Elemental composition of Na pump inhibited rabbit aorta VSM cells by electron probe X-ray microanalysis

1996 ◽  
Vol 271 (2) ◽  
pp. H514-H520
Author(s):  
H. Krep ◽  
A. Lefurgey ◽  
S. W. Graves ◽  
D. Hockett ◽  
P. Ingram ◽  
...  
Keyword(s):  
Electron Probe ◽  
Contractile Response ◽  
Rabbit Aorta ◽  
Charge Redistribution ◽  
X Ray ◽  
Na Pump ◽  
Elemental Profile ◽  
High K ◽  
Intracellular Milieu ◽  
Insight Into

The Na pump in vascular smooth muscle (VSM) is likely to influence not only intracellular Na content but also the content and distribution of other cations and anions measured by electron probe X-ray microanalysis (EPXMA). The hypothesis we tested was that EPXMA of pump-inhibited VSM would yield a characteristic cellular elemental profile, providing insight into the contribution of the Na pump to the intracellular milieu and an approach to identifying when VSM operates under the constraints of pump inhibition. We assessed the contractile state and elemental EPXMA profile of rabbit aorta that was either quiescent or contracted by serotonin (10(-6) M) or ouabain (10(-6) M). VSM cytoplasm showed the anticipated low Na (28 +/- 2 mM) and high K (182 +/- 5 mM) content. With ouabain, Na rose and K fell to reverse the Na-to-K ratio (0.15 +/- 0.01 vs. 6.6 +/- 0.3; P < 0.01). With serotonin, the ratio rose slightly (0.28 +/- 0.2; P < 0.05). Nuclei and mitochondria showed a similar pattern. CI showed a small increase (56 +/- 2 to 102 +/- 4 mM) with ouabain, a shift that could not be accounted for on the basis of charge redistribution to maintain neutrality because the change in Na and K were essentially offsetting. EPXMA measures total and not ionized Ca. If changes in cytoplasmic Ca occurred, they were too small to be measured by the imaging methods employed. The sustained, myogenic contractile response of VSM to Na pump inhibition shows a characteristic elemental profile that could prove useful in its identification. Direct measurement of membrane potential during the myogenic response to Na pump inhibition should have a high priority.

Quantitating Calcium in Biological Specimens by Direct Fittingof X-ray Spectra

2001 ◽  
Vol 7 (S2) ◽  
pp. 994-995
Author(s):  
R. Ho ◽  
Z. Jia ◽  
A.P. Somlyo ◽  
Z. Shao
Keyword(s):  
Traditional Method ◽  
Electron Probe ◽  
Small Error ◽  
Biological Research ◽  
Linear Least Squares ◽  
Additional Error ◽  
X Ray ◽  
Fitting Procedure ◽  
High K ◽  
Least Squares Fit

Electron probe microanalysis has been a useful method for biological research for some years. Its advantages include the low background of x-ray spectra and range to include characteristic peaks of most biological elements. The traditional method of analyzing biological X-ray spectra filtering both the experimental and reference spectra with a top-hat filter, before performing a linear least squares fit, to remove the slowly varying background. We show that, as expected, this procedure introduces an additional error in the quantitation results, and reduces the sensitivity and precision of this method. Our experience with quantitating trace elements with EELS shows that direct fit of unfiltered spectra yields the highest sensitivity, when the data contain only statistical errors. Biological specimens usually contain high K and low Ca, and in X-ray spectra the K Kβ peak is overlapped with the Ca Kα peak. A small error in extracting the K signal will dramatically affect the quantitation of Ca. We demonstrate here the application of a direct fitting procedure, which focuses on the Ca and K region of the X-ray spectra (2800 ∼ 4900 eV), and yields smaller fitting uncertainties compared to the traditional filtered fit method in trace Ca quantitation.

Improvements in the electron probe forming capabilities and x-ray hole counts in the Philips TEM

1983 ◽  
Vol 41 ◽  
pp. 376-377
Author(s):  
Richard L. McConville
Keyword(s):  
Field Strength ◽  
Electron Probe ◽  
Spherical Aberration ◽  
Focal Length ◽  
Objective Lens ◽  
Parallel Beam ◽  
Tilt Axis ◽  
X Ray ◽  
Small Probe ◽  
Specimen Height

A second generation twin lens has been developed. This symmetrical lens with a wider bore, yet superior values of chromatic and spherical aberration for a given focal length, retains both eucentric ± 60° tilt movement and 20°x ray detector take-off angle at 90° to the tilt axis. Adjust able tilt axis height, as well as specimen height, now ensures almost invariant objective lens strengths for both TEM (parallel beam conditions) and STEM or nano probe (focused small probe) modes.These modes are selected through use of an auxiliary lens situ ated above the objective. When this lens is on the specimen is illuminated with a parallel beam of electrons, and when it is off the specimen is illuminated with a focused probe of dimensions governed by the excitation of the condenser 1 lens. Thus TEM/STEM operation is controlled by a lens which is independent of the objective lens field strength.

