Particle size distribution of agglomerated crystal product from a continuous crystallizer

1987 ◽  
Vol 52 (5) ◽  
pp. 1186-1197 ◽  
Author(s):  
Jiří Hostomský

Relationships have been derived for the particle size distribution in a continuous crystallizer operating in a steady-state regime, where agglomeration of the primarily generated crystalline particles takes place. The derivation was made for a constant kinetic coefficient of agglomeration (independent of the particle size) and for a negligible particle growth rate. The relatioships are used to interpret the particle size distribution of calcium carbonate precipitated from 0.2 mol dm-3 solutions of calcium chloride and sodium carbonate in a laboratory continuous crystallizer. Anomalous shapes of the size distributions of small particles frequently observed in continuous crystallizers are discussed in terms of the agglomeration phenomenon.

1991 ◽  
Vol 113 (4) ◽  
pp. 402-411 ◽  
Author(s):  
T. J. Labus ◽  
K. F. Neusen ◽  
D. G. Alberts ◽  
T. J. Gores

A basic investigation of the factors which influence the abrasive jet mixing process was conducted. Particle size analysis was performed on abrasive samples for the “as-received” condition, at the exit of the mixing tube, and after cutting a target material. Grit size distributions were obtained through sieve analysis for both water and air collectors. Two different mixing chamber geometries were evaluated, as well as the effects of pressure, abrasive feed rate, cutting speed, and target material properties on particle size distributions. An analysis of the particle size distribution shows that the main particle breakdown is from 180 microns directly to 63 microns or less, for a nominal 80 grit garnet. This selective breakdown occurs during the cutting process, but not during the mixing process.


1982 ◽  
Vol 60 (8) ◽  
pp. 1101-1107
Author(s):  
C. V. Mathai ◽  
A. W. Harrison

As part of an ongoing general research program on the effects of atmospheric aerosols on visibility and its dependence on aerosol size distributions in Calgary, this paper presents the results of a comparative study of particle size distribution and visibility in residential (NW) and industrial (SE) sections of the city using a mobile laboratory. The study was conducted in the period October–December, 1979. An active scattering aerosol spectrometer measured the size distributions and the corresponding visibilities were deduced from scattering coefficients measured with an integrating nephelometer.The results of this transit study show significantly higher suspended particle concentrations and reduced visibilities in the SE than in the NW. The mean values of the visibilities are 44 and 97 km for the SE and the NW respectively. The exponent of R (particle radius) in the power law aerosol size distribution has a mean value of −3.36 ± 0.24 in the SE compared with the corresponding value of −3.89 ± 0.39 for the NW. These results arc in good agreement with the observations of Alberta Environment; however, they are in contradiction with a recent report published by the City of Calgary.


2019 ◽  
Vol 19 (5) ◽  
pp. 2787-2812 ◽  
Author(s):  
Betty Croft ◽  
Randall V. Martin ◽  
W. Richard Leaitch ◽  
Julia Burkart ◽  
Rachel Y.-W. Chang ◽  
...  

