Solar Light Induced Glass-Supported Zinc Oxide Catalyzed Degradation of Allura Red AC in Aqueous Solution

2020 ◽  
Vol 94 (13) ◽  
pp. 2723-2732
Author(s):  
Tapan Kumar Saha ◽  
Subarna Karmaker ◽  
Sanjay Debnath ◽  
Md. Imran Ali Biswas
Author(s):  
Rusmidah Ali ◽  
Boon Siew Ooi

Dalam kajian ini, ZnO dan TiO2 digunakan sebagai fotomangkin dalam pendegradasian pewarna New Methylene Blue N (NMBN). Kadar fotodegradasi diukur menggunakan alat spektrofotometer UV-Vis. Dalam kajian ini, New Methylene Blue N menunjukkan nilai serapan pada λ = 590 nm dan λ = 286 nm. Lampu UV (λ = 354 nm) digunakan dalam proses fotodegradasi. Dalam proses degradasi menggunakan ZnO menunjukkan 81.42% NMBN terdegradasi pada λ = 590 nm dan 77.75% pada λ = 286 nm. Sebaliknya, degradasi menggunakan TiO2 adalah 25.68% pada λ = 590 nm dan 26.37% pada λ = 286 nm. Peratus degradasi New Methylene Blue N ialah 88.89% dan 68.94% pada masing-masing λ = 590 nm dan λ = 286 nm apabila ditambahkan dengan H2O2. Campuran ZnO dan TiO2 dalam nisbah 85: 15 (0.085 g; 0.015 g) merupakan campuran fotomangkin yang paling optimum iaitu dengan peratus degradasi NMBN sebanyak 96.97% dan 93.61% pada λ = 590 nm dan λ = 286 nm. Penambahan ion logam Cu2+ memberikan peratus degradasi tertinggi berbanding ion logam lain iaitu 83.83% pada λ = 590 nm. Penambahan ion logam Pb2+ memberikan peratus degradasi tertinggi pada λ = 286 nm iaitu 81.25% pewarna terdegradasi. Keadaan optimum dicapai pada pH 5.90, dengan peratus degradasi tertinggi iaitu 92.84% dan 89.30% pada masing-masing λ = 590 nm dan λ = 286 nm. Kata kunci: New Methylene Blue N; fotodegradasi; larutan; ZnO; TiO2 In this study, ZnO and TiO2 are used as photocatalyst to degrade the dye, New Methylene Blue N (NMBN). The photodegradation rate was measured using UV-Visible spectrophotometer. In this study, New Methylene Blue N showed absorption values at λ = 590 nm and λ = 286 nm. UV lamp (λ = 354 nm) is used in the photodegradation process. Results showed that ZnO is a better photocatalyst compared to TiO2. The degradation by ZnO showed that 81% of NMBN was degraded at λ = 590 nm and 77.75% at λ = 286 nm. In contratst, the degradation using TiO2 was 25.68% at λ = 590 nm and 26.37% at λ = 286 nm. The percent degradation of New Methylene Blue N is 88.89% and 68.94% at λ = 590 nm and λ = 286 nm respectively when H2O2 was added. A mixture of ZnO and TiO2 in the ratio of 85: 15 (0.085 g: 0.015 g) is the most optimum ratio for the mixed photocatalyst where the degradation percentage of NMBN are 96.97% and 93.61% at λ = 590 nm and λ = 286 nm. The addition of Cu2+ metal ion gave the highest percentage of degradation (83.83% at λ = 590 nm) compared to other metal ions. The addition of Pb2+ gave the highest percentage of degradation at λ = 286 nm with 81.25% degradation of the dye. The optimum condition was achieved at pH 5.90, which gave the highest percentage degradation, 92.84% and 89.30% at λ = 590 nm and λ = 286 nm respectively. Key words: New Methylene Blue N; photodegradation; aqueous; ZnO; TiO2


Author(s):  
Basma Ghazal ◽  
Saad Makhseed

Novel composites of zinc oxide (ZnO) and copper phthalocyanines (CuTriPc and CuPc) were synthesized as efficient natural solar light photocatalysts for the photodegradation of organic wastewater pollutants. Spectroscopic and analytical measurements confirmed that both bulky triazolo copper phthalocyanine (CuTriPc) and unsubstituted planer (CuPc) were successfully coupled with ZnOnanoparticles. The synthesized nanocomposites were investigated as natural solar radiation photocatalysts toward the photodegradation of methylene blue (MB) analogue dye. The prepared CuTriPc/ZnO nanocomposite was proven to be an efficient solar light photocatalyst compared to pure ZnO and the unsubstituted CuPc/ZnO.


JOM ◽  
2020 ◽  
Vol 73 (1) ◽  
pp. 404-410
Author(s):  
Ahed H. Zyoud ◽  
Hala Salah ◽  
Shaher H. Zyoud ◽  
Samer H. Zyoud ◽  
Muath H. Helal ◽  
...  

2019 ◽  
Vol 296 ◽  
pp. 111834 ◽  
Author(s):  
Seyyed Mohammad Tabrizi Hafez Moghaddas ◽  
Behrouz Elahi ◽  
Majid Darroudi ◽  
Vahid Javanbakht

1957 ◽  
Vol 30 (1) ◽  
pp. 254-263
Author(s):  
T. S. McRoberts

Abstract The solubility of zinc oxide in solutions of ammonia and different ammonium salts has been determined. The interaction between ammonium laurate and zinc ammine (or ethylene diammine) salts has been studied in aqueous solution, in latex, and in oil emulsions. The results indicate that destabilization of ammoniated latex or soap-stabilized emulsions by dissolved zinc oxide is due to the presence of zinc diammine ions, which form insoluble dilaurates. It is suggested that the increased rate of destabilization at elevated temperatures is most probably due to a decrease in hydration of the zinc diammine dilaurate formed at the surface of the rubber or oil particles.


2012 ◽  
Vol 239-240 ◽  
pp. 1585-1588 ◽  
Author(s):  
Yuh Chung Hu ◽  
David T.W. Lin ◽  
Hai Lin Lee ◽  
Pei Zen Chang

The effect of Zinc-Oxide (ZnO) thin film annealed in different ambiences is presented. To achieve low cost and environmentally friendly process, ZnO aqueous solution is synthesized by dissolving zinc acetate dihydrate in deionized water directly. Zinc oxide aqueous solution of high solubility and stability is presented. High quality and dense Zinc oxide thin film is formed by spin coating. Annealing temperatures are in the range of 300 °C~500 °C, and annealing ambiences of both air and N2 are discussed.


Sign in / Sign up

Export Citation Format

Share Document