scholarly journals Floating Active Inductor Based Trans-Impedance Amplifier in 0.18 μm CMOS Technology for Optical Applications

Electronics ◽  
2019 ◽  
Vol 8 (12) ◽  
pp. 1547
Author(s):  
Xiangyu Chen ◽  
Yasuhiro Takahashi
Keyword(s):  
Power Dissipation ◽  
Supply Voltage ◽  
Cmos Technology ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Chip Area ◽  
Active Inductors ◽  
Low Pass ◽  
Optical Applications ◽  
Fifth Order

In this paper, a transimpedance amplifier (TIA) based on floating active inductors (FAI) is presented. Compared with conventional TIAs, the proposed TIA has the advantages of a wider bandwidth, lower power dissipation, and smaller chip area. The schematics and characteristics of the FAI circuit are explained. Moreover, the proposed TIA employs the combination of capacitive degeneration, the broadband matching network, and the regulated cascode input stage to enhance the bandwidth and gain. This turns the TIA design into a fifth-order low pass filter with Butterworth response. The TIA is implemented using 0.18 μ m Rohm CMOS technology and consumes only 10.7 mW with a supply voltage of 1.8 V. When used with a 150 fF photodiode capacitance, it exhibits the following characteristics: gain of 41 dB Ω and −3 dB frequency of 10 GHz. This TIA occupies an area of 180 μ m × 118 μ m.

scholarly journals A CMOS Programmable Fourth-Order Butterworth Active-RC Low-Pass Filter

Electronics ◽  
2020 ◽  
Vol 9 (2) ◽  
pp. 204 ◽  
Author(s):  
Changchun Zhang ◽  
Long Shang ◽  
Yongkai Wang ◽  
Lu Tang
Keyword(s):  
Radio Frequency Identification ◽  
Supply Voltage ◽  
Cutoff Frequency ◽  
Cmos Technology ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Silicon Area ◽  
Fully Differential ◽  
Low Pass ◽  
Low Sensitivity

This paper presents a low-pass filter (LPF) for an ultra-high frequency (UHF) radio frequency identification (RFID) reader transmitter in standard SMIC 0.18 μm CMOS technology. The active-RC topology and Butterworth approximation function are employed mainly for high linearity and high flatness respectively. Two cascaded fully-differential Tow-Thomas biquads are chosen for low sensitivity to process errors and strong resistance to the imperfection of the involved two-stage fully-differential operational amplifiers. Besides, the LPF is programmable in order to adapt to the multiple data rate standards. Measurement results show that the LPF has the programmable bandwidths of 605/870/1020/1330/1530/2150 kHz, the optimum input 1dB compression point of −7.81 dBm, and the attenuation of 50 dB at 10 times cutoff frequency, with the overall power consumption of 12.6 mW from a single supply voltage of 1.8 V. The silicon area of the LPF core is 0.17 mm2.

A Low Power Low-Pass Fourth-Order Filter for WiMAX/LTE Receiver in CMOS 45nm Technology

2016 ◽  
Vol 26 (03) ◽  
pp. 1750048 ◽  
Author(s):  
Vida Orduee Niar ◽  
Gholamreza Zare Fatin
Keyword(s):  
Low Power ◽  
Fourth Order ◽  
Supply Voltage ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Power Filter ◽  
Order Filter ◽  
Source Follower ◽  
Low Pass ◽  
Circuit Technique

In this paper, a [Formula: see text]-[Formula: see text] low-pass and low power filter with tunable in-band attenuation for WiMAX/LTE receiver is presented. The fourth-order filter consists of two cascaded biquad stages. The source-follower (SF) stage is used as a key building block in these biquads. In this paper, we have presented a circuit technique to reduce the nonlinearity of the SF stage resulting from unmatched signal swings at the gate and source terminals of the input transistor. The proposed SF stage, is used for design of a linear biquad which is then utilized in a fourth-order Butterworth low-pass filter. The simulation results of the filter for bandwidth of 10 MHz show that the IIP3 of the filter is equal to 8.22[Formula: see text]dBm, in-band noise density is 100[Formula: see text]nV/[Formula: see text]Hz and power consumption is 5.9[Formula: see text]mW. The supply voltage of the filter is equal to 1[Formula: see text]V.

scholarly journals Ladder-Based Synthesis and Design of Low-Frequency Buffer-Based CMOS Filters

Electronics ◽  
2021 ◽  
Vol 10 (23) ◽  
pp. 2931
Author(s):  
Waldemar Jendernalik ◽  
Jacek Jakusz ◽  
Grzegorz Blakiewicz
Keyword(s):  
Dynamic Range ◽  
Low Voltage ◽  
Supply Voltage ◽  
Low Frequency ◽  
Cmos Technology ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Biomedical Sensors ◽  
Filter Synthesis ◽  
Cascade Method

Buffer-based CMOS filters are maximally simplified circuits containing as few transistors as possible. Their applications, among others, include nano to micro watt biomedical sensors that process physiological signals of frequencies from 0.01 Hz to about 3 kHz. The order of a buffer-based filter is not greater than two. Hence, to obtain higher-order filters, a cascade of second-order filters is constructed. In this paper, a more general method for buffer-based filter synthesis is developed and presented. The method uses RLC ladder prototypes to obtain filters of arbitrary orders. In addition, a set of novel circuit solutions with ultra-low voltage and power are proposed. The introduced circuits were synthesized and simulated using 180-nm CMOS technology of X-FAB. One of the designed circuits is a fourth-order, low-pass filter that features: 100-Hz passband, 0.4-V supply voltage, power consumption of less than 5 nW, and dynamic range above 60 dB. Moreover, the total capacitance of the proposed filter (31 pF) is 25% lower compared to the structure synthesized using a conventional cascade method (40 pF).

