Heteroepitaxy of diamond on c-BN: Growth mechanisms and defect characterization

1994 ◽  
Vol 9 (7) ◽  
pp. 1849-1865 ◽  
Author(s):  
Alberto Argoitia ◽  
John C. Angus ◽  
Jing S. Ma ◽  
Long Wang ◽  
Pirouz Pirouz ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Cubic Boron Nitride ◽  
Three Dimensional ◽  
Diamond Films ◽  
Chemical Vapor ◽  
Diamond Growth ◽  
Defect Characterization ◽  
Cross Sectional ◽  
Transmission Electron ◽  
High Resolution Tem

Diamond films grown on {100}, {111} boron-terminated, and nitrogen-terminated facets of cubic boron nitride (c-BN) single crystals were characterized by Raman spectroscopy, scanning electron microscopy (SEM), and transmission electron microscopy (TEM). The evolution of morphology and microstructure of the diamond films at different stages during the growth process were followed by SEM investigation. The results indicate that diamond growth proceeds by nucleation of oriented three-dimensional islands followed by their coalescence. Cross-sectional TEM specimens were prepared from thick (over 10 μm) continuous diamond films grown on {111} boron-terminated surfaces. Selected-area diffraction and high resolution TEM images show that the diamond film has a parallel orientation relationship with respect to the substrate. Characteristic defects, common to diamond films obtained by chemical vapor deposition on other substrates, are also discussed.

Highly oriented diamond growth on positively biased Si substrates

2001 ◽  
Vol 16 (12) ◽  
pp. 3351-3354 ◽  
Author(s):  
Te-Fu Chang ◽  
Li Chang
Keyword(s):  
Electron Microscopy ◽  
Microwave Plasma ◽  
Diamond Films ◽  
Chemical Vapor ◽  
Diamond Growth ◽  
X Ray Diffraction ◽  
Cross Sectional ◽  
Plasma Chemical Vapor Deposition ◽  
Si Substrates ◽  
Transmission Electron

Deposition of highly textured diamond films on Si(001) has been achieved by using positively bias-enhanced nucleation in microwave plasma chemical vapor deposition. During the biasing period, an additional glow discharge due to the dc plasma effect appeared between the electrode and the substrate. The discharge is necessary for enhanced nucleation of diamond. X-ray diffraction, scanning electron microscopy, and cross-sectional transmission electron microscopy (XTEM) were used to characterize the microstructure of the diamond films on Si. The results show the morphology of diamond grains in square shape with strong diamond (001) texture. XTEM reveals that an amorphous interlayer formed on the smooth Si surface before diamond nucleation.

Heteroepitaxial Diamond Formed on Silicon Wafer Observed by High Resolution Electron Microscopy

1994 ◽  
Vol 357 ◽  
Author(s):  
Jie Yang ◽  
Zhangda Lin ◽  
Li-Xin Wang ◽  
Sing Jin ◽  
Ze Zhang
Keyword(s):  
Electron Microscopy ◽  
High Resolution ◽  
Diamond Films ◽  
Chemical Vapor ◽  
High Resolution Electron Microscopy ◽  
Cross Sectional ◽  
Diamond Crystals ◽  
Transmission Electron ◽  
Resolution Electron ◽  
Hot Filament

AbstractDiamond films with high preferential orientation (111) on silicon (100) crystalline orientation substrates had been obtained by hot-filament chemical vapor deposition (HFCVD) method. X-ray diffraction (XRD), scanning electron microscopy (SEM), Raman spectroscopy, and high-resolution cross-sectional transmission electron microscopy (HREM) are used to characterizate the structure and morphology of the synthesised diamond films. Diamond (111) plans had been local grown epitaxially on the Si(100) substrate observed by HREM. SEM photographes show that plane diamond crystals have been obtained.

