High-Temperature W Diode Lasers Emitting at 3.3µm

1999 ◽  
Vol 607 ◽  
Author(s):  
L. J. Olafsen ◽  
W. W. Bewley ◽  
I. Vurgaftman ◽  
C. L. Felix ◽  
E. H. Aifer ◽  
...  

AbstractW lasers based on type-II antimonides were recently operated nearly to room temperature under the conditions of cw optical pumping. However, the development of electrically pumped mid-infrared lasers has not yet reached the same level of performance. This is largely related to the more challenging task of simultaneously optimizing the doping/transport and gain/optical properties of the devices. Here we report a demonstration of type-II mid-IR diode lasers employing W active quantum wells. Laser structures with 5 or 10 active periods sandwiched between broadened-waveguide separate confinement regions and quaternary optical cladding layers were processed into 100-µm-wide stripes, cleaved into 1-mm-long cavities, and mounted junction side down. For 0.5-1 µs pulses at a repetition rate of 200 Hz, lasing was obtained up to a maximum operating temperature of 310 K, where the emission wavelength was 3.27 µm. The threshold current densities were 110 A/cm2and 25 kA/cm2 at 78 and 310 K, respectively. The characteristic temperature, To, was 48 K for temperatures between 100 and 280 K. Operation in cw mode was obtained to 195 K, with threshold current densities of 63 A/cm2and 1.4 kA/cm2at 78 and 195 K, respectively, with To = 38 K between 78 and 195 K. Significant further improvements in the operating characteristics are expected once the optimization of the designs and fabrication procedures is complete.

2003 ◽  
Vol 794 ◽  
Author(s):  
V.M. Ustinov ◽  
A.E. Zhukov ◽  
A.R. Kovsh ◽  
N.A. Maleev ◽  
S.S. Mikhrin ◽  
...  

ABSTRACT1.5 micron range emission has been realized using the InAs quantum dots embedded into the metamorphic InGaAs layer containing 20% of InAs grown by MBE on a GaAs substrate. Growth regimes were optimized to reduce significantly the density of dislocations propagating into the active layer from the lattice mismatched interface. 2 mm long InGaAs/InGaAlAs lasers with 10 planes of quantum dots in the active region showed threshold current density about 1.4 kA/cm2 with the external differential efficiency as high as 38%. Lasing wavelength depends on the optical loss being in the 1.44–1.49 micron range at room temperature. On increasing the temperature the wavelength reaches 1.515 micron at 85C while the threshold current characteristic temperature of 55–60K was estimated. High internal quantum efficiency (η>60%)and low internal losses (α=3–4 cm ) were realized. Maximum room temperature output power in pulsed regime as high as 5.5 W for 100 micron wide stripe was demonstrated. Using the same concept 1.3 micron InGaAs/InGaAlAs quantum well lasers were fabricated. The active region contained quantum wells with high (∼40%) indium content which was possible due to the intermediate InGaAs strain relaxation layer. 1 mm stripe lasers showed room temperature threshold current densities about 3.3 kA/cm (λ=1.29 micron) and 400 A/cm2 at 85K. Thus, the use of metamorphic InGaAs layers on GaAs substrate is a very promising approach for increasing the emission wavelength of GaAs based lasers.


1992 ◽  
Vol 242 ◽  
Author(s):  
W. Xie ◽  
D.C. Grillo ◽  
M. Kobayashi ◽  
R. L. Gunshor ◽  
H. Jeon ◽  
...  

ABSTRACTStriking progress in the development of II-VI semiconductor heterostructures, coupled with seminal advances in doping, has very recently led to the first demonstration of blue and blue/green diode lasers operating from cryogenic to room temperature. The active region in these devices was based on the (Zn, Cd)Se/ZnSe multiple quantum wells (MQW) which had earlier been actively studied as a candidate for laser medium by optical pumping techniques. We report on the performance of such MQW diode lasers with emphasis on structural versatility in terms of preparation on both p-type and n-type GaAs substrates, and where sulfur is or is not incorporated for blue/green color lasing. In this work we have obtained pulsed, high power, high quantum efficiency laser emission up to near room temperature conditions. Efficient LED devices are described which operate in the blue (494nm) at room temperature.


2003 ◽  
Vol 799 ◽  
Author(s):  
V. M. Ustinov ◽  
A. E. Zhukov ◽  
A. R. Kovsh ◽  
N. A. Maleev ◽  
S. S. Mikhrin ◽  
...  

ABSTRACT1.5 micron range emission has been realized using the InAs quantum dots embedded into the metamorphic InGaAs layer containing 20% of InAs grown by MBE on a GaAs substrate. Growth regimes were optimized to reduce significantly the density of dislocations propagating into the active layer from the lattice mismatched interface. 2 mm long InGaAs/InGaAlAs lasers with 10 planes of quantum dots in the active region showed threshold current density about 1.4 kA/cm2 with the external differential efficiency as high as 38%. Lasing wavelength depends on the optical loss being in the 1.44–1.49 micron range at room temperature. On increasing the temperature the wavelength reaches 1.515 micron at 85C while the threshold current characteristic temperature of 55–60K was estimated. High internal quantum efficiency (η>60%) and low internal losses (α=3–4 cm-1 ) were realized. Maximum room temperature output power in pulsed regime as high as 5.5 W for 100 micron wide stripe was demonstrated. Using the same concept 1.3 micron InGaAs/InGaAlAs quantum well lasers were fabricated. The active region contained quantum wells with high (∼40%) indium content which was possible due to the intermediate InGaAs strain relaxation layer. 1 mm stripe lasers showed room temperature threshold current densities about 3.3 kA/cm2 (λ=1.29 micron) and 400 A/cm2 at 85K. Thus, the use of metamorphic InGaAs layers on GaAs substrate is a very promising approach for increasing the emission wavelength of GaAs based lasers.


