scholarly journals Exergy Evaluation of a Heat Supply System with Vapor Compression Heat Pumps

Energies ◽  
2019 ◽  
Vol 12 (6) ◽  
pp. 1028 ◽  
Author(s):  
Agata Rijs ◽  
Tomasz Mróz
Keyword(s):  
Heat Pump ◽  
Heat Supply ◽  
Heat Supply System ◽  
Heat Pumps ◽  
Supply System ◽  
Exergy Efficiency ◽  
Vapor Compression ◽  
Outdoor Temperature ◽  
Pump System ◽  
Heat Pump System

The vapor compression heat pumps are very popular solutions regarding heat supply systems of modern, low energy buildings. It is partly due to the fact that they are treated as a sustainable heat supply. The question arises: Can a vapor compression heat pump be treated as a sustainable heat supply? To answer this question; the exergy model of a heat pump system operation has been proposed. The proposed model has been employed for evaluation of exergy efficiency of an existing heat supply system equipped with two heat pumps installed in an educational building located on the campus of Poznan University of Technology, Poznan, Poland. The analysis shows that the system exergy efficiency decreases with an increase in outdoor temperature and its values are in the range of 10.9% to 42.0%. The primary exergy efficiency, which considers the conversion of fossil fuel into electricity, is on average 3.2 times lower than the system exergy efficiency for the outdoor temperature range of −9 °C to 11 °C. The performed analysis allowed for the identification of a set of solutions that may increase the exergy and primary exergy efficiency of the system. The first solution is to cover a part of the electricity demand by a renewable energy source. The second proposition is to apply a low-temperature emission system for heating. The third idea is to apply a district heating network as the heat supply instead of the heat pump. The conclusion is that the exergy performance of systems with heat pumps is rather poor because they generate low-quality heat from high-quality electricity. The best way to improve the primary exergy efficiency of a heat pump system is to power the system by electricity generated from a renewable energy source.

scholarly journals Digital technological model of heat exchange control in an air heat pump in a low-rise building

2021 ◽  
Vol 2131 (5) ◽  
pp. 052080
Author(s):  
S V Fedosov ◽  
V N Fedoseev ◽  
V A Emelin ◽  
S A Loginova
Keyword(s):  
Heat Pump ◽  
Heat Supply ◽  
Ventilation System ◽  
Heat Supply System ◽  
Heat Pumps ◽  
Joint Work ◽  
Pump System ◽  
Heat Pump System ◽  
Energy Devices ◽  
Mixing Chamber

Abstract The use of air source heat pumps together with other renewable energy devices and highly efficient heating equipment together with digital control systems is a promising European trend that continues to grow in the face of rising prices for traditional energy sources. The article presents a number of technical energy-saving solutions, such as a mixing chamber for HVH, built into the heat supply system and the use of a supply and exhaust ventilation system, in which the principle of recuperation is incorporated. A digital modular-functional-structural diagram of heat generation of a heat carrier from the environment is proposed. Relying on the energy efficiency of the circuit design with an electric boiler, a buffer tank and a patented mixing chamber, the authors achieve a rationally controlled heat and air exchange of a combined heat pump system for heating premises. Automation of the joint work of rationally selected elements of the heat pump air system is one of the Smart Home technologies that improve the efficiency of heat supply, create comfortable living conditions and safety through digitalization of the control algorithm for this system.

scholarly journals TWO-STAGE HEAT PUMPS FOR ENERGY SAVING TECHNOLOGIES

2017 ◽  
Vol 53 (1) ◽  
Author(s):  
A. E. Denysova ◽  
G. V. Luzhanska ◽  
I. O. Bodnar ◽  
A. S. Denysova
Keyword(s):  
Energy Saving ◽  
Heat Pump ◽  
Heat Supply ◽  
High Efficiency ◽  
Heat Supply System ◽  
Heat Pumps ◽  
Supply System ◽  
Alternative Methods ◽  
Ground Waters ◽  
Two Stages

