scholarly journals Chemical Composition and Light Absorption of PM2.5 Observed at Two Sites near a Busy Road during Summer and Winter

2020 ◽  
Vol 10 (14) ◽  
pp. 4858
Author(s):  
Seungshik Park ◽  
Hue Dinh Thi Hong ◽  
Sung Yong Cho ◽  
Min-Suk Bae

To examine the difference in the major chemical composition of fine particulate matter (PM2.5) between two roadway sites, 24 h integrated PM2.5 samples were simultaneously collected both 15 m (Buk-Ku District Office (BKO) site) and 150 m (Chonnam National University campus (CNU) site) away from busy roads during the summer and winter periods; these samples were taken to determine the concentrations of organic and elemental carbon (OC and EC), water-soluble organic carbon (WSOC), and water-soluble inorganic species. In addition, the real-time aerosol light absorption coefficients (Abs) were measured using a dual-spot seven-wavelength aethalometer at the CNU site to evaluate the influence of traffic and biomass burning (BB) emissions on the concentrations of organic aerosol particles. The hourly NO2 concentration was also observed at an air pollution monitoring network that is about 2 km away from the CNU site. During summer, 24 h PM2.5 concentrations (PM2.5 episode) which exceeded the Korean PM2.5 standard (35 μg/m3) were linked to increases in organic matter (OM) and SO42− concentrations that accounted for on average 35–41% and 26–30%, respectively, of the PM2.5 at the two sites. The increased SO42− concentration was most likely attributable to the inflow of long-range transported aerosols, rather than local production, as demonstrated by both the MODIS (Moderate Resolution Imaging Spectroradiometer) images and transport pathways of air masses reaching the sites. On the other hand, the OM, WSOC, and EC concentrations were directly attributable to traffic emissions at the sampling sites, as supported by the tight correlation between the OC and EC. A small difference between the absorption Ångström exponent (AAE) values calculated at wavelengths of 370–950 nm (AAE370–950nm) and 370–520 nm (AAE370–520nm), and the poor correlation of absorption coefficient by brown carbon (BrC) at 370 nm (AbsBrC370nm) with K+ (R2 = 0.00) also suggest a significant contribution of traffic emissions to OM. However, the wintertime PM2.5 episode was strongly related to the enhanced OM and NO3− concentrations, which contributed 26–28% and 22–23% of the PM2.5 concentration, respectively. It is interesting to note that there were two distinct OC/EC ratios in winter: a lower OC/EC (~3.0), which indicates a significant contribution of traffic emissions to the OC and EC, and a higher OC/EC (~6.5), which suggests an additional influence of BB emissions as well as traffic emissions at the sites. Strong correlations between the OC and EC (R2 = 0.72–0.83) and the enhanced AAE370–520nm values compared to the AAE370–950nm support that BB emissions were also an important contributor to the wintertime OM concentrations as well as traffic emissions at the two sites. A good correlation between the gaseous NO2 and NO3− and meteorological conditions (e.g., low wind speed and high relative humidity) suggest that the heterogeneous oxidation of NO2 on moist particles could be an important contributor to wintertime particulate NO3− formation at the sites. The OC concentrations during summer and winter were higher at the BKO site, with a higher traffic flow and a shorter distance from the roadway than at the CNU site. However, there were slight differences in the concentrations of secondary inorganic species (NO3−, SO42−, and NH4+) between the sites during summer and winter.

2010 ◽  
Vol 10 (23) ◽  
pp. 11791-11803 ◽  
Author(s):  
K. Ram ◽  
M. M. Sarin ◽  
P. Hegde

