Nonlinear distortion of signals radiated by vibroseis sources

Geophysics ◽  
2004 ◽  
Vol 69 (4) ◽  
pp. 968-977 ◽  
Author(s):  
Andrey V. Lebedev ◽  
Igor A. Beresnev

A model of nonlinearity of the contact between the vibrator baseplate and the ground is proposed to describe the distortion of vibroseis signals in the near‐field. A thin layer between the baseplate and the soil exhibits a strong nonlinear response because of the difference in its rigidity between the compression and tension phases. The model allows for a quantitative description of the transmission of seismic energy into the ground, including the observed harmonic distortion. However, the contact nonlinearity does not lead to the dependence of wave traveltimes on the amplitude of the force applied to the ground. This fact can be used in field observations to localize the source of the observed harmonic distortion.

2011 ◽  
Vol 110 (7) ◽  
pp. 074318 ◽  
Author(s):  
Jean Dahdah ◽  
Maria Pilar-Bernal ◽  
Nadège Courjal ◽  
Gwenn Ulliac ◽  
Fadi Baida

1892 ◽  
Vol s2-33 (130) ◽  
pp. 313-324
Author(s):  
ASAJIRO OKA ◽  
ARTHUR WILLEY

Sarcodidemnoides misakiense, Oka and Willey. Generic Characters.--Colony (or cormus) forming very thick lobose masses, laterally compressed; sessile, but not encrusting. Excurrent orifices placed on the tips of the knoll-like prominences. Ascidiozooids very numerous, not arranged in systems; branchial sac with four rows of stigmata; canal system complicated, differentiated into peripheral and central portions. Specific Characters.--Atrial apertures of Ascidiozooids simple pores without teeth or languet; spicules fairly abundant, extremely delicate, confined to a thin layer near surface of test. Test gelatinous, containing numerous bladder-cells, crystals, fusiform cells, and pigment concretions. Stomach of Ascidiozooids vertically placed; surface of attachment of colony narrower than the free portion. Colour, brilliant red. Habitat.--Moroiso, Japan, between the tide-marks. N.B.--Since the above was written I have seen for the first time the exhaustive work of Fernand Lahille, entitled ‘Recherches sur les Tuniciers des côtes de France,' Toulouse, 1890. Lahille devotes considerable attention to what have been spoken of above as tentacle-like processes of the larva, figures them in many larvæ, and gives an excellent figure of the metamorphosing larva of Styela glomerata. He gives an opinion as to their significance which I cannot entirely endorse in the light of my own researches on the "Postembryonic development of Styela," commenced last August at Plymouth. However, I hope to return to this question on a future occasion. Lahille raises an objection to von Drasche's genus Didemnoides on the ground that the thickness of the cormus is not an anatomical character, and that the distinction between thick and thin colonies is a purely subjective one. There is no doubt some truth in this; but the difference between a compound Ascidian which possesses, say, a very few spicules, and one which possesses none at all, would appear to be no more fundamental than that between a colony whose mode of growth resulted in the production of a fleshy mass and one which grew in the form of a thin leathery crust. As stated above, von Drasche intends by Didemnoides a fleshy form of Leptoclinum, the test containing spicules, and the Ascidiozooids having four rows of stigmata in the branchial sac. Lahille, on the contrary,applies the name Didemnoides to those Didemnidse which are characterised by the absence of spicules, and the possession of three rows of stigmata in the branchial sac. The compound Ascidian which we have described above has spicules in the test, and four rows of stigmata in the branchial sac. But as it would be too absurd to call the new form "Sarcoleptoclinum," we shall persist in regarding the genus Didemnoides from the point of view of von Drasche.--A. W.


2013 ◽  
Vol 4 ◽  
pp. 632-637 ◽  
Author(s):  
Tsung Sheng Kao ◽  
Yi Guo Chen ◽  
Ming Hui Hong

By utilizing the strongly induced plasmon coupling between discrete nano-antennas and quantitatively controlling the crystalline proportions of an underlying Ge2Sb2Te5 (GST) phase-change thin layer, we show that nanoscale light localizations in the immediate proximity of plasmonic nano-antennas can be spatially positioned. Isolated energy hot-spots at a subwavelength scale can be created and adjusted across the landscape of the plasmonic system at a step resolution of λ/20. These findings introduce a new approach for nano-circuitry, bio-assay addressing and imaging applications.


2021 ◽  
pp. 107754632110482
Author(s):  
Hamed Keikha ◽  
Gholamreza Ghodrati Amiri

Simplified analysis methods for seismically isolated structures proposed in recent structural codes and specifications are frequently used to reduce the computational effort and to simplify the design procedure, either directly for special cases or for checking the results of nonlinear response history analysis. Of the approximate methods, the equivalent lateral force procedure using the effective stiffness and effective damping is one of the best known. In this study, the simplified method is developed by combining the equivalent lateral force procedure with the capacity spectrum method and evaluated in terms of maximum isolator displacements and base shears for isolated structures with recently invented quintuple friction pendulum isolators , with different geometrical and frictional properties, under two different response spectra with corresponding two different sets of bidirectional near-field ground motions for stiff and soft soils site classes. In order to assess the accuracy of the simplified method, the delivered results of the ELF procedure are compared to those of nonlinear response history analysis, by modelling the quintuple friction pendulum isolator 3D element in OpenSees. Eventually, comments on the accuracy of the simplified method are given to make its applications more appropriate in practical design of base isolation systems.


