scholarly journals Biomass and nutrient distribution in aspen, pine, and spruce stands on the same soil type in Minnesota

1978 ◽  
Vol 8 (3) ◽  
pp. 290-299 ◽  
Author(s):  
David H. Alban ◽  
Donald A. Perala ◽  
Bryce E. Schlaegel
Keyword(s):  
Sandy Loam ◽  
Jack Pine ◽  
Red Pine ◽  
Nutrient Distribution ◽  
Exchangeable Ca ◽  
Spruce Stands ◽  
Soil Complex ◽  
Loam Soil ◽  
Understory Biomass ◽  
Total Tree

Vegetation and soils were sampled in adjacent 40-year-old stands of red pine (Pinusresinosa Ait.), jack pine (Pinusbanksiana Lamb.), white spruce (Piceaglauca (Moench.) Voss), and aspen (Populustremuloides Michx., P. grandidentata Michx.) on a very fine sandy loam soil in north-central Minnesota. Total tree biomass was greatest for red pine followed by aspen, spruce, and jack pine. Nutrient weights (N, P, K, Ca, Mg) in the trees were greatest in aspen followed generally by spruce, red pine, and jack pine. Particularly large proportions of biomass and nutrients were found in aspen bark and spruce foliage and branches. Understory biomass contributed less than 1.2% of the total organic matter in the vegetation–soil complex but contributed up to 5.0% of the nutrients. Exchangeable Ca in the surface soil was much lower under aspen and spruce than under the pines. No significant soil differences between species were detected below 36 cm. Harvesting the entire aboveground portion of the tree would remove up to three times more nutrients from the site than would harvesting only the bole.

Survival and Growth of Red Pine Planted on a Hardwood Site – A Second Look

1980 ◽  
Vol 56 (3) ◽  
pp. 112-114 ◽  
Author(s):  
Douglas M. Stone
Keyword(s):  
Sandy Loam ◽  
Site Index ◽  
Poor Quality ◽  
Red Pine ◽  
Northern Hardwood ◽  
Growing Seasons ◽  
Second Growth ◽  
Loam Soil ◽  
Survival And Growth ◽  
A Site

A 55-year-old stand of second-growth northern hardwood growing on a well-drained sandy loam soil was converted to red pine to compare with an adjacent 1929 plantation. Part of the plantation was cleaned during the second and third growing seasons and second-year survival was 72%. In the non-cleaned portion, which is reverting to maple sprouts, aspen suckers, brush, and weeds, pine survival was 38%. Annual height growth averaged 15.0 and 8.1 cm (6.0 and 3.2. in.), respectively. Differences in early success of the two plantings are attributed to: 1) greater competition after clearing pole-size hardwoods; 2) larger tops and better developed root systems of 2-1-2 transplants used in 1929; 3) planting in prepared spots in 1929; and 4) above normal growing season precipitation during 1929, and below normal in 1976. Converting pole-size northern hardwoods to red pine will be difficult and expensive. Competing vegetation will be the most serious problem, particularly on good hardwood sites. Investments in converting hardwoods to red pine should be concentrated in poor quality stands on well drained soils with a site index for maple of 50 or less.

Spotgun-Applied Hexazinone: Release of Red Pine (Pinus resinosa) from Quaking Aspen (Populus tremuloides) Competition and Residue Persistence in Soil

1990 ◽  
Vol 4 (2) ◽  
pp. 371-375 ◽  
Author(s):  
Raj Prasad ◽  
Joseph C. Feng
Keyword(s):  
Populus Tremuloides ◽  
Sandy Loam ◽  
Pinus Resinosa ◽  
Red Pine ◽  
Quaking Aspen ◽  
Lateral Movement ◽  
White Birch ◽  
Grid Pattern ◽  
Northern Ontario ◽  
Loam Soil

