scholarly journals CATALYTIC PROPERTIES OF SYNTHETIC HAUSMANNITE IN THE OZONE DECOMPOSITION REACTION

2021 ◽  
Vol 26 (1(77)) ◽  
pp. 6-15
Author(s):  
A. S. Truba ◽  
T. L. Rakitskaya
Keyword(s):  
Absorption Band ◽  
Crystal Lattice ◽  
Alkaline Medium ◽  
Diffraction Method ◽  
Decomposition Reaction ◽  
Tetragonal Symmetry ◽  
Ozone Decomposition ◽  
X Ray Diffraction ◽  
Absorption Bands ◽  
X Ray

Samples of IS-Mn and IIS-Mn were synthesized and characterized by X-ray diffraction, IR spectroscopy and pH-metry. The X-ray diffraction method revealed both samples to be crystalline and single-phase. IS-Mn sample contains a phase of gausmannite (Mn3O4) with the parameters of the crystal lattice of tetragonal symmetry and the crystallites sized 43 nm. IIS-Mn sample, obtained by calcination of Mn3O4 sample in air under the condition of 600 oC for 4 hours, contains a phase of bixbyite Mn2O3 with a cubic crystal lattice and the crystallites sized 66 nm. The spectra of the Mn3O4 and Mn2O3 samples are particularly different in the region of Mn-OH and Mn-O valence vibrations. For gausmannite, the absorption band for Mn2+ in Td-coordination at 631 cm-1 and the absorption band for Mn3+ in Oh-coordination at 523 and 407cm-1 were clearly shown. In the IR spectrum of bixbyite, several intense absorption bands were observed at 674; 658; 606 and 542 cm-1, which correlate with the literature data and correspond to the valence oscillations of Mn-O in Mn2O3. The pH measurement of the aqueous suspension of the synthesized samples showed that Mn3O4 forms an alkaline medium, and Mn2O3 –weakly acidic upon contact with water molecules. Testing of Mn3O4 and Mn2O3 samples in the ozone decomposition reaction at the initial concentration of 100 mg/m3 showed that the kinetic curves profiles were determined by the phase composition. The testing of the samples was completed and it was established that the same degree of ozone decomposition, namely 50%, was achieved. For hausmannite, the values of the ozone half-life (t1/2) and the amount of ozone (Qexp), which reacted at the end of the experiment, are greater than Mn2O3 sample. The presence of manganese in two oxidation states Mn2+ and Mn3+ in the Mn3O4 structure promotes the redox process, and the alkaline medium contributes to the radical-chain reaction, which affects values t1/2 of and Qexp, which reacted.

scholarly journals Magnetically Oriented Powder Crystal to Indexing and Structure Determination

2014 ◽  
Vol 70 (a1) ◽  
pp. C1560-C1560
Author(s):  
Fumiko Kimura ◽  
Wataru Oshima ◽  
Hiroko Matsumoto ◽  
Hidehiro Uekusa ◽  
Kazuaki Aburaya ◽  
...  
Keyword(s):  
Crystal Structure ◽  
Single Crystal ◽  
Crystal Lattice ◽  
Powder Diffraction ◽  
Diffraction Method ◽  
Lattice Parameters ◽  
X Ray Diffraction ◽  
X Ray ◽  
Crystal Lattice Parameters

In pharmaceutical sciences, the crystal structure is of primary importance because it influences drug efficacy. Due to difficulties of growing a large single crystal suitable for the single crystal X-ray diffraction analysis, powder diffraction method is widely used. In powder method, two-dimensional diffraction information is projected onto one dimension, which impairs the accuracy of the resulting crystal structure. To overcome this problem, we recently proposed a novel method of fabricating a magnetically oriented microcrystal array (MOMA), a composite in which microcrystals are aligned three-dimensionally in a polymer matrix. The X-ray diffraction of the MOMA is equivalent to that of the corresponding large single crystal, enabling the determination of the crystal lattice parameters and crystal structure of the embedded microcrytals.[1-3] Because we make use of the diamagnetic anisotropy of crystal, those crystals that exhibit small magnetic anisotropy do not take sufficient three-dimensional alignment. However, even for these crystals that only align uniaxially, the determination of the crystal lattice parameters can be easily made compared with the determination by powder diffraction pattern. Once these parameters are determined, crystal structure can be determined by X-ray powder diffraction method. In this paper, we demonstrate possibility of the MOMA method to assist the structure analysis through X-ray powder and single crystal diffraction methods. We applied the MOMA method to various microcrystalline powders including L-alanine, 1,3,5-triphenyl benzene, and cellobiose. The obtained MOMAs exhibited well-resolved diffraction spots, and we succeeded in determination of the crystal lattice parameters and crystal structure analysis.

