scholarly journals Performance analysis of direct detection optical OFDM systems

2018 ◽  
Vol 7 (1.9) ◽  
pp. 123
Author(s):  
Kumar D ◽  
Anilkumar R ◽  
Vijayakumar C N ◽  
S Bhargavi
Keyword(s):  
Performance Analysis ◽  
Communication Systems ◽  
Orthogonal Frequency Division Multiplexing ◽  
Continuous Wave ◽  
Direct Detection ◽  
Multicarrier Modulation ◽  
Laser Source ◽  
Ofdm Systems ◽  
Modulation Technique ◽  
Optical Ofdm

Orthogonal frequency division multiplexing (OFDM) is a multicarrier modulation technique, in which the data information is carried over many lower rate subcarriers. This technique is started effectively using in both line communication and wireless communication systems. This modulation technique has been actively started in the field of light wave communication called optical OFDM (OOFDM) system. OOFDM is a multicarrier modulation technique; it is used to overcome the problem of inter-symbol interference due to the chromatic dispersion and polarization mode dispersion of the fiber channel. In this paper, we have done simulation on direct detection optical OFDM (DDOOFDM) system with data rate of 10Gbps and measuring performance analysis of DDOOFDM system with respect to the received optical power and various full width half maximum value of the continuous wave laser source. This analysis is simulated using RSOFT Design Group OptSim Version-5.2.

scholarly journals Theoretical and Experimental Investigation of Direct Detection Optical OFDM Systems with Clipping and Normalization

2018 ◽  
Vol 2018 ◽  
pp. 1-11 ◽  
Author(s):  
Jiang Wu ◽  
Zhongpeng Wang
Keyword(s):  
Orthogonal Frequency Division Multiplexing ◽  
Direct Detection ◽  
Single Mode ◽  
Superior Performance ◽  
Ofdm Systems ◽  
Ofdm System ◽  
Transmission Scheme ◽  
Awgn Channel ◽  
Ofdm Signal ◽  
Optical Ofdm

A data clipping and normalization technique is employed to improve the performance of the overall direct detection optical orthogonal frequency division multiplexing (DCO-OFDM) system. A detailed analysis of clipping distortion introduced by digital clipping and normalization is provided. The normalization operation amplifies the clipped data signal to the maximum input amplitude of a digital-to-analog converter (DAC). Based on the analysis, a BER formula of the proposed scheme is derived over the AWGN channel and single fiber channel. Performance of an optical clipped OFDM with normalization is assessed through numerical simulations and Monte Claro simulation over the AWGN channel. Theoretical analysis and simulation results both show that the clipping and normalization scheme can greatly improve the BER of an optical OFDM. In particular, BER performance of the proposed transmission scheme was measured in a practical OFDM transmission platform. The measured experimental results show that the clipped and amplified OFDM signal exhibits superior performance in comparison with the conventional OFDM signal. The received sensitivity at a BER of 10−3 for a 4 Gsamples/s (2.6667 Gbits/s) clipped and normalized OFDM signal with clipping ratio of 4 after 100 km standard single-mode fiber (SMF) transmission was improved by 4.3 dB when compared with the conventional OFDM system. The measured results also showed that the clipped OFDM signal exhibits superior performance in comparison with the conventional OFDM signal. Therefore, a clipping and normalization at the transmitter is most effective, and a substantial performance improvement can be obtained by a simple normalization after clipping.

An Improved Frame Synchronization for Optical OFDM Systems

2012 ◽  
Vol 571 ◽  
pp. 646-650
Author(s):  
Meng Liang ◽  
Rong Lu ◽  
Yuan Bo Wang ◽  
Jia Min Gong
Keyword(s):  
Orthogonal Frequency Division Multiplexing ◽  
Direct Detection ◽  
Dispersion Compensation ◽  
Critical Factor ◽  
Timing Synchronization ◽  
Frame Synchronization ◽  
Ofdm Systems ◽  
Ofdm System ◽  
Transmission Distance ◽  
Optical Ofdm

Orthogonal frequency division multiplexing (OFDM) is applied to optical communication widely because of its robustness against channel dispersion and high spectral efficiency. But the synchronization between transmitter and receiver is a critical factor for system performances. This paper proposes an improved frame timing synchronization algorithm for optical OFDM system to keep synchronization by delay time compensation. The simulation of 40 Gb/s single-side-band (SSB) direct-detection optical OFDM system is setup and investigated. The curve of timing metric and the constellation of four-quadrature amplitude modulation (QAM) are given in the paper. And the transmission distance using the proposed method is compared with Park method. The simulation results show that the improved frame synchronization method promote the performances of optical OFDM system greatly. The distance can be 1600 km without dispersion compensation under the bit error ratio of 10-4.

scholarly journals Análisis de la técnica UFMC en un canal multitrayecto y usando estimación de canal

2021 ◽  
Vol 9 (17) ◽  
pp. 26-39
Author(s):  
Hugo Wladimir Iza Benítez ◽  
Diego Javier Reinoso Chisaguano
Keyword(s):  
Communication Systems ◽  
Orthogonal Frequency Division Multiplexing ◽  
Filter Bank ◽  
Estimation Method ◽  
Wireless Communication Systems ◽  
Ofdm Systems ◽  
Matlab Simulation ◽  
Fifth Generation ◽  
Power Spectral ◽  
Filter Bank Multicarrier

