scholarly journals Constraint and opportunity of raw jute production : A case study of eastern Terai, Nepal

2013 ◽  
Vol 3 ◽  
pp. 117-122 ◽  
Author(s):  
TB Ghimire ◽  
NS Thakur
Keyword(s):  
Production Cost ◽  
Cost Effective ◽  
Profit Margin ◽  
Yield Potential ◽  
High Yield ◽  
Climate Change Effect ◽  
Cost Of Production ◽  
Sowing Period ◽  
The Cost ◽  
High Yield Potential

Area and production of raw jute has decreased, though there is a high demand of raw jute in the country. In order to assess production constraints, a survey was carried out in 2005/06 in Jhapa, Morang and Sunsari districts. The study revealed that unstable or low price of raw jute, unavailability of quality jute seed, limited irrigation water at sowing period, diseases complex (wilt), labor shortage during peak season, weed problem, lack of retting water/retting pond were the main constraints in jute production and processing. The study indicates that the maximum production cost has involved in fiber extraction (16.9%) and weeding (16.33%). Jute productivity ranged from 1788 to 2260 kg per hectare. JRO-524 variety of jute has been widely grown across the region due to its wider adaptability, high yield potential and quality fiber. Jute area has been replaced by sugarcane due to its high yield potential and high profit margin. It is observed that the cost of production of jute is high as compared to other crops in the season. Average cost of production of fiber was estimated to be Rs.1563/quintal. For the promotion of jute cultivation in the eastern Terai, it would be better to provide subsidies on seeds and fertilizer to jute growers as practiced in neighboring countries thereby profit margin becomes high and will encourage growers in producing more raw jute within the country for the fulfillment of raw jute requirement of local jute industries. Cost effective technologies have to be developed in jute production and processing aspects for lowering the production cost and increasing the profit margin. Popular genotypes JRO- 524 which was widely adopted needs to be recommended officially for the general cultivation in this region. Being an eco-friendly crop, promotion is required to adapt climate change effect and maintaining the soil properties in jute growing areas. Agronomy Journal of Nepal (Agron JN) Vol. 3. 2013, Page 117-122 DOI: http://dx.doi.org/10.3126/ajn.v3i0.9013

scholarly journals Growth and Yield of Different Varieties of True Shallot Seed on Highland in West Sumatra, Indonesia

2021 ◽  
Vol 2021 ◽  
pp. 1-6
Author(s):  
Atman ◽  
Irfan Suliansyah ◽  
Aswaldi Anwar ◽  
Syafrimen Yasin
Keyword(s):  
Block Design ◽  
Yield Component ◽  
Growth And Yield ◽  
Yield Potential ◽  
High Yield ◽  
Randomized Complete Block Design ◽  
West Sumatra ◽  
The Cost ◽  
High Yield Potential

Cultivation of true shallot seeds has the potential to be developed in Indonesia because apart from being able to reduce the cost of providing seeds, it also has higher productivity than shallot from tubers. This study aims to determine the appearance of true shallot seed varieties that have high yield potential in the highlands of West Sumatra. The study used a randomized complete block design (RCBD) with 4 treatments of true shallot seed varieties, namely, Trisula, Bima, Lokananta, and Sanren, with 6 replications. The results showed that except for the age of harvest and the number of tubers per hill, the treatment of various varieties of true shallot seeds showed a significant effect on all observed variables. Lokananta variety has better growth component, yield component, and yields compared to other varieties (Trisula, Bima, and Sanren). Cultivation of true shallot seeds in the highlands gives lower yields than in the adapted area (lowland), except for the Trisula variety. Lokananta variety is recommended for use in the highlands of West Sumatra.

FloRunTM ‘331’ Peanut Variety

EDIS ◽  
2019 ◽  
Vol 2019 (1) ◽  
Author(s):  
Barry L. Tillman
Keyword(s):  
Seed Size ◽  
Growth Habit ◽  
Yield Potential ◽  
High Yield ◽  
University Of Florida ◽  
High Oleic ◽  
Central Stem ◽  
Research And Education ◽  
The University ◽  
High Yield Potential

FloRunTM ‘331’ peanut variety was developed by the University of Florida, Institute of Food and Agricultural Sciences, North Florida Research and Education Center near Marianna, Florida.  It was released in 2016 because it combines high yield potential with excellent disease tolerance. FloRunTM ‘331’ has a typical runner growth habit with a semi-prominent central stem and medium green foliage.  It has medium runner seed size with high oleic oil chemistry.

