Evolution of nepheline from mafic to highly differentiated members of the alkaline series: the Messum complex, Namibia

2010 ◽  
Vol 74 (3) ◽  
pp. 415-432 ◽  
Author(s):  
S. B. Blancher ◽  
P. D'Arco ◽  
M. Fonteilles ◽  
M.-L. Pascal

AbstractThe change in chemical composition trend of magmatic nepheline through magma evolution has been characterized from the alkaline series of the Messum complex in which nepheline occurs in a succession of different mineral parageneses from mafic-rich (theralites) to strongly evolved felsic-rich rock types (nepheline syenites). The nepheline compositions are dependent on those of coexisting feldspar(s). They record an evolution parallel to that of the melt schematized according to experimental phase diagrams, from initially Ca-rich compositions in equilibrium with calcic plagioclase towards increasingly Ca-poor, Na-rich and Si-rich compositions. The K contents show a maximum that corresponds to the appearance of alkali feldspar in the parageneses. This evolution is qualitatively preserved in spite of the low-T Na/K re-equilibration typical of plutonic nephelines. Although a slight increase in the silica content of nepheline is consistent with the experimentally defined magmatic trend, several high-silica nephelines from the Messum rocks as well as from other reported occurrences, cannot be reconciled with the experimental data. The nepheline solid-solution model available suggests that such ‘abnormal’ compositions might be related to different crystallization mechanisms between natural nephelines and some synthetic analogues.

2019 ◽  
Vol 342 ◽  
Author(s):  
Jean Gérard ◽  
Sébastien Paradis ◽  
Bernard Thibaut

Variability in the chemical composition of 614 species is described in a database containing measurements of wood polymers (cellulose, lignin and pentosan), as well as overall extraneous components (ethanol-benzene, or hot water extracts and ash, with a focus on silica content). These measurements were taken between 1945 and 1990 using the same standard protocol. In all, 1,194 trees belonging to 614 species, 358 genera and 89 families were measured. At species level, variability (quantified by the coefficient of variation) was rather high for density (27%), much lower for lignin and cellulose (14% and 10%) and much higher for ethanol/benzene extractives, hot water extractives and ash content (81%, 60% and 76%). Considering trees with at least five different specimens, and species with at least 10 different trees, it was possible to investigate within-tree and within-species variability. Large differences were found between trees of a given species for extraneous components, and more than one tree should be needed per species. For density, lignin, pentosan and cellulose, the distribution of values was nearly symmetrical, with mean values of 720 kg/m3 for density, 29.1% for lignin, 15.8% for pentosan, and 42.4% for cellulose. There were clear differences between species for lignin content. For extraneous components, the distribution was very dissymmetrical, with a minority of woods rich in this component composing the high value tail. A high value for any extraneous component, even in only one tree, is sufficient to classify the species in respect of that component. Siliceous woods identified by silica bodies in anatomy have a very high silica content and only those species deserve a silica study.


Author(s):  
Ivan Saenko ◽  
O. Fabrichnaya

AbstractThermodynamic parameters were assessed for the MgO–FeOx system and combined with already available descriptions of ZrO2-FeOx and ZrO2-MgO systems to calculate preliminary phase diagrams for planning experimental investigations. Samples of selected compositions were heat treated at 1523, 1673 and 1873 K and characterized using x-ray and scanning electron microscopy combined with energy dispersive x-ray spectroscopy (SEM/EDX). Experiments indicated extension of cubic ZrO2 solid solution into the ternary system at 1873 K (75 mol.% ZrO2, 10 mol.% FeOx and 15 mol.% MgO) and limited solubility of 4 mol.% ZrO2 in spinel phase. Based on the obtained results thermodynamic parameters of C-ZrO2 and spinel phase were optimized.


2018 ◽  
Vol 383 ◽  
pp. 31-35 ◽  
Author(s):  
Alexey Rodin ◽  
Nataliya Goreslavets

The study of diffusion processes in the aluminum - copper system was carried out at the temperature 350 and 520 °C. Special attention was paid on the chemical composition of the system near Al/Cu interface. It was determined that the intermediate phases in the system, corresponding to the equilibrium phase diagram, were not formed at low temperature. At high temperature the intermediate phases forms starting with Cu - rich phases. In both cases supersaturated solid solution of copper in aluminum could be observed near the interface.


Author(s):  
А.А. Семакова ◽  
В.В. Романов ◽  
Н.Л. Баженов ◽  
К.Д. Мынбаев ◽  
К.Д. Моисеев

The results of a study of the electroluminescence of the asymmetric InAs/InAs1−ySby/InAsSbP LED heterostructures with a molar fraction of InSb in the ternary solid solution in the active region y=0.15 and y=0.16 in the temperature range 4.2−300 K are presented. Based on the experimental data, the formation of a staggered type II heterojunction at the InAs1−ySby/InAsSbP heterointerface was determined. The dominant contribution of the interface radiative transitions at the type II heterointerface in the temperature range 4.2−180 K was shown, which makes it possible to minimize the temperature dependence of the operating wavelength of the LEDs.


1912 ◽  
Vol s4-33 (197) ◽  
pp. 433-439
Author(s):  
H. W. Foote ◽  
W. M. Bradley

2020 ◽  
Vol 299 ◽  
pp. 658-663
Author(s):  
S.E. Krylova ◽  
Sergey V. Gladkovskii ◽  
E.V. Romashkov

The scientific bases for the development of rational compositions and methods for hardening a large-sized metallurgical tool from micro-alloyed steels are stated. Based on the generalization of the experimental data, the regularities of phase and structural transformations at various stages of the technological cycle are revealed; the relationships between structural parameters, chemical composition and mechanical properties have been studied and described.


2018 ◽  
Vol 10 (4) ◽  
Author(s):  
Chang Yang ◽  
Yasushi Hirose ◽  
Takuto Wakasugi ◽  
Naoki Kashiwa ◽  
Hiroki Kawai ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document