Spatial resolution of X-ray microanalysis in thin foils

1978 ◽  
Vol 36 (1) ◽  
pp. 544-545
Author(s):  
R. Hutchings ◽  
I.P. Jones ◽  
M.H. Loretto ◽  
R.E. Smallman
Keyword(s):  
Spatial Resolution ◽  
Electron Probe ◽  
Beam Divergence ◽  
Inelastic Interaction ◽  
Specimen Thickness ◽  
High Current ◽  
Beam Spreading ◽  
X Ray ◽  
Thin Foils ◽  
Complex Calculation

There is increasing interest in X-ray microanalysis of thin specimens and the present paper attempts to define some of the factors which govern the spatial resolution of this type of microanalysis. One of these factors is the spreading of the electron probe as it is transmitted through the specimen. There will always be some beam-spreading with small electron probes, because of the inevitable beam divergence associated with small, high current probes; a lower limit to the spatial resolution is thus 2αst where 2αs is the beam divergence and t the specimen thickness.In addition there will of course be beam spreading caused by elastic and inelastic interaction between the electron beam and the specimen. The angle through which electrons are scattered by the various scattering processes can vary from zero to 180° and it is clearly a very complex calculation to determine the effective size of the beam as it propagates through the specimen.

Electron Probe Analysis of Vertebrate Smooth Muscle: Distribution of Ca and Ci

1976 ◽  
Vol 34 ◽  
pp. 334-335 ◽  
Author(s):  
Avril V. Somlyo ◽  
H. Shuman ◽  
A.P. Somlyo
Keyword(s):  
Smooth Muscle ◽  
Electron Probe ◽  
Preliminary Report ◽  
Cell Damage ◽  
Electron Probe Analysis ◽  
Perinuclear Space ◽  
Probe Analysis ◽  
High K ◽  
Low K ◽  
Initial Results

This is a preliminary report of electron probe analysis of rabbit portal-anterior mesenteric vein (PAMV) smooth muscle cryosectioned without fixation or cryoprotection. The instrumentation and method of electron probe quantitation used (1) and our initial results with cardiac (2) and skeletal (3) muscle have been presented elsewhere.In preparations depolarized with high K (K2SO4) solution, significant calcium peaks were detected over the sarcoplasmic reticulum (Fig 1 and 2) and the continuous perinuclear space. In some of the fibers there were also significant (up to 200 mM/kg dry wt) calcium peaks over the mitochondria. However, in smooth muscle that was not depolarized, high mitochondrial Ca was found in fibers that also contained elevated Na and low K (Fig 3). Therefore, the possibility that these Ca-loaded mitochondria are indicative of cell damage remains to be ruled out.

High spatial resolution x-ray microanalysis of interfaces

1995 ◽  
Vol 53 ◽  
pp. 284-285
Author(s):  
J. R. Michael
Keyword(s):  
Spatial Resolution ◽  
Electron Probe ◽  
Solid Angle ◽  
Collection Efficiency ◽  
Spatial Scales ◽  
Energy Dispersive Spectrometer ◽  
X Rays ◽  
X Ray ◽  
Probe Size ◽  
Brightness Field

X-ray microanalysis in the analytical electron microscope (AEM) refers to a technique by which chemical composition can be determined on spatial scales of less than 10 nm. There are many factors that influence the quality of x-ray microanalysis. The minimum probe size with sufficient current for microanalysis that can be generated determines the ultimate spatial resolution of each individual microanalysis. However, it is also necessary to collect efficiently the x-rays generated. Modern high brightness field emission gun equipped AEMs can now generate probes that are less than 1 nm in diameter with high probe currents. Improving the x-ray collection solid angle of the solid state energy dispersive spectrometer (EDS) results in more efficient collection of x-ray generated by the interaction of the electron probe with the specimen, thus reducing the minimum detectability limit. The combination of decreased interaction volume due to smaller electron probe size and the increased collection efficiency due to larger solid angle of x-ray collection should enhance our ability to study interfacial segregation.