Energies ◽  
2019 ◽  
Vol 12 (17) ◽  
pp. 3293 ◽  
Author(s):  
Susana Martín Arroyo ◽  
Miguel García-Gracia ◽  
Antonio Montañés

In this work, a new and accurate method based on the wavelet transform is proposed for fault location in transmission-line systems. The proposed wavelet method consists of the analysis of the transient signal measured at a single end of the transmission line. Aerial current modes are used, and zero modes are included in the fault-detection scheme for low fault-inception angles. The fault distance is evaluated using the wavelet modulus maxima technique and a method based on the response to a half-sine voltage is proposed to overcome drawbacks arising from the limited sampling frequency and low fault-inception angle. The fault distance is calculated using the difference between the time when a 100 kHz half-sine signal is sent and the time when the derivative signal is received. The proposed algorithm is tested considering harmonic distortion and varying fault resistance, ground resistivity, location and inception angle. The high accuracy of the proposed algorithm is obtained even for faults close to the bus and low inception angles.


Author(s):  
Yong Huang ◽  
Xin-Gang Liang

Based on the principle of electric dipole radiation and the Planck’s spectral distribution of emissive power, the enhancement of thermal radiation between two planar semi-infinite media or two nano-spheres was studied in this paper by the Monte Carlo method. By this simple method, some parameter’s influence on the radiative heat transfer was investigated, such as the distance between two semi-infinite media, the particle’s radius, the distance between two particles and the difference in temperature between two particles, and so on. This solution is not rigorous but simple. The results show that heat transfer can be enhanced by several orders of magnitude for the near field effect. And the radiative heat transfer is decreasing sharply with the increasing of the distance.


2019 ◽  
Vol 946 ◽  
pp. 253-257 ◽  
Author(s):  
Alexey Stolyarov ◽  
Guzel Kamalova ◽  
Marina Polyakova

Drawing is characterized by non-uniform character of plastic deformation, which is transferred from the die to the processed wire. Such impact causes specific change of wire microstructure. In the surface area the thin layer with highly deformed grains is observed. It is important to measure the thickness of this thin layer. For this purpose it is proposed in this paper to use the value of coefficient of anisotropy, which is calculated as the ratio of mean quantity of phase particles, crossed by secant line perpendicular to deformation axis on the unit of secant line length to the mean quantity of phase particles, crossed by secant line parallel to deformation axis on the unit of secant line length. Distribution of coefficient of anisotropy, both for low and high carbon steel wire after drawing, was obtained by Thixomet PRO software. It made it possible to calculate the thickness of highly deformed area automatically taking into consideration the difference of steels microstructure.


1995 ◽  
Vol 68 (2) ◽  
pp. 297-310 ◽  
Author(s):  
B. Meissner

Abstract The statistical theory of bound rubber and the polymer-filler gel formation theory are shown to offer a satisfactory quantitative description of a set of experimental bound-rubber data recently obtained by Wolff, Wang, Tan (Rubber Chem. Technol. 66, 163 (1993)) on SBR compounds filled with 17 furnace blacks covering the whole range of rubber grades. The observed decrease of bound-rubber content per unit of interfacial area with increasing loading and/or specific surface area of carbon black is explained by the theory as being due to the statistical nature of the adsorption process. A correlation was found to exist between specific surface activity of filler D (adjustable parameter of the theory, number of active sites per unit surface area) and filler structure, the latter being characterized by the difference between DBP absorption and crushed DBP absorption. Also, D was found to increase with loading of a high-structure black. The two effects are ascribed to filler aggregates breakdown during mixing, which leads to a new active surface formation for polymer bonding.


2019 ◽  
Vol 14 (1) ◽  
pp. 51-60 ◽  
Author(s):  
Masato Iguchi ◽  
Haruhisa Nakamichi ◽  
Kuniaki Miyamoto ◽  
Makoto Shimomura ◽  
I Gusti Made Agung Nandaka ◽  
...  

We propose a method to evaluate the potential volume of eruptive material using the seismic energy of volcanic earthquakes prior to eruptions of Merapi volcano. For this analysis, we used well-documented eruptions of Merapi volcano with pyroclastic flows (1994, 1997, 1998, 2001, 2006, and 2010) and the rates and magnitudes of volcano-tectonic A-type, volcano-tectonic B-type, and multiphase earthquakes before each of the eruptions. Using the worldwide database presented by White and McCausland [1], we derived a log-linear formula that describes the upper limit of the potential volume of erupted material estimated from the cumulative seismic energy of distal volcano-tectonic earthquakes. The relationship between the volume of pyroclastic material and the cumulative seismic energy released in 1994, 1997, 1998, 2001, 2006, and 2010 at Merapi volcano is well-approximated by the empirical formula derived from worldwide data within an order of magnitude. It is possible to expand this to other volcanic eruptions with short (< 30 years) inter-eruptive intervals. The difference in the intruded and extruded volumes between intrusions and eruptions, and the selection of the time period for the cumulative energy calculation are problems that still need to be addressed.


Sign in / Sign up

Export Citation Format

Share Document