Thermodynamic Analysis of a Liquid Desiccant Cooling System Under Mediterranean Climatic Conditions

2012 ◽  
Author(s):  
I. P. Koronaki ◽  
R. I. Christodoulaki ◽  
V. D. Papaefthimiou ◽  
E. D. Rogdakis
Keyword(s):  
Air Conditioning ◽  
Cooling System ◽  
Peak Load ◽  
Climatic Conditions ◽  
Liquid Desiccant ◽  
Step Method ◽  
Mass Rate ◽  
Energy Penalty ◽  
Condensed Water ◽  
Air Conditioning Systems

Liquid desiccant air conditioning systems have recently been attracting attention, owing to their merits in handling the latent heat. Desiccant systems avoid not only the energy penalty caused by overcooling and reheating, but also the bacteria generation caused by condensed water. They can also significantly reduce the electricity peak load caused by conventional compression type air conditioning systems, especially in hot and humid regions. Desiccant systems are thus more energy efficient, healthy and environmentally friendly than conventional mechanical cooling. This paper presents the results from a theoretical study of a liquid desiccant system that provides air conditioning to a typical office building. A coupled heat and mass transfer analytical model was developed, based on the Runge-Kutta fixed step method, to predict the performance of the device under Mediterranean conditions. A parametric analysis was implemented to investigate the effects of ambient temperature and humidity ratio on the dehumidification mass rate, the load coverage and the thermal COP of the system. Simulation results showed that under hot and humid weather, the COP reaches its maximum value, 1.075. However, as the weather becomes more humid, the latent load coverage of the system is decreased and as it becomes hotter, the sensible load coverage of the system is decreased. The maximum latent load coverage, 91.8%, happened at 40°C, 0.011kgw/kgdα. Results can be useful for researchers and engineers.

scholarly journals Desiccant cooling as an alternative to traditional air conditioners in green cooling technology

2019 ◽  
pp. 01-13
Author(s):  
Jani DB
Keyword(s):  
Air Conditioning ◽  
Energy Savings ◽  
Cooling System ◽  
Green Building ◽  
Climatic Conditions ◽  
Coefficient Of Performance ◽  
Low Grade ◽  
Vapor Compression ◽  
Cooling Technology ◽  
Air Conditioning Systems

Desiccant-based dehumidification and air conditioning systems are considered as an energy efficient alternative to traditional vapor compression based air-conditioning systems for green building cooling technology especially in tropical hot and humid ambient climates. It is a novel green cooling technology that makes use of low-grade heat for building air conditioning. It is seen that the desiccant based dehumidification and cooling can efficiently provide comfort conditions in subtropical and especially hot and humid tropical climates. The desiccant integrated novel cooling system has a significant higher coefficient of performance compared to the conventional vapor compression system resulting to substantial electrical energy savings during the summer season by use of renewable solar energy, which also resulted in to major reduction in CO2 emissions. Therefore, these results demonstrate that there is a good potential in desiccant-based dehumidification and cooling system for energy and carbon savings while carry out building air-conditioning. Through a literature review, the feasibility of the desiccant assisted air conditioning in hot and humid climatic conditions is proven and the advantages it can offer in terms energy and cost savings are underscored. Keywords: Air-conditioning; Desiccant cooling; Dehumidification; Green cooling; Thermal comfort

ANALYSIS OF COMPETING VARIANTS OF AIR CONDITIONING SYSTEMS WITHOUT AIR EXTRACTION FROM ENGINES AT THE STAGE OF PASSENGER AIRCRAFT ONBOARD SYSTEMS CONCEPTUAL DESIGN

2019 ◽  
Vol 6 (3) ◽  
pp. 80-85
Author(s):  
Denis Igorevich Smagin ◽  
Konstantin Igorevich Starostin ◽  
Roman Sergeevich Savelyev ◽  
Anatoly Anatolyevich Satin ◽  
Anastasiya Romanovna Neveshkina ◽  
...  
Keyword(s):  
Conceptual Design ◽  
Air Conditioning ◽  
Research University ◽  
Cooling System ◽  
Fuel Efficiency ◽  
Air Cooling ◽  
Moscow Aviation Institute ◽  
Air Conditioning System ◽  
Low Efficiency ◽  
Air Conditioning Systems

