scholarly journals An improved analytical method for triple stub matching (stubs in series)

2021 ◽  
Vol 7 (2) ◽  
pp. 103-123
Author(s):  
Slobodan Babic ◽  
Cevdet Akyel
Keyword(s):  
Transmission Line ◽  
Unique Solution ◽  
Standing Wave ◽  
Analytical Method ◽  
Power Transfer ◽  
Matching Conditions ◽  
The Third ◽  
Special Cases ◽  
In Series

In this paper we give the new improved analytical method of triple stub tuner for matching the load impedances to provide the maximum power transfer between a generator and a load. The stubs are connected in series with the line at the appropriate distances from the load. The characteristic impedances of the transmission line and the stabs are different. The paper points on the determination of the length for the first stub near the load. The limit lengths for the first and the second stub are found for which the matching is possible. The length of the third stub is directly obtained from the matching conditions. Event though there is not the unique solution for the triple stub matching, we shoved also the existence of the unique solutions under some conditions. The special cases are also treated. The results of this method are verified by using the standing wave ratio SWR. Event though there are not many papers on this subject this work could be useful for engineers and physicist which work in this domain.

scholarly journals An improved analytical method for triple stub matching (Stubs in Parallel)

2021 ◽  
Vol 7 (3) ◽  
pp. 157-187
Author(s):  
Slobodan Babic ◽  
Cevdet Akyel
Keyword(s):  
Transmission Line ◽  
Unique Solution ◽  
Analytical Method ◽  
Power Transfer ◽  
Matching Conditions ◽  
The Third ◽  
Special Cases ◽  
Smith Chart ◽  
Good Agreement

In this paper we give the new improved analytical method of triple stub tuner for matching the load impedances to provide the maximum power transfer between a generator and a load. The stubs are connected in parallel with the line at the appropriate distances from the load. The characteristic impedances of the transmission line and the stabs are different. The paper points on the determination of the length for the first stub near the load. The limit lengths for the first and the second stub are found for which the matching is possible. The length of the third stub is directly obtained from the matching conditions. Even though there is not the unique solution for the triple stub matching we also shoved the existence of unique solutions under some conditions. The special cases are also treated. The results of this method are verified by those obtained using the Smith chart and there are in exceptionally good agreement. Even though there are not many papers on this subject this work could be useful for engineers, and physicist which work in this domain.

scholarly journals Determination of Phenylephrine Hydrochloride, Chlorpheniramine Maleate, and Methscopolamine Nitrate in Tablets or Capsules by Liquid Chromatography with Two UV Absorbance Detectors in Series

2006 ◽  
Vol 89 (1) ◽  
pp. 53-57 ◽  
Author(s):  
Ugo R Cieri
Keyword(s):  
Liquid Chromatography ◽  
The Other ◽  
Uv Absorbance ◽  
Chlorpheniramine Maleate ◽  
Phenylephrine Hydrochloride ◽  
Silica Column ◽  
The Third ◽  
Acid Sodium Salt ◽  
In Series

Abstract A procedure is presented for the simultaneous determination of phenylephrine HCl (PE), chlorpheniramine maleate (CM), and methscopolamine nitrate in commercial tablets or capsules by liquid chromatography (LC) with 2 UV absorbance detectors in series. Reference and sample solutions are prepared in methanol. LC separations are performed on a 7.5 cm Novapak silica column. The mobile phase is prepared by mixing 930 mL methanol with 70 mL of a 0.5% aqueous solution of 1-pentanesulfonic acid, sodium salt. The injection volume is 20 L; the flow rate is approximately 1 mL/min. Retention times are approximately 1.5 min for PE, 3 min for CM, and 6 min for methscopolamine nitrate. One detector determines the first 2 compounds at 265 nm, but the third compound does not produce a detectable peak. The other detector set at 210 nm generates peaks for all 3 compounds, but only methscopolamine is within the recorder range; the other 2 compounds are exceedingly off scale. If it is not feasible or desirable to arrange 2 UV absorbance detectors in series, separate determinations can be made, one for the first 2 compounds and the other for the third component of the mixture. Two commercial samples of tablets and 2 commercial samples of capsules were analyzed by the proposed method. Recovery studies were also conducted with amounts of the 3 compounds ranging from 80 to 120% of the quantities present in the sample solutions.

