Characteristics of Multigap Timing Resistive Plate Chambers in the Avalanche Mode Operation

2008 ◽  
Vol 52 (6) ◽  
pp. 1748-1753
Author(s):  
Min Sang Ryu ◽  
Byungsik Hong ◽  
Kyong Sei Lee
2021 ◽  
pp. 1-1
Author(s):  
Qiang Xiao ◽  
Xiaoxin Ma ◽  
Weibiao Wang ◽  
Yanping Fan ◽  
Ping Cai ◽  
...  

Electronics ◽  
2021 ◽  
Vol 10 (4) ◽  
pp. 441
Author(s):  
Marcello Cioni ◽  
Alessandro Bertacchini ◽  
Alessandro Mucci ◽  
Nicolò Zagni ◽  
Giovanni Verzellesi ◽  
...  

In this paper, we investigate the evolution of threshold voltage (VTH) and on-resistance (RON) drifts in the silicon carbide (SiC) power metal-oxide-semiconductor field-effect transistors (MOSFETs) during the switch-mode operation. A novel measurement setup for performing the required on-the-fly characterization is presented and the experimental results, obtained on commercially available TO-247 packaged SiC devices, are reported. Measurements were performed for 1000 s, during which negative VTH shifts (i.e., VTH decrease) and negative RON drifts (i.e., RON decrease) were observed. To better understand the origin of these parameter drifts and their possible correlation, measurements were performed for different (i) gate-driving voltage (VGH) and (ii) off-state drain voltage (VPH). We found that VTH reduction leads to a current increase, thus yielding RON to decrease. This correlation was explained by the RON dependence on the overdrive voltage (VGS–VTH). We also found that gate-related effects dominate the parameter drifts at low VPH with no observable recovery, due to the repeated switching of the gate signal required for the parameter monitoring. Conversely, the drain-induced instabilities caused by high VPH are completely recoverable within 1000 s from the VPH removal. These results show that the measurement setup is able to discern the gate/drain contributions, clarifying the origin of the observed VTH and RON drifts.


2021 ◽  
Vol 11 (11) ◽  
pp. 4722
Author(s):  
Botan Wang ◽  
Xiaolong Chen ◽  
Yi Wang ◽  
Dong Han ◽  
Baohong Guo ◽  
...  

This work reports the latest observations on the behavior of two Multigap Resistive Plate Chambers (MRPC) under wide high-luminosity exposures, which motivate the development and in-beam test of the sealed MRPC prototype assembled with low-resistive glass. The operation currently being monitored, together with previous simulation results, shows the impact of gas pollution caused by avalanches in gas gaps, and the necessity to shrink the gas-streaming volume. With the lateral edge of the detector sealed by a 3D-printed frame, a reduced gas-streaming volume of ~170 mL has been achieved for a direct gas flow to the active area. A high-rate test of the sealed MRPC prototype shows that, ensuring a 97% efficiency and 70 ps time resolution, the sealed design results in a stable operation current behavior at a counting rate of 3–5 kHz/cm2. The sealed MRPC will become a potential solution for future high luminosity applications.


Sign in / Sign up

Export Citation Format

Share Document