Determination procedure of actual drive wheel–rail contact area for railway vehicles

2021 ◽  
pp. 66-70
Author(s):  
A. M. Keropyan
Keyword(s):  
Contact Area ◽  
Railway Vehicles ◽  
Drive Wheel ◽  
Determination Procedure

Load-Bearing in the Ovine Medial Tibial Condyle: Effect of Meniscectomy

1993 ◽  
Vol 06 (02) ◽  
pp. 100-104 ◽  
Author(s):  
D. M. Pickles ◽  
C. R. Bellenger
Keyword(s):  
Knee Joint ◽  
Contact Area ◽  
Mammalian Species ◽  
Total Removal ◽  
Load Bearing ◽  
Human Knee ◽  
Biochemical Effects ◽  
Pressure Sensitive ◽  
Medial Meniscectomy ◽  
Tibial Condyle

SummaryTotal removal of a knee joint meniscus is followed by osteoarthritis in many mammalian species. Altered load-bearing has been observed in the human knee following meniscectomy but less is known about biochemical effects of meniscectomy in other species. Using pressure sensitive paper in sheep knee (stifle) joints it was found that, for comparable loads, the load-bearing area on the medial tibial condyle was significantly reduced following medial meniscectomy. Also, for loads of between 50 N and 500 N applied to the whole joint, the slope of the regression of contact area against load was much smaller. Following medial meniscectomy, the ability to increase contact area as load increased was markedly reduced.The load bearing area on the medial tibial condyle was reduced following meniscectomy.

An Analytical Thermodynamic Approach to Friction of Rubber on Ice

2012 ◽  
Vol 40 (2) ◽  
pp. 124-150
Author(s):  
Klaus Wiese ◽  
Thiemo M. Kessel ◽  
Reinhard Mundl ◽  
Burkhard Wies
Keyword(s):  
Coefficient Of Friction ◽  
Liquid Layer ◽  
Contact Area ◽  
Leading Edge ◽  
Viscous Friction ◽  
Analytical Approximation ◽  
Real Contact Area ◽  
Length Scales ◽  
Real Contact ◽  
Ice Surface

ABSTRACT The presented investigation is motivated by the need for performance improvement in winter tires, based on the idea of innovative “functional” surfaces. Current tread design features focus on macroscopic length scales. The potential of microscopic surface effects for friction on wintery roads has not been considered extensively yet. We limit our considerations to length scales for which rubber is rough, in contrast to a perfectly smooth ice surface. Therefore we assume that the only source of frictional forces is the viscosity of a sheared intermediate thin liquid layer of melted ice. Rubber hysteresis and adhesion effects are considered to be negligible. The height of the liquid layer is driven by an equilibrium between the heat built up by viscous friction, energy consumption for phase transition between ice and water, and heat flow into the cold underlying ice. In addition, the microscopic “squeeze-out” phenomena of melted water resulting from rubber asperities are also taken into consideration. The size and microscopic real contact area of these asperities are derived from roughness parameters of the free rubber surface using Greenwood-Williamson contact theory and compared with the measured real contact area. The derived one-dimensional differential equation for the height of an averaged liquid layer is solved for stationary sliding by a piecewise analytical approximation. The frictional shear forces are deduced and integrated over the whole macroscopic contact area to result in a global coefficient of friction. The boundary condition at the leading edge of the contact area is prescribed by the height of a “quasi-liquid layer,” which already exists on the “free” ice surface. It turns out that this approach meets the measured coefficient of friction in the laboratory. More precisely, the calculated dependencies of the friction coefficient on ice temperature, sliding speed, and contact pressure are confirmed by measurements of a simple rubber block sample on artificial ice in the laboratory.

Measurement and Visualization of the Contact Pressure Distribution of Rubber Disks and Tires

1995 ◽  
Vol 23 (4) ◽  
pp. 238-255 ◽  
Author(s):  
E. H. Sakai
Keyword(s):  
Pressure Distribution ◽  
Contact Pressure ◽  
Contact Area ◽  
Light Absorption ◽  
Lateral Force ◽  
Contact Pressure Distribution ◽  
High Definition ◽  
The Road ◽  
Close Relationship ◽  
Processing Techniques

Abstract The contact conditions of a tire with the road surface have a close relationship to various properties of the tire and are among the most important characteristics in evaluating the performance of the tire. In this research, a new measurement device was developed that allows the contact stress distribution to be quantified and visualized. The measuring principle of this device is that the light absorption at the interface between an optical prism and an evenly ground or worn rubber surface is a function of contact pressure. The light absorption can be measured at a number of points on the surface to obtain the pressure distribution. Using this device, the contact pressure distribution of a rubber disk loaded against a plate was measured. It was found that the pressure distribution was not flat but varied greatly depending upon the height and diameter of the rubber disk. The variation can be explained by a “spring” effect, a “liquid” effect, and an “edge” effect of the rubber disk. Next, the measurement and image processing techniques were applied to a loaded tire. A very high definition image was obtained that displayed the true contact area, the shape of the area, and the pressure distribution from which irregular wear was easily detected. Finally, the deformation of the contact area and changes in the pressure distribution in the tread rubber block were measured when a lateral force was applied to the loaded tire.

