Magmatic evolution of the Gaussberg lamproite (Antarctica): volatile content and glass composition

2004 ◽  
Vol 68 (1) ◽  
pp. 83-100 ◽  
Author(s):  
E. Salvioli-Mariani ◽  
L. Toscani ◽  
D. Bersani

AbstractThe lamproite of Gaussberg is an ultrapotassic rock where leucite, olivine and clinopyroxene microphenocrysts occur in a glass-rich groundmass, containing microliths of leucite, clinopyroxene, apatite, phlogopite and rare K-richterite.Abundant silicate melt inclusions occur in olivine, leucite and, rarely, in clinopyroxene microphenocrysts. Raman investigations on melt inclusions showed the presence of pure CO2 in the shrinkage bubbles. On the other hand, the glass of the groundmass is CO2-poor and contains up to 0.70 wt.% of dissolved H2O, as estimated by infrared spectra. It is inferred that CO2 was released at every stage of evolution of the lamproite magma (CO2-rich shrinkage bubbles), whereas H2O was retained for longer in the liquid. At Gaussberg, CO2 seems to have a major role at relatively high pressure where it favoured the crystallization of H2O-poor microphenocrysts; the uprise of the magma to the surface decreased the solubility of CO2 and caused a relative increase in water activity. As a consequence, phlogopite and K-richterite appeared in the groundmass.The glass composition of both the groundmass and melt inclusions suggests different evolutions for the residual liquids of the investigated samples. Sample G886 shows the typical evolution of a lamproite magma, where the residual liquid evolves toward peralkaline and Na-rich composition and crystallizes K-richterite in the latest stage. Sample G895 derives from mixing/mingling of different batches of magma; effectively glasses from melt inclusions in leucite and clinopyroxene are more alkaline than those found in early crystallized olivine. Leucite and clinopyroxene crystallized early from a relatively more alkaline batch of lamproite magma and, successively, a less alkaline, olivinebearing magma batch assimilated them during its rise to the surface.

1980 ◽  
Vol 35 (5) ◽  
pp. 537-548 ◽  
Author(s):  
P. Klaeboe ◽  
M. Moneeb ◽  
E. Törneng ◽  
H. Hopf ◽  
I. Böhm ◽  
...  

Abstract The infrared spectra of 1-cyano-3-butyne were recorded in the region 4000-50 cm-1 in the vapour and liquid states, as an amorphous and as two different crystalline solids at 90 K. In addition the compound was studied as a high pressure crystalline solid at ambient temperature. Raman spectra of the liquid, including polarization measurements, and of the amorphous and the two crystalline solids at 90 K, were obtained. The spectra revealed the existence of two conformers, anti (Cs) and gauche (C1 symmetry) in the vapour, liquid and in the amorphous solid. When annealed to ca. 140 K a metastable crystal containing one conformer (probably the gauche) was formed, when annealed to ca. 190 K a stable crystal was obtained having the other conformer (probably the anti). The latter conformer was present in the high pressure crystal. Very accurate spectral data for each conformer were collected from the two crystalline solids, making complete assignments for the anti and gauche conformers feasible. The assignments were checked by a normal coordinate analysis. A simple diagonal force field was derived in which the same force constants were employed for the anti and gauche conformers. The mean amplitudes of vibration were calculated for both conformers.


Atmosphere ◽  
2021 ◽  
Vol 12 (3) ◽  
pp. 307
Author(s):  
Makoto Inoue ◽  
Atsushi Ugajin ◽  
Osamu Kiguchi ◽  
Yousuke Yamashita ◽  
Masashi Komine ◽  
...  

In this study, we investigated the effects of the Tibetan High near the tropopause and the North Pacific High in the troposphere on occurrences of hot or cool summers in Japan. We first classified Japan into six regions and identified hot and cool summer years in these regions from a 38-year sample (1980–2017) based on the monthly air temperature. To investigate the features of circulation fields over Asia during hot and cool summers in Japan, we calculated the composite differences (hot summer years minus cool summer years) of several variables such as geopotential height, which indicated significant high-pressure anomalies in the troposphere and lower stratosphere. These results suggest that both the North Pacific and the Tibetan Highs tend to extend to Japan during hot summer years, while cool summers seem to be associated with the weakening of these highs. We found that extension of the Tibetan High to the Japanese mainland can lead to hot summers in Northern, Eastern, and Western Japan. On the other hand, hot summers in the Southwestern Islands may be due to extension of the Tibetan High to the south. Similarly, the latitudinal direction of extension of the North Pacific High is profoundly connected with the summer climate in respective regions.


1992 ◽  
Vol 96 (7) ◽  
pp. 931-937 ◽  
Author(s):  
E. V. Boldyreva ◽  
L. P. Burleva ◽  
E. B. Burgina ◽  
V. P. Baltachinov ◽  
H. Ahsbahs ◽  
...  

