scholarly journals OPERATIONAL MECHANISM OF KARST SPRING “LOGARAS”, NEAR THE VILLAGE “SKORTSINOU”, ARCADIA, (PELOPONNESUS)

2017 ◽  
Vol 43 (4) ◽  
pp. 1707
Author(s):  
N. Karalemas ◽  
S. Lekkas
Keyword(s):  
Water Table ◽  
Carbonate Rocks ◽  
Accurate Determination ◽  
Karst Spring ◽  
Operational Mechanism ◽  
Recession Coefficient ◽  
Geological Map ◽  
The Village ◽  
Discharge Measurements

This paper presents information on the behavior of the Logaras karst spring, which is located 2.5 km north of Skortsinou village of the Municipality of Falaesia. This spring discharges the water table hosted in the carbonate rocks located in the area among Skortsinou, Petrina, Soulario and Voutsaras Villages. This area consists of thin-platy limestones of Pindos Unit that overlay the “First Flysch” formation, which is the stratigraphic bedrock of the aforementioned limestones. Aiming at the accurate determination of the boundaries of the spring’s hydrological basin, the geological map of I.G.M.E., sheet “Megalopolis” (Papadopoulos 1997 και Luettig & Vingen 1964) was re-examined. The geological and tectonic observations that derived from this process contributed to the analysis of the spring’s mechanical operation. This led to the conclusion Logaras Spring is a contact spring. Furthermore, discharge measurements of the spring took place for the period from 24/6/2006 to 26/10/2007 and the relevant hydrograph was drawn, from which the recession coefficient was calculated. More particularly, the spring’s recession coefficient for the hydrological years 2005 – 2006 and 2006 – 2007 is 1,9·10-3 and 4,3·10-3 respectively, while the dynamic volume reach 5,4 • 106 m3 and 1,7 • 106 m3 respectively.

A quantitative approach to inner shell losses

1978 ◽  
Vol 36 (1) ◽  
pp. 526-527 ◽  
Author(s):  
R.D. Leapman ◽  
P. Rez ◽  
D.F. Mayers
Keyword(s):  
Energy Transfer ◽  
Cross Section ◽  
Cross Sections ◽  
Accurate Determination ◽  
Background Intensity ◽  
Core Excitation ◽  
Quantitative Basis ◽  
Cross Section Differential ◽  
Bound Electrons

Microanalysis by EELS has been developing rapidly and though the general form of the spectrum is now understood there is a need to put the technique on a more quantitative basis (1,2). Certain aspects important for microanalysis include: (i) accurate determination of the partial cross sections, σx(α,ΔE) for core excitation when scattering lies inside collection angle a and energy range ΔE above the edge, (ii) behavior of the background intensity due to excitation of less strongly bound electrons, necessary for extrapolation beneath the signal of interest, (iii) departures from the simple hydrogenic K-edge seen in L and M losses, effecting σx and complicating microanalysis. Such problems might be approached empirically but here we describe how computation can elucidate the spectrum shape.The inelastic cross section differential with respect to energy transfer E and momentum transfer q for electrons of energy E0 and velocity v can be written as

Fast calibration of CBED patterns for quantitative analysis

1993 ◽  
Vol 51 ◽  
pp. 674-675
Author(s):  
M.A. Gribelyuk ◽  
M. Rühle
Keyword(s):  
Reciprocal Lattice ◽  
Accurate Determination ◽  
Incident Beam ◽  
Crystal Thickness ◽  
Structure Model ◽  
Beam Direction ◽  
Transmitted Beam ◽  
Reciprocal Vector ◽  
On Line

A new method is suggested for the accurate determination of the incident beam direction K, crystal thickness t and the coordinates of the basic reciprocal lattice vectors V1 and V2 (Fig. 1) of the ZOLZ plans in pixels of the digitized 2-D CBED pattern. For a given structure model and some estimated values Vest and Kest of some point O in the CBED pattern a set of line scans AkBk is chosen so that all the scans are located within CBED disks.The points on line scans AkBk are conjugate to those on A0B0 since they are shifted by the reciprocal vector gk with respect to each other. As many conjugate scans are considered as CBED disks fall into the energy filtered region of the experimental pattern. Electron intensities of the transmitted beam I0 and diffracted beams Igk for all points on conjugate scans are found as a function of crystal thickness t on the basis of the full dynamical calculation.

