scholarly journals Effect of Solvent on the Hydrodynamic Properties of Collagen

Polymers ◽  
2021 ◽  
Vol 13 (21) ◽  
pp. 3626
Author(s):  
Katarzyna Lewandowska ◽  
Marta Szulc ◽  
Alina Sionkowska
Keyword(s):  
Acetic Acid ◽  
Sodium Chloride ◽  
Carboxylic Acid ◽  
Uv Light ◽  
Acid Solutions ◽  
Denaturation Temperature ◽  
Hydrodynamic Properties ◽  
Citrate Buffer ◽  
Effect Of Solvent ◽  
Viscosity Behavior

In this study, the effect of solvent on the hydrodynamic properties of collagen extracted from tail tendons of young rats was researched. Collagen was dissolved in various aqueous carboxylic acid solutions, including acetic acid (AA), acetic acid with the addition of sodium chloride (AA/NaCl), formic acid (FA), lactic acid (LA), citric acid (CA), and also citrate buffer at pH = 3.7 (CB). The properties of collagen solutions at a concentration of 0.45 mg/mL were characterized based on the viscometric method. The reduced viscosity, intrinsic viscosity, and Huggins coefficient of collagen solutions and effect of solvent, temperature, and UV irradiation on these properties were investigated. Collagen solutions in acetic acid, acetic acid/NaCl, and citrate buffer were irradiated with UV light up to 1 h, and the viscosity of collagen solutions was measured. It was found that the organic acids used as solvent affected viscosity behavior, denaturation temperature, and stability of collagen solutions. The lowest values of studied parameters were obtained for the collagen solutions in acetic acid with the addition of sodium chloride. Thus, the effect of various aqueous carboxylic acid solutions on collagen solutions properties and denaturation temperature can also be affected by the sodium chloride addition. The results of this research can be crucial for the preparation of collagen solutions for both cosmetic and biomedical applications.

Researching on the fluorescence spectra of acetic acid solutions induced by different wavelength UV light

2005 ◽  
Author(s):  
Ying Liu ◽  
Xiufeng Lan ◽  
Shumei Gao ◽  
Zhonghua Shen ◽  
Jian Lu ◽  
...  
Keyword(s):  
Acetic Acid ◽  
Fluorescence Spectra ◽  
Uv Light ◽  
Acid Solutions

Durability of Red Mud Based Geopolymer Paste in Acid Solutions

2016 ◽  
Vol 866 ◽  
pp. 99-105 ◽  
Author(s):  
Smita Singh ◽  
M.U. Aswath ◽  
R.V. Ranganath
Keyword(s):  
Mechanical Properties ◽  
Acetic Acid ◽  
Fly Ash ◽  
Red Mud ◽  
Acetic Acid Solution ◽  
Strength Loss ◽  
Acid Solutions ◽  
Test Results ◽  
Acid Attack ◽  
Geopolymer Paste

The present investigation is on the effect of red mud on the mechanical properties and durability of the geopolymer paste in sulphuric and acetic acid solution. Red mud and fly ash were used to form the geopolymer paste along with the alkalies. The variation of red mud in the paste composition was from 0% to 90%. Cylindrical shaped specimens of 1 inch diameter and 1 inch height were prepared. The specimens were immersed in 5% sulphuric acid and 5% acetic acid for 1, 7, 14, 28, 56 and 84 days and tested for weight loss, visual deformation, strength loss and colour of the solvent, based on the procedure specified by ASTM C 267 – 01. SEM/EDX Tests were performed on the geopolymer specimens. Test results show that initially, the strength of the geopolymer increased upon the addition of red mud. The strength was maximum when the percentage of red mud was 30%. The maximum strength obtained was 38 MPa for the paste containing 30% red mud using 10M alkali solution as against 31.69 MPa, when only fly ash was used. Geopolymer paste containing 30% and 50% red mud showed better resistance to acid attack. The strength loss was minimum for the samples containing 30% red mud in both inorganic and organic acid i.e. sulphuric and acetic acid.

The synthesis of norbornanes with functionalized carbon substituents at a bridgehead. 1-(3-Oxonorborn-1-yl)ethanone and 1-(3-oxonorborn-1-yl)-2-propanone

1992 ◽  
Vol 70 (5) ◽  
pp. 1492-1505 ◽  
Author(s):  
Peter Yates ◽  
Magdy Kaldas
Keyword(s):  
Acetic Acid ◽  
Carboxylic Acid ◽  
Hydrogen Bromide ◽  
Tertiary Alcohol ◽  
Ethyl Bromoacetate ◽  
Second Molar ◽  
Molar Equivalent ◽  
Acid Lactone ◽  
Basic Hydrolysis ◽  
Hydrolysis Of

