scholarly journals Influence of Heat Disturbance on the Performance of YSZ based CO2 Sensor with Compound of Li2CO3-BaCO3-Nd2O3 as Auxiliary Sensing Electrode

2020 ◽  
Vol 23 (4) ◽  
pp. 244-251
Author(s):  
Guangwei Wang ◽  
Hongzhen Chen ◽  
Yuanhui Wu

Suddenly changes and fluctuations of temperature often occur in the operational environment of the CO2 electrochemical sensor. In this work, the YSZ based potentiometric CO2 sensor having Li2CO3-BaCO3-Nd2O3 compound as its auxiliary sensing material was prepared. And the effects of several types of heat disturbance on the performance of this kind of sensor ware studied. The results indicate that the sensors after heat disturbances respond similarly with the sensor as prepared, which presents rapid and correct response for the change of CO2 concentration within the experimental range of 271-576802 ppm. The sensors, with or without heat disturbance, respond well as different extents of abrupt alteration of CO2 concentration occurs, and the EMF outputs recover rapidly as the concentration of CO2 change back to the base value. At the constant concentration of CO2, the EMFs of the sensors with or without heat treatment decrease slowly as the time increases, the reason for this phenomenon might be the accumulation of inert substances on the electrode interfaces and ageing of electrodes. However, heat treatment can improve the long-term stability of the sensor to some extent. Furthermore, this type of sensor works stably with the existence of water vapor (10%), it has similar response curve in the dry and water vapor content system. After some further investigations and improvements, it might be potentially applied in the practical combustion atmosphere.

Sensors ◽  
2021 ◽  
Vol 21 (16) ◽  
pp. 5347
Author(s):  
Xiaoning Jia ◽  
Joris Roels ◽  
Roel Baets ◽  
Gunther Roelkens

In this paper, we present a fully integrated Non-dispersive Infrared (NDIR) CO2 sensor implemented on a silicon chip. The sensor is based on an integrating cylinder with access waveguides. A mid-IR LED is used as the optical source, and two mid-IR photodiodes are used as detectors. The fully integrated sensor is formed by wafer bonding of two silicon substrates. The fabricated sensor was evaluated by performing a CO2 concentration measurement, showing a limit of detection of ∼750 ppm. The cross-sensitivity of the sensor to water vapor was studied both experimentally and numerically. No notable water interference was observed in the experimental characterizations. Numerical simulations showed that the transmission change induced by water vapor absorption is much smaller than the detection limit of the sensor. A qualitative analysis on the long term stability of the sensor revealed that the long term stability of the sensor is subject to the temperature fluctuations in the laboratory. The use of relatively cheap LED and photodiodes bare chips, together with the wafer-level fabrication process of the sensor provides the potential for a low cost, highly miniaturized NDIR CO2 sensor.


Nanomaterials ◽  
2021 ◽  
Vol 11 (9) ◽  
pp. 2199
Author(s):  
Seiji Yamaguchi ◽  
Phuc Thi Minh Le ◽  
Seine A. Shintani ◽  
Hiroaki Takadama ◽  
Morihiro Ito ◽  
...  

In the orthopedic and dental fields, simultaneously conferring titanium (Ti) and its alloy implants with antibacterial and bone-bonding capabilities is an outstanding challenge. In the present study, we developed a novel combined solution and heat treatment that controllably incorporates 0.7% to 10.5% of iodine into Ti and its alloys by ion exchange with calcium ions in a bioactive calcium titanate. The treated metals formed iodine-containing calcium-deficient calcium titanate with abundant Ti-OH groups on their surfaces. High-resolution XPS analysis revealed that the incorporated iodine ions were mainly positively charged. The surface treatment also induced a shift in the isoelectric point toward a higher pH, which indicated a prevalence of basic surface functionalities. The Ti loaded with 8.6% iodine slowly released 5.6 ppm of iodine over 90 days and exhibited strong antibacterial activity (reduction rate >99%) against methicillin-resistant Staphylococcus aureus (MRSA), S. aureus, Escherichia coli, and S. epidermidis. A long-term stability test of the antibacterial activity on MRSA showed that the treated Ti maintained a >99% reduction until 3 months, and then it gradually decreased after 6 months (to a 97.3% reduction). There was no cytotoxicity in MC3T3-E1 or L929 cells, whereas apatite formed on the treated metal in a simulated body fluid within 3 days. It is expected that the iodine-carrying Ti and its alloys will be particularly useful for orthopedic and dental implants since they reliably bond to bone and prevent infection owing to their apatite formation, cytocompatibility, and sustainable antibacterial activity.