scholarly journals THE PROCESS OF HEAT TRANSFER IN TWO-LAYERED CYLINDRICAL BODY

2019 ◽  
Vol 20 (11-12) ◽  
pp. 93-98
Author(s):  
U. V. Vidin ◽  
R. V. Kazakov ◽  
V. S. Zlobin
Keyword(s):  
Heat Transfer ◽  
Heat Conduction ◽  
Boundary Conditions ◽  
Analytical Method ◽  
Analytical Methods ◽  
Cylindrical Body ◽  
Characteristic Equations ◽  
The Third ◽  
Thermal Regimes

Determination of thermal regimes of composite cylindrical bodies by analytical methods leads to the appearance of complex characteristic equations, the solution of which is the determination of eigenvalues. The article considers a relatively simple approximate analytical method for determining the eigenvalues of characteristic equations for a two-layer cylindrical body under boundary conditions of the third kind. This method can also be easily used in more complex formulations of heat conduction problems.

Determination of Overvoltages in Transmission Line Terminations Using a Physical Model

1975 ◽  
Vol 12 (4) ◽  
pp. 367-373 ◽  
Author(s):  
D. F. Binns ◽  
H. Habibollahi
Keyword(s):  
Transmission Line ◽  
Physical Model ◽  
Third Harmonic ◽  
Short Line ◽  
The Third ◽  
Transient Voltage

Switching transients have been studied for a short line terminated by an inductor. Resonance with the third harmonic of the transient voltage in the line can produce a peak of 5 pu in the termination, while the fifth harmonic can produce 4.2 pu. Source inductance reduces these voltages appreciably.

Investigations on skeletal growth zones via bone scans as base of determination of optimal time for surgery in mandibular asymmetry

2000 ◽  
Vol 39 (05) ◽  
pp. 121-126 ◽  
Author(s):  
R. Werz ◽  
P. Reuland
Keyword(s):  
Bone Growth ◽  
Region Of Interest ◽  
Tracer Uptake ◽  
Optimal Time ◽  
Mandibular Bone ◽  
The Third ◽  
Mandibular Asymmetry ◽  
Bone Scans ◽  
Epiphyseal Plates

Summary Aim of the study was to find out wether there is a common stop of growth of mandibular bone, so that no individual determination of the optimal time for surgery in patients with asymmetric mandibular bone growth is needed. As there are no epiphyseal plates in the mandibular bone, stop of growth cannot be determined on X-ray films. Methods: Bone scans of 731 patients [687 patients (324 male, 363 female) under 39 y for exact determination of end of growth and 44 (21 male, 23 female) patients over 40 y for evaluation of nongrowth dependant differences in tracer uptake] were reviewed for the study. All the patients were examined 3 hours after injection of 99mTc-DPD. Tracer uptake was measured by region of interest technique in different points of the mandibular bone and in several epiphyseal plates of extremities. Results: Tracer uptake in different epiphyseal plates of the extremities shows strong variation with age and good correlation with reported data of bone growth and closure of the epiphyseal plates. The relative maximum of bone activity is smaller in mandibular bone than in epiphyseal plates, which show well defined peaks, ending at 15-18 years in females and at 18-21 years in males. In contrast, mandibular bone shows no well defined end of growing but a gradually reduction of bone activity which remains higher than bone activity in epiphyseal plates over several years. Conclusion: No well defined end of growth of mandibular bone exists. The optimal age for surgery of asymmetric mandibular bone growth is not before the middle of the third decade of life, bone scans performed earlier for determination of bone growth can be omitted. Bone scans performed at the middle of the third decade of life help to optimize the time of surgical intervention.

