Effects of experimental conditions on the growth of g-C3N4 nanocones by plasma sputtering reaction deposition

2021 ◽  
Author(s):  
Yanan Wei ◽  
Pengxiang Du ◽  
Yu Liu ◽  
Jian Sun ◽  
Zhifeng Ying ◽  
...  
Keyword(s):  
Experimental Conditions ◽  
Plasma Sputtering

Synthesis and Control of Nano-Scale CN Particles and its Distributions

2006 ◽  
Vol 942 ◽  
Author(s):  
Peter x. Feng ◽  
Y. C. Shi
Keyword(s):  
Small Groups ◽  
Carbon Nitride ◽  
Experimental Conditions ◽  
Sputtering Deposition ◽  
Nanoscale Particles ◽  
Particle Distributions ◽  
Nano Scale ◽  
Plasma Sputtering ◽  
And Control ◽  
Deposition Conditions

ABSTRACTMicro-scale to nano-scale carbon nitride (CN) particles were prepared by using plasma sputtering deposition technique. The preferred orientation of nanoscale CN particle distributions was obtained. Particles have been examined by using both Scanning Electron Microscopy (SEM) and Raman scattering (RS) spectroscopy. Setting bias voltage up to 5 kV, plasma-sputtering deposition gave rise to several ring (diameters: 2.4, 3.2, and 4.4 mm) patterns of particle distributions where many small groups of nanoscale particles were observed. Each group of these particles appeared in a sunflower type of distribution, in which the biggest (85 nm) particle at the center was surrounded by many small sizes (30 nm) of CN particles. Disk type of the particles with a diameter of 10 μm was also observed at different experimental conditions. Typical G, D bands and C=N band in the Raman spectra of the samples were identified. The intensity of the D bands obviously varied at the different deposition conditions.

Electrolytic Isolation of Twin-Type Shock Deformation Structures

1967 ◽  
Vol 25 ◽  
pp. 318-319
Author(s):  
F. I. Grace ◽  
L. E. Murr
Keyword(s):  
Grain Boundaries ◽  
Thin Foil ◽  
Electrolyte Composition ◽  
Experimental Conditions ◽  
Average Current Density ◽  
Electron Transmission ◽  
Deformation Structures ◽  
The Matrix ◽  
Average Current ◽  
Specimen Edge

During the course of electron transmission investigations of the deformation structures associated with shock-loaded thin foil specimens of 70/30 brass, it was observed that in a number of instances preferential etching occurred along grain boundaries; and that the degree of etching appeared to depend upon the various experimental conditions prevailing during electropolishing. These included the electrolyte composition, the average current density, and the temperature in the vicinity of the specimen. In the specific case of 70/30 brass shock-loaded at pressures in the range 200-400 kilobars, the predominant mode of deformation was observed to be twin-type faults which in several cases exhibited preferential etching similar to that observed along grain boundaries. A novel feature of this particular phenomenon was that in certain cases, especially for twins located in the vicinity of the specimen edge, the etching or preferential electropolishing literally isolated these structures from the matrix.

Site of Lysosome Production During Hepatic Injury

1969 ◽  
Vol 27 ◽  
pp. 348-349
Author(s):  
Nalin J. Unakar
Keyword(s):  
Electron Microscopy ◽  
Golgi Apparatus ◽  
Mouse Liver ◽  
Hepatic Injury ◽  
Close Approximation ◽  
Experimental Conditions ◽  
Toxic Injury

The increased number of lysosomes as well as the close approximation of lysosomes to the Golgi apparatus in tissue under variety of experimental conditions is commonly observed. These observations suggest Golgi involvement in lysosomal production. The role of the Golgi apparatus in the production of lysosomes in mouse liver was studied by electron microscopy of liver following toxic injury by CCI4.

