following model

2016 ◽  
Vol 30 (18) ◽  
pp. 1650243 ◽  
Author(s):  
Guanghan Peng ◽  
Li Qing
Keyword(s):  
Stability Analysis ◽  
Nonlinear Analysis ◽  
Traffic Flow ◽  
Linear Stability Analysis ◽  
Stable Condition ◽  
Mkdv Equation ◽  
Stable Region ◽  
Car Following ◽  
Car Following Model ◽  
The Stability

In this paper, a new car-following model is proposed by considering the drivers’ aggressive characteristics. The stable condition and the modified Korteweg-de Vries (mKdV) equation are obtained by the linear stability analysis and nonlinear analysis, which show that the drivers’ aggressive characteristics can improve the stability of traffic flow. Furthermore, the numerical results show that the drivers’ aggressive characteristics increase the stable region of traffic flow and can reproduce the evolution and propagation of small perturbation.

Nonlinear Dynamics of Flexible Rotors Supported on Journal Bearings—Part I: Analytical Bearing Model

2017 ◽  
Vol 140 (2) ◽  
Author(s):  
Mohammad Miraskari ◽  
Farzad Hemmati ◽  
Mohamed S. Gadala
Keyword(s):  
Journal Bearing ◽  
Nonlinear Coefficient ◽  
Journal Bearings ◽  
Flexible Rotor ◽  
Dynamic Coefficients ◽  
Flexible Rotors ◽  
Rotor Bearing ◽  
Bearing Force ◽  
Derivatives Of ◽  
Bearing System

To determine the bifurcation types in a rotor-bearing system, it is required to find higher order derivatives of the bearing forces with respect to journal velocity and position. As closed-form expressions for journal bearing force are not generally available, Hopf bifurcation studies of rotor-bearing systems have been limited to simple geometries and cavitation models. To solve this problem, an alternative nonlinear coefficient-based method for representing the bearing force is presented in this study. A flexible rotor-bearing system is presented for which bearing force is modeled with linear and nonlinear dynamic coefficients. The proposed nonlinear coefficient-based model was found to be successful in predicting the bifurcation types of the system as well as predicting the system dynamics and trajectories at spin speeds below and above the threshold speed of instability.

Non-Linear Transient Stability Analysis of a Rigid Rotor Supported on Journal Bearings With Rectangular Dimples

2015 ◽  
Author(s):  
Ram Turaga
Keyword(s):  
Stability Analysis ◽  
Surface Texture ◽  
Transient Stability ◽  
Equations Of Motion ◽  
Journal Bearings ◽  
Pressure Curve ◽  
Rigid Rotor ◽  
Non Linear ◽  
The Stability ◽  
Transient Stability Analysis

The influence of deterministic surface texture on the sub-synchronous whirl stability of a rigid rotor has been studied. Non-linear transient stability analysis has been performed to study the stability of a rigid rotor supported on two symmetric journal bearings with a rectangular dimple of large aspect ratio. The surface texture parameters considered are dimple depth to minimum film thickness ratio and the location of the dimple on the bearing surface. Journal bearings of different Length to diameter ratios have been studied. The governing Reynolds equation for finite journal bearings with incompressible fluid has been solved using the Finite Element Method under isothermal conditions. The trajectories of the journal center have been obtained by solving the equations of motion of the journal center by the fourth-order Runge-Kutta method. When the dimple is located in the raising part of the pressure curve the positive rectangular dimple is seen to decrease the stability whereas the negative rectangular dimple is seen to improve the stability of the rigid rotor.

Linear stability analysis of finite hydrodynamic journal bearing under turbulent lubrication with coupled-stress fluid

2016 ◽  
Vol 68 (3) ◽  
pp. 386-391 ◽  
Author(s):  
Abhishek Ghosh ◽  
Sisir Kumar Guha
Keyword(s):  
Stability Analysis ◽  
Newtonian Fluid ◽  
High Speed ◽  
Journal Bearing ◽  
Slenderness Ratio ◽  
Linear Perturbation ◽  
Content Type ◽  
Hydrodynamic Journal Bearing ◽  
The Stability ◽  
Coupled Stress