Computer-Assisted High-Re Solution TEM

1990 ◽  
Vol 48 (1) ◽  
pp. 162-163
Author(s):  
F.A. Ponce ◽  
H. Hikashi
Keyword(s):  
Signal To Noise Ratio ◽  
Accurate Determination ◽  
Computer Software ◽  
Video Camera ◽  
Image Contrast ◽  
Objective Lens ◽  
Computer Assisted ◽  
Optical Parameters ◽  
Astigmatism Correction

The determination of the atomic positions from HRTEM micrographs is only possible if the optical parameters are known to a certain accuracy, and reliable through-focus series are available to match the experimental images with calculated images of possible atomic models. The main limitation in interpreting images at the atomic level is the knowledge of the optical parameters such as beam alignment, astigmatism correction and defocus value. Under ordinary conditions, the uncertainty in these values is sufficiently large to prevent the accurate determination of the atomic positions. Therefore, in order to achieve the resolution power of the microscope (under 0.2nm) it is necessary to take extraordinary measures. The use of on line computers has been proposed [e.g.: 2-5] and used with certain amount of success.We have built a system that can perform operations in the range of one frame stored and analyzed per second. A schematic diagram of the system is shown in figure 1. A JEOL 4000EX microscope equipped with an external computer interface is directly linked to a SUN-3 computer. All electrical parameters in the microscope can be changed via this interface by the use of a set of commands. The image is received from a video camera. A commercial image processor improves the signal-to-noise ratio by recursively averaging with a time constant, usually set at 0.25 sec. The computer software is based on a multi-window system and is entirely mouse-driven. All operations can be performed by clicking the mouse on the appropiate windows and buttons. This capability leads to extreme friendliness, ease of operation, and high operator speeds. Image analysis can be done in various ways. Here, we have measured the image contrast and used it to optimize certain parameters. The system is designed to have instant access to: (a) x- and y- alignment coils, (b) x- and y- astigmatism correction coils, and (c) objective lens current. The algorithm is shown in figure 2. Figure 3 shows an example taken from a thin CdTe crystal. The image contrast is displayed for changing objective lens current (defocus value). The display is calibrated in angstroms. Images are stored on the disk and are accessible by clicking the data points in the graph. Some of the frame-store images are displayed in Fig. 4.

DINAMIKA POLITIK PERSETUJUAN BERSAMA TENTANG PENETAPAN DESA ADAT DI KABUPATEN ROKAN HULU TAHUN 2014

2017 ◽  
Vol 15 (1) ◽  
pp. 21
Author(s):  
Haryo Suganda ◽  
Raja Muhammad Amin
Keyword(s):  
Regulatory Region ◽  
Field Research ◽  
Analysis Techniques ◽  
Political Dynamics ◽  
Political Interests ◽  
Wide Range ◽  
Information Method ◽  
Qualitative Descriptive ◽  
The Village

This study is motivated the identification of policies issued by the regional Governmentof Rokan Hulu in the form of Regulatory region number 1 by 2015 on the determination of thevillage and Indigenous Village. Political dynamics based on various interests against themanufacture of, and decision-making in the process of formation of the corresponding localregulations determination of Indigenous Villages in the Rokan Hulu is impacted to a verysignificantamount of changes from the initial draft of the number i.e. 21 (twenty one) the villagebecame Customary 89 (eighty-nine) the Indigenous Villages who have passed. Type of thisresearch is a qualitative descriptive data analysis techniques. The research aims to describe theState of the real situation in a systematic and accurate fact analysis unit or related research, aswell as observations of the field based on the data (information). Method of data collectionwas done with interviews, documentation, and observations through fieldwork (field research).The results of the research on the process of discussion of the draft local regulations andmutual agreement about Designation of Indigenous Villages in the Rokan Hulu is, showed thatthe political dynamics that occur due to the presence of various political interests, rejectionorally by Villagers who were judged to have met the requirements of Draft Regulations to beformulated and the area for the set to be Indigenous Villages, and also there is a desire fromsome villages in the yet to Draft local regulations in order to set the Indigenous village , there isa wide range of interests of these aspects influenced the agreement to assign the entire localVillage which is in the Rokan Hulu become Indigenous village, and the village of Transmigrationinto administrative Villages where the initiator of the changes in the number of IndigenousVillages in the Rokan Hulu it is the desire of the local Government of its own.

Assessment of Sylphons Lifetime

2008 ◽  
Vol 59 (5) ◽  
pp. 605-610
Author(s):  
Alexandru Pupazescu ◽  
Stefan Minoiu ◽  
Constantin Manea
Keyword(s):  
Elevated Temperature ◽  
Strain Distribution ◽  
Accurate Determination ◽  
Multiaxial Fatigue ◽  
Tensile Curve

The paper contains an assessment of the sylphons lifetime for multiaxial fatigue. Three criteria were used two based on s � N diagram and one based on energy. For a more accurate determination of the sylphons lifetime the stress and the strain distribution been determined using FEM, the tensile curve of the steel W 4541 at elevated temperature.

Sign in / Sign up

Export Citation Format

Share Document