Investigation of the Shape of InGaAs/GaAs Quantum Dots

2002 ◽  
Vol 737 ◽  
Author(s):  
Susan Y. Lehman ◽  
Alexana Roshko ◽  
Richard P. Mirin ◽  
John E. Bonevich
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Quantum Dots ◽  
Molecular Beam ◽  
Length Scale ◽  
Cross Sectional ◽  
Force Microscopy ◽  
Atomic Force ◽  
Transmission Electron ◽  
Three Samples

ABSTRACTThree samples of self-assembled In0.44Ga0.56As quantum dots (QDs) grown on (001) GaAs by molecular beam epitaxy (MBE) were studied using atomic force microscopy (AFM) and high-resolution transmission electron microscopy (TEM) in order to characterize the height, faceting, and densities of the QDs. The cross-sectional TEM images show both pyramidal dots and dots with multiple side facets. Multiple faceting has been observed only in dots more than 8.5 nm in height and allows increased dot volume without a substantial increase in base area. Addition of a GaAs capping layer is found to increase the diameter of the QDs from roughly 40 nm to as much as 200 nm. The areal QD density is found to vary up to 50 % over the central 2 cm x 2 cm section of wafer and by as much as 23 % on a length scale of micrometers.

Ordering of InGaAs Quantum Dots Grown by Molecular Beam Epitaxy under As2 gas flux

2015 ◽  
Vol 1792 ◽  
Author(s):  
Mourad Benamara ◽  
Yuriy I. Mazur ◽  
Peter Lytvyn ◽  
Morgan E. Ware ◽  
Vitaliy Dorogan ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Quantum Dots ◽  
Atomic Force Microscopy ◽  
Molecular Beam Epitaxy ◽  
Large Scale ◽  
Molecular Beam ◽  
Force Microscopy ◽  
Atomic Force ◽  
Transmission Electron

ABSTRACTThe influence of the substrate temperature on the morphology and ordering of InGaAs quantum dots (QD), grown on GaAs (001) wafers by Molecular Beam Epitaxy (MBE) under As2 flux has been studied using Transmission Electron Microscopy (TEM), Atomic Force Microscopy (AFM) and Photoluminescence (PL) measurements. The experimental results show that lateral and vertical orderings occur for temperatures greater than 520°C and that QDs self-organize in a 6-fold symmetry network on (001) surface for T=555°C. Vertical orderings of asymmetric QDs, along directions a few degrees off [001], are observed on a large scale and their formation is discussed.

TEM Studies on the Microstructure of m-Face Grown 4H-SiC by Solution Growth

2020 ◽  
Vol 1004 ◽  
pp. 414-420
Author(s):  
Junro Takahashi ◽  
Kotaro Kawaguchi ◽  
Kazuhiko Kusunoki ◽  
Tomoyuki Ueyama ◽  
Kazuhito Kamei
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Solution Growth ◽  
Spiral Growth ◽  
Growth Surface ◽  
Vicinal Surface ◽  
Cross Sectional ◽  
Force Microscopy ◽  
Atomic Force ◽  
Transmission Electron

We have studied the microstructure of the growth surface of the 4H-SiC grown by the m-face solution growth. Atomic Force Microscopy (AFM) revealed the micro-striped morphology with the asperity of several nm in the band-like morphology region. The cross-sectional Transmission Electron Microscopy (XTEM) showed that the growth surface consisted of a bunch of nanofacets and vicinal surface. This peculiar morphology is totally different from that of conventional spiral growth on c-face, which can be closely related with the growth mechanism of the m-face solution growth.

A transmission electron microscopy investigation of SiC films grown on Si(111) substrates by solid-source molecular beam epitaxy

1998 ◽  
Vol 13 (12) ◽  
pp. 3571-3579 ◽  
Author(s):  
U. Kaiser ◽  
S. B. Newcomb ◽  
W. M. Stobbs ◽  
M. Adamik ◽  
A. Fissel ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Molecular Beam ◽  
Growth Parameters ◽  
Force Microscopy ◽  
Molecular Beam Epitaxial ◽  
Atomic Force ◽  
Transmission Electron ◽  
Microscopy Investigation ◽  
Sic Films

The effects of different growth parameters on the microstructure of the SiC films formed during simultaneous two-source molecular-beam-epitaxial (MBE) deposition have been investigated. Substrate temperatures as low as 750–900 °C have been used. The relationship between a number of different growth morphologies and deposition conditions has been established. The formation of single-crystal 3C films has been found to occur at low growth rates but within a limited Si: C adatom ratio. A combination of transmission electron microscopy (TEM) and atomic force microscopy (AFM) has been used to examine the different films, and the results of these investigations are described.

