scholarly journals Thermal Analysis of Solar Energy Hot Water Preparing Systems

2005 ◽  
pp. 263-269
Author(s):  
Mustafa Aktas
Keyword(s):  
Thermal Analysis ◽  
Solar Energy ◽  
Hot Water

Sustainable Cooling with Hybrid Concentrated Photovoltaic Thermal (CPVT) System and Hydrogen Energy Storage

2018 ◽  
Vol 1 (2) ◽  
pp. 40-51 ◽  
Author(s):  
Muhammad Burhan ◽  
Muhammad Wakil Shahzad ◽  
Kim Choon Ng
Keyword(s):  
Energy Storage ◽  
Solar Energy ◽  
Optimization Algorithm ◽  
Concentration Ratio ◽  
Cooling System ◽  
Renewable Energy Sources ◽  
Hot Water ◽  
Hydrogen Energy ◽  
Adsorption Chiller ◽  
Back Plate

Standalone power systems have vital importance as energy source for remote area. On the other hand, a significant portion of such power production is used for cooling purposes. In this scenario, renewable energy sources provide sustainable solution, especially solar energy due to its global availability. Concentrated photovoltaic (CPV) system provides highest efficiency photovoltaic technology, which can operate at x1000 concentration ratio. However, such high concentration ratio requires heat dissipation from the cell area to maintain optimum temperature. This paper discusses the size optimization algorithm of sustainable cooling system using CPVT. Based upon the CPV which is operating at x1000 concentration with back plate liquid cooling, the CPVT system size is optimized to drive a hybrid mechanical vapor compression (MVC) chiller and adsorption chiller, by utilizing both electricity and heat obtained from the solar system. The electrolysis based hydrogen is used as primary energy storage system along with the hot water storage tanks. The micro genetic algorithm (micro-GA) based optimization algorithm is developed to find the optimum size of each component of CPVT-Cooling system with uninterrupted power supply and minimum cost, according to the developed operational strategy. The hybrid system is operated with solar energy system efficiency of 71%.

Problem about Solar Water Heating System and Residential Building Integrated

2012 ◽  
Vol 193-194 ◽  
pp. 30-33
Author(s):  
Xue Ying Wang ◽  
Dong Xu ◽  
Ya Jun Wu
Keyword(s):  
Solar Energy ◽  
Integrated Design ◽  
Water System ◽  
Residential Building ◽  
Heating System ◽  
Hot Water ◽  
Solar Water Heating ◽  
Drainage Design ◽  
Hot Water Supply ◽  
Solar Water Heating System

This article analyzes the problem in application the solar system was used in residential building, puts forward the requirements to use energy and choose the setting of the solar energy collector from two aspects of building and drainage design respectively. In addition, the article explicates andthe solar energy collector and building integrated design and the development of solar energy collector. At last, the article puts forward some Suggestions on the improvement and development of residential solar hot water system and the design of the hot water supply bath solution of practice to make solar energy and low power assisted by night combining.

RENEWABLE ENERGY INTEGRATION FOR HOT WATER SUPPLY AND HEATING OF BUILDINGS

2021 ◽  
pp. 3-12
Author(s):  
Yu. Selikhov ◽  
K. Gorbunov ◽  
V. Stasov
Keyword(s):  
Solar Energy ◽  
Heat Production ◽  
Heat Supply ◽  
Alternative Energy ◽  
Fossil Fuel ◽  
Heat Pumps ◽  
Climatic Conditions ◽  
Economic Feasibility ◽  
Hot Water ◽  
The Cost

