scholarly journals Pengaruh Intensitas Matahari Terhadap Karakteristik Sel Surya Jenis Polycristaline Menggunakan Regresi Linear

Kilat ◽  
2021 ◽  
Vol 10 (1) ◽  
pp. 69-76
Author(s):  
Andi Makkulau ◽  
Samsurizal Samsurizal ◽  
Miftahul Fikri ◽  
Christiono Christiono
Keyword(s):  
Renewable Energy ◽  
Solar Cells ◽  
Renewable Energy Sources ◽  
Electrical Energy ◽  
Energy Sources ◽  
Solar Panels ◽  
Mean Absolute Percent Error ◽  
The Relationship ◽  
Power Instability ◽  
Absolute Percent Error

Renewable energy sources have both renewable and sustainable properties and the utilization of renewable energy sources is a continuously developed alternative. One of the technologies that can utilize renewable energy is polycrystalline solar cells. Solar cells are technology that converts sunlight energy into electrical energy. This technology is very potentially applied in Indonesia that has a tropical climate, but the main problem of this system is the power instability generated. The power produced relies heavily on the intensity of the sun received by the solar panels. The intensity of the solar radiation received by the solar panels can be maximised by installing solar panels, with a precise tilt angle. In research acquired the relationship between irradiation and current correlates of R = 0.7251. From the correlation value above indicates that there is a strong link and is directly proportional between irradiation and the current obtained. The acquired Model needs to be seen its accuracy, in which case it will be used Mean Absolute Percent Error So it is obtained by 26.5%. This indicates that the model is good enough.

scholarly journals Empirical Research on the Relationship amongst Renewable Energy Consumption, Economic Growth and Foreign Direct Investment in Kazakhstan and Uzbekistan

Energies ◽  
2021 ◽  
Vol 14 (2) ◽  
pp. 332
Author(s):  
Janusz Grabara ◽  
Arsen Tleppayev ◽  
Malika Dabylova ◽  
Leonardus W. W. Mihardjo ◽  
Zdzisława Dacko-Pikiewicz
Keyword(s):  
Economic Growth ◽  
Foreign Direct Investment ◽  
Renewable Energy ◽  
Energy Consumption ◽  
Direct Investment ◽  
Renewable Energy Sources ◽  
Energy Sources ◽  
Renewable Energy Consumption ◽  
Integration Test ◽  
The Relationship

In this contemporary era, environmental problems spread at different levels in all countries of the world. Economic growth does not just depend on prioritizing the environment or improving the environmental situation. If the foreign direct investment is directed to the polluting industries, they will increase pollution and damage the environment. The purpose of the study is to consider the relationship between foreign direct investment in Kazakhstan and Uzbekistan and economic growth and renewable energy consumption. The study is based on data obtained from 1992 to 2018. The results show that there is a two-way link between foreign direct investment and renewable energy consumption in the considered two countries. The Granger causality test approach is applied to explore the causal relationship between the variables. The Johansen co-integration test approach is also employed to test for a relationship. The empirical results verify the existence of co-integration between the series. The main factors influencing renewable energy are economic growth and electricity consumption. To reduce dependence on fuel-based energy sources, Kazakhstan and Uzbekistan need to attract energy to renewable energy sources and implement energy efficiency based on rapid progress. This is because renewable energy sources play the role of an engine that stimulates the production process in the economy for all countries.

Design of Solar System for LTE Networks

2020 ◽  
Vol 11 (2) ◽  
pp. 1-15
Author(s):  
Naglaa Kamel Bahgaat ◽  
Nariman Abdel Salam ◽  
Monika Mady Roshdy ◽  
Sandy Abd Elrasheed Sakr
Keyword(s):  
Mobile Networks ◽  
Renewable Energy Sources ◽  
Mobile Station ◽  
Electrical Energy ◽  
Environmental Problems ◽  
Base Stations ◽  
Energy Sources ◽  
Solar Panels ◽  
Lte Networks ◽  
Photovoltaic Panel

Rapid growth in mobile networks and the increase of the number of cellular base stations requires more energy sources, but the traditional sources of energy cause pollution and environmental problems. Therefore, modern facilities tend to use renewable energy sources instead of traditional sources. One renewable source is the photovoltaic panel, which made from semiconductor materials which absorb sunlight to generate electricity. This article discusses the importance of using solar panels to produce energy for mobile stations and also a solution to some environmental problems such as pollution. This article provides a design for a solar-power plant to feed the mobile station. Also, in this article is a prediction of all loads, the power consumed, the number of solar panels used, and solar batteries can be used to store electrical energy. Finally, an estimation of the costs of all components will be presented. Good discussion and conclusion will be presented about the results obtained. The results obtained are promising. In addition, a future plan is described to complete this important study.

