Characterization of two ‘mitochondrial’ particulates from rat brain

1960 ◽  
Vol 198 (2) ◽  
pp. 467-470 ◽  
Author(s):  
Dennis R. Dahl ◽  
Roberta J. Jacobs ◽  
Frederick E. Samson
Keyword(s):  
Rat Brain ◽  
Tricarboxylic Acid Cycle ◽  
Chemical Properties ◽  
Oxidative Capacity ◽  
Brain Mitochondria ◽  
P Fraction ◽  
Tricarboxylic Acid Cycle Intermediates ◽  
Physical And Chemical ◽  
The Brain

Two particulate fractions were isolated from a preparation of rat brain mitochondria and some of the physical and chemical properties were studied. The distinguishing physical difference was the color; the heavier, more densely packed particles (P) were dark, while the lighter, loosely packed particles (W) were almost white. The amount of (P) and (W) are approximately equal. P has a higher concentration of protein than W but the nucleic acid (RNA and DNA) concentration is about the same. The per cent water of W is slightly greater than P. The P fraction was capable of oxidative-phosphorylation with several tricarboxylic acid cycle intermediates but W had no oxidative capacity. P appears to undergo the typical ‘swelling’ of mitochondria whereas W does not. P and W both increase in amount with the neonatal maturation of the brain.

scholarly journals Regulation of pyruvate metabolism via pyruvate carboxylase in rat brain mitochondria

1973 ◽  
Vol 132 (2) ◽  
pp. 185-192 ◽  
Author(s):  
Mulchand S. Patel ◽  
Shirley M. Tilghman
Keyword(s):  
Rat Brain ◽  
Pyruvate Carboxylase ◽  
Inorganic Phosphate ◽  
Citrate Synthase ◽  
Tricarboxylic Acid Cycle ◽  
Brain Mitochondria ◽  
Tricarboxylic Acid ◽  
Pyruvate Metabolism ◽  
Rat Brain Mitochondria ◽  
Tricarboxylic Acid Cycle Intermediates

1. The fixation of CO2 by pyruvate carboxylase in isolated rat brain mitochondria was investigated. 2. In the presence of pyruvate, ATP, inorganic phosphate and magnesium, rat brain mitochondria fixed H14CO3- into tricarboxylic acid-cycle intermediates at a rate of about 250nmol/30min per mg of protein. 3. Citrate and malate were the main radioactive products with citrate containing most of the radioactivity fixed. The observed rates of H14CO3- fixation and citrate formation correlated with the measured activities of pyruvate carboxylase and citrate synthase in the mitochondria. 4. The carboxylation of pyruvate by the mitochondria had an apparent Km for pyruvate of about 0.5mm. 5. Pyruvate carboxylation was inhibited by ADP and dinitrophenol. 6. Malate, succinate, fumarate and oxaloacetate inhibited the carboxylation of pyruvate whereas glutamate stimulated it. 7. The results suggest that the metabolism of pyruvate via pyruvate carboxylase in brain mitochondria is regulated, in part, by the intramitochondrial concentrations of pyruvate, oxaloacetate and the ATP:ADP ratio.

scholarly journals Recent Progress in the Synthesis and Characterization of Diarylethene-based MOFs

2014 ◽  
Vol 70 (a1) ◽  
pp. C1223-C1223
Author(s):  
Jason Benedict ◽  
Ian Walton ◽  
Dan Patel ◽  
Jordan Cox
Keyword(s):  
Chemical Properties ◽  
Building Blocks ◽  
Synthesis And Characterization ◽  
Next Generation ◽  
Design Synthesis ◽  
Thermally Induced ◽  
Potential Applications ◽  
External Stimuli ◽  
Physical And Chemical

Metal-organic Frameworks (MOFs) remain an extremely active area of research given the wide variety of potential applications and the enormous diversity of structures that can be created from their constituent building blocks. While MOFs are typically employed as passive materials, next-generation materials will exhibit structural and/or electronic changes in response to applied external stimuli including light, charge, and pH. Herein we present recent results in which advanced photochromic diarylethenes are combined with MOFs through covalent and non-covalent methods to create photo-responsive permanently porous crystalline materials. This presentation will describe the design, synthesis, and characterization of next-generation photo-switchable diarylethene based ligands which are subsequently used to photo-responsive MOFs. These UBMOF crystals are, by design, isostructural with previously reported non-photoresponsive frameworks which enables a systematic comparison of their physical and chemical properties. While the photoswitching of the isolated ligand in solution is fully reversible, the cycloreversion reaction is suppressed in the UBMOF single crystalline phase. Spectroscopic evidence for thermally induced cycloreversion will be presented, as well as a detailed analysis addressing the limits of X-ray diffraction techniques applied to these systems.

