Machinability Of Shape Memory Alloy Using Electro Spark Erosion Process
Abstract In this research work, the nickel – titanium based shape memory alloys are machined using electro spark machining process. The influence of the input process for electro spark production is studied in detail. From the analysis, the tool wear rate (TWR), surface roughness, and material removal rate (MRR) are investigated. The intensity of the electro spark produced at minimum pulse on-time 10 µs and maximum applied voltage (60 V). Variation in MRR is wide for a minimum pulse on time with low applied voltage. The surface roughness of the machined surface is also directly influenced by the in – efficient spark produced. The copper electrode with increase pulse duration the alloy behaves like a strong conductor to transmit electrical energy between the electrode and work material. The contribution of pulse on-time is maximum for material removal and tool wear rate. However, the surface finish depends on the applied voltage of the process designed. The impact on machined surfaces, micro-cracks, electro-discharge carter's, and recast material due to electrical discharge were assessed using a scanning electron microscope and energy-dispersive X-ray spectroscopy (EDX) analysis. The experimental value shows that material removal depends on the pulse on process timings and applied voltage. Thus, by using mathematical analysis the influence of (electric discharge machining) EDM process parameters was evaluated.