Active steering of railway vehicles: A feedforward strategy

2003 ◽  
Author(s):  
Shuiwen Shen ◽  
T X Mei ◽  
R. M. Goodall ◽  
J. Pearson ◽  
G. Himmelstein
Keyword(s):  
Railway Vehicles ◽  
Active Steering

Issues on Design of Piled Raft Foundation

2018 ◽  
Vol 14 (1) ◽  
pp. 6057-6061 ◽  
Author(s):  
Padmanaban M S ◽  
J Sreerambabu
Keyword(s):  
Contact Area ◽  
Concrete Slab ◽  
Design Procedure ◽  
Bending Moment ◽  
Foundation Design ◽  
Detailed Review ◽  
Piled Raft ◽  
Piled Raft Foundation ◽  
Raft Foundation ◽  
Influencing Parameters

A piled raft foundation consists of a thick concrete slab reinforced with steel which covers the entire contact area of the structure, in which the raft is supported by a group of piles or a number of individual piles. Bending moment on raft, differential and average settlement, pile and raft geometries are the influencing parameters of the piled raft foundation system. In this paper, a detailed review has been carried out on the issues on the raft foundation design. Also, the existing design procedure was explained.

Cytomorphometric characteristics of imprints of the contact area between the gingiva and the dental implant after one-step implantation

2017 ◽  
pp. 77-82
Author(s):  
А.С. Рыбалко ◽  
А.С. Григорьян ◽  
А.А. Орлов
Keyword(s):  
Dental Implants ◽  
Dental Implant ◽  
Contact Area ◽  
Inflammatory Reactions ◽  
Diagnosis And Prognosis ◽  
Dental Implantation ◽  
Data Points ◽  
One Step ◽  
Cytological Method ◽  
Clinical Pictures

Цель исследования состояла в разработке неинвазивного метода диагностики состояния тканей периимплантационной зоны после постановки дентальных имплантатов, а также прогноза течения послеоперационного периода и ранней диагностики послеоперационных осложнений, таких, как мукозит и периимплантит, при одноэтапном методе дентальной имплантации. Методы. В исследовании представлена цитологическая характеристика отпечатков из области контакта имплантата с десной, в которых оценивали состояние эпителиальных клеток при различных проявлениях цитопатологии. Определяли индекс деструкции (ИД) и воспалительно-деструктивный индекс (ВДИ) в клетках воспалительного инфильтрата, которые сопоставляли с клинической картиной течения послеоперационного периода. Сроки забора цитологического материала 1, 5, 15, 25, 30, 60, 120 дней после постановки имплантатов. Количество исследованных цитограмм - 442 от 11 пациентов (по 1-2 имплантата). Общий массив использованных для вычисления интегральных показателей составил »2550. Результаты. Было установлено, что в сроки 1-5 дней после постановки дентальных имплантатов происходит резкое повышение показателей ИД (до 7500 ± 15) и ВДИ (до 80 ± 20), что отражает процесс развития в области имплантатов острых воспалительных реакций. В отдаленные сроки наблюдений отмечалось 2 варианта развития событий. Первый из них характеризовался сохранением во все сроки высоких показателей ИД и ВДИ. Для второго варианта динамики показателей было характерно их падение, что соответствовало развитию процесса остеоинтеграции дентальных имплантатов. The objectives of the investigation were to develop protocols evaluating the validity and effectiveness of the cytological method for diagnosis and prognosis of tissue conditions adjacent to a dental implant. Methods. This study examined the cytological characteristics of imprints of the gingiva-implant contact area, a. the correlation of quantitative ratios of epithelial cells either with or without hystopathological manifestations (an index of destruction, ID); b. ratio of cells of the inflammatory infiltrate (an inflammatory and destructive index, IDI); these data were researched in relation with dynamics of the clinical pictures during a postoperative period.The cytological material was obtained 1, 5, 15, 25, 30, 60, 120 days after dental implantation. Totally 442 cytogramme from 11 patients (1-2 implant per a patient) were assayed. The data array for computation of integrated indicators was composed of ca. 2550 data points. Results. A significant increase of ID (7500 ± 15) and IDI (80 ± 20) indicators, which reflects the development of acute inflammatory reactions in tissues neighboring an implant, was observed within 1-5 days following the insertion of dental implants. Long-term observations revealed two scenarios. The first scenario was characterized by the retention of high levels of ID and IDI over the period of observations. The second scenario featured the reduction of ID and IDI indices, which corresponded to the development of the osseointegration of dental implants.

Sign in / Sign up

Export Citation Format

Share Document