scholarly journals Comparative economics of cashew nut kernel processing technology in Bastar region of India

2014 ◽  
Vol 39 (1) ◽  
pp. 165-172
Author(s):  
Praveen Kumar Verma ◽  
SK Nag ◽  
SK Patil

The paper has studied the economic viability of improved technology (Introduced under NAIP component-3) for extraction of cashew kernel from cashew nut in Bastar region of Chhattisgarh, India. Cost concept has been used to calculate economics of cashew kernel. The technology (Boiling, steaming, cutting, drying, and peeling) has been found viable over conventional practices (Traditional manual separation by stone or hammer) on account of higher recovery of 40 percent and cost reduction by 29.71 percent. Overall net profit per unit (One unit includes one boiler, one steamer, two cutter, one dryer, six peelers and cost of land, depreciation and interest on working capital) in the case of improved technology has been estimated to be Rs 7.32 lakh. Cost of production in machine extraction practices was 202.80 Rupees per kilogram of cashew in spite of traditionally practiced 288.56 Rupees per kilogram. The cost benefit ratio was found higher in machine extraction (1.57) as compare to traditionally practiced (0.169). The mechanical decortications and separation could not only save time and money, also reduced women drudgery (due to manual breaking by stone or hammer to separate kernel). The technology has been found suitable for promotion of entrepreneurship on the processing of cashew kernel from cashew nut in the production catchments which otherwise is not properly utilized. DOI: http://dx.doi.org/10.3329/bjar.v39i1.20166 Bangladesh J. Agril. Res. 39(1): 165-172, March 2014

Nutrients ◽  
2021 ◽  
Vol 13 (3) ◽  
pp. 744
Author(s):  
Sophie I. Mavrogeni ◽  
Flora Bacopoulou ◽  
George Markousis-Mavrogenis ◽  
George Chrousos ◽  
Evangelia Charmandari

Obesity represents one of the most challenging public health problems of our century. It accounts for approximately 5% of deaths worldwide, mostly owing to cardiovascular disease and its associated complications. Cardiovascular noninvasive imaging may provide early accurate information about hypertrophy and ischemia/fibrosis in obese subjects. Echocardiography and nuclear cardiology have serious limitations in obese subjects owing to poor acoustic window and attenuation artifacts, respectively. Coronary computed tomography angiography can provide information about obstructive coronary disease; however, the use of radiation is a serious disadvantage. Finally, cardiac magnetic resonance (CMR) holds the promise of an “all in one” examination by combining evaluation of function, wall motion/thickness, stress rest/perfusion, replacement and diffuse fibrosis without radiation. Future studies are required to document the cost/benefit ratio of the CMR in the evaluation of cardiovascular risk in overweight/obese children and adolescents.


PEDIATRICS ◽  
1992 ◽  
Vol 89 (1) ◽  
pp. 169-169
Author(s):  
NORMAN J. SISSMAN

To the Editor.— Two recent reviews in Pediatrics1,2 provide much interesting information on the effect of home visits on the health of women and children. However, I was disappointed not to find in either article more than token reference to the cost of the programs reviewed. In this day of increasingly scarce health care resources, we no longer have the luxury of evaluating programs such as these without detailed consideration of their cost-benefit ratio.


2015 ◽  
Vol 48 (5) ◽  
pp. 319-323 ◽  
Author(s):  
André Hadyme Miyague ◽  
Fernando Marum Mauad ◽  
Wellington de Paula Martins ◽  
Augusto César Garcia Benedetti ◽  
Ana Elizabeth Gomes de Melo Tavares Ferreira ◽  
...  

AbstractThe authors review the main concepts regarding the importance of cleaning/disinfection of ultrasonography probes, aiming a better comprehension by practitioners and thus enabling strategies to establish a safe practice without compromising the quality of the examination and the operator productivity. In the context of biosafety, it is imperative to assume that contact with blood or body fluids represents a potential source of infection. Thus, in order to implement cleaning/disinfection practice, it is necessary to understand the principles of infection control, to consider the cost/benefit ratio of the measures to be implemented, and most importantly, to comprehend that such measures will not only benefit the health professional and the patient, but the society as a whole.


2014 ◽  
Vol 41 (4) ◽  
pp. 292-296
Author(s):  
Luiz Carlos Buarque Gusmão ◽  
Sérgio Henrique Chagas Valoes ◽  
José da Silva Leitão Neto

The objective is to reinforce the importance of blood reinfusion as a cheap, safe and simple method, which can be used in small hospitals, especially those in which there is no blood bank. Moreover, even with the use of devices that perform the collection and filtration of blood, more recent studies show that the cost-benefit ratio is much better when autologous transfusion is compared with blood transfusions, even when there is injury to hollow viscera and blood contamination. It is known that the allogeneic blood transfusion carries a number of risks to patients, among them are the coagulation disorders mediated by excess enzymes in the conserved blood, and deficiency in clotting factors, mainly the Factor V, the proacelerin. Another factor would be the risk of contamination with still unknown pathogens or that are not investigated during screening for selection of donors, such as the West Nile Fever and Creutzfeldt-Jacob, better known as "Mad Cow" disease. Comparing both methods, we conclude that blood autotransfusion has numerous advantages over heterologous transfusion, even in large hospitals. We are not against blood transfusions, just do not agree that the patient's own blood is discarded without making sure there will be enough blood in stock to get him out of the hemorrhagic shock.


