Formation of ball streamers at a subnanosecond breakdown of gases at a high pressure in a nonuniform electric field

JETP Letters ◽  
2017 ◽  
Vol 106 (10) ◽  
pp. 653-658 ◽  
Author(s):  
D. V. Beloplotov ◽  
V. F. Tarasenko ◽  
D. A. Sorokin ◽  
M. I. Lomaev
2011 ◽  
Vol 39 (11) ◽  
pp. 2088-2089 ◽  
Author(s):  
Mikhail I. Lomaev ◽  
Victor F. Tarasenko ◽  
Dmitri A. Sorokin ◽  
Dmitri V. Rybka

2013 ◽  
Vol 58 (8) ◽  
pp. 1115-1121 ◽  
Author(s):  
V. F. Tarasenko ◽  
E. Kh. Baksht ◽  
M. I. Lomaev ◽  
D. V. Rybka ◽  
D. A. Sorokin

2004 ◽  
Vol 34 (11) ◽  
pp. 1007-1010 ◽  
Author(s):  
S B Alekseev ◽  
V P Gubanov ◽  
I D Kostyrya ◽  
Viktor M Orlovskii ◽  
V S Skakun ◽  
...  

2010 ◽  
Vol 55 (2) ◽  
pp. 210-218 ◽  
Author(s):  
V. F. Tarasenko ◽  
E. Kh. Baksht ◽  
A. G. Burachenko ◽  
I. D. Kostyrya ◽  
M. I. Lomaev ◽  
...  

2013 ◽  
Vol 58 (3) ◽  
pp. 370-374 ◽  
Author(s):  
A. M. Boichenko ◽  
V. F. Tarasenko ◽  
E. Kh. Baksht ◽  
A. G. Burachenko ◽  
M. V. Erofeev ◽  
...  

2013 ◽  
Vol 818 ◽  
pp. 72-76 ◽  
Author(s):  
Gang Su

The crystalline electric field parameters Anmfor HoFe11Ti under different pressures were evaluated by fitting calculations to the magnetization curves measured on the single crystals at several temperatures. It was found that magneto-crystalline anisotropy has been changed by high pressure and the Anmfor HoFe11Ti under high pressures are strikingly different from Anmfor the corresponding HoFe11Ti H with interstitial hydrogen atom.


2001 ◽  
Vol 700 ◽  
Author(s):  
Malinda M. Tupper ◽  
Marjorie E. Chopinaud ◽  
Takamichi Ogawa ◽  
Michael J. Cima

AbstractDispensing micron-scale dielectric materials can be achieved through the use of dielectrophoresis. Electrodes are designed to create a nonuniform electric field. This method is expected to be applicable for transfer of a wide range of dielectric powders as well as small, shaped components. Small, 150 μm diameter silica spheres, as well as sodium fluorescein powder have been dispensed by this method. Selecting the appropriate electrode geometry and electric field intensity controls the amount collected. As little as 1.0 μg of sodium fluorescein powder, and as much as 16 mg of silica beads have been collected, and repeatability within 10 % of the total amount dispensed has been achieved.


Author(s):  
V. M. (Bala) Balasubramaniam

Consumers demand healthier fresh tasting foods without chemical preservatives. To address the need, food industry is exploring alternative preservation methods such as high pressure processing (HPP) and pulsed electric field processing. During HPP, the food material is subjected to elevated pressures (up to 900 MPa) with or without the addition of heat to achieve microbial inactivation with minimal damage to the food. One of the unique advantages of the technology is the ability to increase the temperature of the food samples instantaneously; this is attributed to the heat of compression, resulting from the rapid pressurization of the sample. Pulsed electric field (PEF) processing uses short bursts of electricity for microbial inactivation and causes minimal or no detrimental effect on food quality attributes. The process involves treating foods placed between electrodes by high voltage pulses in the order of 20–80 kV (usually for a couple of microseconds). PEF processing offers high quality fresh-like liquid foods with excellent flavor, nutritional value, and shelf life. Pressure in combination with other antimicrobial agents, including CO2, has been investigated for juice processing. Both HPP and PEF are quite effective in inactivating harmful pathogens and vegetative bacteria at ambient temperatures. Both HPP and PEF do not present any unique issues for food processors concerning regulatory matters or labeling. The requirements are similar to traditional thermal pasteurization such as development of a Hazard Analysis Critical Control Point (HACCP) plan for juices and beverages. Examples of high pressure, pasteurized, value added products commercially available in the United States include smoothies, fruit juices, guacamole, ready meal components, oysters, ham, poultry products, and salsa. PEF technology is not yet widely utilized for commercial processing of food products in the United States. The presentation will provide a brief overview of HPP and PEF technology fundamentals, equipment choices for food processors, process economics, and commercialization status in the food industry, with emphasis on juice processing. Paper published with permission.


Sign in / Sign up

Export Citation Format

Share Document