Weed control and red pine release by spotgun-applied hexazinone in a northern Ontario plantation were evaluated 3 yr after treatment, while hexazinone residues and lateral movement in the sandy loam soil were determined 1 yr after treatment. Hexazinone, grid pattern spot applied at 480 mg ai/spot, approximating 1.6 kg ai/ha, resulted in 88% quaking aspen stem dieback and variable suppression of white birch and pin cherry. The height and basal diam of treated red pine were 131 and 150% of control, respectively, after 3 yr. Hexazinone residues were reduced to 1% at the treated spot and did not move laterally beyond 0.5 m, 1 yr after treatment. Detection of small amounts of metabolites A and B (0.2 and 0.3%) indicated the non-cumulative degradation of hexazinone in soils.

Emissions of nitrous oxide and nitric oxide associated with the decomposition of arable crop residues on a sandy loam soil in Eastern England

Agronomie ◽  
2002 ◽  
Vol 22 (7-8) ◽  
pp. 731-738 ◽  
Author(s):  
Roland Harrison ◽  
Sharon Ellis ◽  
Roy Cross ◽  
James Harrison Hodgson
Keyword(s):  
Nitric Oxide ◽  
Nitrous Oxide ◽  
Crop Residues ◽  
Sandy Loam ◽  
Sandy Loam Soil ◽  
Arable Crop ◽  
Loam Soil

Effect of Bio and Organic Fertilizers on Pumpkin's (Cucurbita pepo L.) Leave Content of N, P, and K

2020 ◽  
Vol 10 (1) ◽  
pp. 241-245
Author(s):  
Ammar Hameed Madi ◽  
Jawad A. Kamal Al-Shibani
Keyword(s):  
Cucurbita Pepo ◽  
Sandy Loam ◽  
Block Design ◽  
Organic Fertilizers ◽  
Flowering Stage ◽  
College Of Agriculture ◽  
Significant Difference ◽  
Randomized Complete Block Design ◽  
Loam Soil ◽  
Four Levels

This study was conducted to investigate the effect of bacterial bio-fertilization A. chroococcum and P. putide and four levels of compost (0, 1, 2, 3) tons.h-1 on the leaves content of N.P.K elements. The experiment was carried out in one of the greenhouses of the College of Agriculture - University of Al-Qadisiyah during fall season 2018-2019. It designed in accordance with the Randomized Complete Block Design (RCBD) with three replicates in sandy loam soil. The means of treatments were compared with the least significant difference (LSD) at (5)% probability level. The results present that the treatments of A. chroococcum, P. putide and compost at (3) tons.kg-1 significantly increases the leaves content of K.P.K compared to all other treatments in the flowering stage (4.970, 0.5000, and 4.930) mg.kg-1, respectively. This treatment was followed by the effect of the treatment of A. chroococcum and compost at (3) tons.kg-1, which increases the values of all traits except the leaf content of (P). Bio-fertilizer with P. putide + A. chroococcum significantly increases the leaves' content of P.

INFLUENCE OF UNCONVENTIONAL FERTILIZERS ON MICROBIOLOGICAL ACTIVITY OF SODDY-PODZOLY SANDY SOIL

2020 ◽  
Vol 18 (4) ◽  
pp. 84-87
Author(s):  
Yu.V. Leonova ◽  
◽  
T.A. Spasskaya ◽  
Keyword(s):  
Sewage Sludge ◽  
Sandy Soil ◽  
Sandy Loam ◽  
Sandy Loam Soil ◽  
Microbiological Activity ◽  
Coffee Waste ◽  
Loam Soil

The change in the microbiological activity of sod-podzolic sandy loam soil when using coffee waste and sewage sludge as a fertilizer for oats in comparison with traditional fertilizers is considered. During the study, it was determined that the predominant groups were bacteria and actinomycetes. Bacilli and fungi are few in number. The introduction of sewage sludge and coffee waste into the sod-podzolic sandy loam soil at a dose of 10 t / ha increases the activity of the microflora of the sod-podzolic sandy loam soil, which increases the effective and potential fertility.