Abstract. Summertime Arctic aerosol size distributions are strongly controlled by natural regional emissions. Within this context, we use a chemical transport model with size-resolved aerosol microphysics (GEOS-Chem-TOMAS) to interpret measurements of aerosol size distributions from the Canadian Arctic Archipelago during the summer of 2016, as part of the “NETwork on Climate and Aerosols: Addressing key uncertainties in Remote Canadian Environments” (NETCARE) project. Our simulations suggest that condensation of secondary organic aerosol (SOA) from precursor vapors emitted in the Arctic and near Arctic marine (ice-free seawater) regions plays a key role in particle growth events that shape the aerosol size distributions observed at Alert (82.5∘ N, 62.3∘ W), Eureka (80.1∘ N, 86.4∘ W), and along a NETCARE ship track within the Archipelago. We refer to this SOA as Arctic marine SOA (AMSOA) to reflect the Arctic marine-based and likely biogenic sources for the precursors of the condensing organic vapors. AMSOA from a simulated flux (500 µgm-2day-1, north of 50∘ N) of precursor vapors (with an assumed yield of unity) reduces the summertime particle size distribution model–observation mean fractional error 2- to 4-fold, relative to a simulation without this AMSOA. Particle growth due to the condensable organic vapor flux contributes strongly (30 %–50 %) to the simulated summertime-mean number of particles with diameters larger than 20 nm in the study region. This growth couples with ternary particle nucleation (sulfuric acid, ammonia, and water vapor) and biogenic sulfate condensation to account for more than 90 % of this simulated particle number, which represents a strong biogenic influence. The simulated fit to summertime size-distribution observations is further improved at Eureka and for the ship track by scaling up the nucleation rate by a factor of 100 to account for other particle precursors such as gas-phase iodine and/or amines and/or fragmenting primary particles that could be missing from our simulations. Additionally, the fits to the observed size distributions and total aerosol number concentrations for particles larger than 4 nm improve with the assumption that the AMSOA contains semi-volatile species: the model–observation mean fractional error is reduced 2- to 3-fold for the Alert and ship track size distributions. AMSOA accounts for about half of the simulated particle surface area and volume distributions in the summertime Canadian Arctic Archipelago, with climate-relevant simulated summertime pan-Arctic-mean top-of-the-atmosphere aerosol direct (−0.04 W m−2) and cloud-albedo indirect (−0.4 W m−2) radiative effects, which due to uncertainties are viewed as an order of magnitude estimate. Future work should focus on further understanding summertime Arctic sources of AMSOA.


Open Physics ◽  
2019 ◽  
Vol 17 (1) ◽  
pp. 779-789 ◽  
Author(s):  
Ambrož Kregar ◽  
Tomaž Katrašnik

Abstract The limited durability of hydrogen fuel cells is one of the main obstacles in their wider adoption as a clean alternative technology for small scale electricity production. The Ostwald ripening of catalyst material is recognized as one of the main unavoidable degradation processes deteriorating the fuel cell performance and shortening its lifetime. The paper systematically studies how the modeling approach towards the electrochemically driven Ostwald ripening in the fuel cell catalyst differs from the classical diffusion driven models and highlights how these differences affect the resulting evolution of particle size distribution. At moderately low electric potential, root-law growth of mean particle size is observed with linear relation between mean particle size and standard deviation of particle size distribution, similar to Lifshitz-Slyozov-Wagner theory, but with broader and less skewed distribution. In case of high electric potential, rapid particle growth regime is observed and qualitatively described by redeposition of platinum from a highly oversaturated solution, revealing the deficiencies of the existing platinum degradation models at describing the Ostwald ripening in the fuel cells at high electric potentials. Several improvements to the established models of platinum degradation in fuel cell catalysts are proposed, aimed at better description of the diffusion processes involved in particle growth due to Ostwald ripening.


2010 ◽  
Vol 177 ◽  
pp. 22-24
Author(s):  
Zheng Min Li ◽  
Zhi Wei Chen ◽  
Min Tan ◽  
Ke Jing Xu ◽  
Bing Jiang

Nano-TiO2 coating film is one of the efficient photocatalysts. The particle size distribution of TiO2 has important influence on photocatalytic activity. A new method to determine the particle size distribution of TiO2 nano-film coated on ceramic was developed, by which the images of film acquired by Atom force microscope (AFM) were processed, and TiO2 particles contacted with others were separated and detected. The particle size distributions of two TiO2 nano-films were determined.


1994 ◽  
Vol 74 (2) ◽  
pp. 383-385 ◽  
Author(s):  
R. Soofi-Siawash ◽  
G. W. Mathison

Two studies were conducted to assess the possibility of using particle size distribution following grinding as a routine procedure of forage evaluation. It was concluded that although differences in particle size distribution could be detected when different feeds were ground, it would be difficult to standardize the technique since particle size distributions were influenced by type of mill used for grinding, particle size of forage before grinding, and moisture content of the forage. Key words: Forages, grinding, particle size, moisture, mill


2017 ◽  
Author(s):  
Yuanyuan Xie ◽  
Xingnan Ye ◽  
Zhen Ma ◽  
Ye Tao ◽  
Ruyu Wang ◽  
...  