The problem of energy saving becomes one of the most important in power engineering. It is caused by exhaustion of world reserves in hydrocarbon fuel, such as gas, oil and coal representing sources of traditional heat supply. Conventional sources have essential shortcomings: low power, ecological and economic efficiencies, that can be eliminated by using alternative methods of power supply, like the considered one: low-temperature natural heat of ground waters of on the basis of heat pump installations application. The heat supply system considered provides an effective use of two stages heat pump installation operating as heat source at ground waters during the lowest ambient temperature period. Proposed is a calculation method of heat pump installations on the basis of groundwater energy. Calculated are the values of electric energy consumption by the compressors’ drive, and the heat supply system transformation coefficient µ for a low-potential source of heat from ground waters allowing to estimate high efficiency of two stages heat pump installations.

scholarly journals The Efficiency of Vapor Compression Transformation of Energy Flows for Heat Supply Based on the Sea Water

2021 ◽  
Vol 64 (6) ◽  
pp. 538-558
Author(s):  
V. D. Petrash ◽  
V. O. Makarov ◽  
A. A. Khomenko
Keyword(s):  
Heat Pump ◽  
Heat Supply ◽  
Sea Water ◽  
Heat Supply System ◽  
Water Area ◽  
Supply System ◽  
The Black Sea ◽  
Outdoor Temperature ◽  
External Energy ◽  
Energy Flows

The results of the analytical study substantiated the operating conditions for the highly efficient use of the temperature potential of seawater in heat pump heating systems (HPHS) for buildings a building with correspondingly improved environmental indicators. Based on the analysis of the regional conditions of the Odessa water area of the Black Sea, the initial parameters have been substantiated and rational modes of operation of an improved HPHS with central, decentralized or local heating of the subscriber energy carrier have been determined. As indicators for evaluating the efficiency of the HPHS operation, the conversion factor of energy flows and the specific consumption of external energy for the drive of the compressor and the circulating pump of cooled water in the operation of heat pump units were considered. For seawater in the Odessa water area of the Black Sea during the entire heating period, the following temperatures were considered as initial data for analysis: water at the inlet to the evaporator (5–10) ° C, at the outlet (1 °C); calculated temperature difference of the coolant in the heating system (50–40) °C, indoor air (20 °C); estimated outdoor temperature (–18 °C). The characteristic correspondence between the flow rates of the cooled sea water and the heated energy carrier of the heat supply system was taken into account. The prerequisites of high efficiency of the heat pump heat supply system in which the actual conversion coefficient exceeds the seasonal normalized calculated and minimum value at an outdoor temperature of (–10) °C under the limiting conditions of the monoenergy regime for both new and reconstructed buildings were substantiated. In the course of the study, it has been determined that the total specific consumption of external energy for the compressor drive and the circulation of cooled water in the operation of a heat pump unit with a characteristic ratio of water equivalents, even under the limiting conditions of the monoenergetic mode of operation of the heat supply system at an outdoor temperature of (–10) °C, are within the range of generally accepted values (w = 0.28–0.34).

DETERMINING THE PROFITABILITY OF GREENHOUSE ELECTROTECHNOLOGIES: A MODELING APPROACH

HortScience ◽  
1994 ◽  
Vol 29 (4) ◽  
pp. 249a-249
Author(s):  
Eric A. Lavoie ◽  
Damien de Halleux ◽  
André Gosselin ◽  
Jean-Claude Dufour
Keyword(s):  
Energy Consumption ◽  
Heat Pump ◽  
Water System ◽  
Heat Pumps ◽  
Hot Water ◽  
Pump System ◽  
Heat Pump System ◽  
Artificial Lighting ◽  
Hot Air ◽  
Marketable Fruit

The main objective of this research was to produce a simulated model that permitted the evaluation of operating costs of commercial greenhouse tomato growers with respect to heating methods (hot air, hot water, radiant and heat pumps) and the use of artificial lighting for 1991 and 1992. This research showed that the main factors that negatively influence profitability were energy consumption during cold periods and the price of tomatoes during the summer season. The conventional hot water system consumed less energy than the heat pump system and produced marketable fruit yields similar to those from the heat pump system. The hot water system was generally more profitable in regards to energy consumption and productivity. Moreover, investment costs were less; therefore, this system gives best overall financial savings. As for radiant and hot air systems, their overall financial status falls between that of the hot water system and the heat pump. The radiant system proved to be more energy efficient that the hot air system, but the latter produced a higher marketable fruit yield over the 2-year study.