Crystals ◽  
2018 ◽  
Vol 8 (8) ◽  
pp. 311 ◽  
Author(s):  
Nikolay Baidus ◽  
Vladimir Aleshkin ◽  
Alexander Dubinov ◽  
Konstantin Kudryavtsev ◽  
Sergei Nekorkin ◽  
...  

The paper presents the results of the application of MOCVD growth technique for formation of the GaAs/AlAs laser structures with InGaAs quantum wells on Si substrates with a relaxed Ge buffer. The fabricated laser diodes were of micro-striped type designed for the operation under the electrical pumping. Influence of the Si substrate offcut from the [001] direction, thickness of a Ge buffer and insertion of the AlAs/GaAs superlattice between Ge and GaAs on the structural and optical properties of fabricated samples was studied. The measured threshold current densities at room temperatures were 5.5 kA/cm2 and 20 kA/cm2 for lasers operating at 0.99 μm and 1.11 μm respectively. In order to obtain the stimulated emission at wavelengths longer than 1.1 μm, the InGaAs quantum well laser structures with high In content and GaAsP strain-compensating layers were grown both on Ge/Si and GaAs substrates. Structures grown on GaAs exhibited stimulated emission under optical pumping at the wavelengths of up to 1.24 μm at 300 K while those grown on Ge/Si substrates emitted at shorter wavelengths of up to 1.1 μm and only at 77 K. The main reasons for such performance worsening and also some approaches to overcome them are discussed. The obtained results have shown that monolithic integration of direct-gap A3B5 compounds on Si using MOCVD technology is rather promising approach for obtaining the Si-compatible on-chip effective light source.


1996 ◽  
Vol 450 ◽  
Author(s):  
Michael E. Flatté ◽  
C. H. Grein ◽  
J. T. Olesberg ◽  
T. F. Boggess

ABSTRACTWe will present calculations of the ideal performance of mid-infrared InAs/InGaSb superlattice quantum well lasers. For these systems several periods of an InAs/InGaSb type-II superlattice are grown in quantum wells. Calculations of the non-radiative and radiative lifetimes of the carriers utilize the full non-parabolic band structure and momentum-dependent matrix elements calculated from a semi-empirical multilayer K · P theory. From these lifetimes, threshold current densities have been evaluated for laser structures. We find serious problems with the hole and electron confinement in the superlattice quantum wells grown to date, and propose a four-layer superlattice structure which corrects these problems.


2001 ◽  
Vol 707 ◽  
Author(s):  
Vadim Tokranov ◽  
M. Yakimov ◽  
A. Katsnelson ◽  
K. Dovidenko ◽  
R. Todt ◽  
...  

ABSTRACTThe influence of two monolayer - thick AlAs under- and overlayers on the formation and properties of self-assembled InAs quantum dots (QDs) has been studied using transmission electron microscopy (TEM) and photoluminescence (PL). Single sheets of InAs QDs were grown inside a 2ML/8ML AlAs/GaAs short-period superlattice with various combinations of under- and overlayers. It was found that 2.4ML InAs QDs with GaAs underlayer and 2ML AlAs overlayer exhibited the lowest QD surface density of 4.2x1010 cm-2 and the largest QD lateral size of about 19 nm as compared to the other combinations of cladding layers. This InAs QD ensemble has also shown the highest room temperature PL intensity with a peak at 1210 nm and the narrowest linewidth, 34 meV. Fabricated edge-emitting lasers using triple layers of InAs QDs with AlAs overlayer demonstrated 120 A/cm2 threshold current density and 1230 nm emission wavelength at room temperature. Excited state QD lasers have shown high thermal stability of threshold current up to 130°C.


2013 ◽  
pp. 156-157
Author(s):  
C. Höfling ◽  
C. Schneider ◽  
A. Forchel
Keyword(s):  

2001 ◽  
Vol 692 ◽  
Author(s):  
C. Mermelstein ◽  
M. Rattunde ◽  
J. Schmitz ◽  
S. Simanowski ◽  
R. Kiefer ◽  
...  

AbstractIn this paper we review recent progress achieved in our development of type-I GaInAsSb/AlGaAsSb quantum-well (QW) lasers with emission wavelength in the 1.74–2.34 μm range. Triple-QW (3-QW) and single-QW (SQW) diode lasers having broadened waveguide design emitting around 2.26 μm have been studied in particular. Comparing the two designs we have find that the threshold current density at infinite cavity length as well as the transparency current density scale with the number of QWs. Maximum cw operating temperature exceeding 50°C and 90°C has been obtained for ridge waveguide lasers emitting above and below 2 μm, respectively. Ridge waveguide diode lasers emitting at 1.94 μm exhibited internal quantum efficiencies in excess of 77%, internal losses of 6 cm−1, and threshold current density at infinite cavity length as low as 121 A/cm2 reflecting the superior quality of our diode lasers, all values recorded at 280 K. A high characteristic temperature TOof 179 K for the threshold current along with a value of T1 = 433 K for the characteristic temperature of the external efficiency have been attained for the 240–280 K temperature interval. Room temperature cw output powers exceeding 1.7 W have been demonstrated for broad area single element devices with highreflection/ antireflection coated mirror facets, mounted epi-side down. The latter result is a proof for the high power capabilities of these GaSb-based mid-ir diode lasers.


Sign in / Sign up

Export Citation Format

Share Document