Analysis of the reasons behind the fracture of the 220kV pipe busbar horizontal line clamp

Author(s):  
Shuang Liu ◽  
Zhibin Fan ◽  
Mingde Gao
Keyword(s):  
Micromachines ◽  
2021 ◽  
Vol 12 (8) ◽  
pp. 922
Author(s):  
Seunghoon Ko

This paper presents a mutual capacitance touch readout IC architecture for 120 Hz high-refresh-rate AMOLED displays. In high-refresh-rate AMOLED panels, whole pixels in a horizontal line should be updated without any time-sharing with each other, leading to an amplified display noise on touch screen panel (TSP) electrodes. The proposed system architecture mitigates severe display noise by synchronizing the driving for the TSP and AMOLED pixel circuits. The proposed differential sensing technique, which is based on noise suppression in reference to mutual capacitance channels, minimizes common-mode display noise. In the front-end circuit, intrinsic circuit offset is cancelled by a chopping scheme, which correlates to the phase of the driving signals in the TSP driver and operating clocks of the front-end. Operating at a 120 Hz scan-rate, it reduces display noise by more than 11.6 dB when compared with the conventional single-ended TSP sensing method. With a built-in 130-nm CMOS, a prototype IC occupies an area of 8.02 mm2 while consuming 6.4-mW power from a 3.3 V analog voltage supply.


2021 ◽  
Vol 12 (1) ◽  
Author(s):  
Vadim Grinenko ◽  
Debarchan Das ◽  
Ritu Gupta ◽  
Bastian Zinkl ◽  
Naoki Kikugawa ◽  
...  

AbstractThere is considerable evidence that the superconducting state of Sr2RuO4 breaks time reversal symmetry. In the experiments showing time reversal symmetry breaking, its onset temperature, TTRSB, is generally found to match the critical temperature, Tc, within resolution. In combination with evidence for even parity, this result has led to consideration of a dxz ± idyz order parameter. The degeneracy of the two components of this order parameter is protected by symmetry, yielding TTRSB = Tc, but it has a hard-to-explain horizontal line node at kz = 0. Therefore, s ± id and d ± ig order parameters are also under consideration. These avoid the horizontal line node, but require tuning to obtain TTRSB ≈ Tc. To obtain evidence distinguishing these two possible scenarios (of symmetry-protected versus accidental degeneracy), we employ zero-field muon spin rotation/relaxation to study pure Sr2RuO4 under hydrostatic pressure, and Sr1.98La0.02RuO4 at zero pressure. Both hydrostatic pressure and La substitution alter Tc without lifting the tetragonal lattice symmetry, so if the degeneracy is symmetry-protected, TTRSB should track changes in Tc, while if it is accidental, these transition temperatures should generally separate. We observe TTRSB to track Tc, supporting the hypothesis of dxz ± idyz order.


2011 ◽  
Vol 4 (1) ◽  
pp. 67-88 ◽  
Author(s):  
G. J. Marseille ◽  
K. Houchi ◽  
J. de Kloe ◽  
A. Stoffelen

Abstract. The definition of an atmospheric database is an important component of simulation studies in preparation of future earth observing remote sensing satellites. The Aeolus mission, formerly denoted Atmospheric Dynamics Mission (ADM) or ADM-Aeolus, is scheduled for launch end of 2013 and aims at measuring profiles of single horizontal line-of-sight (HLOS) wind components from the surface up to about 32 km with a global coverage. The vertical profile resolution is limited but may be changed during in-orbit operation. This provides the opportunity of a targeted sampling strategy, e.g., as a function of geographic region. Optimization of the vertical (and horizontal) sampling strategy requires a characterization of the atmosphere optical and dynamical properties, more in particular the distribution of atmospheric particles and their correlation with the atmospheric dynamics. The Aeolus atmospheric database combines meteorological data from the ECMWF model with atmosphere optical properties data from CALIPSO. An inverse algorithm to retrieve high-resolution particle backscatter from the CALIPSO level-1 attenuated backscatter product is presented. Global weather models tend to underestimate atmospheric wind variability. A procedure is described to ensure compatibility of the characteristics of the database winds with those from high-resolution radiosondes. The result is a high-resolution database of zonal, meridional and vertical wind, temperature, specific humidity and particle and molecular backscatter and extinction at 355 nm laser wavelength. This allows the simulation of small-scale atmospheric processes within the Aeolus observation sampling volume and their impact on the quality of the retrieved HLOS wind profiles. The database extends over four months covering all seasons. This allows a statistical evaluation of the mission components under investigation. The database is currently used for the development of the Aeolus wind processing, the definition of wind calibration strategies and the optimization of the Aeolus sampling strategy.