IMPLEMENTASI JOB ORDER COSTING METHOD DALAM PERHITUNGAN HARGA POKOK PRODUKSI MAP

2018 ◽  
Vol 4 (2) ◽  
pp. 43-55
Author(s):  
Ika Yulianti ◽  
Endah Masrunik ◽  
Anam Miftakhul Huda ◽  
Diana Elvianita
Keyword(s):  
Production Process ◽  
Quantitative Data ◽  
Production Cost ◽  
Qualitative Data ◽  
Cost Data ◽  
Method Calculation ◽  
Cost Of Production ◽  
The Right ◽  
The Cost

This study aims to find a comparison of the calculation of the cost of goods manufactured in the CV. Mitra Setia Blitar uses the company's method and uses the Job Order Costing (JOC) method. The method used in this study is quantitative. The types of data used are quantitative and qualitative. Quantitative data is in the form of map production cost data while qualitative data is in the form of information about map production process. The result of calculating the cost of production of the map between the two methods results in a difference of Rp. 306. Calculation using the company method is more expensive than using the Job Order Costing method. Calculation of cost of goods manufactured using the company method is Rp. 2,205,000, - or Rp. 2,205, - each unit. While using the Job Order Costing (JOC) method is Rp. 1,899,000, - or Rp 1,899, - each unit. So that the right method used in calculating the cost of production is the Job Order Costing (JOC) method

scholarly journals Cost Effectiveness of Transbronchial Needle Aspiration

1999 ◽  
Vol 6 (4) ◽  
pp. 332-335 ◽  
Author(s):  
Jennifer A Crocket ◽  
Eric YL Wong ◽  
Dale C Lien ◽  
Khanh Gia Nguyen ◽  
Michelle R Chaput ◽  
...  
Keyword(s):  
Cost Effectiveness ◽  
Cost Effective ◽  
Diagnostic Procedures ◽  
Needle Aspiration ◽  
Benign Disease ◽  
University Hospital ◽  
High Yield ◽  
Transbronchial Needle Aspiration ◽  
Computed Tomographic ◽  
The Cost

OBJECTIVE: To evaluate the yield and cost effectiveness of transbronchial needle aspiration (TBNA) in the assessment of mediastinal and/or hilar lymphadenopathy.DESIGN: Retrospective study.SETTING: A university hospital.POPULATION STUDIED: Ninety-six patients referred for bronchoscopy with computed tomographic evidence of significant mediastinal or hilar adenopathy.RESULTS: Ninety-nine patient records were reviewed. Three patients had two separate bronchoscopy procedures. TBNA was positive in 42 patients (44%) and negative in 54 patients. Of the 42 patients with a positive aspirate, 40 had malignant cytology and two had cells consistent with benign disease. The positive TBNA result altered management in 22 of 40 patients with malignant disease and one of two patients with benign disease, thereby avoiding further diagnostic procedures. The cost of these subsequent procedures was estimated at $27,335. No complications related to TBNA were documented.CONCLUSIONS: TBNA is a high-yield, safe and cost effective procedure for the diagnosis and staging of bronchogenic cancer.

scholarly journals Genomic Prediction and Indirect Selection for Grain Yield in US Pacific Northwest Winter Wheat Using Spectral Reflectance Indices from High-Throughput Phenotyping

2019 ◽  
Vol 21 (1) ◽  
pp. 165 ◽  
Author(s):  
Dennis N. Lozada ◽  
Jayfred V. Godoy ◽  
Brian P. Ward ◽  
Arron H. Carter
Keyword(s):  
Winter Wheat ◽  
Pacific Northwest ◽  
Prediction Accuracy ◽  
Indirect Selection ◽  
Yield Potential ◽  
High Yield ◽  
High Throughput Phenotyping ◽  
Reflectance Indices ◽  
Selection Of ◽  
High Yield Potential

