MOISTURE AND TEMPERATURE RELATIONS OF HEARTWOOD FUNGI IN SUBALPINE SPRUCE

1957 ◽  
Vol 35 (6) ◽  
pp. 935-944 ◽  
Author(s):  
D. E. Etheridge

The optimum moisture content for maximum development in wood was higher for butt-rotting fungi than for trunk-rotting fungi but the optimum and maximum temperature for growth on malt agar was about 5 °C. lower for the butt-rotting fungi. The fungi appeared to have the power of regulating to some extent the moisture content of the wood to a level more suitable for their development. There is evidence of a relationship between the maximum growth of the fungi on agar and their maximum development in wood. The possibility that adaptation to different host environmental conditions might explain differences in the moisture and temperature requirements of the fungi is discussed.

Agrotek ◽  
2018 ◽  
Vol 2 (6) ◽  
Author(s):  
Wilson Palelingan Aman

<em>A research about cocoa beans drying used solar tunnel dryer with photovoltaic module driven have conducted in Manokwari. Solar tunnel dryer used in this research adapted from type Hohenheim with photovoltaic module and integrated air heat collector has been installed at the Department of Agricultural Technology, Papua State University Manokwari to dried cocoa beans. The objectives of this research were to design solar tunnel dryer and evaluate it�s performance in dryed cocoa beans. The result obtained was a new construction of solar tunnel dryer for cocoa beans with dimensions 6 m of length and 0,9 m of wide. The dryer completed with photovoltaic module to drive the blowers of hot drying air. �Performance test of the dryer showed that drying of 10 kg of cocoa beans with initial moisture content about 70% wet basis needed 13 hours of drying time to achieved final moisture content about 7,17% wet basis. The drying time achieved was faster compared than traditional solar drying that needed 20 hours of drying time. The maximum temperature achieved in drying chamber was 60 <sup>o</sup>C.</em>


2021 ◽  
Vol 9 (1) ◽  
pp. 16-20
Author(s):  
Iyad Alkroosh ◽  
Ali Al-Robay ◽  
Prabir Sarker ◽  
Saif Alzabeebee

This paper investigates the influence of sand content on the mechanical behavior of a low plasticity clay that collected from south of Iraq (Sumer town). Samples have been prepared with sand contents of 0%, 10%, 20%, 30%, and 40% of the clay weight. Standard Proctor and unconfined compression tests have been carried out and the optimum moisture content, maximum dry density, and undrained shear strength have been determined. The results show a gradual increasing trend of the maximum dry density with the increase of the sand content up to 30%. The highest dry density reaches 1.90 g/cm3 corresponding to an optimum moisture content of 12%. In addition, this paper shows that the undrained shear strength is inversely proportional to the increase of the percentage of sand. The results of this work provide a useful addition to the literature regarding the behaviour or low plasticity clay-sand mixture.


Author(s):  
Jason Wright ◽  
S. Sonny Kim ◽  
Mi G. Chorzepa ◽  
Stephan A. Durham

In a geosynthetic-reinforced pavement system, the load-bearing capacity of subgrade soil is improved by the lateral distribution of vertical stresses at the reinforcing layer. Under small-scale triaxial testing, the tensile properties of the geosynthetic are difficult to measure. Therefore, it is desirable to conduct large-scale testing to accurately monitor the behavior of geosynthetic-reinforced pavement foundations when subjected to rolling-wheel loadings. This study investigates the behavior of geosynthetic-reinforced pavement foundation systems through large-scale rolling-wheel tests performed with problematic subgrade soils found in north Georgia. Sixteen large-scale specimens were constructed of which twelve were reinforced with geosynthetic. Subgrade soils were compacted either at their optimum moisture content or at a higher than optimum moisture content to produce different California Bearing Ratios during specimen preparation. Both an extruded biaxial geogrid and woven geotextile were placed at various locations to investigate the optimal placement locations for different subgrade conditions. Pressure sensors were installed near the bottom of the aggregate base layer and near the top of the subgrade layer to monitor the variations in vertical stress within the pavement system under rolling-wheel load. Further, light weight deflectometer measurements were collected post-test to determine the effect of the geosynthetic on pavement foundation stiffness. The vertical pressure at the bottom of the aggregate base and top of subgrade decreased on average approximately 15.3% and 18.8%, respectively. The results indicate which type of geosynthetic and placement location provides the greatest reduction of pressure for each of the given subgrade conditions.