scholarly journals Synthesis, Microstructure and the Crystalline Structure of the Barium Titanate Ceramics Doped with Lanthanum

2013 ◽  
Vol 58 (4) ◽  
pp. 1305-1308 ◽  
Author(s):  
B. Wodecka-Duś ◽  
M. Plońska ◽  
D. Czekaj
Keyword(s):  
Thermal Analysis ◽  
Crystalline Structure ◽  
Diffraction Method ◽  
Simultaneous Thermal Analysis ◽  
Tetragonal Symmetry ◽  
X Ray Diffraction ◽  
Ceramic Powders ◽  
X Ray ◽  
Composition Formula ◽  
Titanate Ceramics

Abstract In the present study BaTiO3 and Ba1-xLaxTiO3 (0.1-0.4mol.% La) ceramic powders were synthesized by the conventional mixed oxide method (MOM). The characterization of the ceramic powders was carried out using a simultaneous thermal analysis (STA), with a combined DTA/TG/DTG system (Netzsch STA409). The results of thermal analysis allowed to determine the optimal temperature of synthesis. Microstructure was investigated by scanning electron microscopy (SEM), crystalline structure was studied by X-ray diffraction method (XRD). The EDS investigations showed that samples exhibited conservation of stoichiometry according to the chemical composition formula. The X-ray diffraction analysis confirmed formation of the desired crystalline structure both pure and La3+-doped BaTiO3 ceramics exhibiting a perovskite-type structure ABO3 with tetragonal symmetry P4 mm.

Crystal Structure of ζ2' Martensite in Au-49.5at%Cd Alloy

1991 ◽  
Vol 246 ◽  
Author(s):  
Yutaka Emura ◽  
Takuya Ohba ◽  
Kazuhiro Otsuka
Keyword(s):  
Crystal Structure ◽  
Single Crystal ◽  
Crystal Lattice ◽  
Least Squares ◽  
Least Squares Method ◽  
Diffraction Method ◽  
X Ray Diffraction ◽  
Full Matrix ◽  
X Ray ◽  
Lattice Constants

AbstractCrystal structure of the ζ2' martensite in a Au-49.5at%Cd ally has been analyzed by the single crystal x-ray diffraction method. The crystal lattice was trigonal and the lattice constants were a:0.8095(3) and c=o.57940(6) nm. There were 18 atoms in a unit cell. The space group was P3, which was different from that previously determined by Vatanayon and Hehemann. The structure was refined by the full matrix least squares method to a final R factor of 7.8% and a weighted R factor of 4.1%.

scholarly journals Photoconductivity of the Single Crystals Pb4Ga4GeS12 and Pb4Ga4GeSe12

Proceedings ◽  
2020 ◽  
Vol 62 (1) ◽  
pp. 4
Author(s):  
Hadj Bellagra ◽  
Oksana Nyhmatullina ◽  
Yuri Kogut ◽  
Halyna Myronchuk ◽  
Lyudmyla Piskach
Keyword(s):  
Ternary Systems ◽  
Semiconductor Materials ◽  
Tetragonal Symmetry ◽  
Bandgap Energy ◽  
Experimental Measurements ◽  
X Ray Diffraction ◽  
X Ray ◽  
Vertical Bridgman ◽  
Symmetry Space ◽  
Symmetry Space Group

Quaternary semiconductor materials of the Pb4Ga4GeS(Se)12 composition have attracted the attention of researchers due to their possible use as active elements of optoelectronics and nonlinear optics. The Pb4Ga4GeS(Se)12 phases belong to the solid solution ranges of the Pb3Ga2GeS(Se)8 compounds which form in the quasi-ternary systems PbS(Se)−Ga2S(Se)3−GeS(Se)2 at the cross of the PbGa2S(Se)4−Pb2GeS(Se)4 and PbS(Se)−PbGa2GeS(Se)6 sections. The quaternary sulfide melts congruently at 943 K. The crystallization of the Pb4Ga4GeSe12 phase is associated with the ternary peritectic process Lp + PbSe ↔ PbGa2S4 + Pb3Ga2GeSe8 at 868 K. For the single crystal studies, Pb4Ga4GeS(Se)12 were pre-synthesized by co-melting high-purity elements. The X-ray diffraction results confirm that these compounds possess non-centrosymmetric crystal structure (tetragonal symmetry, space group P–421c). The crystals were grown by the vertical Bridgman method in a two-zone furnace. The starting composition was stoichiometric for Pb4Ga4GeS12, and the solution-melt method was used for the selenide Pb4Ga4GeSe12. The obtained value of the bandgap energy for the Pb4Ga4GeS12 and Pb4Ga4GeSe12 crystals is 1.86 and 2.28 eV, respectively. Experimental measurements of the spectral distribution of photoconductivity for the Pb4Ga4GeS12 and Pb4Ga4GeSe12 crystals exhibit the presence of two spectral maxima. The first lies in the region of 570 (2.17 eV) and 680 nm (1.82 eV), respectively, and matches the optical bandgap estimates well. The locations of the admixture maxima at about 1030 (1.20 eV) and 1340 nm (0.92 eV), respectively, agree satisfactorily with the calculated energy positions of the defects vs. and VSe.