One of the ways to achieve safety and comfort is to improve on-board air conditioning systems.The use of air cooling machine determines the air pressure high level at the point of selection from the aircraft engine compressor. Because of the aircraft operation in different modes and especially in the modes of small gas engines, deliberately high stages of selection have to be used for ensuring proper operation of the refrigeration machine in the modes of the aircraft small gas engines. Into force of this, most modes of aircraft operation have to throttle the pressure of the selected stage of selection, which, together with the low efficiency of the air cycle cooling system, makes the currently used air conditioning systems energy inefficient.A key feature of the architecture without air extraction from the main engines compressors is the use of electric drive compressors as a source of compressed air.A comparative analysis of competing variants of on-board air conditioning system without air extraction from engines for longrange aircraft projects was performed at the Moscow Aviation Institute (National Research University).The article deals with the main approaches to the decision-making process on the appearance of a promising aircraft on-board air conditioning system at the stage of its conceptual design and formulated the basic requirements for the structure of a complex criterion at different life cycle stages.The level of technical and technological risk, together with a larger installation weight, will require significant costs for development, testing, debugging and subsequent implementation, but at the same time on-board air conditioning system scheme without air extraction from the engines will achieve a significant increase in fuel efficiency at the level of the entire aircraft.

scholarly journals Indoor Air Quality Enhancement Performance of Liquid Desiccant and Evaporative Cooling-Assisted Air Conditioning Systems

2019 ◽  
Vol 11 (4) ◽  
pp. 1036 ◽  
Author(s):  
Beom-Jun Kim ◽  
Junseok Park ◽  
Jae-Weon Jeong
Keyword(s):  
Air Quality ◽  
Indoor Air Quality ◽  
Indoor Air ◽  
Reference System ◽  
Air Conditioning ◽  
Evaporative Cooling ◽  
Quality Enhancement ◽  
Liquid Desiccant ◽  
Air Conditioning Systems ◽  
Indoor Pm2.5

The main objective of this study is to investigate the indoor air quality enhancement performance of two different liquid desiccant and evaporative cooling-assisted air conditioning systems, such as the variable air volume (VAV) system with the desiccant-enhanced evaporative (DEVap) cooler, and the liquid desiccant system with an indirect and direct evaporative cooling-assisted 100% outdoor air system (LD-IDECOAS), compared with the conventional VAV system. The transient simulations of concentration variations of carbon dioxide (CO2), coarse particles, and fine particles (PM10 and PM2.5) in a model office space served by each system were performed using validated system models that were found in the literature. Based on the hourly thermal loads of the model space predicted by the TRNSYS 18 program, each air conditioning system was operated virtually using a commercial equation solver program (EES). The results indicated that the LD-IDECOAS provided the lowest annual indoor CO2 concentration among all the systems considered in this research, while the VAV system with DEVap cooler exceeded the threshold concentration (i.e., 1000 ppm) during the cooling season (i.e., July, August, and September). For the indoor particulate contaminant concentrations, both liquid desiccant and evaporative cooling-assisted air conditioning systems indicated lower indoor PM2.5 and PM10 concentrations compared with the reference system. The LD-IDECOAS and the VAV with a DEVap cooler demonstrated 33.3% and 23.5% lower annual accumulated indoor PM10 concentrations than the reference system, respectively. Similarly, the annual accumulated indoor PM2.5 concentration was reduced by 16% using the LD-IDECOAS and 17.1% using the VAV with DEVap cooler.

Analysis of the Behavior of an Air Conditioning System Based on the Solar Energy Natural Regulation in Amazonian Climatic Conditions

2020 ◽  
Vol 143 (3) ◽  
Author(s):  
Elson C. Santos ◽  
Emanuel N. Macêdo ◽  
Marcos A. B. Galhardo ◽  
Thiago Oliveira Costa ◽  
André Felipe P. Costa ◽  
...  
Keyword(s):  
Direct Current ◽  
Air Conditioning ◽  
Cooling Capacity ◽  
Climatic Conditions ◽  
Power Modeling ◽  
Frequency Converters ◽  
Industrial Buildings ◽  
Air Conditioning Systems ◽  
Solar Resource ◽  
Installed Capacity