Diagnostics ◽  
2021 ◽  
Vol 11 (4) ◽  
pp. 658
Author(s):  
Federico Corvi ◽  
Federico Zicarelli ◽  
Matteo Airaldi ◽  
Salvatore Parrulli ◽  
Mariano Cozzi ◽  
...  

Background: To compare four different optical coherence tomography (OCT) devices for visualization of retinal and subretinal layers in highly myopic eyes. Methods: In this prospective, observational, cross-sectional study, consecutive patients with high myopia and control subjects were imaged by four OCT devices: Spectralis OCT2, PlexElite 2.0 100 kHz, PlexElite 2.0 200 kHz and the Canon Xephilio OCT-S1. The acquisition protocol for comparison consisted of single vertical and horizontal line scans centered on the fovea. Comparison between the devices in the extent of visible retina, presence of conjugate image or mirror artifacts, visibility of the sclerochoroidal interface and retrobulbar tissue. Results: 30 eyes with high myopia and 30 control subjects were analyzed. The visualized RPE length was significantly different between the OCT devices with Xephilio OCT-S1 imaging the largest extent (p < 0.0001). The proportion of eyes with conjugate image artifact was significantly higher with the Spectralis OCT (p < 0.0001), and lower with the PlexElite 200 kHz (p < 0.0001). No difference in visibility of the sclerochoroidal interface was noted among instruments. The retrobulbar tissue was visible in a higher proportion of eyes using swept-source PlexElite 100 kHz and 200 kHz (p < 0.007) compared to the other devices. Conclusions: In highly myopic eyes, the four OCT devices demonstrated significant differences in the extent of the retina imaged, in the prevalence of conjugate image artifact, and in the visualization of the retrobulbar tissue.


Geophysics ◽  
1955 ◽  
Vol 20 (3) ◽  
pp. 539-564 ◽  
Author(s):  
J. O. Parr ◽  
W. H. Mayne

In areas where reflection shooting is difficult, it is often necessary to attenuate the energy in a broad continuous band of disturbing wavelengths to less than a few hundredths of what would be recorded if all units were bunched together. The wavelength band of the attenuated energy should be adjacent to the band of reflection wavelengths received. Attenuation of the undesired energy is best accomplished with multiple detectors or charges. In many areas the pattern should attenuate energy horizontally propagated in all directions, not just in the direction of the detector line. Neither a finite number of uniformly effective, uniformly spaced units in line nor a uniformly effective sheet of finite length will accomplish this result. A system for gradation of the effectiveness of units described in this paper does produce this result (not only for in‐line disturbances but also for disturbances coming in from the side of the line). The attenuation band can be made broad with good attenuation or narrower with still better attenuation, as desired. The variation of effectiveness can be applied to detectors or charges arranged in a horizontal line, over a horizontal area, in a vertical line, or over a vertical area. The principle of varying effectiveness can also be applied to reversed‐polarity detectors in order to accentuate certain apparent wavelengths.


Sensors ◽  
2018 ◽  
Vol 18 (10) ◽  
pp. 3462 ◽  
Author(s):  
Chunyu Qiu ◽  
Shuqing Ma ◽  
Yu Chen ◽  
Zhou Meng ◽  
Jianfei Wang

A method is developed in this paper to calculate the spatial gain of a vertical line array when the plane-wave assumption is not applicable and when the oceanic ambient noise is correlated. The proposed optimal array gain (OAG), which can evaluate the array’s performance and effectively guide its deployment, can be given by an equation in which the noise gain (NG) is subtracted from the signal gain (SG); hence, a high SG and a negative NG can enhance the performance of the array. OAGs and SGs with different array locations are simulated and analyzed based on the sound propagation properties of the direct-arrival zone (DAZ) and the reliable acoustic path (RAP) using ray theory. SG and NG are related to the correlation coefficients of the signals and noise, respectively, and the vertical correlation is determined by the structures of the multipath arrivals. The SG in the DAZ is always high because there is little difference between the multipath waves, while the SG in the RAP changes with the source-receiver range because of the variety of structure in the multiple arrivals. The SG under different conditions is simulated in this work. The “dual peak” structure can often be observed in the vertical directionality pattern of the noise because of the presence of bottom reflection and deep sound channel. When the directions of the signal and noise are close, the conventional beamformer will enhance the correlation of not only the signals but also the noise; thus, the directivity of the signals and noise are analyzed. Under the condition of having a typical sound speed profile, the OAG in some areas of the DAZ and RAP can achieve high values and even exceed the ideal gain of horizontal line array 10 logN dB, while, in some other areas, it will be lowered because of the influence of the NG. The proposed method of gain analysis can provide analysis methods for vertical arrays in the deep ocean under many conditions with references. The theory and simulation are tested by experimental data.


Sign in / Sign up

Export Citation Format

Share Document