scholarly journals Effects of Palm Kernel Shell Ash on Lime-Stabilized Lateritic Soil

2017 ◽  
Vol 25 (3) ◽  
pp. 1-7 ◽  
Author(s):  
Emeka Segun Nnochiri ◽  
Olumide M. Ogundipe ◽  
Opeyemi E. Oluwatuyi

Abstract The research investigated the effects of palm kernel shell ash (PKSA) on lime-stabilized lateritic soil. Preliminary tests were performed on three soil samples, i.e., L1, L2 and L3 for identification; the results showed that L1 was A-7-6, L2 was A-7-6, and L3 was A-7-6. The optimum amount of lime for each of the soil samples was achieved. The optimum amount for L1 was 10%, for L2, 8% and for L3, 10%; at these values they recorded the lowest plasticity indexes. The further addition of PKSA was performed by varying the amount of PKSA and lime added to each of the soil samples. The addition of 4% PKSA+ 6% lime, the addition of 4% PKSA + 4% lime, and the addition of 4% PKSA + 6% lime increased the California Bearing Ratio (CBR) to the highest values for L1, L2 and L3 from 8.20%. It was concluded that PKSA can be a suitable complement for lime stabilization in lateritic soil.

Lateritic soils at Otun Ekiti, Ekiti state, southwestern Nigeria were investigated with respect to their geotechnical properties and their suitability for subgrade and sub – base construction materials. Four disturbed lateritic soil samples (sample A, B, C and D) were selected for the various laboratory techniques. The grain size analyses, the specific gravity tests, the atterberg limit tests, compaction, California bearing ratio and shear box tests were carried out on the samples. The grain size analysis shows that sample A is gravelly silt-clayey sand. Sample B is silt – clayey gravel composition. Sample C is gravelly silt-clayey while Sample D is silt-clayey gravel. Atterberg consistency limit test indicate that sample A has 30.0%, liquid limit 19.5% plastic limit, 10.5% plasticity index, 9.1% shrinkage limit. Sample B has liquid limit of 27.0%, 16.2% plastic limit, 10.8% plasticity index and 7.4% shrinkage limit. Sample C has a liquid limit of 32.4%, plastic limit of 15.6%. It has a plastic index of 16.8%, Shrinkage limit of 9.7% while Sample D has a liquid limit of 36.2%, plastic limit of 17.7%. It has a plastic index of 18.5% and 11.1% as shrinkage limit. Thus, the soil is classified to be intermediate plasticity which can be used for sub – grade and sub – base materials. The soil samples are above the activity (A) line in the zone of intermediate plasticity (CL) which suggests that they are inorganic soils. Based on engineering use chart, the workability as construction engineering is good to fair particularly as erosion resistance in canal construction. However, the high shrinkage limit may also reduce erosion in this area because of cohesion of the plastic clay material. The California Bearing Ratio (CBR) values are within 2 – 3% (mean = 2.75%) and 2 - 4% (mean = 2.75%) in sample A and sample B respectively while California Bearing Ratio (CBR) of 2 - 4% (mean = 2.75%) and 2 – 3% (mean = 2.75%) in sample C and sample D respectively. This implies that the materials can be used as a sub-grade to base course material for support of flexible pavements. The compaction tests for the optimum water content for sample A is 15.0% and 13.0% for standard and modified proctor respectively. The standard and modified proctor for sample B is 15.0% and 14.0% respectively. The compaction tests for the optimum water content for sample C and D is 15.0% and 14.0% for standard and modified proctor respectively. The compaction tests for Sample A indicate a higher fine fraction and thus a higher optimum moisture content while sample B, C and D has higher coarse fraction with lower optimum moisture content. The cohesion falls within 70-90Kpa (mean = 79Kpa) and the angle of internal friction ranges from 260 - 320 with mean of 280 for standard and modified compaction energies respectively. The results obtained from geotechnical analysis suggest that the soil is good to fair as erosion resistance in canal construction because of its high bearing capacity and it can also be used as sub – grade and base course in road construction. Keywords: Lateritic soil, Construction, Erosional and Geotechnical.


2017 ◽  
Vol 12 (1) ◽  
pp. 19-28
Author(s):  
Olumuyiwa S. Aderinola ◽  
Emeka S. Nnochiri

Abstract This study assesses stabilizing lateritic soil using Terrasil solution. Preliminary tests were carried out on six natural soil samples from three borrow pit locations-two soil samples from a particular borrow pit location, for the purpose of identification and classification. Soil samples 1 and 2 from borrow pit 3 were found to be poor, hence, needed stabilization. While the other four samples from borrow pits 1 and 2 were found to be good enough. Engineering property tests such as California Bearing Ratio (CBR), Unconfined Compressive Strength (UCS) and Compaction tests were performed on both the natural soil samples and the stabilized lateritic soil samples which were stabilized by adding terrasil solution in percentages ranging from 0% to 16% at 2% interval. The results showed that the addition of terrasil solution enhanced the strength of the two soil samples from borrow pit 3. For soil sample 1, the unsoaked CBR values increased from 8.4% at 0% to optimum value of 30.3% at 12% terrasil solution, while for soil sample 2, the unsoaked CBR values increased from 6.2% to optimum value of 32.0% at 12% terrasil solution. It was therefore concluded that the terrasil solution serves as a cheap and effective stabilizing agent for poor soil.


Author(s):  
Adeyemi Adeboje ◽  
Williams Kupolati ◽  
Emmanuel Sadiku ◽  
Julius Ndambuki ◽  
Chewe Kambole ◽  
...  

2017 ◽  
Vol 16 (12) ◽  
pp. 2657-2663
Author(s):  
Jamaliah Idris ◽  
Siti Fadira Osman ◽  
Eyu Gaius ◽  
Chukwuekezie Christian

2021 ◽  
Vol 11 (4) ◽  
pp. 1630
Author(s):  
Yakubu Newman Monday ◽  
Jaafar Abdullah ◽  
Nor Azah Yusof ◽  
Suraya Abdul Rashid ◽  
Rafidah Hanim Shueb

Carbon dots (CDs), a nanomaterial synthesized from organic precursors rich in carbon content with excellent fluorescent property, are in high demand for many purposes, including sensing and biosensing applications. This research focused on preparing CDs from natural and abundant waste, palm kernel shells (PKS) obtained from palm oil biomass, aiming for sensing and biosensing applications. Ethylenediamine and L-phenylalanine doped CDs were produced via the hydrothermal and solvothermal methods using one-pot synthesis techniques in an autoclave batch reactor. The as-prepared N-CDs shows excellent photoluminescence (PL) property and a quantum yield (QY) of 13.7% for ethylenediamine (EDA) doped N-CDs (CDs-EDA) and 8.6% for L-phenylalanine (L-Ph) doped N-CDs (CDs-LPh) with an excitation/emission wavelength of 360 nm/450 nm. The transmission electron microscopy (TEM) images show the N-CDs have an average particle size of 2 nm for both CDs. UV-Visible spectrophotometric results showed C=C and C=O transition. FTIR results show and confirm the presence of functional groups, such as -OH, -C=O, -NH2 on the N-CDs, and the X-ray diffraction pattern showed that the N-CDs were crystalline, depicted with sharp peaks. This research work demonstrated that palm kernel shell biomass often thrown away as waste can produce CDs with excellent physicochemical properties.


2021 ◽  
Vol 1051 (1) ◽  
pp. 012054
Author(s):  
N A Najwa Annuar ◽  
N Kamarulzaman ◽  
Z F M Shadzalli ◽  
I H I Abdullah ◽  
P Y Liew ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document