scholarly journals Numerical evaluation of the performance of a single-well groundwater source heat pump system in Beijing, China

2019 ◽  
Vol 38 (1) ◽  
pp. 201-221 ◽  
Author(s):  
Tianfu Xu ◽  
Fengyu Li ◽  
Bo Feng ◽  
Guanhong Feng ◽  
Zhenjiao Jiang
Keyword(s):  
Heat Transport ◽  
Heat Pump ◽  
Transport Model ◽  
Heat Pumps ◽  
Transport Processes ◽  
Pump System ◽  
Heat Pump System ◽  
Single Well ◽  
Groundwater Source ◽  
Beijing China

Shallow geothermal energy is stable and clean. Using a heat pump to produce groundwater and realize heating and cooling can effectively prevent haze and reduce energy consumption. To reduce engineering costs, many buildings in Beijing, China, plan to utilize single-well groundwater source heat pumps. Numerical modeling is an effective way to gain an understanding of thermal transport processes. However, wellbore-reservoir coupling and the uncertainty of productivity due to geological parameters make simulation difficult. A wellbore-reservoir-integrated fluid and heat transport model is defined by T2Well simulator to predict the productivity of a typical single-well system, with consideration of complex geological factors. The model is validated by the analytical model developed in Beijing, China. The fluid processes in the wellbore are described by 1 D non-Darcy flow, and the reservoir 3 D fluid and heat transport processes are calculated. Six crucial factors satisfying a random distribution are used, and for a single well that can supply heat for an area of 9000 m2, the output temperature during the heating season ranges from 11°C to 15°C.

An Economical Analysis on a Solar Greenhouse Integrated Solar Assisted Geothermal Heat Pump System

2005 ◽  
Vol 128 (1) ◽  
pp. 28-34 ◽  
Author(s):  
Onder Ozgener ◽  
Arif Hepbasli
Keyword(s):  
Heat Pump ◽  
Cooling System ◽  
Heat Pumps ◽  
Renewable Energy Resources ◽  
Ahp Method ◽  
Geothermal Heat ◽  
Pump System ◽  
Heat Pump System ◽  
Economical Analysis ◽  
Geothermal Heat Pump

The main objective in doing the present study is twofold, namely (i) to review briefly the utilization of geothermally heated greenhouses and geothermal heat pumps in Turkey, since the system studied utilizes both renewable energy resources and (ii) to present the Analytical Hierarchy Process (AHP) as a potential decision making method for use in a greenhouse integrated solar assisted geothermal heat pump system (GISAGHPS), which was installed in the Solar Energy Institute of Ege University, Izmir, Turkey. This investigation may also be regarded as the one of the limited studies on the application of the AHP method to GISAGHPs, as no studies on the GISAGHPS have appeared in the literature. In this context, an economic analysis is performed based on the life cycle costing technique first. The results are then evaluated by applying the AHP method to a study, which is a comparative study on the GISAGHPS and split system. The results indicated that the GISAGHPS is economically preferable to the conventional split heating/cooling system under Turkey’s conditions.

Numerical Simulations of a Ground Source Heat Pump System With Pile Heat Exchangers

2014 ◽  
Vol 7 (1) ◽  
Author(s):  
Masahito Oguma ◽  
Takeshi Matsumoto ◽  
Takao Kakizaki
Keyword(s):  
Numerical Simulation ◽  
Numerical Simulations ◽  
Heat Pump ◽  
Heat Exchangers ◽  
Heat Supply ◽  
Ground Surface ◽  
Ground Source Heat Pump ◽  
Pump System ◽  
Heat Pump System ◽  
Ground Source

Feasibility of a ground source heat pump (GSHP) system with pile heat exchangers for use in houses is evaluated through a numerical simulation. This GSHP system differs from ordinary borehole-type GSHP systems because short foundation piles installed at close intervals are used as heat exchangers. It is shown that the annual heat supply provided by this GSHP system is able to satisfy the demand of a house due to the air-source exchange at ground surface.

Sign in / Sign up

Export Citation Format

Share Document