Solar energy is widely used in solar systems, where economy and ecology are combined. Namely, this represents an important moment in the era of depletion of energy resources. The use of solar energy is a promising economical item for all countries of the world, meeting their interests also in terms of energy independence, thanks to which it is confidently gaining a stable position in the global energy sector. The cost of heat obtained through the use of solar installations largely depends on the radiation and climatic conditions of the area where the solar installation is used. The climatic conditions of our country, especially the south, make it possible to use the energy of the Sun to cover a significant part of the need for heat. A decrease in the reserves of fossil fuel and its rise in price have led to the development of optimal technical solutions, efficiency and economic feasibility of using solar installations. And today this is no longer an idle curiosity, but a conscious desire of homeowners to save not only their financial budget, but also health, which is possible only with the use of alternative energy sources, such as: double-circuit solar installations, geothermal heat pumps (HP), wind power generators. The problem is especially acute in the heat supply of housing and communal services (HCS), where the cost of fuel for heat production is several times higher than the cost of electricity. The main disadvantages of centralized heat supply sources are low energy, economic and environmental efficiency. And high transport tariffs for the delivery of energy carriers and frequent accidents on heating mains exacerbate the negative factors inherent in traditional district heating. One of the most effective energy-saving methods that make it possible to save fossil fuel, reduce environmental pollution, and meet the needs of consumers in process heat is the use of heat pump technologies for heat production.

scholarly journals Evaluation of Solar Ponds and Aplication Area

2018 ◽  
Vol 64 ◽  
pp. 02002
Author(s):  
Sogukpinar Haci ◽  
Bozkurt Ismail ◽  
Cag Serkan
Keyword(s):  
Solar Energy ◽  
Electricity Generation ◽  
Storage Capacity ◽  
Heat Storage ◽  
Storage Systems ◽  
Hot Water ◽  
Temperature Variations ◽  
Solar Ponds ◽  
Salty Water ◽  
Solar Pond

Solar ponds are heat storage systems where solar energy is collected and stored thermally. Solar ponds were discovered during the temperature variations in the lower regions of existing saltwater pond in the area is found to be higher than their surface. Later, it was constructed artificially and started to be used. These systems have heat storage capacity at moderate temperatures. Solar pons are used in many areas such as electricity generation, heating the environment, meeting the need of hot water, drying food and obtaining fresh water from salty water. In this study, the studies about solar ponds were summarized, the construction of solar pond was explained, and the application areas were examined.

scholarly journals Combining Heat Pumps with Solar Energy for Domestic Hot Water Production

2012 ◽  
Vol 30 ◽  
pp. 101-105 ◽  
Author(s):  
Andreas Genkinger ◽  
Ralf Dott ◽  
Thomas Afjei
Keyword(s):  
Solar Energy ◽  
Heat Pumps ◽  
Hot Water ◽  
Water Production ◽  
Domestic Hot Water

Evacuated Tube Heat Pipe Solar Collectors Applied to Recirculation Loop in a Federal Building: SSA Philadelphia

Solar Energy ◽  
2004 ◽  
Author(s):  
Andy Walker ◽  
Fariborz Mahjouri ◽  
Robert Stiteler
Keyword(s):  
Solar Energy ◽  
Heat Pipe ◽  
Heat Loss ◽  
Heating System ◽  
Hot Water ◽  
Solar Array ◽  
Solar Collectors ◽  
Water Heating ◽  
Evacuated Tube ◽  
Recirculation Loop

This paper describes design, simulation, construction and measured initial performance of a solar water heating system (360 Evacuated Heat-Pipe Collector tubes, 54 m2 gross area, 36 m2 net absorber area) installed at the top of the hot water recirculation loop in the Social Security Mid-Atlantic Center in Philadelphia. Water returning to the hot water storage tank is heated by the solar array when solar energy is available. This new approach, as opposed to the more conventional approach of preheating incoming water, is made possible by the thermal diode effect of heat pipes and low heat loss from evacuated tube solar collectors. The simplicity of this approach and its low installation costs makes the deployment of solar energy in existing commercial buildings more attractive, especially where the roof is far removed from the water heating system, which is often in the basement. Initial observed performance of the system is reported. Hourly simulation estimates annual energy delivery of 111 GJ/year of solar heat and that the annual efficiency (based on the 54 m2 gross area) of the solar collectors is 41%, and that of the entire system including parasitic pump power, heat loss due to freeze protection, and heat loss from connecting piping is 34%. Annual average collector efficiency based on a net aperture area of 36 m2 is 61.5% according to the hourly simulation.

scholarly journals SOLAR RADIATION PROTECTION SYSTEM WITH SIMULTANEOUS HOT WATER SUPPLY

