Frequency Domain Equalization and Adaptive OFDM vs. Single Carrier Modulation

2011 ◽  
pp. 126-132
Author(s):  
Inderjeet Kaur
Keyword(s):  
Frequency Domain ◽  
Communication Systems ◽  
Orthogonal Frequency Division Multiplexing ◽  
Transfer Functions ◽  
Average Power ◽  
Channel Sounder ◽  
Single Carrier ◽  
Adaptive Ofdm ◽  
Frequency Independent ◽  
The Individual

In the present article an attempt is made to compare multi-carrier and single carrier modulation schemes for wireless communication systems with the utilization of fast Fourier transform (FFT) and its inverse in both cases. With the assumption that in OFDM (orthogonal frequency division multiplexing), the inverse FFT transforms the complex amplitudes of the individual sub-carriers at the transmitter into time domain, the inverse operation is carried out at the receiver. In case of single carrier modulation, the FFT and its inverse are used at the input and output of the frequency domain equalizer in the receiver. Different single carrier and multi-carrier transmission systems are simulated with time-variant transfer functions measured with a wideband channel sounder. In case of OFDM, the individual sub-carriers are modulated with fixed and adaptive signal alphabets. Furthermore, a frequency-independent as well as the optimum power distribution are used. Single carrier modulation uses a single carrier, instead of the hundreds or thousands typically used in OFDM, so the peak-to-average transmitted power ratio for single carrier modulated signals is smaller. This in turn means that a SC system requires a smaller linear range to support a given average power. This enables the use of cheaper power amplifier as compared to OFDM system.[Article copies are available for purchase from InfoSci-on-Demand.com]

scholarly journals PAPR Analysis of Fifth Generation Multiple Access Waveforms for Advanced Wireless Communication

2018 ◽  
Vol 7 (3.34) ◽  
pp. 487 ◽  
Author(s):  
Kommabatla Mahender ◽  
Tipparti Anil Kumar ◽  
K S Ramesh
Keyword(s):  
Wireless Communication ◽  
Communication Systems ◽  
Orthogonal Frequency Division Multiplexing ◽  
Multiple Access ◽  
Average Power ◽  
Cumulative Distribution ◽  
Fourth Generation ◽  
Frequency Division Multiplexing ◽  
Frequency Division ◽  
Single Carrier

This paper describes the aspects of multiple access for emerging (5G) Wireless Communication Systems. Orthogonal Frequency Division Multiplexing (OFDM) is best suited for fourth generation (4G) but it suffers from the problem of high Peak to Average Power Ratio (PAPR) & Side band leakage. Single carrier frequency division multiple access (SC-FDMA) has worked like an alternative to OFDMA only in the uplink process and PAPR was reduced. OFDM based 4G network is not capable of supporting diverse applications and these applications can be implemented by 5G.  High traffic requirements of 5G can be evaluated by using multiple access schemes, namely filter-bank multi-carrier (FBMC), universal-filtered multi-carrier (UFMC), generalized frequency-division multiplexing (GFDM). Comparison of PAPR reduction is done based on Complementary Cumulative Distribution Function (CCDF), for various multiple access 5G waveforms.  

BER Improvement in OFDM Systems Using Wavelet Transform Based on Kalman Filter

2020 ◽  
pp. 102-124
Author(s):  
Sajjan Singh
Keyword(s):  
Kalman Filter ◽  
Wavelet Transform ◽  
Fading Channels ◽  
Communication Systems ◽  
Orthogonal Frequency Division Multiplexing ◽  
High Speed ◽  
Performance Enhancement ◽  
Average Power ◽  
Discrete Wavelet ◽  
Rate Analysis

Orthogonal frequency division multiplexing (OFDM) is an efficient method of data transmission for high speed communication systems over multipath fading channels. However, the peak-to-average power ratio (PAPR) is a major drawback of multicarrier transmission systems such as OFDM is the high sensitivity of frequency offset. The bit error rate analysis (BER) of discrete wavelet transform (DWT)-OFDM system is compared with conventional fast Fourier transform (FFT)-OFDMA system in order to ensure that wavelet transform based OFDMA transmission gives better improvement to combat ICI than FFT-based OFDMA transmission and hence improvement in BER. Wavelet transform is applied together with OFDM technology in order to improve performance enhancement. In the proposed system, a Kalman filter has been used in order to improve BER by minimizing the effect of ICI and noise. The obtained results from the proposed system simulation showed acceptable BER performance at standard SNR.