Microchemical imaging in biomedical research

1992 ◽  
Vol 50 (2) ◽  
pp. 1118-1119
Author(s):  
P. Ingram
Keyword(s):  
Data Analysis ◽  
Electron Probe ◽  
The Other ◽  
X Ray ◽  
Cell Element ◽  
Physiological Information ◽  
Functional States ◽  
Elemental Maps ◽  
Electron Energy Loss ◽  
Secondary Ion

It is well established that unique physiological information can be obtained by rapidly freezing cells in various functional states and analyzing the cell element content and distribution by electron probe x-ray microanalysis. (The other techniques of microanalysis that are amenable to imaging, such as electron energy loss spectroscopy, secondary ion mass spectroscopy, particle induced x-ray emission etc., are not addressed in this tutorial.) However, the usual processes of data acquisition are labor intensive and lengthy, requiring that x-ray counts be collected from individually selected regions of each cell in question and that data analysis be performed subsequent to data collection. A judicious combination of quantitative elemental maps and static raster probes adds not only an additional overall perception of what is occurring during a particular biological manipulation or event, but substantially increases data productivity. Recent advances in microcomputer instrumentation and software have made readily feasible the acquisition and processing of digital quantitative x-ray maps of one to several cells.

Quantitative Analysis Of X-Ray Images From Geological Materials

1990 ◽  
Vol 48 (2) ◽  
pp. 244-245
Author(s):  
J. M. Paque ◽  
R. Browning ◽  
P. L. King ◽  
P. Pianetta
Keyword(s):  
Quantitative Analysis ◽  
Bulk Composition ◽  
Principal Component ◽  
Analytical Description ◽  
Bulk Sample ◽  
Geological Samples ◽  
X Ray ◽  
Software And Hardware ◽  
And Storage ◽  
Insight Into

Geological samples typically contain many minerals (phases) with multiple element compositions. A complete analytical description should give the number of phases present, the volume occupied by each phase in the bulk sample, the average and range of composition of each phase, and the bulk composition of the sample. A practical approach to providing such a complete description is from quantitative analysis of multi-elemental x-ray images.With the advances in recent years in the speed and storage capabilities of laboratory computers, large quantities of data can be efficiently manipulated. Commercial software and hardware presently available allow simultaneous collection of multiple x-ray images from a sample (up to 16 for the Kevex Delta system). Thus, high resolution x-ray images of the majority of the detectable elements in a sample can be collected. The use of statistical techniques, including principal component analysis (PCA), can provide insight into mineral phase composition and the distribution of minerals within a sample.

Reduction of Potassium in Kidney Proximal Tubules to Aid in Electron Probe X-Ray Microanalysis of Calcium

1985 ◽  
Vol 43 ◽  
pp. 474-475
Author(s):  
A. LeFurgey ◽  
P. Ingram ◽  
L.J. Mandel
Keyword(s):  
Smooth Muscle ◽  
Proximal Tubule ◽  
Electron Probe ◽  
Clinical Applications ◽  
Proximal Tubules ◽  
Rabbit Kidney ◽  
Target Cells ◽  
X Ray ◽  
Freeze Dried

For quantitative determination of subcellular Ca distribution by electron probe x-ray microanalysis, decreasing (and/or eliminating) the K content of the cell maximizes the ability to accurately separate the overlapping K Kß and Ca Kα peaks in the x-ray spectra. For example, rubidium has been effectively substituted for potassium in smooth muscle cells, thus giving an improvement in calcium measurements. Ouabain, a cardiac glycoside widely used in experimental and clinical applications, inhibits Na-K ATPase at the cell membrane and thus alters the cytoplasmic ion (Na,K) content of target cells. In epithelial cells primarily involved in active transport, such as the proximal tubule of the rabbit kidney, ouabain rapidly (t1/2= 2 mins) causes a decrease2 in intracellular K, but does not change intracellular total or free Ca for up to 30 mins. In the present study we have taken advantage of this effect of ouabain to determine the mitochondrial and cytoplasmic Ca content in freeze-dried cryosections of kidney proximal tubule by electron probe x-ray microanalysis.

Copper–oxygen Dynamics in Tyrosinase

2019 ◽  
Author(s):  
Nobutaka Fujieda ◽  
Sachiko Yanagisawa ◽  
Minoru Kubo ◽  
Genji Kurisu ◽  
Shinobu Itoh
Keyword(s):  
Catalytic Mechanism ◽  
Substrate Binding ◽  
Active Form ◽  
Copper Ion ◽  
Atomic Resolution ◽  
Oxygen Species ◽  
X Ray ◽  
Oxygen Dynamics ◽  
Insight Into ◽  
Copper Centre

To unveil the activation of dioxygen on the copper centre (Cu<sub>2</sub>O<sub>2</sub>core) of tyrosinase, we performed X-ray crystallograpy with active-form tyrosinase at near atomic resolution. This study provided a novel insight into the catalytic mechanism of the tyrosinase, including the rearrangement of copper-oxygen species as well as the intramolecular migration of copper ion induced by substrate-binding.<br>

Sign in / Sign up

Export Citation Format

Share Document