Purpose Several researchers have observed that to satisfy modern day’s need, it is essential to enhance the characteristics of journal bearing, which is used in numerous applications. Moreover, the use of Newtonian fluid as a lubricant is diminishing day by day, and the use of Non-Newtonian fluids is coming more into picture. Furthermore, if turbo-machinery applications are taken into account, then it can be seen that journal bearings are used for high speed applications as well. Thus, neglecting turbulent conditions may lead to erroneous results. Hence, this paper aims to present focuses on studying the stability characteristics of finite hydrodynamic journal bearing under turbulent coupled-stress lubrication. Design/methodology/approach First, the governing equation relevant to the problem is generated. Then, the dynamic analysis is carried out by linear perturbation technique, leading to three perturbed equations, which are again discretized by finite difference method. Finally, these discretized equations are solved with the help of Gauss-Seidel Iteration technique with successive over relaxation scheme. Consequently, the film response coefficients and the stability parameters are evaluated at different parametric conditions. Findings It has been concluded from the study that with increase in value of the coupled-stress parameter, the stability of the journal may increase. Whereas, with increase in Reynolds number, the stability of the journal decreases. On the other hand, stability increases with increasing values of slenderness ratio. Originality/value Researches have been performed to study the dynamic characteristics of journal bearing with non-Newtonian fluid as the lubricant. But in the class of non-Newtonian lubricants, the use of coupled-stress fluid has not yet been properly investigated. So, an attempt has been made to perform the stability analysis of bearings with coupled-stress fluid as the advanced lubricant.

Stability Analysis of Two-Layered Finite Hydrodynamic Porous Journal Bearing Using Linear and Nonlinear Transient Method

2007 ◽  
Author(s):  
S. K. Kakoty ◽  
S. K. Laha ◽  
P. Mallik
Keyword(s):  
Journal Bearing ◽  
Journal Bearings ◽  
Operating Conditions ◽  
System Stability ◽  
Rigid Rotor ◽  
Transient Method ◽  
Porous Bearing ◽  
Nonlinear Transient ◽  
Linear And Nonlinear ◽  
The Stability

A theoretical analysis has been carried out to determine the stability of rigid rotor supported on two symmetrical finite two-layered porous oil journal bearings. The stability curves have been drawn for different eccentricity ratios and Sommerfeld numbers. The effect of bearing feeding parameter, L/D ratio on the stability is also investigated. This paper also deals with a theoretical investigation of stability using a non-linear transient method. This analysis gives the journal centre locus and from this the system stability can be determined. With the help of graphics, several trajectories of the journal centre have been obtained for different operating conditions. Finally a comparison between single-layered porous bearing and the two-layered porous bearing is presented here.

Dynamic stability of micropolar lubricated hydrodynamic offset-halves journal bearings

2020 ◽  
pp. 135065012093685
Author(s):  
Sanyam Sharma ◽  
Chimata M Krishna
Keyword(s):  
High Speed ◽  
Reynolds Equation ◽  
Journal Bearing ◽  
Critical Mass ◽  
Journal Bearings ◽  
Aspect Ratios ◽  
Input Parameters ◽  
Output Characteristics ◽  
The Stability ◽  
Offset Factor

The plain circular journal bearings are not found to be stable by researchers when used in high speed rotating machineries. Hence, extensive research in the study of stability characteristics of non-circular bearings or lobed bearings assumed importance, of late. Present article deals with the stability analysis of non-circular offset bearing by taking selected set of input and output parameters. Modified Reynolds equation for micropolar lubricated rigid journal bearing system is solved using finite element method. Two kinds of input parameters namely, offset factors (0.2, 0.4) and aspect ratios (1.6, 2.0) have been selected for the study. The important output characteristics such as load, critical mass, whirl frequency ratio, and threshold speed are computed and plotted for various set of values of input parameters. The results obtained indicate that micropolar lubricated circular offset bearing is highly stable for higher offset factor and higher aspect ratio.

The Stability of a Flexible Rotor Supported by Circumferentially Fed Journal Bearings

1977 ◽  
Vol 99 (4) ◽  
pp. 469-477 ◽  
Author(s):  
P. Bar-Yoseph ◽  
J. J. Blech
Keyword(s):  
Journal Bearings ◽  
Asymptotically Stable ◽  
Direct Integration ◽  
Flexible Rotor ◽  
Nonlinear Prediction ◽  
Speed Range ◽  
The Stability

The stability of a flexible rotor, perfectly balanced, was investigated theoretically. The rotor is symmetrically supported by circumferentially fed journal bearings. Short and finite bearings were treated. Stability was checked for small and large disturbances. Two methods were employed to treat large disturbances: Direct integration and the slowly varying technique. The nonlinear prediction was tested concurrently with the prediction of the stability charts. It was observed that in certain cases stability can be obtained in the asymptotic and in the unstable regions. Instability was obtained for regions which presumably are asymptotically stable in the entire speed range.

Sign in / Sign up

Export Citation Format

Share Document