scholarly journals AVALIAÇÃO DA ESTRUTURA ELETRÔNICA DA FASE MONOCLINICA DO ÓXIDO DE NIÓBIO COM BASE NO USO DE DIFERENTES FUNCIONAIS DE DENSIDADE

Química Nova ◽  
2021 ◽  
Author(s):  
Kamila Ody ◽  
João Jesus ◽  
Carlos Cava ◽  
Anderson Albuquerque ◽  
Ary Maia ◽  
...  
Keyword(s):  
Density Functional ◽  
Chemical Properties ◽  
Physical And Chemical Properties ◽  
Density Functionals ◽  
Monoclinic Structure ◽  
Functional Theory ◽  
Periodic Models ◽  
Physical And Chemical ◽  
And Chemical Properties

ASSESSMENT OF THE ELECTRONIC STRUCTURE OF THE MONOCLINIC PHASE OF NIOBIUM OXIDE BASED ON THE USE OF DIFFERENT DENSITY FUNCTIONALS. Niobium oxides, Nb2O5, are considered semiconductor materials with very attractive physical and chemical properties for applications in many areas, such as catalysis, sensors, medical, aerospace, etc. Especially, the characterization of Nb2O5-based nanostructures with monoclinic structure has received much attention in recent years. However, despite the great importance of this system, some of its fundamentals properties are still not fully understood. Hence, this work aims to apply the theoretical methodologies through Density Functional Theory (DFT) calculations in periodic models based on the use of different density functionals (like B1WC, B3PW, B3LYP, PBE0, PBESOL0, SOGGAXC, and WC1LYP) to investigate the physical and chemical properties of the monoclinic structure of Nb2O5. The band structures, energy bandgap, density of state, and vibrational properties, as well as order-disorder effects on the monoclinic structure of Nb2O5 are investigated in this study. Our theoretical results show a better agreement with experimental data for the B3LYP functional and hence lead to new perspectives on the deeper physicochemical understanding of the monoclinic Nb2O5. From these computational tools, it is possible to unravel the relations between structure and properties, which may contribute to the future development of new devices and applications based on these materials.

scholarly journals The role of ADP in the modulation of the calcium-efflux pathway in rat brain mitochondria

1985 ◽  
Vol 225 (1) ◽  
pp. 41-49 ◽  
Author(s):  
J Vitorica ◽  
J Satrústegui
Keyword(s):  
Rat Brain ◽  
Binding Sites ◽  
Tricarboxylic Acid Cycle ◽  
Brain Mitochondria ◽  
Ruthenium Red ◽  
Calcium Efflux ◽  
Rat Brain Mitochondria ◽  
Pi Complex ◽  
Efflux Pathway

The role of ADP in the regulation of Ca2+ efflux in rat brain mitochondria was investigated. ADP was shown to inhibit Ruthenium-Red-insensitive H+- and Na+-dependent Ca2+-efflux rates if Pi was present, but had no effect in the absence of Pi. The primary effect of ADP is an inhibition of Pi efflux, and therefore it allows the formation of a matrix Ca2+-Pi complex at concentrations above 0.2 mM-Pi and 25 nmol of Ca2+/mg of protein, which maintains a constant free matrix Ca2+ concentration. ADP inhibition of Pi and Ca2+ efflux is nucleotide-specific, since in the presence of oligomycin and an inhibitor of adenylate kinase ATP does not substitute for ADP, is dependent on the amount of ADP present, and requires ADP concentrations in excess of the concentrations of translocase binding sites. Brain mitochondria incubated with 0.2 mM-Pi and ADP showed Ca2+-efflux rates dependent on Ca2+ loads at Ca2+ concentrations below those required for the formation of a Pi-Ca2+ complex, and behaved as perfect cytosolic buffers exclusively at high Ca2+ loads. The possible role of brain mitochondrial Ca2+ in the regulation of the tricarboxylic acid-cycle enzymes and in buffering cytosolic Ca2+ is discussed.

scholarly journals Characterization of gelatins from Nile tilapia skins preserved by freezing and salting