scholarly journals Palm Date Leaf Clipping: A New Method to Reduce PAPR in OFDM Systems

Information ◽  
2020 ◽  
Vol 11 (4) ◽  
pp. 190 ◽  
Author(s):  
Brahim Bakkas ◽  
Reda Benkhouya ◽  
Idriss Chana ◽  
Hussain Ben-Azza
Keyword(s):  
Communication Systems ◽  
Orthogonal Frequency Division Multiplexing ◽  
High Speed ◽  
Average Power ◽  
Papr Reduction ◽  
Frequency Division ◽  
Ofdm Systems ◽  
Leaf Clipping ◽  
Hyperbolic Cosine ◽  
Transmitted Signal

Orthogonal frequency division multiplexing (OFDM) is the key technology used in high-speed communication systems. One of the major drawbacks of OFDM systems is the high peak-to-average power ratio (PAPR) of the transmitted signal. The transmitted signal with a high PAPR requires a very large linear range of the Power Amplifier (PA) on the transmitter side. In this paper, we propose and study a new clipping method named Palm Clipping (Palm date leaf) based on hyperbolic cosine. To evaluate and analyze its performance in terms of the PAPR and Bit Error Rate (BER), we performed some computer simulations by varying the Clipping Ratio (CR) and modulation schemes. The obtained results show that it is possible to achieve a gain of between 7 and 9 dB in terms of PAPR reduction depending on the type of modulation. In addition, comparison with several techniques in terms of PAPR and BER shows that our method is a strong alternative that can be adopted as a PAPR reduction technique for OFDM-based communication systems.

scholarly journals Investigation on the PAPR performance of odd-bit QAM constellations for DFT spread OFDM systems

2021 ◽  
Vol 21 (2) ◽  
pp. 1005
Author(s):  
Ahmed M. Sana ◽  
Amer T. Saeed ◽  
Yaseen Kh. Yaseen
Keyword(s):  
Communication Systems ◽  
Adaptive Modulation ◽  
Average Power ◽  
Transmission Efficiency ◽  
Distribution Functions ◽  
Cumulative Distribution ◽  
Ofdm Systems ◽  
Single Carrier ◽  
Papr Performance

<p>Adaptive quadrature amplitude modulation (QAM) is a crucial scheme that enables the modern communication systems to overcome the adverse effects of channel fluctuations and maintain an acceptable spectral efficiency. In order to enhance adaptive modulation even further, adoption of odd-bit QAM constellations alongside even constellations had been suggested to improve the transmission efficiency of adaptive QAM modulation. Hence, odd-bit QAM had been extensively studied, analyzed, and tested by many researchers for various patterns, sizes, and communication systems in terms of bit error rate (BER) and peak to average power ratio (PAPR). However, the PAPR performance of odd-bit QAM constellation with single carrier transmission systems adopted in the uplink of the 4G long term evolution (LTE) standards caught almost no research interest. In this paper, the PAPR performance of both cross and rectangular odd-bit QAM constellations are investigated for DFT-S-OFDM systems. Complementary cumulative distribution functions (CCDFs) and probability density functions (PDFs) curves for PAPR are also obtained. Finally, an equation for PAPR PDF is empirically derived for odd-bit cross QAM based DFT-S-OFDM. The results show that cross odd-bit QAM outperforms the rectangular odd-bit QAM in terms of PAPR by 1.02 dB for 8-QAM and 1.3 dB for 32-QAM. This proves that cross odd-bit QAM is a better choice in terms of PAPR for DFT-S-OFDM systems. </p>

scholarly journals Three Term Weighted Type Fractional Fourier Transform Based Generalized Hybrid Carrier and Its Application into PAPR Suppression

2021 ◽  
Author(s):  
Yong Li ◽  
Zhiqun Song ◽  
Teng Sun ◽  
Bin Wang
Keyword(s):  
Fourier Transform ◽  
Orthogonal Frequency Division Multiplexing ◽  
Fractional Fourier Transform ◽  
Average Power ◽  
The Novel ◽  
Cumulative Density Function ◽  
Ofdm System ◽  
Single Carrier ◽  
Definition Of ◽  
Weighted Type

