scholarly journals MODIFIED QUADRATIC BUCK BOOST CONVERTER FOR PV APPLICATIONS

2021 ◽  
Vol 6 (1) ◽  
Author(s):  
Aparna Mohan S ◽  
Prof. Anjana K R
Keyword(s):  
Fuzzy Logic ◽  
Fuzzy Logic Controller ◽  
Boost Converter ◽  
Conversion Ratio ◽  
Output Port ◽  
Output Current ◽  
Input And Output ◽  
Single Input ◽  
Voltage Conversion ◽  
Current Ripples

Buck-boost DC/DC converters have been extensively employed in stepping up/down the voltage for PV applications. The input and the output port current of the traditional quadratic buck-boost converter are discontinuous, which result in increased input and output current ripples and complicate the design of the input and output filters. Hence these problems can be solved by using a modified quadratic buck boost converter, which provides wider voltage conversion ratio with continuous input and output ports current. Dual output can be derived from this single input converter for multiple output applications. Also a fuzzy logic controller can be designed for this proposed converter for better and faster performance.

scholarly journals Design of Smart Fuzzy Logic Controller in Quad Buck-Boost DC-DC Converter with Constant Input and Output Current

2020 ◽  
Vol 9 (5) ◽  
pp. 957-963
Keyword(s):  
Fuzzy Logic ◽  
Fuzzy Logic Controller ◽  
Boost Converter ◽  
Output Current ◽  
Constant Input ◽  
Intelligent Controller ◽  
Simulink Simulation ◽  
Input And Output ◽  
Step Down ◽  
Voltage Conversion

In this paper, the design of a fuzzy logic controller based quad buck-boost converter with constant input and output current is presented. In contrast with the ordinary step-down-up converters the advanced converter with same duty cycle, a large limit of voltage conversion ratio could be acquired. A proposed converter is designed and studied with an intelligent controller i.e. fuzzy logic controller/FLC and differentiated with the ordinary Proportional-Integral /PIC controller. Finally, the analysis of the presented converter by employing MATLAB/Simulink, simulation results of the presented converter is recorded to substantiate the effectualness and rationality of the output voltage control of Quad buck-boost converter in both step-down-up mode and its comparative analysis is presented where the fuzzy logic has a minimum overshoot and settling time compared to regular PI controller.

Improvement of output current waveforms using SVM technique and fuzzy logic controller for matrix converter

2015 ◽  
Vol 34 (6) ◽  
pp. 1896-1916
Author(s):  
Aziz Boukadoum ◽  
Tahar Bahi ◽  
Youcef Soufi ◽  
Abla Bouguerne ◽  
Sofiane Oudina
Keyword(s):  
Fuzzy Logic ◽  
Fuzzy Logic Controller ◽  
Harmonic Distortion ◽  
Input Voltage ◽  
Matrix Converter ◽  
Point Of View ◽  
Power Electronic ◽  
Output Current ◽  
Content Type ◽  
Input And Output

Purpose – The use of power electronic equipment such as conventional AC-DC-AC converters cause several problems in electrical networks and its components. They generate harmonic currents and disturb the electrical power sources; so, it is necessary to research alternative topologies of power electronic converters based on advanced intelligent controllers, which reduce or even eliminate harmonics to achieve energy-saving and environmental protection. The use of matrix converter (MC) is, considered as an attractive solution to maintain pure sinusoidal input and output current waveforms. The paper aims to discuss this issue. Design/methodology/approach – The studied system is composed of a three phase matrix converter (TMC) feeding a linear R, L load and a trees phase rectifier considered as a non-linear load; the proposed control strategy is based on a fuzzy logic controller (FLC) associated to the (space vector modulation) SVM modulation technique, this choice is motivated by the advantages that represent the combination of FLC and SVM in term of power quality enhancement in both input and output sides of MC. Findings – The model is validated based on simulation results that illustrate the effectiveness of the proposed system in term of power quality amelioration. The high performance of the proposed FLC is illustrated in all study cases especially in the case of perturbed input voltage, it is not only able to keep the whole system stable, but also it reduces harmonic distortion THD to respect international standards recommendation. Originality/value – In this paper, an associated linear (RL), non-linear loads and TMC is studied. From the mathematical point of view, the MC is modeled and analyzed. From the technique point of view, the MC allows sinusoidal current absorbance from the network with good qualities in term of harmonic distortion compensation, and high reliability under various loads and disturbed input voltage.

scholarly journals Evaluasi Performa Fuzzy Logic Controller untuk mengatur kecepatan Motor DC Penguatan Terpisah

2020 ◽  
Vol 12 (2) ◽  
pp. 100-110
Author(s):  
Muhammad Aditya Ardiansyah ◽  
Renny Rakhmawati ◽  
Hendik Eko Hadi Suharyanto ◽  
Era Purwanto
Keyword(s):  
Fuzzy Logic ◽  
Steady State ◽  
Duty Cycle ◽  
Fuzzy Logic Controller ◽  
Dc Motor ◽  
Boost Converter ◽  
Voltage Source ◽  
Single Output ◽  
Multiple Input ◽  
State Error