Enamel Crystal Shape: History of an Idea

1987 ◽  
Vol 1 (2) ◽  
pp. 322-329 ◽  
Author(s):  
H. Warshawsky
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Cross Sections ◽  
Three Dimensional ◽  
Unit Cell ◽  
Cross Sectional ◽  
Transmission Electron ◽  
History Of ◽  
Sectional Shape ◽  
Imaging Plane

The purpose of this paper is to review evidence which casts doubt on the interpretation universally applied to hexagonal images seen in sectioned enamel. The evidence is based on two possible models to explain the hexagonal profiles seen in mammalian enamel with transmission electron microscopy. The "hexagonal ribbon" model proposes that hexagonal profiles are true cross-sections of elongated hexagonal ribbons. The "rectangular ribbon" model proposes that hexagonal profiles are caused by three-dimensional segments that are parallelepipeds contained in the Epon section. Since shadow projections of such rectangular segments give angles that are inconsistent with the hexagonal unit cell, a model based on ribbons with rhomboidal cut ends and angles of 60 and 120° is proposed. The "rhomboidal ribbon" model projects shadows with angles that are predicted by the unit cell. It is suggested that segments of such crystallites in section project as opaque hexagons on the imaging plane in routine transmission electron microscopy. Morphological observations on crystallites in sections - together with predictions from the hexagonal, rectangular, and rhomboidal ribbon models - indicate that crystallites in rat incisor enamel are flat ribbons with rhomboidal cross-sectional shape. Hexagonal images in electron micrographs of thin-sectioned enamel can result from rhomboidal-ended, parallelepiped-shaped segments of these crystallites projected and viewed as two-dimensional shadows.

A Study of the Origin of Band-A Emission in Homoepitaxial Diamond Thin Films

1999 ◽  
Vol 588 ◽  
Author(s):  
Daisuke Takeuchi ◽  
Hideyuki Watanabe ◽  
Sadanori Yamanaka ◽  
Hideyo Okushi ◽  
Koji Kajimura ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
High Resolution ◽  
Grain Boundaries ◽  
Microwave Plasma ◽  
Diamond Films ◽  
Chemical Vapor ◽  
Plasma Chemical Vapor Deposition ◽  
Transmission Electron ◽  
Excitonic Emission

AbstractThe band-A emission (around 2.8 eV) observed in high quality (device-grade) homoepitaxial diamond films grown by microwave-plasma chemical vapor deposition (CVD) was studied by means of scanning cathodoluminescence spectroscopy and high-resolution transmission electron microscopy. Recent progress in our study on homoepitaxial diamond films was obtained through the low CH4/H2 conditions by CVD. These showed atomically flat surfaces and the excitonic emission at room temperature, while the band-A emission (2.95 eV) decreased. Using these samples, we found that the band-A emission only appeared at unepitaxial crystallites (UC) sites, while other flat surface parts still showed the excitonic emission. High-resolution transmission electron microscopy revealed that there were grain boundaries which contained π-bonds in UC. This indicates that one of the origin of the band-A emission in diamond films is attributed to π bonds of grain boundaries.

Low Temperature Silicon Epitaxial Growth by Plasma Enhanced Chemical Vapor Deposition From SiH4/He/H2

1991 ◽  
Vol 235 ◽  
Author(s):  
Yung-Jen Lin ◽  
Ming-Deng Shieh ◽  
Chiapying Lee ◽  
Tri-Rung Yew
Keyword(s):  
Electron Microscopy ◽  
Chemical Vapor Deposition ◽  
Epitaxial Growth ◽  
Vapor Deposition ◽  
Chemical Vapor ◽  
Ex Situ ◽  
Epitaxial Layers ◽  
Cross Sectional ◽  
Transmission Electron

ABSTRACTSilicon epitaxial growth on silicon wafers were investigated by using plasma enhanced chemical vapor deposition from SiH4/He/H2. The epitaxial layers were growm at temperatures of 350°C or lower. The base pressure of the chamber was greater than 2 × 10−5 Torr. Prior to epitaxial growth, the wafer was in-situ cleaned by H2 baking for 30 min. The epi/substrate interface and epitaxial layers were observed by cross-sectional transmission electron microscopy (XTEM). Finally, the influence of the ex-situ and in-situ cleaning processes on the qualities of the interface and epitaxial layers was discussed in detail.

Intra- and Intergranular Fracture of Diamond Thin Films

1989 ◽  
Vol 162 ◽  
Author(s):  
H. A. Hoff ◽  
A. A. Morrish ◽  
W. A. Carrington ◽  
J. E. Butler ◽  
B. B. Rath
Keyword(s):  
Electron Microscopy ◽  
Thin Films ◽  
Diamond Films ◽  
Chemical Vapor ◽  
Relative Strength ◽  
Ambient Atmosphere ◽  
Transmission Electron ◽  
Welding Torch ◽  
Diamond Thin Films ◽  
Inherent Strength