2014 ◽  
Vol 99 (5-6) ◽  
pp. 976-998 ◽  
Author(s):  
R. Esposito ◽  
J. Hunter ◽  
J. D. Schiffbauer ◽  
N. Shimizu ◽  
R. J. Bodnar

1961 ◽  
Vol 39 (11) ◽  
pp. 2343-2352 ◽  
Author(s):  
Ernest Rivet ◽  
Real Aubin ◽  
Roland Rivest

Co-ordination complexes between diesters of α,ω-dicarboxylic acids and titanium tetrachloride, tin tetrachloride, and zirconium tetrachloride have been prepared. The analytical results, the infrared spectra, the melting points, and the molecular-weight determinations indicate that for the titanium and zirconium complexes, two types of complexes are obtained, one having a general formula MX4•1 diester in which chelate rings from five to nine atoms are formed and the other one, 2MX4•1 diester in which there are two 4-membered rings per complex molecule. With tin tetrachloride only one type of complex is formed, which has two tin tetrachlorides and two diesters per complex molecule.


2001 ◽  
Vol 15 (18) ◽  
pp. 2491-2497 ◽  
Author(s):  
J. L. ZHU ◽  
L. C. CHEN ◽  
R. C. YU ◽  
F. Y. LI ◽  
J. LIU ◽  
...  

In situ high pressure energy dispersive X-ray diffraction measurements on layered perovskite-like manganate Ca 3 Mn 2 O 7 under pressures up to 35 GPa have been performed by using diamond anvil cell with synchrotron radiation. The results show that the structure of layered perovskite-like manganate Ca 3 Mn 2 O 7 is unstable under pressure due to the easy compression of NaCl-type blocks. The structure of Ca 3 Mn 2 O 7 underwent two phase transitions under pressures in the range of 0~35 GPa. One was at about 1.3 GPa with the crystal structure changing from tetragonal to orthorhombic. The other was at about 9.5 GPa with the crystal structure changing from orthorhombic back to another tetragonal.


2014 ◽  
Vol 354 ◽  
pp. 79-83
Author(s):  
Soumitra Roy ◽  
Soma Prasad ◽  
Aloke Paul

The growth of phases by reactive diffusion in Mo-Si and W-Si systems are compared. The crystal structures of MSi2 and M5Si3 phases (M = Mo, W) are similar in these two systems. However, the diffusion rates of the components change systematically with a change in the atomic number. Integrated diffusion coefficients in both phases increase with an increasing atomic number of refractory elements i.e. from Mo to W. On the other hand, the ratio of diffusivities of the components decreases. This indicates a relative increase in the diffusion rates of the metal components with increasing atomic number and a difference in defects concentrations in these two systems.


2005 ◽  
Vol 127 (6) ◽  
pp. 1191-1197 ◽  
Author(s):  
Yasuo Fujioka ◽  
Tomotsugu Sakai

Structures composed of a rotary disk and a shaft, which are fastened with bolts and nuts having tapered bearing surfaces, are loaded with a rotating-bending force. Upon investigation, two rotating mechanisms of the nut were derived. In one mechanism a high-pressure contact area is formed at the nearest loading point on threads and bearing surfaces. This leads to a difference in the curvature radii between the bearing surface of the disk and that of the nut. During the revolution of the disk, two friction torques occur in opposite directions on the bearing surface and the threads, respectively. The relative rotating direction of the nut is dominated by the greater torque. The other mechanism is due to the eccentricities caused by dimensional errors of the bolt, nut, and disk. By combining the two mechanisms, the rotations of the nuts either cause a loosening or tightening after many revolutions of the disk.


1963 ◽  
Vol 4 (36) ◽  
pp. 809-812
Author(s):  
R. L. Shreve

AbstractIn August 1961 an aluminum pipe (3.5 cm. internal diameter, 4.2 cm. external diameter) having 92 specially modified socket couplings (5.0 cm. external diameter) sealed with a quick-polymerizing synthetic rubber was sunk 226 m. in a vertical water-filled bore hole in Blue Glacier, Washington. U.S.A. The geometry of threads and mating surfaces of pipe and coupling was designed to cause increasing external water pressure to tighten the seal. One joint at a depth of 66 m. immediately developed an extremely slow leak (probably because of faulty cleaning), but the other 91 joints apparently were sound, as the pipe was free of water to a depth of at least 157 m. when resurveyed after one year.


Author(s):  
Takayasu Tahara

Pressure equipment in refinery and petrochemical industries in Japan has been getting old, mostly more than 30 years in operation. Currently, the Japanese regulations for pressure equipment in service are the same as those in existence during the fabrication of the pressure equipment. Accordingly, there is an immediate need for an up to date more advanced “Fitness For Service” (FFS) evaluation requirements for pressure equipment. In order to introduce the latest FFS methodologies to Japanese industries, the High Pressure Institute of Japan (HPI) has organized two task groups. One is a working group for development of a maintenance standard for non-nuclear industries. Its prescribed code “Assessment procedure for crack-like flaws in pressure equipment” is for conducting quantitative safety evaluations of flaws detected in common pressure equipment such as pressure vessels, piping, storage tanks. The other is a special task group to study of API RP579 from its drafting stage as a member of TG579. The FFS Handbook, especially for refinery and petrochemical industries, has been developed based on API RP579 with several modifications to meet Japanese pressure vessel regulations on April 2001. [1] It is expected that both the Standard and FFS handbook will be used as an exemplified standard with Japanese regulations for practical maintenance. This paper presents concepts of “Assessment procedure for crack-like flaws in pressure equipment” HPIS Z101, 2001 [2].


Sign in / Sign up

Export Citation Format

Share Document