scholarly journals Effect of Curing Condition on Resistance to Chloride Ingress in Concrete Using Ground Granulated Blast Furnace Slag

Materials ◽  
2019 ◽  
Vol 12 (19) ◽  
pp. 3233 ◽  
Author(s):  
JangHyun Park ◽  
Cheol Park ◽  
SungHyung Joh ◽  
HanSeung Lee
Keyword(s):  
Compressive Strength ◽  
Diffusion Coefficient ◽  
Blast Furnace Slag ◽  
Chloride Ion ◽  
Ion Diffusion ◽  
Concrete Compressive Strength ◽  
Replacement Ratio ◽  
Granulated Blast Furnace Slag ◽  
Chloride Ion Diffusion ◽  
Furnace Slag

Changes in the salt attack resistance of concrete using ground granulated blast furnace slag (GGBFS) were examined based on different curing conditions. These conditions were divided into air and underwater curing. Three concrete mixes with GGBFS replacement ratios of 0% (control group), 30% and 60% were fabricated. Then, evaluation of concrete compressive strength, evaluation of chloride ion diffusion coefficient and electrochemical impedance spectroscopy (EIS) were performed. As the GGBFS replacement ratio increased, the concrete compressive strength of the air cured specimens decreased compared to the underwater cured specimens. With respect to the chloride ion diffusion coefficient measurements, the coefficient decreased as the GGBFS replacement ratio increased. However, the diffusion coefficient of the air cured specimen relative to the underwater cured ones increased up to two times. The EIS results showed that as the GGBFS replacement ratio increased, |Z| increased in every frequency range. However, the |Z| of the air cured specimen was lower than the underwater cured one. This showed the same tendency as the evaluation results of the chloride ion diffusion coefficient.

Effect of Ground Granulated Blast Furnace Slag on Compressive Strength of POFA Blended Concrete

2015 ◽  
Vol 802 ◽  
pp. 142-148
Author(s):  
M.N. Noor Azline ◽  
Farah Nora Aznieta Abd Aziz ◽  
Arafa Suleiman Juma
Keyword(s):  
Compressive Strength ◽  
Blast Furnace ◽  
Blast Furnace Slag ◽  
Strength Development ◽  
Replacement Level ◽  
Concrete Compressive Strength ◽  
Cement Replacement ◽  
Granulated Blast Furnace Slag ◽  
Strength Tests ◽  
Furnace Slag

The article reports a laboratory experimental programme that investigated effect of ground granulated blast furnace (GGBS) on compressive strength of POFA ternary concrete. Compressive strength tests were performed at a range of cements combinations, including 100%PC, two POFA levels for binary concrete, 35% and 45%, and 15%GGBS inclusion for POFA ternary concrete. The compressive strength results were examined in comparison to PC only and equivalent POFA binary concretes for up to 28 days. Results show that the reduction in compressive strength is greater with the higher cement replacement level for all concretes particularly for POFA binary concretes. However, 15%GGBS in POFA blended concrete has a comparable compressive strength compared to PC concrete at both, 35% and 45%, cement replacement levels except for ternary concrete at 0.65 w/c. In addition, the compressive strength of ternary concrete is slightly higher compared to binary concrete for all concrete combinations. Although there is no significant noticeable influence on strength development, the presence of GGBS did not adverse the strength development of POFA blended concrete. Thus, it can be concluded that GGBS compensates the adverse effect of POFA at early strength development.

scholarly journals Evaluation of Strength Development in Concrete with Ground Granulated Blast Furnace Slag Using Apparent Activation Energy

Materials ◽  
2020 ◽  
Vol 13 (2) ◽  
pp. 442 ◽  
Author(s):  
Hyun-Min Yang ◽  
Seung-Jun Kwon ◽  
Nosang Vincent Myung ◽  
Jitendra Kumar Singh ◽  
Han-Seung Lee ◽  
...  
Keyword(s):  
Activation Energy ◽  
Compressive Strength ◽  
Blast Furnace ◽  
Apparent Activation Energy ◽  
Blast Furnace Slag ◽  
Curing Temperature ◽  
Strength Development ◽  
Replacement Ratio ◽  
Granulated Blast Furnace Slag ◽  
Furnace Slag

Ground granulated blast furnace slag (GGBFS) conventionally has been incorporated with ordinary Portland cement (OPC) owing to reduce the environmental load and enhance the engineering performance. Concrete with GGBFS shows different strength development of normal concrete, but sensitive, to exterior condition. Thus, a precise strength evaluation technique based on a quantitative model like full maturity model is required. Many studies have been performed on strength development of the concrete using equivalent age which is based on the apparent activation energy. In this process, it considers the effect of time and temperature simultaneously. However, the previous models on the apparent activation energy of concrete with mineral admixtures have limitation, and they have not considered the effect of temperature on strength development. In this paper, the apparent activation energy with GGBFS replacement ratio was calculated through several experiments and used to predict the compressive strength of GGBFS concrete. Concrete and mortar specimens with 0.6 water/binder ratio, and 0 to 60% GGBFS replacement were prepared. The apparent activation energy (Ea) was experimentally derived considering three different curing temperatures. Thermodynamic reactivity of GGBFS mixed concrete at different curing temperature was applied to evaluate the compressive strength model, and the experimental results were in good agreement with the model. The results show that when GGBFS replacement ratio was increased, there was a delay in compressive strength.

scholarly journals Durability and Engineering Performance Evaluation of CaO Content and Ratio of Binary Blended Concrete Containing Ground Granulated Blast-Furnace Slag