Power Cycles of Generation III and III+ Nuclear Power Plants

2014 ◽  
Author(s):  
Alexey Dragunov ◽  
Eugene Saltanov ◽  
Igor Pioro ◽  
Pavel Kirillov ◽  
Romney Duffey
Keyword(s):  
Renewable Energy ◽  
Natural Gas ◽  
Thermal Efficiency ◽  
Nuclear Power ◽  
Power Plants ◽  
Renewable Energy Sources ◽  
Thermal Power ◽  
Electrical Energy ◽  
Energy Sources ◽  
Thermal Power Plants

It is well known that the electrical-power generation is the key factor for advances in any other industries, agriculture and level of living. In general, electrical energy can be generated by: 1) non-renewable-energy sources such as coal, natural gas, oil, and nuclear; and 2) renewable-energy sources such as hydro, wind, solar, biomass, geothermal and marine. However, the main sources for electrical-energy generation are: 1) thermal - primary coal and secondary natural gas; 2) “large” hydro and 3) nuclear. The rest of the energy sources might have visible impact just in some countries. Modern advanced thermal power plants have reached very high thermal efficiencies (55–62%). In spite of that they are still the largest emitters of carbon dioxide into atmosphere. Due to that, reliable non-fossil-fuel energy generation, such as nuclear power, becomes more and more attractive. However, current Nuclear Power Plants (NPPs) are way behind by thermal efficiency (30–42%) compared to that of advanced thermal power plants. Therefore, it is important to consider various ways to enhance thermal efficiency of NPPs. The paper presents comparison of thermodynamic cycles and layouts of modern NPPs and discusses ways to improve their thermal efficiencies.

DEVELOPMENT OF CONSTRUCTION OF THREE-INPUT GENERATING INSTALLATIONS ON BASED OF RENEWABLE ENERGY SOURCES

2018 ◽  
Author(s):  
Я.М. КАШИН ◽  
Л.Е. КОПЕЛЕВИЧ ◽  
А.В. САМОРОДОВ ◽  
Ч. ПЭН
Keyword(s):  
Renewable Energy ◽  
Kinetic Energy ◽  
Total Energy ◽  
Thermal Energy ◽  
Output Voltage ◽  
Renewable Energy Sources ◽  
Electrical Energy ◽  
Energy Sources ◽  
Voltage Regulator ◽  
The Sun

Описаны конструктивные особенности трехвходовой аксиальной генераторной установки (ТАГУ), преобразующей кинетическую энергию ветра и световую энергию солнца и суммирующей механическую, световую и тепловую энергию с одновременным преобразованием полученной суммарной энергии в электрическую. Показаны преимущества ТАГУ перед двухвходовыми генераторными установками. Дополнительное включение стабилизатора напряжения в схему ТАГУ позволило расширить область применения стабилизированной трехвходовой аксиальной генераторной установки за счет стабилизации ее выходного напряжения. The design features of the three-input axial generating installation (TAGI), which converts the kinetic energy of wind and light energy of the sun and sums the mechanical, light and thermal energy with the simultaneous conversion of the total energy into electrical energy, are described. The benefits of TAGI in front of the two-input generating installation shown. The additional introduction of a voltage regulator into the TAGI scheme allowed to expand the scope of the stabilized three-input axial generating installation by stabilizing its output voltage.

scholarly journals The Global Survey of the Electrical Energy Distribution System: A Review

2019 ◽  
Vol 9 (4) ◽  
pp. 2247 ◽  
Author(s):  
Archana Sudhakar Talhar ◽  
Sanjay B. Bodkhe
Keyword(s):  
Renewable Energy ◽  
Renewable Energy Sources ◽  
Electrical Power ◽  
Electrical Energy ◽  
Clean Energy ◽  
Central Intelligence Agency ◽  
Energy Sources ◽  
Power Sources ◽  
Energy Scenario ◽  
The World

This paper gives a review of energy scenario in India and other countries. Today’s demand of the world is to minimize greenhouse gas emissions, during the production of electricity. Henceforth over the world, the production of electrical power is changing by introducing abundantly available renewable energy sources like sun and wind. But, because of the intermittent nature of sustainable power sources, the electrical power network faces many problems, during the transmission and distribution of electricity. For resolving these issues, Electrical Energy Storage (EES) is acknowledged as supporting technology. This paper discusses about the world electrical energy scenario with top renowned developed countries in power generation and consumption. Contribution of traditional power sources changed after the introduction of renewable energy sources like sun and wind. Worldwide Agencies are formed like International Energy Agency (IEA), The Central Intelligence Agency, (CIS) etc. The main aim of these agencies is to provide reliable, affordable and clean energy. This paper will discuss about the regulatory authority and government policies/incentives taken by different countries.  At the end of this paper, author focuses on obstacles in implementation, development and benefits of renewable energy.