Abstract. A long-term study, conducted from February 2005 to July 2008, involving chemical composition and optical properties of ambient aerosols from a high-altitude site (Manora Peak: 29.4° N, 79.5° E, ~1950 m a.s.l.) in the central Himalaya is reported here. The total suspended particulate (TSP) mass concentration varied from 13 to 272 μg m−3 over a span of 42 months. Aerosol optical depth (AOD) and TSP increase significantly during the summer (April–June) due to increase in the concentration of mineral dust associated with the long-range transport from desert regions (from the middle-East and Thar Desert in western India). The seasonal variability in the carbonaceous species (EC, OC) is also significantly pronounced, with lower concentrations during the summer and monsoon (July–August) and relatively high during the post-monsoon (September–November) and winter (December–March). On average, total carbonaceous aerosols (TCA) and water-soluble inorganic species (WSIS) contribute nearly 25 and 10% of the TSP mass, respectively. The WSOC/OC ratios range from 0.36 to 0.83 (average: 0.55 ± 0.15), compared to lower ratios in the Indo-Gangetic Plain (range: 0.35–0.40), and provide evidence for the enhanced contribution from secondary organic aerosols. The mass fraction of absorbing EC ranged from less than a percent (during the summer) to as high as 7.6% (during the winter) and absorption coefficient (babs, at 678 nm) varied between 0.9 to 33.9 Mm−1 (1 Mm−1=10−6 m−1). A significant linear relationship between babs and EC (μgC m−3) yields a slope of 12.2 (± 2.3) m2 g−1, which is used as a measure of the mass absorption efficiency (σabs) of EC.


Atmosphere ◽  
2015 ◽  
Vol 6 (6) ◽  
pp. 732-750 ◽  
Author(s):  
Seung-Myung Park ◽  
Beom-Keun Seo ◽  
Gangwoong Lee ◽  
Sung-Hyun Kahng ◽  
Yu Jang

2021 ◽  
Vol 8 ◽  
Author(s):  
Ankush Kaushik ◽  
Ashwini Kumar ◽  
M. A Aswini ◽  
P. P. Panda ◽  
Garima Shukla ◽  
...  

Water-soluble species constitute a significant fraction (up to 60–70%) of the total aerosol loading in the marine atmospheric boundary layer (MABL). The “indirect” effects, that is, climate forcing due to modification of cloud properties depend on the water-soluble composition of aerosols. Thus, the characterization of aerosols over the MABL is of greater relevance. Here, we present 1-year long aerosol chemical composition data of PM10 and PM2.5 at a costal location in the northeastern Arabian Sea (Goa; 15.45°N, 73.20°E, 56 m above the sea level). Average water-soluble ionic concentration (sum of anion and cation) is highest (25.5 ± 6.9 and 19.6 ± 5.8 μg·m−3 for PM10 and PM2.5, respectively) during winter season and lowest during post-monsoon (17.3 ± 9.1 and 14.4 ± 8.1 μg·m−3 for PM10 and PM2.5, respectively). Among water-soluble ionic spices, SO42- ion was found to be dominant species in anions and NH4+ is dominant in cations, for both PM10 and PM2.5 during all the seasons. These observations clearly hint to the contribution from anthropogenic emission and significant secondary inorganic species formation. Sea-salt (calculated based on Na+ and Cl−) concentration shows significant temporal variability with highest contribution during summer seasons in both fractions. Sea-salt corrected Ca2+, an indicator of mineral dust is found mostly during summer months, particularly in PM10 samples, indicates contribution from mineral dust emissions from arid/semiarid regions located in the north/northwestern India and southwest Asia. These observations are corroborated with back-trajectory analyses, wherein air parcels were found to derive from the desert area in summer and Indo-Gangetic Plains (a hot spot for anthropogenic emissions) during winter. In addition, we also observe the presence of nss-K+ (sea-salt corrected), for PM2.5, particularly during winter months, indicating influence of biomass burning emissions. The impact on aerosol chemistry is further assessed based on chloride depletion. Chloride depletion is observed very significant during post-monsoon months (October and November), wherein more than 80 up to 100% depletion is found, mediated by excess sulfates highlighting the role of secondary species in atmospheric chemistry. Regional scale characterization of atmospheric aerosols is important for their better parameterization in chemical transport model and estimation of radiative forcing.


2020 ◽  
Vol 10 (1) ◽  
Author(s):  
Rasa Zalakeviciute ◽  
Katiuska Alexandrino ◽  
Yves Rybarczyk ◽  
Alexis Debut ◽  
Karla Vizuete ◽  
...  