Treatment of 2-norobornene-1-carboxylic acid (7) with one equivalent of methyllithium in ether followed by a second molar equivalent after dilution with tetrahydrofuran gave 1-(norborn-2-en-lyl)ethanone (10) and only a trace of the tertiary alcohol 11. Reaction of 7 with formic acid followed by hydrolysis gave a 4:3 mixture of exo-3- and exo-2-hydroxynorbornane-1-carboxylic acid (16 and 17), whereas oxymercuration–demercuration gave only the exo-3-hydroxy isomer 16. Oxidation of 16 and 17 gave 3- and 2-oxonorbornane-1-carboxylic acid (27 and 29), respectively. Oxymercuration–demercuration of 10 gave exclusively 1-(exo-3-hydroxynorborn-1-yl)ethanone (30), which was also prepared by treatment of 16 with methyllithium in analogous fashion to that used for the conversion of 7 to 10. Oxidation of 30 gave 1-(3-oxonorborn-1-yl)ethanone (1). Dehydrobromination of exo-2-bromonorbornane-1-acetic acid and dehydration of 2-hydroxy-norbornane-2-acetic acid derivatives gave 1-(norborn-2-ylidene) acetic acid derivatives to the exclusion of norborn-2-ene-1 -acetic acid derivatives. Treatment of exo-5-acetyloxy-2-norobornanone (52) with ethyl bromoacetate and zinc gave ethyl exo-5-acetyloxy-2-hydroxynorbornane-(exo- and endo-2-acetate (53 and 54). Reaction of 53 with hydrogen bromide gave initially ethyl endo-3-acetyloxy-exo-6-bromonorbornane-1-acetate (59), which was subsequently converted to a mixture of 59 and its exo-3-acetyloxy epimer 61. Catalytic hydrogenation of this mixture gave a mixture of ethyl endo- and exo-3-acetyloxynorbornane-1 -acetate (62 and 63). Basic hydrolysis of this gave a mixture of the corresponding hydroxy acids, 70 and 71; the former was slowly converted to the latter at pH 5. Oxidation of the mixture of 70 and 71 gave 3-oxonorbornane-1-acetic acid (72). Treatment of the mixture with methyllithium as for 16 gave a mixture of 1-(endo- and exo-3-hydroxynorborn-1-yl)-2-propanone (73 and 74), which was oxidized to 1-(3-oxo-norborn-1-yl)-2-propanone (2). Reaction of exo-2-hydroxynorbornane-1-acetic acid lactone (75) with methyllithium in ether gave (1-(exo-2-hydroxynorborn-1-yl)-2-propanone (76), which on oxidation gave the 2-oxo isomer 78 of 2.

scholarly journals REGULATORY MECHANISMS OF CELLULAR RESPIRATION

1950 ◽  
Vol 34 (2) ◽  
pp. 211-224 ◽  
Author(s):  
E. S. Guzman Barron ◽  
Maria Isabel Ardao ◽  
Marion Hearon
Keyword(s):  
Acetic Acid ◽  
Pyruvic Acid ◽  
No Oxidation ◽  
Yeast Cells ◽  
Acid Formation ◽  
Cellular Respiration ◽  
Acid Oxidase ◽  
Acid Solutions ◽  
Fluoroacetic Acid ◽  
A Cell

The rate of the aerobic metabolism of pyruvic acid by bakers' yeast cells is determined mainly by the amount of undissociated acid present. As a consequence, the greatest rate of oxidation was observed at pH 2.8. Oxidation, at a slow rate, started at pH 1.08; at pH 9.4 there was no oxidation at all. The anaerobic metabolism, only a fraction of the aerobic, was observed only in acid solutions. There was none at pH values higher than 3. Pyruvic acid in the presence of oxygen was oxidized directly to acetic acid; in the absence of oxygen it was metabolized mainly by dismutation to lactic and acetic acids, and CO2. Acetic acid formation was demonstrated on oxidation of pyruvic acid at pH 1.91, and on addition of fluoroacetic acid. Succinic acid formation was shown by addition of malonic acid. These metabolic pathways in a cell so rich in carboxylase may be explained by the arrangement of enzymes within the cell, so that carboxylase is at the center, while pyruvic acid oxidase is located at the periphery. Succinic and citric acids were oxidized only in acid solutions up to pH 4. Malic and α-ketoglutaric acids were not oxidized, undoubtedly because of lack of penetration.

Accelerated ripening of Dhakki dates by artificial means: ripening by acetic acid and sodium chloride

2005 ◽  
Vol 70 (1) ◽  
pp. 61-66 ◽  
Author(s):  
Shahzada A. Saleem ◽  
Ahmad K. Baloch ◽  
Musa Kaleem Baloch ◽  
Waqar A. Baloch ◽  
Abdul Ghaffoor
Keyword(s):  
Acetic Acid ◽  
Sodium Chloride ◽  
Accelerated Ripening

Improved synthesis of anti-sesquinorbornene

1984 ◽  
Vol 62 (9) ◽  
pp. 1840-1844 ◽  
Author(s):  
Karl R. Kopecky ◽  
Alan J. Miller
Keyword(s):  
Acetic Acid ◽  
Sulfuric Acid ◽  
Carboxylic Acid ◽  
Lead Tetraacetate ◽  
Carboxyl Group ◽  
Silver Acetate ◽  
Benzenesulfonyl Chloride ◽  
Methoxide Ion ◽  
Hydrolysis Of ◽  
Monomethyl Ester

Treatment of methyl hydrogen decahydro-1,4:5,8-exo,endo-dimethanonaphthalene-4a,8a-dicarboxylate with lead tetraacetate in benzene – acetic acid replaces the carboxyl group by an acetoxy group. Hydrolysis of this product with 25% sulfuric acid at 130 °C forms 8a-hydroxydecahydro-1,4:5,8-exo,endo-dimethanonaphthalene-4a-carboxylic acid 10. The reaction between 10 and benzenesulfonyl chloride in pyridine containing triethylamine at 95 °C produces anti-sesquinorbornene 1 in 34% yield. In the absence of triethylamine 1 is converted to the hydrochloride. The iodohydroperoxide of 1 is converted by silver acetate at 0 °C to the diketone in a luminescent reaction. The 1,2-dioxetane could not be isolated. Decahydro-1,4:5,8-exo,exo-dimethanonaphthalene-4a,8a-dicarboxylic anhydride is converted slowly by methoxide ion in methanol at 150 °C to the monomethyl ester which then undergoes demethylation. The isomeric exo,endo anhydride undergoes reaction readily with methoxide ion at 80 °C.

Sign in / Sign up

Export Citation Format

Share Document