2020 ◽  
Vol 8 ◽  
pp. 1-9
Author(s):  
Kiran Kumar R Patil ◽  

Objectives: This research was undertaken to examine the economic benefit of mechanization in dehusking arecanut. Methods/Statistical analysis: A sample consisting 15 each of pre-harvest contractors, arecanut farmers using machines of different capacities for dehusking arecanut were randomly selected from Davanagere district of Karnataka. The economic viability of mechanization was assessed under these situations using partial budgeting technique. Findings: The results of the study indicated that the cost of dehusking one quintal of arecanut using machine was ₹141 as compared to manual method (₹276) in case of pre-harvest contractors. The per quintal cost of dehusking of own arecanut produce came to Rs.78 as against manual method(Rs.277)in case of farmers who used the machine for dehusking of their own arecanut produce and rental purpose. Application/Improvements: The study suggested that marginal farmers should use two gear machine, small farmers four gear machine and large farmers six gear machine to economize dehusking their own farm produce and earning rental income. Keywords: Mechanization; Arecanut dehusking; economic evaluation; horticulture


2021 ◽  
Vol 3 (2) ◽  
pp. 111-120
Author(s):  
Segun Adebayo ◽  
Ozichi Emuoyibofarhe ◽  
Tolulope Awofolaju

Farmers are faced with challenges of producing enough food and the use of traditional methods seems not to keep pace with the ever-growing demand of the populace thus creating increased concern in food scarcity. Although it has been identified that smart tools will enhance the production pace needed in the Agricultural sector, unfortunately, most of these tools are designed for farmers without their inputs, thus creating tools that are not meeting demands. This study focused on a farmer-centered design, development, and deployment approach to improving farm productivity. The design thinking approach was used to identify the specific need of the farmers in selected areas, ideas were created using brainstorming sessions involving experts in the field, and prototypes were developed and deployed to evaluate the impact performance. The result shows that the proposed system improved the cost-benefit ratio of crop farming from 2.14 to 2.26. This is a 12% productivity increase.


2015 ◽  
Vol 15 (1) ◽  
pp. 22-33 ◽  
Author(s):  
Saravanan Dhanushkodi ◽  
Vincent H. Wilson ◽  
Kumarasamy Sudhakar

Abstract Cashew nut farming in India is mostly carried out in small and marginal holdings. Energy consumption in the small scale cashew nut processing industry is very high and is mainly due to the high energy consumption of the drying process. The drying operation provides a lot of scope for energy saving and substitutions of other renewable energy sources. Renewable energy-based drying systems with loading capacity of 40 kg were proposed for application in small scale cashew nut processing industries. The main objective of this work is to perform economic feasibility of substituting solar, biomass and hybrid dryer in place of conventional steam drying for cashew drying. Four economic indicators were used to assess the feasibility of three renewable based drying technologies. The payback time was 1.58 yr. for solar, 1.32 for biomass and 1.99 for the hybrid drying system, whereas as the cost-benefit estimates were 5.23 for solar, 4.15 for biomass and 3.32 for the hybrid system. It was found that it is of paramount importance to develop solar biomass hybrid dryer for small scale processing industries.


2019 ◽  
Vol 2019 ◽  
pp. 1-5
Author(s):  
Setu Bazie ◽  
Yohannes Ebabuye ◽  
Sang Woo Kim ◽  
Youn Su Lee

A field experiment was conducted to determine the integrated effect of planting dates, insecticides, and their interaction on the reduction of yield and yield related components of haricot bean caused by haricot bean foliage beetle damage at Sirinka Agriculture Research Center, Ethiopia. Planting dates were normal planting (NP) and late planting (10 days after normal planting) (LP), while insecticides comprised Apron star seed dressing (A) and without insecticide (WI). The combined analysis revealed that late planting combined with Apron star seed dressing (LPA) resulted in the highest yield (1223.7 Kg/ha). On the other hand, normal planting date without insecticide application (NPWI) gave the lowest yield (209.6 kg/ha) and the maximum yield loss (209.6%). The cost-benefit analysis showed that use of LPA gave by far better high net profit over control. Thus, LPA are recommended for haricot bean foliage beetle management in northeastern Ethiopia.


2016 ◽  
Vol 8 (2) ◽  
pp. 19 ◽  
Author(s):  
Saidatou Dicko

<p>This study investigates the impact of political connections on the awarding of government contracts to Canadian companies.<strong> </strong>Two-stage least squares (2SLS) analyses were performed on a sample of S&amp;P/TSX companies from 2010 to 2014 inclusively.<strong> </strong>The results show that political connections are positively and significantly associated with the winning of government contracts. Politically connected firms obtain more government contracts and higher contract values than non-connected firms. Political connections thus appear to be directly associated with securing government contracts in the Canadian context. Firms can view political connections as a non-market, long-term strategy to help them gain competitive advantages and improve their performance. Accordingly, they tend to appoint directors and managers taking these connections and the advantages that can be gained into account. However, they must seriously consider the cost-benefit ratio of this strategy. For example, the costs incurred could be ethical in nature and firms could find themselves in a position of conflict of interest that could lead to extensive negative media exposure.<strong> </strong>These results alert regulatory and governmental organizations to the need for them to remain vigilant and to strengthen corporate governance regulations to prevent the excesses and abuses that could arise from firms’ political actions.<strong> </strong>Our study is the first to demonstrate a direct relationship between corporate political connections and government contracts in the Canadian context. The results confirm the growing interdependence between politics and business, particularly the increase in the number of corporate actions intended to influence government decisions.</p>


Sign in / Sign up

Export Citation Format

Share Document