Characterization of Sputtered Films using the Scanning Electron Microscope

1973 ◽  
Vol 31 ◽  
pp. 44-45
Author(s):  
R. F. Schneidmiller ◽  
W. F. Thrower ◽  
C. Ang
Keyword(s):  
Electron Microscope ◽  
Scanning Electron Microscope ◽  
Thin Film Deposition ◽  
Film Deposition ◽  
Sputtered Films ◽  
Plasma Sputtering ◽  
Microelectronic Devices ◽  
Control Film ◽  
Scanning Electron

Solid state materials in the form of thin films have found increasing structural and electronic applications. Among the multitude of thin film deposition techniques, the radio frequency induced plasma sputtering has gained considerable utilization in recent years through advances in equipment design and process improvement, as well as the discovery of the versatility of the process to control film properties. In our laboratory we have used the scanning electron microscope extensively in the direct and indirect characterization of sputtered films for correlation with their physical and electrical properties.Scanning electron microscopy is a powerful tool for the examination of surfaces of solids and for the failure analysis of structural components and microelectronic devices.

Optimizing conditions for x-ray microchemical analysis in analytical electron microscopy

1978 ◽  
Vol 36 (1) ◽  
pp. 548-549 ◽  
Author(s):  
N. J. Zaluzec
Keyword(s):  
Solid Angle ◽  
Analytical Electron Microscopy ◽  
Incident Beam ◽  
Thin Foil ◽  
Experimental Conditions ◽  
X Ray ◽  
Microchemical Analysis ◽  
Analytical Electron ◽  
Image Position ◽  
Incident Beam Energy

The ultimate sensitivity of microchemical analysis using x-ray emission rests in selecting those experimental conditions which will maximize the measured peak-to-background (P/B) ratio. This paper presents the results of calculations aimed at determining the influence of incident beam energy, detector/specimen geometry and specimen composition on the P/B ratio for ideally thin samples (i.e., the effects of scattering and absorption are considered negligible). As such it is assumed that the complications resulting from system peaks, bremsstrahlung fluorescence, electron tails and specimen contamination have been eliminated and that one needs only to consider the physics of the generation/emission process.The number of characteristic x-ray photons (Ip) emitted from a thin foil of thickness dt into the solid angle dΩ is given by the well-known equation

SEM analysis of the change in the reaction rates with deposit structures in the copper-iron cementation system

1978 ◽  
Vol 36 (1) ◽  
pp. 456-457
Author(s):  
V. Annamalai ◽  
L.E. Murr
Keyword(s):  
Structural Characteristics ◽  
Secondary Electron Emission ◽  
Copper Deposit ◽  
Reaction Rates ◽  
Sem Analysis ◽  
Experimental Conditions ◽  
Major Drawback ◽  
Emission Mode ◽  
Scrap Iron ◽  
Image Position

Economical recovery of copper metal from leach liquors has been carried out by the simple process of cementing copper onto a suitable substrate metal, such as scrap-iron, since the 16th century. The process has, however, a major drawback of consuming more iron than stoichiometrically needed by the reaction.Therefore, many research groups started looking into the process more closely. Though it is accepted that the structural characteristics of the resultant copper deposit cause changes in reaction rates for various experimental conditions, not many systems have been systematically investigated. This paper examines the deposit structures and the kinetic data, and explains the correlations between them.A simple cementation cell along with rotating discs of pure iron (99.9%) were employed in this study to obtain the kinetic results The resultant copper deposits were studied in a Hitachi Perkin-Elmer HHS-2R scanning electron microscope operated at 25kV in the secondary electron emission mode.

Relative Intensities in ED Patterns From Thin Gold Films

1972 ◽  
Vol 30 ◽  
pp. 636-637
Author(s):  
R. H. Morriss ◽  
J. D. C. Peng ◽  
C. D. Melvin
Keyword(s):  
Theoretical Calculations ◽  
Diffraction Theory ◽  
Gold Films ◽  
Reasonable Accuracy ◽  
Experimental Conditions ◽  
Crystal Perfection ◽  
Heavy Atoms ◽  
Fine Focus ◽  
Convergent Beam ◽  
Beam Diffraction

Although dynamical diffraction theory was modified for electrons by Bethe in 1928, relatively few calculations have been carried out because of computational difficulties. Even fewer attempts have been made to correlate experimental data with theoretical calculations. The experimental conditions are indeed stringent - not only is a knowledge of crystal perfection, morphology, and orientation necessary, but other factors such as specimen contamination are important and must be carefully controlled. The experimental method of fine-focus convergent-beam electron diffraction has been successfully applied by Goodman and Lehmpfuhl to single crystals of MgO containing light atoms and more recently by Lynch to single crystalline (111) gold films which contain heavy atoms. In both experiments intensity distributions were calculated using the multislice method of n-beam diffraction theory. In order to obtain reasonable accuracy Lynch found it necessary to include 139 beams in the calculations for gold with all but 43 corresponding to beams out of the [111] zone.