METHOD FOR MEASURING THE EQUIVALENT PARAMETERS OF INDUCTORS AS PART OF LOW-PASS FILTERS

2020 ◽  
pp. 19-29
Author(s):  
A. G. Zinovev ◽  
I. A. Shestakov
Keyword(s):  
The Self ◽  
Network Analyzer ◽  
Q Factor ◽  
Practical Application ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Loss Resistance ◽  
Low Pass ◽  
Low Pass Filters ◽  
Fifth Order

A method for measuring the self-capacitance, inductance, loss resistance, and Q-factor of inductors as part of an LC low-pass filter at its operating frequency is presented. An example of the practical application of this method for measuring the equivalent pa-rameters of inductors and capacitors as part of a fifth-order Cauer low-pass filter using network analyzer.

THE DIFFERENTIAL DIFFERENCE OPERATIONAL FLOATING AMPLIFIER: NEW CMOS REALIZATIONS AND APPLICATIONS

2009 ◽  
Vol 18 (07) ◽  
pp. 1287-1308 ◽  
Author(s):  
EMAN A. SOLIMAN ◽  
SOLIMAN A. MAHMOUD
Keyword(s):  
Analog Circuits ◽  
Cmos Technology ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Variable Gain Amplifiers ◽  
Variable Gain ◽  
Fully Differential ◽  
Filter Performance ◽  
Low Pass ◽  
Band Pass

This paper presents different novel CMOS realizations for the differential difference operational floating amplifier (DDOFA). The DDOFA was first introduced in Ref. 1 and was used to realize different analog circuits like integrators, filters and variable gain amplifiers. New CMOS realizations for the DDOFA are introduced in this literature. Furthermore the DDOFA is modified to realize a fully differential current conveyor (FDCC). Novel CMOS realizations of the FDCC are presented. The FDCC is used to realize second-order band pass–low-pass filter. Performance comparisons between the different realizations of the DDOFA and FDCC are given in this literature. PSPICE simulations of the overall proposed circuits are given using 0.25 μm CMOS Technology from TMSC MOSIS model and dual supply voltages of ±1.5 V.

DGS-SMS Compact Fifth Order Low Pass Filter

2017 ◽  
Author(s):  
Heba El-Halabi ◽  
Soubhi Abou-Chahine ◽  
Darine Kaddour ◽  
Emmanuel Pistono ◽  
Philippe Ferrari
Keyword(s):  
Pass Filter ◽  
Low Pass Filter ◽  
Low Pass ◽  
Fifth Order

Conception D'un Filtre Passe-Bas En Technologie Microruban

1997 ◽  
Vol 34 (2) ◽  
pp. 133-140
Author(s):  
Mohammed Bekhti
Keyword(s):  
Microstrip Technology ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Technologie Microruban ◽  
Mathematical Expressions ◽  
Low Pass ◽  
Fifth Order

The article describes the design of a fifth order low pass filter using microstrip technology. Mathematical expressions are derived for this case (fifth order) and all component values are shown.

scholarly journals Design and Implementation of High Performance PPSK demodulator in Biomedical Implant

2021 ◽  
Author(s):  
Hima Bindu Katikala ◽  
G.Ramana Murthy ◽  
Yatavakilla Amarendra Nath
Keyword(s):  
Low Power ◽  
Hearing Aids ◽  
Data Transmission ◽  
High Performance ◽  
Large Scale ◽  
Analog Circuit ◽  
Supply Voltage ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Low Pass

Abstract The important challenge for the realization of hearing aids is small size, low cost, low power consumption and better performance, etc. Keeping these requirements in view this work concentrates on the VLSI (Very Large Scale Integrated) implementation of analog circuit that mimic the PPSK (Passive Phase Shift Keying) demodulator with low pass filter. This research deals with RF Cochlear implant circuits and their data transmission. A PPSK modulator is used for uplink data transmission in biomedical implants with simultaneous power, data transmission This paper deals about the implementation of PPSK demodulator with related circuits and low pass filter which are used in cochlear implants consumes low power and operates at 14MHz frequency. These circuits are designed using FINFET 20nm technology with 0.4v DC supply voltage. The performance of proposed design over the previous design is operating at low threshold voltage, reduces static leakage currents and often observed greater than 30 times of improvement in speed performance

scholarly journals CMOS CDBA-Based Inverse Filter Structure

2020 ◽  
Vol 9 (3) ◽  
pp. 2226-2231
Keyword(s):  
Cmos Technology ◽  
Experimental Results ◽  
Band Pass Filter ◽  
Inverse Filter ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Filter Structure ◽  
Low Pass ◽  
Band Pass ◽  
High Pass

This paper presents a voltage-mode(VM) tunable multifunction inverse filter configuration employing current differencing buffered amplifiers (CDBA). The presented structure utilizes two CDBAs, two/three capacitors and four/five resistors to realize inverse low pass filter (ILPF), inverse high pass filter (IHPF), inverse band pass filter (IBPF), and inverse band reject filter(IBRF) from the same circuit topology by suitable selection(s) of the branch admittances(s). PSPICE simulations have been performed with 0.18µm TSMC CMOS technology to validate the theory. Some sample experimental results have also been provided using off-the-shelf IC AD844 based CDBA.

Sign in / Sign up

Export Citation Format

Share Document