scholarly journals Growth of sillenite Bi12FeO20 single crystals: structural, thermal, optical, photocatalytic features and first principle calculations

2020 ◽  
Vol 10 (1) ◽  
Author(s):  
Durga Sankar Vavilapalli ◽  
Ambrose A. Melvin ◽  
F. Bellarmine ◽  
Ramanjaneyulu Mannam ◽  
Srihari Velaga ◽  
...  
Keyword(s):  
Single Crystal ◽  
Single Crystals ◽  
Photoelectron Spectroscopy ◽  
Diffraction Method ◽  
Lattice Parameter ◽  
First Principle ◽  
X Ray Diffraction ◽  
X Ray ◽  
First Principle Calculations ◽  
Photodegradation Efficiency

AbstractIdeal sillenite type Bi12FeO20 (BFO) micron sized single crystals have been successfully grown via inexpensive hydrothermal method. The refined single crystal X-ray diffraction data reveals cubic Bi12FeO20 structure with single crystal parameters. Occurrence of rare Fe4+ state is identified via X-ray photoelectron spectroscopy (XPS) and X-ray absorption spectroscopy (XAS). The lattice parameter (a) and corresponding molar volume (Vm) of Bi12FeO20 have been measured in the temperature range of 30–700 °C by the X-ray diffraction method. The thermal expansion coefficient (α) 3.93 × 10–5 K−1 was calculated from the measured values of the parameters. Electronic structure and density of states are investigated by first principle calculations. Photoelectrochemical measurements on single crystals with bandgap of 2 eV reveal significant photo response. The photoactivity of as grown crystals were further investigated by degrading organic effluents such as Methylene blue (MB) and Congo red (CR) under natural sunlight. BFO showed photodegradation efficiency about 74.23% and 32.10% for degrading MB and CR respectively. Interesting morphology and microstructure of pointed spearhead like BFO crystals provide a new insight in designing and synthesizing multifunctional single crystals.

scholarly journals Study of Corrosion Resistance and Degradation Mechanisms in LiTiO2-Li2TiO3 Ceramic

Crystals ◽  
2021 ◽  
Vol 11 (7) ◽  
pp. 753
Author(s):  
Dmitriy Shlimas ◽  
Artem L. Kozlovskiy ◽  
Maxim Zdorovets
Keyword(s):  
Degradation Mechanism ◽  
Diffraction Method ◽  
Large Mass ◽  
Time Frame ◽  
X Ray Diffraction ◽  
Acidic Media ◽  
X Ray ◽  
Mass Losses ◽  
The Stability ◽  
Thermal Sintering

The interest in lithium-containing ceramics is due to their huge potential as blanket materials for thermonuclear reactors for the accumulation of tritium. However, an important factor in their use is the preservation of the stability of their strength and structural properties when under the influence of external factors that determine the time frame of their operation. This paper presents the results of a study that investigated the influence of the LiTiO2 phase on the increasing resistance to degradation and corrosion of Li2TiO3 ceramic when exposed to aggressive acidic media. Using the X-ray diffraction method, it was found that an increase in the concentration of LiClO4·3H2O during synthesis leads to the formation of a cubic LiTiO2 phase in the structure as a result of thermal sintering of the samples. During corrosion tests, it was found that the presence of the LiTiO2 phase leads to a decrease in the degradation rate in acidic media by 20–70%, depending on the concentration of the phase. At the same time, and in contrast to the samples of Li2TiO3 ceramics, for which the mechanisms of degradation during a long stay in aggressive media are accompanied by large mass losses, for the samples containing the LiTiO2 phase, the main degradation mechanism is pitting corrosion with the formation of pitting inclusions.

Sign in / Sign up

Export Citation Format

Share Document