2020 ◽  
Author(s):  
І. Puhoviy ◽  
М. Makhrov
Keyword(s):  
Solar Energy ◽  
Energy Savings ◽  
Electrical Power ◽  
Warm Season ◽  
Hot Water ◽  
Air Conditioner ◽  
Domestic Water ◽  
Environmental Friendliness ◽  
Additional Advantage ◽  
The Cost

Problems. Windows in the summer let through a large amount of solar energy into the room, which causes an additional cost of cooling the air by conditioning. It is known that the limit of comfort is the temperature of 26 oC. To reduce the temperature, use air conditioners, which are required 0,3...0,5 kW of electrical power for 10 m2 of housing. The study deals with the capture of solar energy by water and its use for domestic water purposes (DHW). The goal of the research. Experimental verification of patented developments and calculations of hot water quantity obtained per day, energy savings and economic indicators. Methods of implementation. Experiments were conducted on the south window of the room, with water pumping by a pump and periodic measurement of air and water temperatures at the outlet of the system by mercury thermometer. The calculations were performed using the methods developed by the authors. The studies were conducted within three days of November. The temperature inside ranged a room from 19 to 23 °C. The system was operated in circulating mode on a water battery tank located below the absorber. Isolation of the absorber from the side of the room was made of a transparent food film. Research results. Water temperature reached 45 °C per 1,5-2 hours. Water consumption is enhanced by the thermosiphon effect when water moves from the bottom up. On a clear day of spring and autumn, you can heat for 50-70 % more water than the average for the average day of months of the warm season. For preparing DHW with 1 m2 of absorber, it is possible to get 45-50 kW∙h of heat for each month from March to September, taking into account cloudiness. The savings from the use of hot water and from reducing the consumption of electricity in the air conditioner are calculated. Conclusions. The payback period of the system, taking into account the cost of the heat for DHW and electricity savings for an electric air conditioner, is approximately 4-5 years. The cost of the system is close to the cost of a home air conditioner, for a premise with a single window oriented south. To the energy-saving factor, an additional advantage is the environmental friendliness of the system compared to the air conditioner.

scholarly journals Comparative Analysis of Small-Scale Organic Rankine Cycle Systems for Solar Energy Utilisation

Energies ◽  
2019 ◽  
Vol 12 (5) ◽  
pp. 829 ◽  
Author(s):  
Ruiqi Wang ◽  
Long Jiang ◽  
Zhiwei Ma ◽  
Abigail Gonzalez-Diaz ◽  
Yaodong Wang ◽  
...  
Keyword(s):  
Solar Energy ◽  
Power Output ◽  
Organic Rankine Cycle ◽  
Rankine Cycle ◽  
Hot Water ◽  
Superior Performance ◽  
Small Scale ◽  
Water Storage Tank ◽  
Solar Thermal Collector ◽  
Cycle Systems

Small-scale organic Rankine cycle (ORC) systems driven by solar energy are compared in this paper, which aims to explore the potential of power generation for domestic utilisation. A solar thermal collector was used as the heat source for a hot water storage tank. Thermal performance was then evaluated in terms of both the conventional ORC and an ORC using thermal driven pump (TDP). It is established that the solar ORC using TDP has a superior performance to the conventional ORC under most working conditions. Results demonstrate that power output of the ORC using TDP ranges from 72 W to 82 W with the increase of evaporating temperature, which shows an improvement of up to 3.3% at a 100 °C evaporating temperature when compared with the power output of the conventional ORC. Energy and exergy efficiencies of the ORC using TDP increase from 11.3% to 12.6% and from 45.8% to 51.3% when the evaporating temperature increases from 75 °C to 100 °C. The efficiency of the ORC using TDP is improved by up to 3.27%. Additionally, the exergy destruction using TDP can be reduced in the evaporator and condenser. The highest exergy efficiency in the evaporator is 96.9%, an improvement of 62% in comparison with that of the conventional ORC, i.e., 59.9%. Thus, the small-scale solar ORC system using TDP is more promising for household application.

Sign in / Sign up

Export Citation Format

Share Document