Author(s):  
Kirsten L. Brookshire ◽  
Mariusz Martyniuk ◽  
K. K. M. B. Dilusha Silva ◽  
Yinong Liu ◽  
Lorenzo Faraone

2005 ◽  
Vol 107 ◽  
pp. 141-144 ◽  
Author(s):  
Youtao Xie ◽  
Paul K. Chu ◽  
Xuan Yong Liu ◽  
Chuan Xian Ding

The long-term stability of plasma-sprayed dicalcium silicate (C2S) composite coatings is determined by the phase composition, crystallinity, and other properties. Zirconia reinforcement and post-spraying heat treatment are applied to C2S coatings simultaneously in this work. The stability of the coating increases evidently by reinforcement with 70wt% zirconia and heat treatment at 800oC for 4 hours. SEM reveals that the smooth glassy surface of the as-sprayed coatings is replaced by randomly dispersed crystals. Tris-HCl immersion test results show that the dissolution rate of the composite coatings decreases after the heat treatment.


2009 ◽  
Vol 2 (4) ◽  
pp. 2055-2085 ◽  
Author(s):  
P. Sturm ◽  
A. Knohl

Abstract. We present a detailed assessment of a commercially available water vapor isotope analyzer (WVIA, Los Gatos Research, Inc.) for simultaneous in-situ measurements of δ2H and δ18O in water vapor. This method, based on off-axis integrated cavity output spectroscopy, is an alternative to the conventional water trap/isotope ratio mass spectrometry (IRMS) techniques. We evaluate the analyzer in terms of precision, memory effects, concentration dependence, temperature sensitivity and long-term stability. A calibration system based on ink jet technology is used to characterize the performance and to calibrate the analyzer. Our results show that the precision at an averaging time of 15 s is 0.16‰ for δ2H and 0.08‰ for δ18O. The isotope ratios are strongly dependent on the water mixing ratio of the air. Taking into account this concentration dependence as well as the temperature sensitivity of the instrument we obtained a long-term stability of the water isotope measurements of 0.38‰ for δ2H and 0.25‰ for δ18O. The accuracy of the WVIA was further assessed by comparative measurements using IRMS and a dew point generator indicating a linear response in isotopic composition and H2O concentrations. The WVIA combined with a calibration system provides accurate high resolution water vapor isotope measurements and opens new possibilities for hydrological and ecological applications.


2010 ◽  
Vol 3 (1) ◽  
pp. 67-77 ◽  
Author(s):  
P. Sturm ◽  
A. Knohl

Abstract. We present a detailed assessment of a commercially available water vapor isotope analyzer (WVIA, Los Gatos Research, Inc.) for simultaneous in-situ measurements of δ2H and δ18O in water vapor. This method, based on off-axis integrated cavity output spectroscopy, is an alternative to the conventional water trap/isotope ratio mass spectrometry (IRMS) techniques. We evaluate the analyzer in terms of precision, memory effects, concentration dependence, temperature sensitivity and long-term stability. A calibration system based on a droplet generator is used to characterize the performance and to calibrate the analyzer. Our results show that the precision at an averaging time of 15 s is 0.16‰ for δ2H and 0.08‰ for δ18O. The isotope ratios are strongly dependent on the water mixing ratio of the air. Taking into account this concentration dependence as well as the temperature sensitivity of the instrument we obtained a long-term stability of the water isotope measurements of 0.38‰ for δ2H and 0.25‰ for δ18O. The accuracy of the WVIA was further assessed by comparative measurements using IRMS and a dew point generator indicating a linear response in isotopic composition and H2O concentrations. The WVIA combined with a calibration system provides accurate high resolution water vapor isotope measurements and opens new possibilities for hydrological and ecological applications.