Nanomechanical Properties and Nanostructure of CMG and CMP Machined Si Substrates

2008 ◽  
Vol 381-382 ◽  
pp. 525-528 ◽  
Author(s):  
B.L. Wang ◽  
Han Huang ◽  
Jin Zou ◽  
Li Bo Zhou
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Substrate Surface ◽  
Transmission Electron Microscopy Analysis ◽  
Cross Sectional ◽  
Force Microscopy ◽  
Si Substrates ◽  
Atomic Force ◽  
Transmission Electron ◽  
Electron Microscopy Analysis

Silicon (100) substrates machined by chemo-mechanical-grinding (CMG) and chemicalmechanical- polishing (CMP) were investigated using atomic force microscopy, cross-sectional transmission electron microscopy and nanoindentation. It was found that the substrate surface after CMG was slightly better than machined by CMP in terms of roughness. The transmission electron microscopy analysis showed that the CMG-generated subsurface was defect-free, but the CMP specimen had a crystalline layer of about 4 nm in thickness on the top of the silicon lattice as evidenced by the extra diffraction spots. Nanoindentation results indicated that there exists a slight difference in mechanical properties between the CMG and CMP machined substrates.

scholarly journals Conjugated Quantum Dots Inhibit the Amyloidβ(1–42) Fibrillation Process

2011 ◽  
Vol 2011 ◽  
pp. 1-15 ◽  
Author(s):  
Garima Thakur ◽  
Miodrag Micic ◽  
Yuehai Yang ◽  
Wenzhi Li ◽  
Dania Movia ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Quantum Dots ◽  
Atomic Force Microscopy ◽  
Amyloid Beta ◽  
Dihydrolipoic Acid ◽  
Force Microscopy ◽  
Atomic Force ◽  
Transmission Electron ◽  
Tht Fluorescence

Nanoparticles have enormous potential in diagnostic and therapeutic studies. We have demonstrated that the amyloid beta mixed with and conjugated to dihydrolipoic acid- (DHLA) capped CdSe/ZnS quantum dots (QDs) of size approximately 2.5 nm can be used to reduce the fibrillation process. Transmission electron microscopy (TEM) and atomic force microscopy (AFM) were used as tools for analysis of fibrillation. There is a significant change in morphology of fibrils when amyloidβ(1–42) (Aβ(1–42)) is mixed or conjugated to the QDs. The length and the width of the fibrils vary under modified conditions. Thioflavin T (ThT) fluorescence supports the decrease in fibril formation in presence of DHLA-capped QDs.

Dislocation reduction with quantum dots in GaN grown on sapphire substrates by molecular beam epitaxy

2002 ◽  
Vol 722 ◽  
Author(s):  
David J. Smith ◽  
Daming Huang ◽  
Michael A Reshchikov ◽  
Feng Yun ◽  
T. King ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Atomic Force Microscopy ◽  
Molecular Beam ◽  
Buffer Layers ◽  
Force Microscopy ◽  
Sapphire Substrates ◽  
Atomic Force ◽  
Transmission Electron ◽  
Aln Buffer

AbstractWe have investigated a novel approach for improving GaN crystal quality by utilizing a stack of quantum dots (QDs) in GaN grown on sapphire substrates by molecular beam epitaxy. The GaN films were grown on GaN/AlN buffer layers containing multiple QDs and characterized using x-ray diffraction, photoluminescence, atomic force microscopy, and transmission electron microscopy. The density of the dislocations in the films was determined by defect delineation wet chemical etching and atomic force microscopy. It was found that the insertion of a set of multiple GaN QD layers in the buffer layer effectively reduced the density of the dislocations in the epitaxial layers. As compared to a density of ∼1010cm-2in typical GaN films grown on AlN buffer layers, a density of ∼3×107cm-2was demonstrated in GaN films grown with the QD layers. Transmission electron microscopy observations confirmed termination of threading dislocations by the QD layers.

Structural Characterization of Prismatic Stacking Faults of Two Types of Carrot Defects in 4H-SiC Epi Wafers

2020 ◽  
Vol 1004 ◽  
pp. 421-426
Author(s):  
Hideki Sako ◽  
Kentaro Ohira ◽  
Kenji Kobayashi ◽  
Toshiyuki Isshiki
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Stacking Faults ◽  
Wafer Surface ◽  
Cross Sectional ◽  
Force Microscopy ◽  
Atomic Force ◽  
Transmission Electron ◽  
Scanning Transmission ◽  
The Difference

Two types of carrot defects with and without a shallow pit were found by mirror projection electron microscopy (MPJ) inspection in 4H-SiC epi wafer. Surface morphology and cross-sectional structure of prismatic stacking faults (PSFs) were investigated using MPJ and atomic force microscopy (AFM), transmission electron microscopy (TEM) and high-resolution scanning transmission electron microscopy (STEM). The depths of the surface grooves due to the PSFs, the stacking sequences around the PSFs and the structure of the Frank-type stacking faults which were connected to the PSFs were different. We discuss the difference between the two types of carrot defects.

Sign in / Sign up

Export Citation Format

Share Document