UFMC (Universal Filtered Multi-Carrier) is a novel multi-carrier transmission technique that aims to replace the OFDM (Orthogonal Frequency Division Multiplexing) modulation technique for fifth generation (5G) wireless communication systems. UFMC, being a generalization of OFDM and FBMC (Filter Bank Multicarrier), combines the advantages of these systems and at the same time avoids their main disadvantages. Using a Matlab simulation, this article presents an analysis of the robustness of UFMC against fading effects of multipath channels without using a CP (cyclic prefix). The behavior of the UFMC system is analyzed in terms of the PSD (Power Spectral Density), BER (Bit Error Rate) and MSE (Mean Square Error). The results show that UFMC reduces the out-band side lobes produced in the PSD of the processed signal. Also, it is shown that the pilot-assisted channel estimation method applied in OFDM systems can also be applied in UFMC systems.

scholarly journals On the Comparative Performance Analysis of PAPR Reduction Techniques in OFDM System

2015 ◽  
Vol 43 ◽  
pp. 39-49
Author(s):  
Md. Ibrahim Khalil ◽  
Sabbir Ahmed
Keyword(s):  
Performance Analysis ◽  
Orthogonal Frequency Division Multiplexing ◽  
Average Power ◽  
Papr Reduction ◽  
Hadamard Transform ◽  
Ofdm Systems ◽  
Comparative Performance ◽  
Computational Overhead ◽  
Reduction Techniques ◽  
Overall Performance

Selected Mapping (SLM) and Partial Transmit Sequence (PTS) are two very well-known Peak-to-average Power Ratio (PAPR) reduction techniques for Orthogonal Frequency Division Multiplexing (OFDM) systems. Both these schemes show good PAPR reduction capabilities. However, for any PAPR reduction technique, the nature of spectral occupancy and the associated computational complexity also need to be taken into account when the overall performance is considered. In this paper, our goal is to perform a comparative performance analysis of SLM and PTS techniques by considering these three parameters, i.e. PAPR reduction, computational overhead and spectral compactness. For this, we at first look for the optimum values in terms of number of sequences in SLM and no. of sub-blocks in PTS. And then based on this finding, we perform performance analysis. Our finding shows that, PTS outperforms SLM when compared on the parameters mentioned above. Finally, to explore the feasibility of further improvement, we apply Walsh-Hadamard Transform to PTS scheme and show that it further reduces PAPR and improves spectral compactness.

scholarly journals Palm Date Leaf Clipping: A New Method to Reduce PAPR in OFDM Systems

Information ◽  
2020 ◽  
Vol 11 (4) ◽  
pp. 190 ◽  
Author(s):  
Brahim Bakkas ◽  
Reda Benkhouya ◽  
Idriss Chana ◽  
Hussain Ben-Azza
Keyword(s):  
Communication Systems ◽  
Orthogonal Frequency Division Multiplexing ◽  
High Speed ◽  
Average Power ◽  
Papr Reduction ◽  
Frequency Division ◽  
Ofdm Systems ◽  
Leaf Clipping ◽  
Hyperbolic Cosine ◽  
Transmitted Signal

Orthogonal frequency division multiplexing (OFDM) is the key technology used in high-speed communication systems. One of the major drawbacks of OFDM systems is the high peak-to-average power ratio (PAPR) of the transmitted signal. The transmitted signal with a high PAPR requires a very large linear range of the Power Amplifier (PA) on the transmitter side. In this paper, we propose and study a new clipping method named Palm Clipping (Palm date leaf) based on hyperbolic cosine. To evaluate and analyze its performance in terms of the PAPR and Bit Error Rate (BER), we performed some computer simulations by varying the Clipping Ratio (CR) and modulation schemes. The obtained results show that it is possible to achieve a gain of between 7 and 9 dB in terms of PAPR reduction depending on the type of modulation. In addition, comparison with several techniques in terms of PAPR and BER shows that our method is a strong alternative that can be adopted as a PAPR reduction technique for OFDM-based communication systems.

Efficient Blind Adaptive CSE to Reduce Cyclic Prefix Length in Direct Detection Optical OFDM Systems

2019 ◽  
Vol 0 (0) ◽  
Author(s):  
Asmaa Benieddi ◽  
Sid Ahmed Elahmar
Keyword(s):  
Orthogonal Frequency Division Multiplexing ◽  
Direct Detection ◽  
Group Velocity Dispersion ◽  
Signal To Noise Ratio ◽  
Single Mode ◽  
Optical Signal ◽  
Single Mode Fiber ◽  
Cyclic Prefix ◽  
Ofdm Systems ◽  
Blind Adaptive

AbstractDirect detection optical orthogonal frequency division multiplexing (DDO-OFDM) systems for a long-reach of standard single mode fiber (SSMF) require a large length of cyclic prefix (CP) to avoid the inter-symbol interference (ISI) effect caused by group velocity dispersion (GVD). Unfortunately, this method is inefficient due to the energy wasted in CP samples. In order to reduce the CP length and to mitigate the residual ISI, a novel blind adaptive channel shortening equalizer (CSE) is proposed in this paper. Based on the orthogonality between subcarriers in the fast Fourier transform (FFT) property, the proposed algorithm attempts to minimize the sum-squared correlation (SSCM) between each sample located in a well-defined window to update the CSE coefficients. Thus, the combined channel-CSE response is shortened. Therefore, it can cancel the residual ISI effect due to the GVD and the short CP length. The performance of the system is evaluated on basis of bit error rate (BER) versus optical signal to noise ratio (OSNR) for different CP lengths. The simulation results validate the new algorithm SSCM and show that it can reduce the CP length with a much better system improvement than existing algorithms.

Sign in / Sign up

Export Citation Format

Share Document