To suppress the peak to average power ratio (PAPR) of wireless communication based upon multi-carrier system. We, in this paper, proposed the three term weighted type fractional Fourier transform (3-WFRFT) based generalized hybrid carrier (GHC) system. We first provide the definition of 3-WFRFT. Moreover, some useful properties of 3-WFRFT have been presented, in this paper, which will helpful to comprehend the novel 3-WFRFT transform. Furthermore, we take PAPR of the proposed algorithm, in comparison with orthogonal frequency division multiplexing (OFDM) system and single carrier modulation (SC) system under typical complementary cumulative density function (CCDF) level. It would be demonstrated that, from some numerical simulations, the proposed 3-WFRFT based GHC performs better than OFDM system and will be useful to reduce the PAPR level.

scholarly journals Proposal of Single Sideband Modulation Scheme Using Frequency Domain Filtering

2021 ◽  
Vol 3 (2) ◽  
Author(s):  
Hiroaki Waraya ◽  
Masahiro Muraguchi
Keyword(s):  
Frequency Domain ◽  
Amplitude Modulation ◽  
Additive White Gaussian Noise ◽  
Rapid Development ◽  
Average Power ◽  
Pulse Amplitude ◽  
Modulation Scheme ◽  
Single Carrier ◽  
Single Sideband ◽  
Ber Performance

With the rapid development of wireless systems, the demand for frequency resources has been increasing in recent years. Therefore, it is necessary to consider the high-quality communication method that efficiently utilizes finite frequency resources. In this paper, Single Sideband 16 Pulse Amplitude Modulation (SSB 16PAM) scheme for the uplink communication is proposed. It transmits data in only Lower Sideband (LSB) without extra Hilbert components. Under Additive White Gaussian Noise (AWGN) channel environment, Bit Error Rate (BER) performance of the proposed scheme is superior by 3 dB in terms of Carrier-to-Noise Ratio (CNR) to 256 Quadrature Amplitude Modulation (256QAM) scheme with the same frequency efficiency and the same Peak-to-Average Power Ratio (PAPR). Our proposed scheme employs the original frequency domain filter on the transmitter side to form an ideal spectrum. The configuration of its process is almost similar to Single Carrier-Frequency Division Multiple Access (SC-FDMA), moreover, half of the input data on the frequency domain is removed. The proposed frequency domain filter produces the SSBmodulated spectrum with a roll-off rate of zero without degrading the BER performance.

scholarly journals PERFORMANCE EVALUATION OF SINGLE CARRIER FREQUENCY DOMAIN EQUILIZER (SC-FDE) OVER IMPULSIVE NOISE CHANNEL

2019 ◽  
Vol 11 (2) ◽  
pp. 270-277
Author(s):  
Hussein Abdullah Leftah ◽  
Husham Lateef Swadi
Keyword(s):  
Frequency Domain ◽  
Carrier Frequency ◽  
Communication Systems ◽  
Impulsive Noise ◽  
Signal To Noise Ratio ◽  
High Signal ◽  
Signal To Noise ◽  
Single Carrier ◽  
Noise Ratio ◽  
Error Floors

Impulsive noise is considered as one of the major source of disturbance in the state-of-the-art multicarrier (MC) communication systems. Therefore, several techniques are being constantly proposed to eliminate the effect of such noise. In this work, a time domain matrix interleaved is compiled with a single carrier frequency domain equalizer (SC-FDE) is proposed to reduce the deleterious effects of impulsive noise. A mathematical model for the proposed scheme is also presented in this paper. Simulation results show that the proposed technique superiors the interleaved multicarrier system where the proposed scheme can completely avoid the error floors not only at high signal-to-noise ratio (SNR) but also at heavily distributed impulsive noise. The bit-error-rate (BER) of the alternative proposed scheme decreases as the signal-to-noise ratio (SNR) increases whereas the BER of the standard system suffers from error-floors with a constant BER at about 10-3 for about 8 dB SNR for medium and heavily impulsive noise.

Sign in / Sign up

Export Citation Format

Share Document