1977 ◽  
Vol 4 (3-4) ◽  
pp. 133-137 ◽  
Author(s):  
Jürgen Griessing

A process is described to obtain NiCr resistors with adjustable temperature coefficient of resistance (TCR) by reactive sputtering in an Ar-atmosphere with a small amount of oxygen in the range of 2% to 6%. As deposited the films show a TCR < −200 ppm/K. By heat treatment in air at a temperature of 350°C the TCR can be raised to values above −20 ppm/K. The time of heat treatment necessary to obtain a given TCR depends on the oxygen/argon ratio during sputtering. The long term stability is not affected by the choice of this ratio in a wide range.Resistor networks with a solderable conductor pattern of TiPdAu have a TCR of 0±7 ppm/K and a long term resistance drift ≤ 2‰ in the first 1,000 hours at 125°C.


2021 ◽  
Vol 21 (20) ◽  
pp. 15409-15430
Author(s):  
Nathaniel J. Livesey ◽  
William G. Read ◽  
Lucien Froidevaux ◽  
Alyn Lambert ◽  
Michelle L. Santee ◽  
...  

Abstract. The Microwave Limb Sounder (MLS), launched on NASA's Aura spacecraft in 2004, measures vertical profiles of the abundances of key atmospheric species from the upper troposphere to the mesosphere with daily near-global coverage. We review the first 15 years of the record of H2O and N2O measurements from the MLS 190 GHz subsystem (along with other 190 GHz information), with a focus on their long-term stability, largely based on comparisons with measurements from other sensors. These comparisons generally show signs of an increasing drift in the MLS “version 4” (v4) H2O record starting around 2010. Specifically, comparisons with v4.1 measurements from the Atmospheric Chemistry Experiment Fourier Transform Spectrometer (ACE-FTS) indicate a ∼ 2 %–3 % per decade drift over much of the stratosphere, increasing to as much as ∼ 7 % per decade around 46 hPa. Larger drifts, of around 7 %–11 % per decade, are seen in comparisons to balloon-borne frost point hygrometer measurements in the lower stratosphere. Microphysical calculations considering the formation of polar stratospheric clouds in the Antarctic winter stratosphere corroborate a drift in MLS v4 water vapor measurements in that region and season. In contrast, comparisons with the Sounding of the Atmosphere using Broadband Emission Radiometry (SABER) instrument on NASA's Thermosphere Ionosphere Mesosphere Energetics and Dynamics (TIMED) mission, and with ground-based Water Vapor Millimeter-wave Spectrometer (WVMS) instruments, do not show statistically significant drifts. However, the uncertainty in these comparisons is large enough to encompass most of the drifts identified in other comparisons. In parallel, the MLS v4 N2O product is shown to be generally decreasing over the same period (when an increase in stratospheric N2O is expected, reflecting a secular growth in emissions), with a more pronounced drift in the lower stratosphere than that found for H2O. Comparisons to ACE-FTS and to MLS N2O observations in a different spectral region, with the latter available from 2004 to 2013, indicate an altitude-dependent drift, growing from 5 % per decade or less in the mid-stratosphere to as much as 15 % per decade in the lower stratosphere. Detailed investigations of the behavior of the MLS 190 GHz subsystem reveal a drift in its “sideband fraction” (the relative sensitivity of the 190 GHz receiver to the two different parts of the microwave spectrum that it observes). Our studies indicate that sideband fraction drift accounts for much of the observed changes in the MLS H2O product and some portion of the changes seen in N2O. The 190 GHz sideband fraction drift has been corrected in the new “version 5” (v5) MLS algorithms, which have now been used to reprocess the entire MLS record. As a result of this correction, the MLS v5 H2O record shows no statistically significant drifts compared to ACE-FTS. However, statistically significant drifts remain between MLS v5 and frost point measurements, although they are reduced. Drifts in v5 N2O are about half the size of those in v4 but remain statistically significant. Scientists are advised to use MLS v5 data in all future studies. Quantification of interregional and seasonal to annual changes in MLS H2O and N2O will not be affected by the drift. However, caution is advised in studies using the MLS record to examine long-term (multiyear) variability and trends in either of these species, especially N2O; such studies should only be undertaken in consultation with the MLS team. Importantly, this drift does not affect any of the MLS observations made in other spectral regions such as O3, HCl, CO, ClO, or temperature.


Sign in / Sign up

Export Citation Format

Share Document