scholarly journals Microstrip Rectangular Monopole Antennas with Defected Ground for UWB Applications

2017 ◽  
Vol 7 (4) ◽  
pp. 2027 ◽  
Author(s):  
S. Elajoumi ◽  
A. Tajmouati ◽  
A. Errkik ◽  
Am. Sanchez ◽  
M. Latrach
Keyword(s):  
Wide Band ◽  
Impedance Bandwidth ◽  
Defected Ground Structure ◽  
Ground Structure ◽  
Rectangular Patch ◽  
Ansoft Hfss ◽  
Monopole Antennas ◽  
Compact Antennas ◽  
Uwb Applications ◽  
Good Agreement

This paper presents the design of new compact antennas for ultra wide band applications. Each antenna consists of a rectangular patch fed by 50Ω microstrip transmission line and the ground element is a defected ground structure (DGS). The aim of this study is to improve the bandwidth of these antennas by using DGS and the modification geometry of rectangular structure, which gives new compact antennas for UWB applications. The input impedance bandwidth of the antennas with S11<-10dB is more than 10GHz, from 3GHz to more than 14 GHz. The proposed antennas are investigated and optimized by using CST microwave studio, they are validated by using another electromagnetic solver Ansoft HFSS. The measured parameters present good agreement with simulation. The final antenna structures offer excellent performances for UWB system.

scholarly journals Novel UWB Microstrip Antenna Structures with Defected Ground Structure

2018 ◽  
Vol 11 (2) ◽  
pp. 429
Author(s):  
Saida Elajoumi ◽  
A. Tajmouati ◽  
J. Zbitou ◽  
A. Errkik ◽  
L. El Abdellaoui ◽  
...  
Keyword(s):  
Microstrip Antenna ◽  
Return Loss ◽  
Federal Communication Commission ◽  
Wide Band ◽  
Impedance Bandwidth ◽  
Defected Ground Structure ◽  
Ground Structure ◽  
Printed Antennas ◽  
Ansoft Hfss ◽  
Good Agreement

<p>This paper presents the design of new compact printed antennas for Ultra Wide Band applications, fed with a microstrip-line. The proposed designs consist of a patch antenna with defected ground, which are fed by 50Ω microstrip transmission line. The frequency range is 3.1-10.6 GHz which is the Federal Communication Commission (FCC) band of UWB. The proposed antennas are easy for integration with microwave circuits. They are validated into simulation by using two electromagnetic solvers CST-MW and Ansoft HFSS. The simulated input impedance bandwidth ranging 3GHz to more than 14 GHz is obtained with return loss less -10dB, and exhibits good UWB characteristics. The measured parameters are good agreement with the simulation. Therefore these antennas offer excellent performance for UWB system.</p>

scholarly journals DGS based monopole circular-shaped patch antenna for UWB applications

2021 ◽  
Vol 3 (2) ◽  
Author(s):  
Dattatreya Gopi ◽  
Appala Raju Vadaboyina ◽  
J. R. K. Kumar Dabbakuti
Keyword(s):  
Patch Antenna ◽  
Substrate Material ◽  
Impedance Bandwidth ◽  
Defected Ground Structure ◽  
Ground Structure ◽  
Compact Structure ◽  
Resonant Frequencies ◽  
Low Profile ◽  
Uwb Applications ◽  
Good Agreement

AbstractA simple low profile defected ground structure based monopole circular-shaped patch antenna is proposing for ultrawide-band applications. The design allows for a simple and compact structure on the FR-4 substrate material. The proposed design initially has a meager antenna gain and bandwidth. To increase the antenna bandwidth and gain, the defective ground structure is implemented with four dumble-shaped slots. Parametric analysis is considered to find the radius of circular patch for tuning of UWB frequency applications. The proposed MCP antenna resonates at 2.9 GHz, 9.1 GHz frequencies with a S11 of − 34.84 dB, − 33.74 dB, respectively, and achieves 8.1 GHz (2.5–10.6 GHz) impedance bandwidth concerning the − 10 dB reference line of the reflection coefficient. The gains are 8.4 dBi, 8.2 dBi for the two resonant frequencies, and the radiation patterns are semi-omnidirectional, omnidirectional. The proposed antenna has-been validated by observing good agreement between the simulation and the measured results.

scholarly journals Dual Band Gap Coupled Antenna Design with DGS for Wireless Communications