Evaluation of Presswheels and Seed Coverers for Direct Seeding of Brassica

HortScience ◽  
1997 ◽  
Vol 32 (4) ◽  
pp. 599E-600
Author(s):  
Regina P. Bracy ◽  
Richard L. Parish
Keyword(s):  
Soil Moisture ◽  
Sandy Loam ◽  
Visual Observation ◽  
Mustard Seed ◽  
High Soil Moisture ◽  
Loam Soil ◽  
Direct Seeded ◽  
Plant Emergence ◽  
Moisture Conditions ◽  
Determine Effect

Improved stand establishment of direct-seeded crops has usually involved seed treatment and/or seed covers. Planters have been evaluated for seed/plant spacing uniformity, singulation, furrow openers, and presswheel design; however, effects of presswheels and seed coverers on plant establishment have not been widely investigated. Five experiments were conducted in a fine sandy loam soil to determine effect of presswheels and seed coverers on emergence of direct-seeded cabbage and mustard. Seed were planted with Stanhay 870 seeder equipped with one of four presswheels and seed coverers. Presswheels included smooth, mesh, concave split, and flat split types. Seed coverers included standard drag, light drag, paired knives, and no coverer. Soil moisture at planting ranged from 8% to 19% in the top 5 cm of bed. Differences in plant counts taken 2 weeks after planting were minimal with any presswheel or seed coverer. Visual observation indicated the seed furrow was more completely closed with the knife coverer in high soil moisture conditions. All tests received at least 14 mm of precipitation within 6 days from planting, which may account for lack of differences in plant emergence.

Chloride and Lithium Transport in Large Arrays of Undisturbed Silt Loam and Sandy Loam Soil Columns

2004 ◽  
Vol 3 (1) ◽  
pp. 316
Author(s):  
M. Saleem Akhtar ◽  
Tammo S. Steenhuis ◽  
Brian K. Richards ◽  
Murray B. McBride
Keyword(s):  
Sandy Loam ◽  
Sandy Loam Soil ◽  
Silt Loam ◽  
Soil Columns ◽  
Lithium Transport ◽  
Loam Soil

scholarly journals A Modified Pressure–Sinkage Model for Studying the Effect of a Hard Layer in Sandy Loam Soil

2021 ◽  
Vol 11 (12) ◽  
pp. 5499
Author(s):  
Nihal D. Salman ◽  
György Pillinger ◽  
Muammel M. Hanon ◽  
Péter Kiss
Keyword(s):  
Bearing Capacity ◽  
Sandy Loam ◽  
Sandy Loam Soil ◽  
High Fidelity ◽  
Load Bearing Capacity ◽  
Soil Thickness ◽  
Load Bearing ◽  
Hard Layer ◽  
Loam Soil ◽  
New Perspective

The applicability of the typical pressure–sinkage models used to characterize the soil’s bearing properties is limited to homogeneous soils (infinite thickness) that have no hard layer. At a given depth, a hard layer can have a considerable impact on the soil’s load-bearing capacity. It is thus necessary to alter the pressure–sinkage equation by taking this condition into account when assessing the load-bearing capacity. The present paper aims to determine a simple, high-fidelity model, in terms of soil characterization, that can account for the hard layer affection. To assess hard layer affection in this paper, a plate sinkage test (bevameter) was conducted on sandy loam soil. To this end, the soil was prepared by considering three bulk densities and two soil thickness levels at 7–9% moisture content levels. According to the results, this paper put forth a new perspective and related equations for characterizing bearing performance. The sinkage modulus (k) is an intrinsic soil parameter that has a determined unit of N/cm2 and is significant for managing the bearing performance. The results showed that the new modulus sinkage model incorporates the main factor of the rigid layer effect involving high fidelity that the conventional models have failed to account for.

Sign in / Sign up

Export Citation Format

Share Document