2019 ◽  
Vol 19 ◽  
pp. 35-43
Author(s):  
Wentao Li ◽  
Douglas J. Wilson ◽  
Tam J. Larkin ◽  
Philippa M. Black

2013 ◽  
Vol 710 ◽  
pp. 348-351
Author(s):  
Zheng Rong Zhao ◽  
Lei Wang ◽  
Hong Xia Yang

Through compaction test discussed about the compaction characteristics of expansive soil by lime modified in middle of Shandong province. The results show that the optimum moisture content is lower when the expansive soil is cured by dry compaction method, and the maximum dry density is higher. Compaction curve appeared the phenomenon of two peaks when expansive soil is cured by wet compaction method.Lime content of lime improved expansive soil, particle size composition, age and compaction function have influence on compaction curve.With the increase of the quantity of lime, the optimum moisture content increases, the maximum dry density decreases. With the age growth, the optimum moisture content increase slightly,the maximum dry density decreases slightly. The bigger the compaction work, the smaller moisture content is, the larger the maximum dry density is.


1978 ◽  
Vol 5 (4) ◽  
pp. 511 ◽  
Author(s):  
N Takahashi

The lengths of mesocotyls (first internodes) and coleoptiles of rice varied greatly with the moisture content of the seed-bed. The optimum moisture content in most Indica cultivars was much higher for coleoptile than for mesocotyl growth, but not in some Japonica cultivars because the mesocotyl growth was not vigorous and did not vary with water content. Under submerged conditions, coleoptile growth was markedly stimulated, particularly in Japonica cultivars but there was no mesocotyl elongation in either cultivar. The plastic variability in the growth of coleoptile, leaves, mesocotyl and other internodes may be an adaptive response of rice to the water tension of the soil. Endogenous ethylene formation and effects of ethylene and carbon dioxide were also studied.


1995 ◽  
Vol 5 (1) ◽  
pp. 1 ◽  
Author(s):  
D Gillon ◽  
V Gomendy ◽  
C Houssard ◽  
J Marechal ◽  
JC Valette

The aim of this study was to assess the effects on combustion characteristics, and their consequences on nutrient losses, of (1) the change in load and packing ratio of the fuel bed, and (2) the change in fuel moisture content. Eighty-one experimental burns were carried out, on a test bench in the laboratory; the fuel was composed of needles and twigs of Pinus pinaster. Two levels of fuel load an dpacking ratio (8t ha-1 needles, packing ratio of 0.040; and 16t ha-1 twigs and needles, packing ratio of 0.066) were compared at constant moisture content (6%); and four levels of moisture content(6%, 12%, 24% and 30% dry weight) were compared at constant fuel load (8t ha-1 needles). At constant moisture content, an increase in the load and packing ratio of the fuel bed led to an increase in the height of flames and in the maximum temperature 25 cm above the fuel bed, in the duration of the rise in temperatures within the fuel, and in the fireline intensity. Conversely, the rate of fire spread decreased. At constant fuel load, an increase in the moisture content of the fuel led to a decrease in the rate of fire spread, in the flame height and the maximum temperature 25 cm above the fuel bed, and in the fireline intensity. In contrast, the maximum temperatures reached within the fuel, when the flaming front was continuous, did not significantly change with varying fuel loads or fuel moisture contents. The percentage fuel consumption was always high, more than 80%, but it significantly decreased with increasing fuel load and packing ratio and with increasing moisture content. Total losses of N, S, and K significantly decreased with increasing fuel load and packing ratio, with increasing moisture content and with decreasing percentage fuel consumption. Losses in P only significantly decreased with increasing fuel load and packing ratio. Losses in Mg and Ca were not significantly affected by fuel load, moisture content. or percentage consumption. An attempt was made to separate volatile from particulate losses, based on the assumption that all the losses of Ca were in particulate form. Whereas losses in particulate form remained relatively constant, losses of nutrients in volatile form seem to have been related to the percentage fuel consumption. Even if these experimental burns were of low intensity (40 to 56 kW m-1), their impact, in terms of lethal temperatures and nutrient losses, was not negligible, particularly for N and P. The increasing fireline intensity with increasing fuel load was not accompanied by an enhancement in the proportion of nutrient losses. In the same way, the strong decrease in fireline intensity with increasing fuel moisture content led only to a slight decrease in some nutrient losses. It was through their effect on the percentage fuel consumption that fuel load or moisture content modified the nutrient losses, particularly volatile losses.


Sign in / Sign up

Export Citation Format

Share Document