2014 ◽  
Vol 2 (3) ◽  
pp. 51 ◽  
Author(s):  
A. Kandwal ◽  
R. Sharma ◽  
S. K. Khah
Keyword(s):  
Side Lobe ◽  
Dual Band ◽  
Impedance Bandwidth ◽  
Side Lobe Level ◽  
Defected Ground Structure ◽  
Ground Structure ◽  
Wireless Applications ◽  
X Band ◽  
Ring Antenna ◽  
Good Agreement

A novel gap coupled dual band multiple ring antenna with a defected ground structure (DGS) has been successfully implemented. A different technique is used in this communication where both gap coupling and defected ground are applied to obtain better results for wireless applications. The designed antenna operates in two different frequency bands. The antenna shows a wideband in C-band and also resonates in the X-band. The main parameters like return loss, impedance bandwidth, radiation pattern and gain are presented and discussed. The gain is increased and the side lobe level is considerably reduced to a good extent. Designed antenna is tested and the results show that the simulation and experimental results are in good agreement with each other.

Cordate-shaped UWB-MIMO antenna with notch band characteristic and high isolation

2021 ◽  
Vol ahead-of-print (ahead-of-print) ◽  
Author(s):  
Preeti Pannu ◽  
Devendra Kumar Sharma
Keyword(s):  
Multiple Input Multiple Output ◽  
Small Variation ◽  
Wide Band ◽  
Antenna System ◽  
Data Rate ◽  
Impedance Bandwidth ◽  
Defected Ground Structure ◽  
Content Type ◽  
Mimo Antenna ◽  
Good Agreement

Purpose This paper aims to design a most demanding low profile and compact ultra-wide band (UWB) antenna system for various wireless applications. The performance (in terms of data rate) of UWB system is improved by using multiple-input-multiple-output (MIMO) technology with it. Owing to the overlap of other existing licensed bands with that of UWB, electromagnetic signals can interfere. So, notched band UWB MIMO antenna system reported here which is highly compact, bandwidth efficient, superior data rate and high inter-element isolation comparatively to other reported designs. Design/methodology/approach A 49 × 49 × 1.6 mm3 quad-port UWB MIMO antenna with specific bandwidth elimination property is designed. The proposed planar MIMO configuration comprises unique four identical “Cordate-shaped” monopole radiators fed by 2.3-mm thick microstrip-lines. The radiators are located right-angled to each other to enhance inter-element isolation. Further, a different approach of slitted-substrate is applied to minimize the overall size and mutual coupling of the MIMO antenna, as a substitute of decoupling and matching structures. The defected ground structure is used to obtain −10 dB impedance bandwidth in entire UWB band, without compromising with the lower cut-off frequency response. Further, to eliminate the undesired resonant band (WLAN at 5.5 GHz) from UWB, a rounded split ring resonator is introduced in monopole patch. Findings In the entire operating band of 2.8 to 11 GHz, isolation among elements is more than 24 dB, envelope correlation coefficient less than 0.002, diversity gain greater than 9.99 dB and TARC less than −7 dB are obtained at all 4-ports. Research limitations/implications The measured parameters of the fabricated prototype antenna on FR4 substrate are found in good agreement with the simulated results. The small variation in software results and hardware results are observed due to hardware design limitations. Practical implications The proposed design may be used for any wireless application following in the range of UWB. Originality/value It can be shown from graphs of measured parameters of the fabricated prototype antenna. They found to be in good agreement with the simulated results.

Design and Analysis of Inset Fed Wide-Band Rectenna with Defected Ground Structure

2019 ◽  
Vol 29 (03) ◽  
pp. 2050047
Author(s):  
Asmita Rajawat ◽  
P. K. Singhal
Keyword(s):  
Power Transmission ◽  
Wide Band ◽  
Center Frequency ◽  
Impedance Bandwidth ◽  
Wireless Power ◽  
Frequency Range ◽  
Defected Ground Structure ◽  
Ground Structure ◽  
Feed Line ◽  
Voltage Doubler