THE FACTORS OF CAREER SELF-DETERMINATION OF STUDENTS OF HIGHER EDUCATION INSTITUTIONS

2019 ◽  
Vol 7 (1) ◽  
pp. 9-20
Author(s):  
Inna Yeung
Keyword(s):  
Higher Education ◽  
Higher Education Institutions ◽  
Well Being ◽  
Young Person ◽  
Self Determination ◽  
Full Time ◽  
Actual Problem ◽  
The Third ◽  
The Right

Choice of profession is a social phenomenon that every person has to face in life. Numerous studies convince us that not only the well-being of a person depends on the chosen work, but also his attitude to himself and life in general, therefore, the right and timely professional choice is very important. Research about factors of career self-determination of students of higher education institutions in Ukraine shows that self-determination is an important factor in the socialization of young person, and the factors that determine students' career choices become an actual problem of nowadays. The present study involved full-time and part-time students of Institute of Philology and Mass Communications of Open International University of Human Development "Ukraine" in order to examine the factors of career self-determination of students of higher education institutions (N=189). Diagnostic factors of career self-determination of students studying in the third and fourth year were carried out using the author's questionnaire. Processing of obtained data was carried out using the Excel 2010 program; factorial and comparative analysis were applied. Results of the study showed that initial stage of career self-determination falls down on the third and fourth studying year at the university, when an image of future career and career orientations begin to form. At the same time, the content of career self-determination in this period is contradictory and uncertain, therefore, the implementation of pedagogical support of this process among students is effective.

LUMINESCENT DETERMINATION OF SUGAR IN NATURAL HONEY

2020 ◽  
Vol 0 (4) ◽  
pp. 29-32
Author(s):  
B.M. GAREEV ◽  
◽  
A.M. ABDRAKHMANOV ◽  
G.L. SHARIPOV ◽  
◽  
...  
Keyword(s):  
Quantum Dots ◽  
Laboratory Test ◽  
Aqueous Solutions ◽  
Analytical Method ◽  
Sugar Content ◽  
Carbon Quantum Dots ◽  
Photoluminescence Intensity ◽  
Sucrose Content ◽  
Natural Honey

The photoluminescence of carbon quantum dots synthesized from natural honey and mixtures of honey and sugar has been studied. An increase in the sugar content leads to a decrease in the photoluminescence intensity without changing the shape of the luminescence spectrum of these quantum dots aqueous solutions, which is associated with a decrease in the yield of their synthesis in the sugar presence. The discovered effect can be used to detect sugar in honey. When examining five different market samples of flower honey using this method, two of them showed a significant decrease in the photoluminescence intensity. A laboratory test for compliance with GOST 19792-2017 Standard requirements established an excess of the sucrose content in these samples. Luminescent determination of sugar in honey does not require complicated equipment and can be used to develop a new analytical method for determining the sugar content in counterfeit natural honey.

Comparative assessment of informational content of the equations of F.P. Hadlock and the computer program of V.N. Demidov in determination of term of gestation and fetal weight in the III trimester of gestation

2017 ◽  
Author(s):  
E.A. Derkach , O.I. Guseva
Keyword(s):  
Computer Program ◽  
High Precision ◽  
Gestational Age ◽  
Computer Programs ◽  
Comparative Assessment ◽  
Fetal Weight ◽  
Informational Content ◽  
Third Trimester ◽  
The Third

Objectives: to compare the accuracy of equations F.P. Hadlock and computer programs by V.N. Demidov in determining gestational age and fetal weight in the third trimester of gestation. Materials: 328 patients in terms 36–42 weeks of gestation are examined. Ultrasonography was performed in 0–5 days prior to childbirth. Results: it is established that the average mistake in determination of term of pregnancy when using the equation of F.P. Hadlock made 12,5 days, the computer program of V.N. Demidov – 4,4 days (distinction 2,8 times). The mistake within 4 days, when using the equation of F.P. Hadlock has met on average in 23,1 % of observations, the computer program of V.N. Demidov — 65,9 % (difference in 2,9 times). The mistake more than 10 days, took place respectively in 51,7 and 8,2 % (distinction by 6,3 times). At a comparative assessment of size of a mistake in determination of fetal mass it is established that when using the equation of F.P. Hadlock it has averaged 281,0 g, at application of the computer program of V.N. Demidov — 182,5 g (distinction of 54 %). The small mistake in the mass of a fetus which isn't exceeding 200 g at application of the equation of F.P. Hadlock has met in 48,1 % of cases and the computer program of V.N. Demidov — 64,0 % (distinction of 33,1 %). The mistake exceeding 500 g has been stated in 18 % (F.P. Hadlock) and 4,3 % (V.N. Demidov) respectively (distinction 4,2 times). Conclusions: the computer program of V.N. Demidov has high precision in determination of term of a gestation and mass of a fetus in the III pregnancy.

Sign in / Sign up

Export Citation Format

Share Document