scholarly journals Determination of Hydrated Water in Soaps by Measurement of Dielectric Constant, Infrared Spectra and X-Ray Diffraction

1960 ◽  
Vol 34 (8) ◽  
pp. 694-698
Author(s):  
Syun NOGUCHI
Keyword(s):  
Dielectric Constant ◽  
Infrared Spectra ◽  
X Ray Diffraction ◽  
X Ray

Well-defined colloidal tin(IV) oxide particles

1990 ◽  
Vol 5 (5) ◽  
pp. 1083-1091 ◽  
Author(s):  
Manuel Ocaña ◽  
Egon Matijević
Keyword(s):  
Dielectric Constant ◽  
Infrared Spectra ◽  
Particle Morphology ◽  
Spherical Particles ◽  
Degree Of Crystallinity ◽  
Narrow Size Distribution ◽  
X Ray Diffraction ◽  
X Ray ◽  
Additional Information ◽  
Oxide Particles

Spherical and rod-like SnO2 particles of narrow size distribution have been obtained by aging at 100°C acidified tin(IV) chloride solutions in the presence of urea or formamide. It was shown that spherical particles, the x-ray diffraction of which was characteristic of cassiterite, consisted of a large number of much smaller subunits. The rod-like particles had the same structure, but of higher degree of crystallinity. Infrared spectra of these powders were evaluated in terms of the theory of the average dielectric constant (TADC), in order to gain additional information on the particle morphology and the state of aggregation.

Physicochemical Properties and Method for Determination of Potassium Guaiacolsulfonate

1987 ◽  
Vol 70 (4) ◽  
pp. 673-678
Author(s):  
Kunio Kawamura ◽  
Hideo Nakamachi ◽  
Hiroaki Araki ◽  
Kiyokazu Sonoda
Keyword(s):  
Liquid Chromatography ◽  
Physicochemical Properties ◽  
Infrared Spectra ◽  
Uv Spectra ◽  
Differential Scanning Calorimetric ◽  
X Ray Diffraction ◽  
X Ray ◽  
Ph Values ◽  
Diffraction Patterns

Abstract The physicochemical properties of potassium guaiacol-4-sulfonate (I) and -S-suIfonate (II) have been investigated. Analyses of the X-ray diffraction patterns, infrared spectra, and thermogravimetric and differential scanning calorimetric curves showed that I occurs as crystals that are anhydrous or hydrated up to ⅔ mole (4.8%) and that II occurs as crystals that are anhydrous or dihydrated (13.5%). Solutions of I and II at various pH values showed almost the same UV spectra at <pH 6.0 but very different UV spectra >pH 7.0. Most commercially available potassium guaiacolsulfonate consists predominantly of potassium guaiacol-4-sulfonate (as determined by UVabsorption measurements and liquid chromatography).

Sem and X-Ray Analysis of Renal and Biliary Calculi

1976 ◽  
Vol 34 ◽  
pp. 306-307
Author(s):  
R. J. Narconis ◽  
G. L. Johnson
Keyword(s):  
Chemical Constituents ◽  
Natural State ◽  
X Ray Diffraction ◽  
Chemical Methods ◽  
X Ray ◽  
Additional Dimension ◽  
Biliary Calculi ◽  
Calculus Formation ◽  
Scanning Electron

Analysis of the constituents of renal and biliary calculi may be of help in the management of patients with calculous disease. Several methods of analysis are available for identifying these constituents. Most common are chemical methods, optical crystallography, x-ray diffraction, and infrared spectroscopy. The application of a SEM with x-ray analysis capabilities should be considered as an additional alternative.A scanning electron microscope equipped with an x-ray “mapping” attachment offers an additional dimension in its ability to locate elemental constituents geographically, and thus, provide a clue in determination of possible metabolic etiology in calculus formation. The ability of this method to give an undisturbed view of adjacent layers of elements in their natural state is of advantage in determining the sequence of formation of subsequent layers of chemical constituents.

New Coordination Compounds of Fe(III) with Organic Ligands

2009 ◽  
Vol 59 (12) ◽  
Author(s):  
Mihaela Flondor ◽  
Ioan Rosca ◽  
Doina Sibiescu ◽  
Mihaela-Aurelia Vizitiu ◽  
Daniel-Mircea Sutiman ◽  
...  
Keyword(s):  
Chemical Analysis ◽  
Complex Compounds ◽  
Organic Ligands ◽  
X Ray Diffraction ◽  
X Ray ◽  
Elemental Chemical Analysis ◽  
Structural Formulae ◽  
Paramagnetic Properties

In this paper the synthesis and the study of some complex compounds of Fe(III) with ligands derived from: 2-(4-chloro-phenylsulfanyl)-1-(2-hydroxy-3,5-diiodo-phenyl)-ethanone (HL1), 1-(3,5-dibromo-2-hydroxy-phenyl)-2-phenylsulfanyl-ethanone(HL2), and 2-(4-chloro-phenylsulfanyl)-1-(3,5-dibromo-2-hydroxy-phenyl)-ethanone (HL3) is presented. The characterization of these complexes is based on method as: the elemental chemical analysis, IR and ESR spectroscopy, M�ssbauer, the thermogravimetric analysis and X-ray diffraction. Study of the IR and chemical analysis has evidenced that the precipitates form are a complexes and the combination ratio of M:L is 1:2. The central atoms of Fe(III) presented paramagnetic properties and a octaedric hybridization. Starting from this precipitation reactions, a method for the gravimetric determination of Fe(III) with this organic ligands has been possible. Based on the experimental data on literature indications, the structural formulae of the complex compounds are assigned.