The design proposed and fabricated in this paper is a slotted wide-band rectenna with the inclusion of Defected Ground Structure (DGS) which can harvest RF energy in the frequency range of 5.336–6.194[Formula: see text]GHz with a center frequency of 5.8[Formula: see text]GHz. For the development of antenna, FR4 substrate having a dielectric permittivity of 4.3 has been adopted. Two parallel slots on the patch are incorporated on either side of the feed line to obtain the wide-band structure. Dumbbell-shaped DGS is also incorporated exactly underneath the feed line to increase the gain of the antenna. HSMS-285C Schottky diode has been used for the implementation of the rectifier circuit and a Greinacher voltage doubler has been chosen. ADS design software has been used for rectifier simulation and CST has been used for the designing of the antenna. Current behavior on the patch can be investigated to explore the wide-band mechanism. The antenna operates in the frequency range of 5.336–6.194[Formula: see text]GHz and with VSWR less than 2, which corresponds to 16.07% impedance bandwidth. The antenna achieves a gain of 6.189[Formula: see text]dB and a directivity of 8.776[Formula: see text]dBi. The conversion efficiency of the rectifier was optimized to 75% at 5.8[Formula: see text]GHz. The proposed design gave an output of 3.2[Formula: see text]V which can be used under numerous energy harvesting and wireless power transmission applications.

scholarly journals Compact Broadband Monopole Antenna for C Band Applications

2018 ◽  
Vol 7 (5) ◽  
pp. 118-123 ◽  
Author(s):  
P. Pathak ◽  
P. K. Singhal
Keyword(s):  
Wireless Communication ◽  
Numerical Simulations ◽  
Ieee 802.11 ◽  
Patch Antenna ◽  
Radiation Characteristic ◽  
Impedance Bandwidth ◽  
Defected Ground Structure ◽  
Ground Structure ◽  
Rectangular Patch ◽  
Electrical Permittivity

This paper reports a new design of broadband monopole patch antenna. The proposed antenna possess corner truncated rectangular patch with slits and defected ground structure, these modifications considerably improves the impedance bandwidth to 41.29% over a wideband (5.1–7.59 GHz). The design is appropriate for wireless communication including WLAN IEEE 802.11 g/a (5.15–5.35 GHz and 5.725–5.825 GHz) and C Band (4–8 GHz) applications. An antenna prototype is fabricated using FR-4 with an electrical permittivity of 4.4. Experimental and numerical simulations of antenna’s radiation characteristic are also reported and exhibits good concurrence.

Design of S-Band Antenna With L-Shaped Slits on Rectangular Patch With Defected Ground Structure

2018 ◽  
Vol 7 (2) ◽  
pp. 50-58
Author(s):  
Ketavath Kumar Naik ◽  
Ravi Kumar Palla ◽  
Sriram Sandhya Rani ◽  
Dattatreya Gopi
Keyword(s):  
Resonance Frequency ◽  
Radiation Pattern ◽  
Patch Antenna ◽  
Return Loss ◽  
Impedance Bandwidth ◽  
Defected Ground Structure ◽  
Ground Structure ◽  
Rectangular Patch ◽  
Antenna Model

Monopole L-shaped slits are embedded on rectangular patch antenna is designed for S-band applications. The proposed antenna is a square patch radiator with four L-shaped slits are presented. The proposed antenna radiates at 3GHz resonance frequency with bandwidth of 1.9GHz and -26.4dB return loss. The impedance bandwidth is enhanced 62.7% with proposed antenna model. The proposed L-shaped slit patch antenna is small in size and compact. The radiation pattern is presented in the results and it works at S-band applications.

Measurement Analysis of Ultra-Wideband Monopole Antenna With Defected Ground Structure

2017 ◽  
Vol 6 (1) ◽  
pp. 1-12
Author(s):  
Madan Kumar Sharma ◽  
Mithilesh Kumar ◽  
J.P. Saini
Keyword(s):  
Monopole Antenna ◽  
Ultra Wideband ◽  
Impedance Bandwidth ◽  
Defected Ground Structure ◽  
Ground Structure ◽  
Radiation Characteristics ◽  
Measurement Analysis ◽  
Low Profile ◽  
X 24 ◽  
Uwb Applications

This article describes how a compact, low profile Ultra-wideband (UWB) monopole antenna with a defected ground structure is designed and demonstrated experimentally. The design and experimentation activities have been carried out with the help of a CST Microwave studio tool. The UWB characteristics of the proposed antenna are achieved with a modification of the ground structure of the referenced antenna with novel L shaped defected ground structure (DGS). Both antennas are fabricated on the same substrate with the dimensions of 28.3 x 24 mm2. The comparative analysis of the results for both antennas clearly indicate that the proposed UWB monopole antenna enhanced the impedance bandwidth from 3.7 GHz – 14.9 GHz without DGS and to 3.4 GHz – 20 GHz with DGS. The enhanced bandwidth, constant group delay and good radiation characteristics of the proposed antenna have identified it as a good candidate for portable UWB applications.

Sign in / Sign up

Export Citation Format

Share Document