Power Electronics and Controls in Solar Photovoltaic Systems

2013 ◽  
pp. 68-125
Author(s):  
Radian Belu
Keyword(s):  
Renewable Energy ◽  
Power Electronics ◽  
Renewable Energy Sources ◽  
Energy Systems ◽  
Solar Thermal ◽  
System Capacity ◽  
Energy Sources ◽  
Solar Panels ◽  
Renewable Energy Systems ◽  
Pv Systems

The use of renewable energy sources is increasingly being pursued as a supplemental and an alternative to traditional energy generation. Several distributed energy systems are expected to a have a significant impact on the energy industry in the near future. As such, the renewable energy systems are presently undergoing a rapid change in technology and use. Such a feature is enabled clearly by power electronics. Both the solar-thermal and photovoltaic (PV) technologies have an almost exponential growth in installed capacity and applications. Both of them contribute to the overall grid control and power electronics research and advancement. Among the renewable energy systems, photovoltaic (PV) systems are the ones that make use of an extended scale of the advanced power electronics technologies. The specification of a power electronics interface is subject to the requirements related not only to the renewable energy source itself but also to its effects on the operations of the systems on which it is connected, especially the ones where these intermittent energy sources constitute a significant part of the total system capacity. Power electronics can also play a significant role in enhancing the performance and efficiency of PV systems. Furthermore, the use of appropriate power electronics enables solar generated electricity to be integrated into power grid. Aside from improving the quality of solar panels themselves, power electronics can provide another means of improving energy efficiency in PV and solar-thermal energy systems.

Seamless Control and Unified Dynamic Energy Management in a Renewable/Clean Energy Integrated Self-Reliant DC Microgrid

2021 ◽  
pp. 1083-1122
Author(s):  
Vulisi Narendra Kumar ◽  
Gayadhar Panda ◽  
Bonu Ramesh Naidu
Keyword(s):  
Renewable Energy ◽  
Renewable Energy Sources ◽  
Electrical Energy ◽  
Clean Energy ◽  
High Gain ◽  
Energy Sources ◽  
Dc Microgrid ◽  
Dc Power ◽  
Terminal Voltage ◽  
Operating Constraints

The growing demand for electrical energy calls for the assimilation of renewable energy sources to the main utility grid. Multiple renewable energy sources (RESs) like solar PV array, wind turbine, micro-hydro plant, etc. can be combined and controlled to form a microgrid. In spite of the availability of different microgrid topologies, DC microgrid largely facilitates the injection of DC power from various renewable energy sources into the stabilised DC power pool. The requirement for a minimal number of conversion stages, simple structure, economic operation, and numerous localised applications are driving factors for the DC microgrid technology. The mettle of the DC microgrid technology lies in choosing the appropriate microgrid participants for energy interchange and the suitable supervisory control to tap power from the microgrid partakers even after respecting their operating constraints. The use of high gain DC-DC converters is inevitable in DC microgrid due to the low terminal voltage levels of different RESs.

Design of Solar System for LTE Networks

2021 ◽  
pp. 416-432
Author(s):  
Naglaa Kamel Bahgaat ◽  
Nariman Abdel Salam ◽  
Monika Mady Roshdy ◽  
Sandy Abd Elrasheed Sakr
Keyword(s):  
Mobile Networks ◽  
Renewable Energy Sources ◽  
Mobile Station ◽  
Electrical Energy ◽  
Environmental Problems ◽  
Base Stations ◽  
Energy Sources ◽  
Solar Panels ◽  
Lte Networks ◽  
Photovoltaic Panel

Rapid growth in mobile networks and the increase of the number of cellular base stations requires more energy sources, but the traditional sources of energy cause pollution and environmental problems. Therefore, modern facilities tend to use renewable energy sources instead of traditional sources. One renewable source is the photovoltaic panel, which made from semiconductor materials which absorb sunlight to generate electricity. This article discusses the importance of using solar panels to produce energy for mobile stations and also a solution to some environmental problems such as pollution. This article provides a design for a solar-power plant to feed the mobile station. Also, in this article is a prediction of all loads, the power consumed, the number of solar panels used, and solar batteries can be used to store electrical energy. Finally, an estimation of the costs of all components will be presented. Good discussion and conclusion will be presented about the results obtained. The results obtained are promising. In addition, a future plan is described to complete this important study.

Sign in / Sign up

Export Citation Format

Share Document