Geology and Structural Control of Geothermal System at Roosevelt Hot Springs KGRA, Beaver County, Utah: ABSTRACT

AAPG Bulletin ◽  
1979 ◽  
Vol 63 ◽  
Author(s):  
Dennis L. Nielson, Bruce S. Sibbett
2018 ◽  
Vol 37 (2) ◽  
pp. 626-645
Author(s):  
Wei Zhang ◽  
Guiling Wang ◽  
Linxiao Xing ◽  
Tingxin Li ◽  
Jiayi Zhao

The geochemical characteristics of geothermically heated water can reveal deep geothermal processes, leading to a better understanding of geothermal system genesis and providing guidance for improved development and utilization of such resources. Hydrochemical and hydrogen oxygen isotope analysis of two geothermal field (district) hot springs based on regional geothermal conditions revealed that the thermal water in the Litang region is primarily of the HCO3Na type. The positive correlations found between F−, Li2+, As+, and Cl− indicated a common origin, and the relatively high Na+ and metaboric acid concentrations suggested a relatively long groundwater recharge time and a slow flow rate. The values of δD and δ18O were well distributed along the local meteoric line, indicating a groundwater recharge essentially driven by precipitation. The thermal reservoir temperature (152°C–195°C) and thermal cycle depth (3156–4070 m) were calculated, and the cold water mixing ratio (60%–68%) was obtained using the silica-enthalpy model. Finally, hydrogeochemical pathway simulation was used to analyze the evolution of geothermal water in the region. The results were further supported by the high metasilicate content in the region. Of the geothermal fields in the region, it was found that the Kahui is primarily affected by albite, calcite precipitation, and silicate, while the Gezha field is primarily affected by calcite dissolution, dolomite precipitation, and silicate.


2018 ◽  
Vol 2 (2) ◽  
pp. 48
Author(s):  
Vanadia Martadiastuti ◽  
Agung Harijoko ◽  
I Wayan Warmada ◽  
Kotaro Yonezu

Arjuno-Welirang Volcanic Complex (AWVC) is one of geothermal fields whichlocated in East Java province, Indonesia. It belongs to a Quarternary volcanic arc and has potential for development of electricity. The field is situated in a steep volcanic terrain and there are only few geothermal manifestations, i.e., hot springs, fumaroles, solfataras, steaming ground and hydrothermal alteration. This study aims to classify the type and source of geothermal fluid and to estimate the reservoir condition of Arjuno- Welirang geothermal system. Data are obtained from collecting water samples including hot springs, cold springs, river waters and rain water, then they are analyzed using ICP-AES, titration and ion chromatography.All thermal waters have temperatures from 39.5–53°C and weakly acidic pH (5.2–6.5). Cangar and Padusanhot springs show bicarbonate water, formed by steam condensing or groundwater mixing. On the other hand, Songgoriti shows Cl-HCO3 type, formed by dilution of chloride fluid by either groundwater or bicarbonate water during lateral flow. All of the waters represent immature waters, indicating no strong outflow of neutral Cl-rich deep waters in AWVC. Cl/B ratios show that all water samples have a similar mixing ratio, showing they are from common fluid sources. However, Padusan and Songgoriti have higher Cl/B ratios than Cangar, suggesting that geothermal fluids possibly have reacted with sedimentary rocks before ascending to the surface. All waters were possibly mixed with shallow groundwater and they underwent rock-water reactions at depth before ascending to the surface. An estimated temperatures reservoir calculated using CO2 geothermometer yielded temperatures of 262–263 °C based on collecting of fumarole gas at Mt. Welirang crater. According to their characteristics, Cangar and Padusan are associated with AWVC, while Songgoriti is associated with Mt. Kawi.


2018 ◽  
Vol 35 (2) ◽  
pp. 116-141 ◽  
Author(s):  
Erika Almirudis ◽  
Edgar R. Santoyo-Gutiérrez ◽  
Mirna Guevara ◽  
Francisco Paz-Moreno ◽  
Enrique Portugal