Control of Autogenous Vein Grafts Prior to Reimplantation, By Electron Microscopy

1972 ◽  
Vol 30 ◽  
pp. 106-107
Author(s):  
John H. L. Watson ◽  
John L. Swedo ◽  
M. Vrandecic
Keyword(s):  
Electron Microscopy ◽  
Light And Electron Microscopy ◽  
Physiological Saline ◽  
Experimental Conditions ◽  
Vein Grafts ◽  
Arterial Blood ◽  
Saphenous Veins ◽  
Autogenous Vein ◽  
Control Of Parameters ◽  
Post Implantation

The ambient temperature and the nature of the storage fluids may well have significant effects upon the post-implantation behavior of venus autografts. A first step in the investigation of such effects is reported here. Experimental conditions have been set which approximate actual operating room procedures. Saphenous veins from dogs have been used as models in the experiments. After removal from the dogs the veins were kept for two hours under four different experimental conditions, viz at either 4°C or 23°C in either physiological saline or whole canine arterial blood. At the end of the two hours they were prepared for light and electron microscopy. Since no obvious changes or damage could be seen in the veins by light microscopy, even with the advantage of tissue specific stains, it was essential that the control of parameters for successful grafts be set by electron microscopy.

A comparative study on the cold type and thermal type field emission guns used in the same electron microscope

1978 ◽  
Vol 36 (1) ◽  
pp. 58-59
Author(s):  
M. Iwatsuki ◽  
Y. Kokubo ◽  
Y. Harada
Keyword(s):  
Electron Microscope ◽  
Field Emission ◽  
Signal To Noise Ratio ◽  
Electron Source ◽  
Resolving Power ◽  
Optical Source ◽  
Experimental Conditions ◽  
High Brightness ◽  
Illumination System ◽  
Transmission Electron

On accout of its high brightness, small optical source size, and minimal energy spread, the field emission gun (FEG) has the advantage that it provides the conventional transmission electron microscope (TEM) with a highly coherent illumination system and directly improves the resolving power and signal-to-noise ratio of the scanning electron microscope (SEM). The FEG is generally classified into two types; the cold field emission (C-FEG) and thermal field emission gun (T-FEG). The former, in which a field emitter is used at the room temperature, was successfully developed as an electron source for the SEM. The latter, in which the emitter is heated to the temperature range of 1000-1800°K, was also proved to be very suited as an electron source for the TEM, as well as for the SEM. Some characteristics of the two types of the FEG have been studied and reported by many authors. However, the results of the respective types have been obtained separately under different experimental conditions.

Structural and functional renal alterations in five-sixth nephrectomized rats on unrestricted diet

1986 ◽  
Vol 44 ◽  
pp. 342-343
Author(s):  
I. Stachura ◽  
M. Pardo ◽  
J. Costello ◽  
D.M. Landwehr
Keyword(s):  
Wistar Rats ◽  
Renal Damage ◽  
Standard Diet ◽  
Experimental Conditions ◽  
Phosphate Intake ◽  
Dietary Restrictions ◽  
Severe Reduction ◽  
Male Wistar Rats ◽  
Unrestricted Diet ◽  
Progressive Renal Insufficiency

Under experimental conditions severe reduction of renal mass results in the hyperfiltration of the remaining nephrons leading to a progressive renal insufficiency. Similar changes are observed in patients with various renal disorders associated with a loss of the functioning nephrons. The progression of renal damage is accelerated by high protein and phosphate intake, and may be modified by the dietary restrictions.We studied 50 five-sixth nephrectarrized male Wistar rats on a standard diet (Rodent Laboratory Chow 5001 Ralston Purina Co., Richmond, Indiana; containing 23.4% protein) over a 20 week period.

Sign in / Sign up

Export Citation Format

Share Document