Infrared spectroscopic study of the YPO4-YCrO4 system

1985 ◽  
Vol 50 (10) ◽  
pp. 2139-2145
Author(s):  
Alexander Muck ◽  
Eva Šantavá ◽  
Bohumil Hájek
Keyword(s):  
Spectroscopic Study ◽  
Infrared Spectra ◽  
Point Of View ◽  
Mixed Crystals ◽  
Crystal Symmetry ◽  
Infrared Spectroscopic Study ◽  
X Ray Diffraction ◽  
X Ray ◽  
Infrared Spectroscopic ◽  
Diffraction Patterns

The infrared spectra and powder X-ray diffraction patterns of polycrystalline YPO4-YCrO4 samples are studied from the point of view of their crystal symmetry. Mixed crystals of the D4h19 symmetry are formed over the region of 0-30 mol.% YPO4 in YCrO4. The Td → D2d → D2 or C2v(GS eff) correlation is appropriate for both PO43- and CrO43- anions.

Crystal structure determination of the conformation of two bicyclo[3.3.1]nonan-ones

1985 ◽  
Vol 63 (6) ◽  
pp. 1166-1169 ◽  
Author(s):  
John F. Richardson ◽  
Ted S. Sorensen
Keyword(s):  
Crystal Structure ◽  
Direct Methods ◽  
Chair Conformation ◽  
Molecular Structures ◽  
Boat Conformation ◽  
X Ray Diffraction ◽  
Space Group ◽  
X Ray ◽  
Final Agreement

The molecular structures of exo-7-methylbicyclo[3.3.1]nonan-3-one, 3, and the endo-7-methyl isomer, 4, have been determined using X-ray-diffraction techniques. Compound 3 crystallizes in the space group [Formula: see text] with a = 15.115(1), c = 7.677(2) Å, and Z = 8 while 4 crystallizes in the space group P21 with a = 6.446(1), b = 7.831(1), c = 8.414(2) Å, β = 94.42(2)°, and Z = 2. The structures were solved by direct methods and refined to final agreement factors of R = 0.041 and R = 0.034 for 3 and 4 respectively. Compound 3 exists in a chair–chair conformation and there is no significant flattening of the chair rings. However, in 4, the non-ketone ring is forced into a boat conformation. These results are significant in interpreting what conformations may be present in the related sp2-hybridized carbocations.

scholarly journals Mining Wastes of an Albite Deposit as Raw Materials for Vitrified Mullite Ceramics

Minerals ◽  
2021 ◽  
Vol 11 (3) ◽  
pp. 232
Author(s):  
Pedro J. Sánchez-Soto ◽  
Eduardo Garzón ◽  
Luis Pérez-Villarejo ◽  
George N. Angelopoulos ◽  
Dolores Eliche-Quesada
Keyword(s):  
Particle Size ◽  
Raw Materials ◽  
Phase Evolution ◽  
Particle Size Analysis ◽  
Size Analysis ◽  
Mining Wastes ◽  
X Ray Diffraction ◽  
X Ray ◽  
Maximum Value

In this work, an examination of mining wastes of an albite deposit in south Spain was carried out using X-ray Fluorescence (XRF), X-ray diffraction (XRD), particle size analysis, thermo-dilatometry and Differential Thermal Analysis (DTA) and Thermogravimetric (TG) analysis, followed by the determination of the main ceramic properties. The albite content in two selected samples was high (65–40 wt. %), accompanied by quartz (25–40 wt. %) and other minor minerals identified by XRD, mainly kaolinite, in agreement with the high content of silica and alumina determined by XRF. The content of Na2O was in the range 5.44–3.09 wt. %, being associated with albite. The iron content was very low (<0.75 wt. %). The kaolinite content in the waste was estimated from ~8 to 32 wt. %. The particle size analysis indicated values of 11–31 wt. % of particles <63 µm. The ceramic properties of fired samples (1000–1350 °C) showed progressive shrinkage by the thermal effect, with water absorption and open porosity almost at zero at 1200–1250 °C. At 1200 °C, the bulk density reached a maximum value of 2.38 g/cm3. An abrupt change in the phase evolution by XRD was found from 1150 to 1200 °C, with the disappearance of albite by melting in accordance with the predictions of the phase diagram SiO2-Al2O3-Na2O and the system albite-quartz. These fired materials contained as main crystalline phases quartz and mullite. Quartz was present in the raw samples and mullite was formed by decomposition of kaolinite. The observation of mullite forming needle-shape crystals was revealed by Scanning Electron Microscopy (SEM). The formation of fully densified and vitrified mullite materials by firing treatments was demonstrated.

Sign in / Sign up

Export Citation Format

Share Document