Secondary traits from high-throughput phenotyping could be used to select for complex target traits to accelerate plant breeding and increase genetic gains. This study aimed to evaluate the potential of using spectral reflectance indices (SRI) for indirect selection of winter-wheat lines with high yield potential and to assess the effects of including secondary traits on the prediction accuracy for yield. A total of five SRIs were measured in a diversity panel, and F5 and doubled haploid wheat breeding populations planted between 2015 and 2018 in Lind and Pullman, WA. The winter-wheat panels were genotyped with 11,089 genotyping-by-sequencing derived markers. Spectral traits showed moderate to high phenotypic and genetic correlations, indicating their potential for indirect selection of lines with high yield potential. Inclusion of correlated spectral traits in genomic prediction models resulted in significant (p < 0.001) improvement in prediction accuracy for yield. Relatedness between training and test populations and heritability were among the principal factors affecting accuracy. Our results demonstrate the potential of using spectral indices as proxy measurements for selecting lines with increased yield potential and for improving prediction accuracy to increase genetic gains for complex traits in US Pacific Northwest winter wheat.

Potential of warm-season annual forages and Brassica crops for grazing: A Canadian Review

2009 ◽  
Vol 89 (4) ◽  
pp. 431-440 ◽  
Author(s):  
D McCartney ◽  
J Fraser ◽  
A Ohama
Keyword(s):  
Foxtail Millet ◽  
Warm Season ◽  
Yield Potential ◽  
High Yield ◽  
Hordeum Vulgare L ◽  
Grazing Season ◽  
Brassica Crops ◽  
Fodder Crops ◽  
Secale Cereale L ◽  
The Cost

Extension of the grazing season beyond the normal perennial grazing season has been identified as a potential mechanism to reduce the cost of production on Canadian cow-calf operations. This review will provide an overview of the potential use of warm-season and Brassica crops including corn (Zea mays), Golden German foxtail millet (Setaria italica L. Beauv.), kale (Brassica oleracea L.), forage rape (B. napus ssp. biennis L.) and turnip (B. rapa L.). These crops have a high yield potential, but the cost for grazing these crops has not been adequately compared with the cost of grazing oat (Avena sativa L.), barley (Hordeum vulgare L.), and fall rye (Secale cereale L.). There are very few actual animal grazing trials evaluating the economics of using these crops in grazing systems in Canada, and this requires further research.Key words: Corn, millet, sorgum, sudan grass, fodder crops, brassicas

scholarly journals Aplikasi Metode Simpleks Pada Optimalisasi Biaya Bahan Baku (Studi Kasus: Ukm Najmah Klappertart)

2020 ◽  
Vol 17 (2) ◽  
pp. 129-140
Author(s):  
D Damayanti ◽  
A I Jaya ◽  
Resnawati
Keyword(s):  
Simplex Method ◽  
Production Cost ◽  
Production Costs ◽  
Optimal Production ◽  
Total Cost ◽  
Optimal Cost ◽  
Cost Of Production ◽  
The Cost

ABSTRACT The purpose of this research is to obtain an the optimal production costs of Klappertart based on the basic ingredients comparing the production cost of Klappertart in Najmah Klappertart with production costs using the simplex method. The result showed that the optimal costs is ,-. This result is equal to the total cost of klappertart by SMEs Najmah Klappertart, so it can be concluded that the cost of production klappertart based on the basic ingredients on SMEs Najmah Klappertart were optimal. Keywords      : Optimal Cost, Basic Ingredients, Production Costs. (A-Z), Simplex Method  

scholarly journals Analisis Penentuan Beban Pokok Produksi Pada Usaha Tempe Sumber Mas Jember

2018 ◽  
Vol 5 (2) ◽  
pp. 134
Author(s):  
Luqman Arif Baihaqi ◽  
Imam Mas'ud ◽  
Yosefa Sayekti
Keyword(s):  
Control System ◽  
Production Process ◽  
Production Cost ◽  
Cost Control ◽  
Total Production ◽  
Cost Of Production ◽  
The Cost ◽  
Business Cost

This study aims to find out the system of business cost control of Tempe Sumber Mas. A Controling based difference between the calculation of the cost of production with cost of production of tempe using full costing. and This research uses Descriptive by Source and Technique Triangulation. The results of this study indicate that the cost control system used by the company is still simple and the calculation of the cost of production of tempe using full costing method is greater than calculate the total production cost used in the tempe production process. Keywords: Expense, Cost of Production, Full Costing, Cost Control

Sign in / Sign up

Export Citation Format

Share Document