2020 ◽  
Vol 10 (7) ◽  
pp. 2504
Author(s):  
Jaehyun Lee ◽  
Taegyu Lee
Keyword(s):  
Compressive Strength ◽  
Blast Furnace ◽  
Blast Furnace Slag ◽  
Construction Sites ◽  
Replacement Ratio ◽  
Test Items ◽  
Granulated Blast Furnace Slag ◽  
Local Construction ◽  
Content Range ◽  
Furnace Slag

This study aimed to evaluate the durability and engineering performance of concrete mixed with locally produced ground granulated blast-furnace slag (GGBS) based on CaO content and ratio, and to derive the optimal CaO content range that can secure durability. Hence, tests were conducted by increasing the GGBS replacement ratio by 10% from 0% to 70%, while the unit binder weight was fixed at 330 kg/m3. The results indicated that the compressive strength exhibited a tendency to increase when the CaO content and basicity increased within 28 d of age, although similar compressive strength characteristics were observed at 56 d of age, irrespective of the CaO content and basicity. Additionally, four test items (i.e., carbonation depth, chloride penetration depth, relative dynamic elastic modulus, and weight reducing ratio) were measured to evaluate durability. The optimal CaO content satisfying all four parameters was observed as ranging between 53% and 56% (GGBS replacement ratio: 27.5%–47.1%). The results of the study can provide guidelines on the mixing proportions of GGBS concrete with excellent durability that can be applied to local construction sites and can be used as basic data to set chemical composition criteria for the development of binders to improve durability.

scholarly journals CHLORIDE ION DIFFUSION BEHAVIOR IN BLAST FURNACE SLAG CEMENT WITH CaO・2Al2O3

2017 ◽  
Vol 71 (1) ◽  
pp. 191-196
Author(s):  
Masataka USHIRO ◽  
Taiichiro MORI ◽  
Akihiro HORI ◽  
Minoru MORIOKA
Keyword(s):  
Blast Furnace ◽  
Blast Furnace Slag ◽  
Chloride Ion ◽  
Ion Diffusion ◽  
Slag Cement ◽  
Diffusion Behavior ◽  
Chloride Ion Diffusion ◽  
Furnace Slag

The Influence of the Properties of the Material Used for Obtaining Geopolymers on Their Structure and Compressive Strength

2017 ◽  
Vol 68 (6) ◽  
pp. 1182-1187
Author(s):  
Ilenuta Severin ◽  
Maria Vlad
Keyword(s):  
Compressive Strength ◽  
Blast Furnace ◽  
Wheat Straw ◽  
Red Mud ◽  
Blast Furnace Slag ◽  
Complex Structure ◽  
Point Of View ◽  
Granulated Blast Furnace Slag ◽  
Furnace Slag ◽  
Straw Ash

This article presents the influence of the properties of the materials in the geopolymeric mixture, ground granulated blast furnace slag (GGBFS) + wheat straw ash (WSA) + uncalcined red mud (RMu), and ground granulated blast furnace slag + wheat straw ash + calcined red mud (RMc), over the microstructure and mechanical properties of the synthesised geopolymers. The activation solutions used were a NaOH solution with 8M concentration, and a solution realised from 50%wt NaOH and 50%wt Na2SiO3. The samples were analysed: from the microstructural point of view through SEM microscopy; the chemical composition was determined through EDX analysis; and the compressive strength tests was done for samples tested at 7 and 28 days, respectively. The SEM micrographies of the geopolymers have highlighted a complex structure and an variable compressive strength. Compressive strength varied from 24 MPa in the case of the same recipe obtained from 70% of GGBFS + 25% WSA +5% RMu, alkaline activated with NaOH 8M (7 days testing) to 85 MPa in the case of the recipe but replacing RMu with RMc with calcined red mud, alkaline activated with the 50%wt NaOH and 50%wt Na2SiO3 solution (28 days testing). This variation in the sense of the rise in compressive strength can be attributed to the difference in reactivity of the materials used in the recipes, the curing period, the geopolymers structure, and the presence of a lower or higher rate of pores, as well as the alkalinity and the nature of the activation solutions used.

scholarly journals Effect of fine recycled aggregates on the properties of non-cement blended materials

2020 ◽  
Vol 323 ◽  
pp. 01018
Author(s):  
Wei-Ting Lin ◽  
Lukáš Fiala ◽  
An Cheng ◽  
Michaela Petříková
Keyword(s):  
Compressive Strength ◽  
Blast Furnace Slag ◽  
Interface Structure ◽  
Strength Test ◽  
Recycled Aggregates ◽  
Test Results ◽  
Granulated Blast Furnace Slag ◽  
Fine Aggregates ◽  
Compressive Strength Test ◽  
Furnace Slag

In this study, the different proportions of co-fired fly ash and ground granulated blast-furnace slag were used to fully replace the cement as non-cement blended materials in a fixed water-cement ratio. The recycled fine aggregates were replaced with natural fine aggregates as 10%, 20%, 30%, 40% and 50%. The flowability, compressive strength, water absorption and scanning electron microscope observations were used as the engineered indices by adding different proportions of recycled fine aggregates. The test results indicated that the fluidity cannot be measured normally due to the increase in the proportion of recycled fine aggregates due to its higher absorbability. In the compressive strength test, the compressive strength decreased accordingly as the recycled fine aggregates increased due to the interface structure and the performance of recycled aggregates. The fine aggregates and other blended materials had poor cementation properties, resulting in a tendency for their compressive strength to decrease. However, the compressive strength can be controlled above 35 MPa of the green non-cement blended materials containing 20% recycled aggregates.

Sign in / Sign up

Export Citation Format

Share Document