Abstract Air conditioning systems (ACSs) represent one of the main demands for electricity in residential, commercial, and industrial buildings. The use of a photovoltaic air conditioning unit (PVACU) represents an attractive application to this demand for reasons such as environmental concerns and the match between diurnal cooling load and solar resource. A PVACU consists of a photovoltaic generator (PVG) that supply an ACS through direct current to direct current and frequency converters, without energy storage. This system considers the natural adjustment of the ACS cooling capacity according to the PVG power. Modeling the ACS, the PVG, and the thermal load (TL) makes possible to evaluate PVACU performance. For this, a small library’s TL and an ACS supplied by a PVG were used as case study. The PVG installed capacity assumes values of 700, 1000, and 1400 Wp. The simulation results show that the PVACU with a 1400 Wp PVG would be sufficient to regulate internal temperature within international comfort standards in the range of 20 °C to 24 °C. According to the data obtained in the simulations, it was possible to conclude that the PVACU has a large potential to be used in air conditioning of other environments in regions with Amazonian climatic conditions.

Spreading of SARS-CoV-2 via Heating, Ventilation, and Air Conditioning Systems—An Overview of Energy Perspective and Potential Solutions

2020 ◽  
Vol 143 (8) ◽  
Author(s):  
Ahmad K. Sleiti ◽  
Samer F. Ahmed ◽  
Saud A. Ghani
Keyword(s):  
Air Conditioning ◽  
High Performance ◽  
Public Perception ◽  
High Efficiency ◽  
Uv Light ◽  
Experimental Studies ◽  
High Energy ◽  
Penalty Cost ◽  
Energy Penalty ◽  
Air Conditioning Systems

Abstract The role of heating, ventilation, and air conditioning systems (HVAC) in spreading SARS-CoV-2 is a complex topic and has not been studied thoroughly. There are some existing strategies and technologies for health and high performance buildings; however, applications to other types of buildings come at large energy penalty: cost; design, regulations and standards changes, and varied public perception. In the present work, different factors and strategies are reviewed and discussed and suggested mitigations and solutions are provided including the required air flowrates with the presence of infectors with and without mask and disinfection techniques including ultraviolet (UV) light. Experimental and numerical research in open literature suggests that the airborne transmission of SARS-CoV-2 is sufficiently likely. However, in situ detailed experimental studies are still needed to understand the different scenarios of the virus spread. Displacement ventilation, underfloor air distribution, chilled beams, radiant ceiling panels, and laminar flow systems have varied effectiveness. High-efficiency particulate arrestance (HEPA) filters and UV light can clean viruses but at high energy cost. Suggested solutions to reduce the infection probability include recommended levels of ventilation and a combination of virus sampling technologies including cyclones, liquid impinger, filters, electrostatic precipitators, and water-based condensation.

scholarly journals Energy Performance Comparison between Two Liquid Desiccant and Evaporative Cooling-Assisted Air Conditioning Systems

Energies ◽  
2020 ◽  
Vol 13 (3) ◽  
pp. 522
Author(s):  
Su Liu ◽  
Jae-Weon Jeong
Keyword(s):  
Energy Consumption ◽  
Air Conditioning ◽  
Evaporative Cooling ◽  
Dew Point ◽  
Outdoor Air ◽  
Liquid Desiccant ◽  
Energy Saving Potential ◽  
Evaporative Cooler ◽  
Air Conditioning Systems ◽  
Direct Evaporative Cooler

This study investigated the annual energy saving potential and system performance of two different evaporative cooling-based liquid desiccant and evaporative cooling-assisted air conditioning systems. One system used an indirect and direct evaporative cooler with a two-stage package to match the target supply air point. The other was equipped with a single-stage, packaged dew-point evaporative cooler that used a portion of the process air, which had been dehumidified in advance. Systems installed with the two evaporative coolers were compared to determine which one was more energy efficient and which one could provide better thermal comfort for building occupants in a given climate zone, using detailed simulation data. The detailed energy consumption data of these two systems were estimated using an engineering equation solver with each component model. The results showed that the liquid desiccant and dew-point evaporative-cooler-assisted 100% outdoor air system (LDEOAS) resulted in approximately 34% more annual primary energy consumption than that of the liquid desiccant and the indirect and direct evaporative-cooler-assisted 100% outdoor air system (LDIDECOAS). However, the LDEOAS could provide drier and cooler supply air, compared with the LDIDECOAS. In conclusion, LDIDECOAS has a higher energy saving potential than LDEOAS, with an acceptable level of thermal comfort.

Sign in / Sign up

Export Citation Format

Share Document