2019 ◽  
Vol 40 (6) ◽  
pp. 2581
Author(s):  
Adriana Cristina Bordignon ◽  
Maria Luiza Rodrigues de Souza ◽  
Eliane Gasparino ◽  
Edson Minoru Yajima ◽  
Jesuí Vergílio Visentainer ◽  
...  
Keyword(s):  
Fatty Acids ◽  
Nile Tilapia ◽  
Saturated Fatty Acids ◽  
Chemical Properties ◽  
Monounsaturated Fatty Acids ◽  
Gel Strength ◽  
Physical And Chemical Properties ◽  
Physical And Chemical ◽  
And Chemical Properties

After Nile tilapia skin was preserved using the methods of freezing and dry salting, characteristics of skin gelatin were evaluated with regard to yield, rheological features and physical and chemical properties. Preservation was performed after filleting, at which time skins were either frozen (-18°C) for 7 days or salted (25°C) for 7 days. Although no differences (p > 0.05) were observed with respect to humidity, protein, lipid, ash and calcium levels, gelatin from salted skins had a higher concentration of iron relative to frozen skins. Further, twenty-three fatty acids were detected in salted skins compared with merely three found in skin derived gelatin. Of amino acids found, glycine, alanine, proline and arginine were the most abundant. Hydroxyproline abundance in salted and frozen skin gelatin were 8.76% and 8.71%, respectively. In addition, salted skin gelatins had a greater accumulation of saturated fatty acids and lower rates of monounsaturated fatty acids. Salted skin gelatin had the highest yield (18g × 100g-1), gel strength (200 g) and viscosity (19.02mPas) when compared to the yield (17g × 100g-1), gel strength (12.7g) and viscosity (9.16 mPas) of frozen skins. Results show that gelatin from dry salted skin had the best yield and also had relatively better rheological properties, more iron, and better coloration relative to gelatin obtained from frozen skins of Nile tilapia.

Characterization of Shivirtui Zeolite Modified with Aluminum Oxyhydroxide Nanofibers

2019 ◽  
Vol 942 ◽  
pp. 40-49
Author(s):  
Yulia Murashkina ◽  
Olga B. Nazarenko
Keyword(s):  
Chemical Properties ◽  
Nitrogen Adsorption ◽  
X Ray Diffraction ◽  
Scanning Electronic Microscopy ◽  
Electronic Microscopy ◽  
X Ray ◽  
Physical And Chemical ◽  
And Chemical Properties ◽  
Aluminum Oxyhydroxide

Natural zeolite of Shivirtui deposit (Russia) was modified with nanofibers of aluminum oxyhydroxide AlOOH. Aluminum oxyhydroxide nanofibers were produced at the heating and oxidation of aluminum powder with water. The properties of modified zeolite were investigated by means of X-ray diffraction, transmission electronic microscopy, scanning electronic microscopy, low-temperature nitrogen adsorption, thermal analysis, and Fourier transform infrared spectroscopy. It was found that water content in the modified sample of zeolite was about 15 %. Based on the study of the physical and chemical properties, shivirtui zeolite modified with nanofibers of aluminum oxyhydroxide can be proposed for use as a flame-retardant additive to polymers.

scholarly journals Characterization of Engineering Plastics Plasticized Using Supercritical CO2

Polymers ◽  
2020 ◽  
Vol 12 (1) ◽  
pp. 134
Author(s):  
Masaki Watanabe ◽  
Yoshihide Hashimoto ◽  
Tsuyoshi Kimura ◽  
Akio Kishida
Keyword(s):  
Molecular Weight ◽  
Supercritical Co2 ◽  
Chemical Properties ◽  
Molding Process ◽  
Test Pieces ◽  
Engineering Plastics ◽  
Transition Points ◽  
Physical And Chemical ◽  
And Chemical Properties

The purpose of this study was to evaluate the physical and chemical properties of engineering plastics processed using supercritical CO2. First, we prepared disk-shaped test pieces via a general molding process, which were plasticized using supercritical CO2 at temperatures lower than the glass-transition points of engineering plastics. Amorphous polymers were plasticized, and their molecular weight remained nearly unchanged after treatment with supercritical CO2. The mechanical strength significantly decreased despite the unchanged molecular weight. The surface roughness and contact angle increased slightly, and electrical properties such as the rate of charging decreased significantly. These results suggest that supercritical CO2 could be used for a new molding process performed at lower temperatures than those used in general molding processes, according to the required properties.

Sign in / Sign up

Export Citation Format

Share Document