Abstract Particulate matter (PM) is one of the key pollutants causing health risks worldwide. While the preoccupation for increased concentrations of these particles mainly depends on their sources and thus chemical composition, some regions are yet not well investigated. In this work the composition of chemical elements of atmospheric PM10 (particles with aerodynamic diameters ≤ 10 µm), collected at the urban and suburban sites in high elevation tropical city, were chemically analysed during the dry and wet seasons of 2017–2018. A large fraction (~ 68%) of PM10 composition in Quito, Ecuador is accounted for by water-soluble ions and 16 elements analysed using UV/VIS spectrophotometer and Inductively Coupled Plasma—Optical Emission Spectroscopy (ICP-OES). Hierarchical clustering analysis was performed to study a correlation between the chemical composition of urban pollution and meteorological parameters. The suburban area displays an increase in PM10 concentrations and natural elemental markers during the dry (increased wind intensity, resuspension of soil dust) season. Meanwhile, densely urbanized area shows increased total PM10 concentrations and anthropogenic elemental markers during the wet season, which may point to the worsened combustion and traffic conditions. This might indicate the prevalence of cardiovascular and respiratory problems in motorized areas of the cities in the developing world.


LWT ◽  
2007 ◽  
Vol 40 (2) ◽  
pp. 239-248 ◽  
Author(s):  
Keyvan Dastmalchi ◽  
H.J. Damien Dorman ◽  
Müberra Koşar ◽  
Raimo Hiltunen

2012 ◽  
Vol 12 (21) ◽  
pp. 10239-10255 ◽  
Author(s):  
L. T. Padró ◽  
R. H. Moore ◽  
X. Zhang ◽  
N. Rastogi ◽  
R. J. Weber ◽  
...  

Abstract. Aerosol composition and mixing state near anthropogenic sources can be highly variable and can challenge predictions of cloud condensation nuclei (CCN). The impacts of chemical composition on CCN activation kinetics is also an important, but largely unknown, aspect of cloud droplet formation. Towards this, we present in-situ size-resolved CCN measurements carried out during the 2008 summertime August Mini Intensive Gas and Aerosol Study (AMIGAS) campaign in Atlanta, GA. Aerosol chemical composition was measured by two particle-into-liquid samplers measuring water-soluble inorganic ions and total water-soluble organic carbon. Size-resolved CCN data were collected using the Scanning Mobility CCN Analysis (SMCA) method and were used to obtain characteristic aerosol hygroscopicity distributions, whose breadth reflects the aerosol compositional variability and mixing state. Knowledge of aerosol mixing state is important for accurate predictions of CCN concentrations and that the influence of an externally-mixed, CCN-active aerosol fraction varies with size from 31% for particle diameters less than 40 nm to 93% for accumulation mode aerosol during the day. Assuming size-dependent aerosol mixing state and size-invariant chemical composition decreases the average CCN concentration overprediction (for all but one mixing state and chemical composition scenario considered) from over 190–240% to less than 20%. CCN activity is parameterized using a single hygroscopicity parameter, κ, which averages to 0.16 ± 0.07 for 80 nm particles and exhibits considerable variability (from 0.03 to 0.48) throughout the study period. Particles in the 60–100 nm range exhibited similar hygroscopicity, with a κ range for 60 nm between 0.06–0.076 (mean of 0.18 ± 0.09). Smaller particles (40 nm) had on average greater κ, with a range of 0.20–0.92 (mean of 0.3 ± 0.12). Analysis of the droplet activation kinetics of the aerosol sampled suggests that most of the CCN activate as rapidly as calibration aerosol, suggesting that aerosol composition exhibits a minor (if any) impact on CCN activation kinetics.


2021 ◽  
Vol 316 ◽  
pp. 521-526
Author(s):  
Vladimir A. Nosenko ◽  
Alexander V. Fetisov ◽  
Semen P. Kuznetsov

The article summarizes the results of the of the titanium alloy surface morphology and chemical composition study after grinding with a wheel of cubic boron nitride on a ceramic bond. The titanium alloy was treated using the method of cut-in grinding in the finishing mode using a synthetic water-soluble lubricant-cooling liquid that does not contain mineral oil. The research was carried out using the FEI Versa 3D LoVac electron microscope. Digital photos of the titanium alloy surface at different magnifications are given. Individual objects’ morphology allows us to identify them as wear products of abrasive tools. The chemical composition of the selected objects was studied by local x-ray spectral analysis. CBN crystals are partially or completely pressed into the treated surface and covered with a layer of the treated material. On the surface of CBN crystals, there are chemical elements that are part of the abrasive tool bond.


Sign in / Sign up

Export Citation Format

Share Document