Abstract. We characterize a representative haze event from a series of periodic particulate matter (PM) episodes that occurred in Shanghai during winter 2014. Particle size distribution, hygroscopicity, and effective density were measured online, along with analysis of water-soluble inorganic ions and single particle mass spectrometry. Regardless of pollution level, the mass ratio of SNA/PM1.0 (sulfate, nitrate, and ammonium) slightly fluctuated around 0.28 over the whole observation, suggesting that both secondary inorganic compounds and carbonaceous aerosols (including soot and organic matter) contributed substantially to the haze formation. Nitrate was the most abundant ionic species during hazy periods, indicating that NOx contributed more to haze formation in Shanghai than did SO2. The calculated PM concentration from particle size distribution displayed a variation pattern similar to that of measured PM1.0 during the representative PM episode, indicating that enhanced pollution level was attributable to the elevated number of larger particles. The number fraction of the near-hydrophobic group increased as the PM episode developed, indicating accumulation of local emissions. Three "banana-shape" particle evolutions were consistent with the rapid increase in PM1.0 mass loading, indicating rapid size growth by condensation of condensable materials was responsible for the severe haze formation. Both hygroscopicity and effective density of the particles increased considerably with growing particle size during the banana-shaped evolutions, indicating that secondary transformation of NOx and SO2 was a major contributor to the particle growth. Our results suggest that the accumulation of gas-phase and particulate pollutants under stagnant meteorological conditions and subsequent rapid particle growth by secondary processes, were primarily responsible for the haze pollution in Shanghai during wintertime.


1953 ◽  
Vol 26 (2) ◽  
pp. 441-446
Author(s):  
M. van den Tempel

Abstract The particle size distribution of the rubber globules in Hevea latex has been studied by means of electron microscopy. Most of the particles, even in concentrated latex, are less than 0.2 micron in diameter and are, consequently, not visible in the light microscope. These small particles have considerable influence on the specific interface, but they contain only a few per cent of the rubber present.


2020 ◽  
Vol 57 (11) ◽  
pp. 1684-1694
Author(s):  
Shijin Li ◽  
Adrian R. Russell ◽  
David Muir Wood

Internal erosion (suffusion) is caused by water seeping through the matrix of coarse soil and progressively transporting out fine particles. The mechanical strength and stress–strain behavior of soils within water-retaining structures may be affected by internal erosion. Some researchers have set out to conduct triaxial erosion tests to study the mechanical consequences of erosion. Prior to conducting a triaxial test they subject a soil sample, which has an initially homogeneous particle-size distribution and density throughout, to erosion by causing water to enter one end of a sample and wash fine particles out the other. The erosion and movement of particles causes heterogeneous particle-size distributions to develop along the sample length. In this paper, a new soil sample formation procedure is presented that results in homogeneous particle-size distributions along the length of an eroded sample. Triaxial tests are conducted on homogeneous samples formed using the new procedure as well as heterogeneous samples created by the more commonly used approach. Results show that samples with homogeneous post-erosion particle-size distributions exhibit slightly higher peak deviator stresses than those that were heterogeneous. The results highlight the importance of ensuring homogeneity of post-erosion particle-size distributions when assessing the mechanical consequences of erosion. Forming samples using the new procedure enables the sample’s response to triaxial loading to be interpreted against a measure of its initially homogenous state.


CrystEngComm ◽  
2018 ◽  
Vol 20 (38) ◽  
pp. 5672-5676 ◽  
Author(s):  
Run-Zhi Zhang ◽  
Yong-qing Huang ◽  
Wei Zhang ◽  
Ji-Min Yang

UiO-67 nano/microcrystals with different particle size distributions (PSDs) were successfully obtained by a simple solvothermal method.


Sign in / Sign up

Export Citation Format

Share Document