ABSTRACTDiamond thin films have been synthesized at low pressures by chemical vapor deposition (CVD) and, recently, at ambient atmosphere with an oxygen-acetylene welding torch. By the application of appropriate thermal or mechanical stresses to the substrate, the diamond films can be delaminated. The delaminated films which are only a few microns thick have been fractured by manual bending. Scanning electron microscopy (SEM) examination of fractured CVD diamond films shows the presence of primarily intragranular fracture attesting to the inherent strength of the films. Using transmission electron microscopy (TEM), twinning and stacking faults are seen within the crystallites of the films along the fracture surfaces. By combining SEM and TEM examination, the relative degree of intragranular fracture found in films synthesized by both CVD and oxygen-acetylene torch has been investigated. Possible mechanisms for the intragranular fracture and the relative strength of such films are discussed.

Low Temperature Silicon Epitaxial Growth by Plasma Enhanced Chemical Vapor Deposition from SiH4/He/H2

1991 ◽  
Vol 236 ◽  
Author(s):  
Yung-Jen Lin ◽  
Ming-Deng Shieh ◽  
Chiapying Lee ◽  
Tri-Rung Yew
Keyword(s):  
Electron Microscopy ◽  
Chemical Vapor Deposition ◽  
Epitaxial Growth ◽  
Vapor Deposition ◽  
Chemical Vapor ◽  
Ex Situ ◽  
Epitaxial Layers ◽  
Cross Sectional ◽  
Transmission Electron

AbstractSilicon epitaxial growth on silicon wafers were investigated by using plasma enhanced chemical vapor deposition from SiH4/He/H2. The epitaxial layers were growm at temperatures of 350°C or lower. The base pressure of the chamber was greater than 2 × 10−5 Torr. Prior to epitaxial growth, the wafer was in-situ cleaned by H2 baking for 30 min. The epi/substrate interface and epitaxial layers were observed by cross-sectional transmission electron microscopy (XTEM). Finally, the influence of the ex-situ and in-situ cleaning processes on the qualities of the interface and epitaxial layers was discussed in detail.

scholarly journals Structural Property Study for GeSn Thin Films

Materials ◽  
2020 ◽  
Vol 13 (16) ◽  
pp. 3645
Author(s):  
Liyao Zhang ◽  
Yuxin Song ◽  
Nils von den Driesch ◽  
Zhenpu Zhang ◽  
Dan Buca ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Thin Films ◽  
Transmission Electron Microscopy ◽  
Molecular Beam ◽  
Chemical Vapor ◽  
Threading Dislocations ◽  
X Ray Diffraction ◽  
Cross Sectional ◽  
X Ray ◽  
Transmission Electron

The structural properties of GeSn thin films with different Sn concentrations and thicknesses grown on Ge (001) by molecular beam epitaxy (MBE) and on Ge-buffered Si (001) wafers by chemical vapor deposition (CVD) were analyzed through high resolution X-ray diffraction and cross-sectional transmission electron microscopy. Two-dimensional reciprocal space maps around the asymmetric (224) reflection were collected by X-ray diffraction for both the whole structures and the GeSn epilayers. The broadenings of the features of the GeSn epilayers with different relaxations in the ω direction, along the ω-2θ direction and parallel to the surface were investigated. The dislocations were identified by transmission electron microscopy. Threading dislocations were found in MBE grown GeSn layers, but not in the CVD grown ones. The point defects and dislocations were two possible reasons for the poor optical properties in the GeSn alloys grown by MBE.

scholarly journals Oblique Stacking of Three-Dimensional Dome Islands in Ge/Si Multilayers

2000 ◽  
Vol 648 ◽  
Author(s):  
P. Sutter ◽  
E. Sutter ◽  
L. Vescan
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Three Dimensional ◽  
Surface Curvature ◽  
Surface Strain ◽  
Complex Interplay ◽  
Cross Sectional ◽  
Transmission Electron ◽  
Planar Substrate ◽  
Inherent Tendency

AbstractThe organization of Ge ‘dome’ islands in Ge/Si multilayers has been investigated by cross-sectional transmission electron microscopy. Ge ‘domes’ are found to spontaneously arrange in oblique stacks, replicating at a well-defined angle from one bilayer to the next. The formation of oblique island stacks is governed by a complex interplay of surface strain - generated by the already buried islands - and surface curvature - caused by the inherent tendency of large ‘domes’ to carve out material from the surrounding planar substrate.

Sign in / Sign up

Export Citation Format

Share Document