Beragamnya metode yang ditawarkan oleh fuzzy logic kontroller membuat sebagaian orang meneliti mengenai perbedaan metode inferensi yang digunakan oleh fuzzy logic controller. Sejauh ini terdapat tiga metode fuzzy logic kontroller yang telah dikembangkan yaitu Mamdani, Sugono dan Sukamoto. Pada jurnal ini penggunaan fuzzy logic kontroller akan dievaluasi dengan menggunakan motor dc penguat terpisah sebagai beban untuk melakukan pengaturan kecepatan motor dc. Pada paper ini tujuan utamanya adalah dapat mengendalikan kecepatan dari motor DC Penguatan Terpisah dengan mengatur tegangan jangkar dari motor tersebut. DC motor merupakan salah satu jenis motor memiliki banyak aplikasi dan memiliki kemudahan untuk mengatur kecepatan pada motor tersebut. Logika fuzzy yang digunakan pada studi ini adalah inferensi sugeno dimana dengan konfigurasi Multiple Input Single Output (MiSo). Dimana input berupa error dan perubahan error dan output berupa duty cycle dikarenakan yang dikendalikan oleh logika fuzzy adalah Boost Converter selaku controlled voltage source. Target pada jurnal ini adalah dari kecilnya nilai steady – state error dan minimnya osilasi sehingga mampu membuat sistem lebih stabil. Pada studi ini, Hasil pengujian dilakukan dengan menggunakan Simulink by Matlab dengan Hasil pengujian berupa error rata rata sebesar 5.36%.

Modelling and Simulation of Boost Converter with Maximum Power Point Tracking (MPPT) for Photovoltaic Application

2014 ◽  
Vol 71 (5) ◽  
Author(s):  
Ahmad Shaharuddin Mat Su, ◽  
Rasli Abd Ghani ◽  
Slamet Slamet
Keyword(s):  
Fuzzy Logic ◽  
Fuzzy Logic Controller ◽  
Maximum Power Point Tracking ◽  
Boost Converter ◽  
Maximum Power ◽  
Maximum Power Point ◽  
Point Tracking ◽  
Power Point Tracking ◽  
Proposed Model ◽  
Power Point

This paper presents the proposed model and simulation of a DC to DC converter with maximum power point tracking (MPPT) using fuzzy logic controller (FLC) for a standalone Photovoltaic (PV) System. This research will focus on the developing high performance DC to DC converter with fuzzy logic controller based to extract the maximum power that generated by the PV panel. The system composed of the PV array and DC-DC boost converter with MPPT system. The maximum power point tracking control is based on adaptive fuzzy logic to control ON/OFF time of IGBT switch of DC-DC boost converter. The proposed DC to DC converter is designed by using the Multisim software while the controller programme will be carried out by using the Matlab Simulink software. Pulse width modulation will be generated by the controller to trigger the IGBT gate. The performance of the proposed model is evaluated by the simulation and the result show that our proposed converter can convert more power from generated voltage. By using the fuzzy logic method to track the maximum power of the PV array, it is faster and the voltage is stable.

scholarly journals MATHEMATICAL ALGORITHM OF FUZZY LOGIC CONTROLLER FOR MULTILEVEL INVERTER CREATING VERTICAL DIVIDED VOLTAGE

2019 ◽  
Vol 59 (1) ◽  
pp. 1-11 ◽  
Author(s):  
Erol Can
Keyword(s):  
Mathematical Model ◽  
Fuzzy Logic ◽  
Fuzzy Logic Control ◽  
Pid Controller ◽  
Output Voltage ◽  
Fuzzy Logic Controller ◽  
Boost Converter ◽  
Multilevel Inverter ◽  
Logic Control ◽  
Multi Level

A 9-level inverter with a boost converter has been controlled with a fuzzy logic controller and a PID controller for regulating output voltage applications on resistive (R) and inductive (L), capacitance (C). The mathematical model of this system is created according to the fuzzy logic controlling new high multilevel inverter with a boost converter. The DC-DC boost converter and the multi-level inverter are designed and explained, when creating a mathematical model after a linear pulse width modulation (LPWM), it is preferred to operate the boost multi-level inverter. The fuzzy logic control and the PID control are used to manage the LPWM that allows the switches to operate. The fuzzy logic algorithm is presented by giving necessary mathematical equations that have second-degree differential equations for the fuzzy logic controller. After that, the fuzzy logic controller is set up in the 9-level inverter. The proposed model runs on different membership positions of the triangles at the fuzzy logic controller after testing the PID controller. After the output voltage of the converter, the output voltage of the inverter and the output current of the inverter are observed at the MATLAB SIMULINK, the obtained results are analysed and compared. The results show the demanded performance of the inverter and approve the contribution of the fuzzy logic control on multi-level inverter circuits.

Optimum Solar Panel Implementation Using DC-DC Boost Converter Controlled by Fuzzy Logic Controller

2015 ◽  
Vol 793 ◽  
pp. 378-382 ◽  
Author(s):  
Nurul Afiqah Zainal ◽  
Sasikala A.P. Ganaisan ◽  
Ajisman
Keyword(s):  
Fuzzy Logic ◽  
Fuzzy Logic Controller ◽  
Voltage Divider ◽  
Boost Converter ◽  
Solar Panel ◽  
Maximum Power ◽  
Point Tracking ◽  
Power Point Tracking ◽  
Arduino Uno ◽  
Power Point

This paper proposes the implementation of a simple fuzzy logic controller (FLC) for a DC-DC boost converter based on a microcontroller to obtain maximum power from the solar system with the maximum power point tracking (MPPT) method. The system includes a solar panel, DC-DC boost converter, the fuzzy logic controller implemented on Arduino Uno for controlling on/off time of MOSFET of the boost converter, voltage divider and optocoupler circuit. This paper presents a fuzzy logic real time code in the Arduino language for ATmega328 microcontroller on the Arduino UNO board. The designed system increases the efficiency of the solar panel based on experimental results.

Sign in / Sign up

Export Citation Format

Share Document