A promissory low-to-medium temperature geothermal system located in Sonora (Mexico) has been studied. In the present work, a detailed geochemical survey was carried out to understand the hydrogeochemical signatures of hot spring waters. A field work campaign was conducted for collecting water samples from twelve hot springs placed in four major zones (NW, NE, C, and S). The collected samples were analysed by chemical and isotopic methods for determining their chemical (major and trace elements) and isotopic (18O/16O and D/H) compositions. Using geochemometric analyses of the fluid composition and fractionation, depletion and enrichment processes exhibited by major and trace elements were analysed. Hydrogeochemical classification was used to indicate the presence of sodium-sulphate (Na-SO4) waters in the North (NW and NE) and South hydrothermal zones; whereas calcium-magnesium-bicarbonate (Ca-Mg-HCO3) waters were identified for the Central zone. Some hot spring waters located in the NE zone were also typified as sodium-bicarbonate (Na-HCO3). In relation to the isotopic signatures of 18O/16O and D/H, four water samples from NE and C zones lie near to the global meteoric water line; whereas the remaining eight samples showed a shift for both oxygen and deuterium isotopes. A mixing line with a small shift of δ18O was identified and used as a proxy to discriminate waters with different isotopic signatures. After applying a geochemometric outliers detection/rejection and an iterative ANOVA statistical test, the mean temperature inferred from the most reliable solute geothermometers was 149±40 °C, which suggests to be considered as the minimum value of the reservoir temperature. As most of the hot spring waters fall outside of the full equilibrium curve, the original reservoir conditions were corrected by using a mixing conductive model, which predicted a deep equilibrium temperature of 210±11 °C. As this temperature is considerably higher than the mean temperature inferred from the geothermometers, it was suggested as an optimistic maximum reservoir temperature of the Sonora geothermal system. Using 150 °C and 200 °C as rounded-off reservoir temperatures (or min-max estimates), geochemical equilibria modelling based on fluid-mineral stability diagrams was carried out. An equilibrium process among local hydrothermal waters and albite-potassium feldespar and muscovite-prehnite-laumontite mineral assemblages was found. These minerals were proposed as representative mineral assemblages of low-grade metamorphism, which seems to indicate that the geothermal fluid equilibria were probably reached within the intermediate to acidic volcanic rocks from the Tarahumara Formation.


2012 ◽  
Vol 3 ◽  
pp. 34-40
Author(s):  
Hendrik Tjiawi ◽  
Andrew C. Palmer ◽  
Grahame J. H. Oliver

 The existence of hot springs coupled with the apparent anomalous high heat flow has sparked interest in the potential for geothermal development in Singapore. This geothermal resource may be potentially significant and could be exploited through Engineered Geothermal System (EGS) technology, i.e. a method to create artificial permeability at depth in granitic or sandstone formations as found under Singapore. The apparently ever-increasing fossil fuel price has made the cost of using the EGS technology more viable than it was in the past. Thus, to assess the resource, a numerical model for the geothermal reservoir has been constructed. Mass and heat flows in the system are simulated in 2D with AUTOUGH2.2, and the graphical interface processed through MULGRAPH2.2. Natural state calibration was performed to match both the observed and the expected groundwater profile, and also to match the hot water upflow at the Sembawang hot spring, with simulated flowrate matching the hot spring natural flowrate. The simulation gives an encouraging result of 125 - 150 °C hot water at depth 1.25 – 2.75 km.


2014 ◽  
Vol 886 ◽  
pp. 489-495
Author(s):  
Ze De Liang ◽  
Shu Jie Wang

The main geothermal resources in China are low or medium-temperature geothermal resources, these are more than 3000 hot springs, which of above 60 °C account for 24 percent of total, those are more than 720. In these hot springs bases for tourism and leisure and spa medical, the demand of electricity and air-conditioning is relatively large, so these is a very important practical significance to develop low or medium-temperature geothermal resources technology. If hot springs geothermal system uses lithium bromide-water azeotropic binary mixtures as working fluid, which not only reduces the heat loss of temperature difference, but also plays the advantages in thermodynamics and environmental aspects. Three systems of this article described all use water vapor as the working fluid, their characteristics are analyzed and compared, respectively. By analysis found that: when the demand is only for power generation and non-condensable gas content in hot springs geothermal water is not too high, the single-stage flash evaporation electrical system is more favorable; because of hot springs primarily for leisure travel and medical care function, and the demand for air conditioning and refrigeration is also large, so the combined system is more favorable.


2017 ◽  
Vol 329 ◽  
pp. 54-68 ◽  
Author(s):  
Thomas M. Etzel ◽  
John R. Bowman ◽  
Joseph N. Moore ◽  
John W. Valley ◽  
Michael J. Spicuzza ◽  
...  

Geothermics ◽  
2008 ◽  
Vol 37 (6) ◽  
pp. 565-585 ◽  
Author(s):  
Kamil Erkan ◽  
Gwen Holdmann ◽  
Walter Benoit ◽  
David Blackwell

Sign in / Sign up

Export Citation Format

Share Document